Ford Super Duty (1999-2016) :: Driver Headlight Keeps Blowing
Aug 27, 2014
Got a little wild while i was in the trails the other day and was bouncing pretty hard and my headlight blew. Well now im on my third one and id suspect a short. This time it blew the bulb right apart so it must have got pretty hot. Any common problem areas i should look into before trying to figure this out?
View 2 Replies
Advertisement
2013 F350 passenger headlight bulb keeps blowing both high and low? Replaced 2 times now?
View 1 Replies
This has been a problem for awhile, my pass. side headlight has gotten really dim and as a result the driver headlight has gotten really bright. I cleaned the connector up as it had some white corrosion on it but it didn't seem to work. I can move it sometimes and it will come back bright but it doesn't last long. So the question is can I do anything with what I have or do I need a new connector or pigtail?
View 7 Replies
01 Superduty headlight burnt out. Its a sealed beam, haven't changed one of those for years. Most are bulbs.
Anyway I took all the screws I could see from around the headlight door and underneath it.
Headlights still in there as solid as when I started. What screws I seem to be missing?
View 14 Replies
I dont want to pry on the wrong thing and brake something. I am trying to remove the headlight. I was told that their are some pins that need to be pulled up. I dont see any pins. I do see two plastic clips on each side of the headlight. They are flat on the top with a small slot in them. There is a "T" stamped on the top of it. Are these the pins? I tried to find a shop manual today without much luck. Looking for a picture to show the pins that need to be removed.
View 7 Replies
I just had my pass side head lite burn out.....or at least I thought? I replaced the bulb twice......not touching either 1 with my fingures.......and I have no low beam on that side? Only hi beam on the pass side? All my fuses are good, and I even unhooked all my plow harness.
View 4 Replies
I'm really not satisfied with my Ford F350 SDC headlight bulbs!! I need a BRIGHTER bulb suggestion that won't break the bank and not have to add ballasts and rewire the circuit...
View 11 Replies
I have a 01 - F350 with the old nasty yellowing headlights. I know you can polish them or whatever but would like to just put the clear style like some of the newer 04 or up has. I have been doing some searches on here but have not found the answer or part #, brand, picture of the replacement headlight. Is there an easy way to do this without splicing harness, adding relays,ect ?
View 14 Replies
My '99 truck doesn't have fog lights installed, but the headlight switch pulls out. Is there a way to add fog lights and have the headlight switch activate them? Is there something pre-wired, yet untapped? I don't want to start adding extra switches.
View 1 Replies
this doesn't make any since to , what's going is, sometimes the AC starts blowing warm air, I found out if I goose it I can hear what sounds like the damper door slamming shut, then AC starts blowing cold again. I changed out electric vacuum pump, but it still does it, starting to get worse & its hot.
Truck is a 2002 f250 powerstroke, the way I understand it, is only thing vacuum pump is supposed to control is AC & 4 wheel locks, my truck is only 2wd. I don't understand why when when I goose it ,it goes to working, what can I do to fix this.
I just found out the " heat and cool "adjustment is electrical, not vacuum, it goes to something under dash, but what it is, heat strip, reastat(sp)??? where and what damper am I hearing. It is not like heater is on ,not that hot, feels like ambient temp, I am at a loss...
View 7 Replies
I have followed the vacuum lines but don't see any holes or cracked lines. I dont have the ESOF hubs so that is ruled out. Also checked the connector on the vacuum pump to make sure it still had power. Everybody says that when I turn the key to acc I should hear the vacuum pump running. I don't or do I feel it moving. Am I on the right track? I don't want to replace if not bad. Do all vacuum pumps run on keyed power? I honestly don't remember hearing it run before but that doesn't mean anything with my memory.
View 8 Replies
My problem had been intermittent for last few days. I have a Ford Crew Cab - 7.3 Powerstroke Diesel. The ford store told me it would cost hundreds of dollars to chase this short- to wait til it finally burns out then - bring truck to them.?
My fuse # 45 a 10 AMP fuse . Keeps blowing out. This fuse controls the gauges on dashboard and fuel peddle. I can start engine and if gauges come up like they should- I can place into driver - and give engine fuel from peddle- gauges down dead and no fuel go to motor. It just idles and still runs and will still move forward or backward. But only at idle speed.
I could replace blown fuse - #45 - 10 amp and it would a the first few times would go and work normally.
Now everytime I replace fuse it blows fuse - sometimes after putting 10 or more fuses in- one might work until I stop or put into park. Then fuse blows again??
Last night and today it took no less than 20 - 10amp fuses to get close to home and end up straight wiring with a small piece of electrical wire - severing as a jumper- it ran great - til I stop at mail box and got mail - saw slight smoke and pulled wire quickly out and idled down driveway to house..
View 10 Replies
The illumination for my headlight switch and my shift-on-the-fly switch is not working. How do I replace the bulbs?
View 1 Replies
I have never liked that the headlights are below the turn signals on the newer super duties. Has anyone swapped the positions so the headlights are on top? Will be ordering a 2016 next week and this would be one mod I would like to do. Not having the truck yet, I have not been able to do any investigation on what this would take or if it is even possible.
View 11 Replies
When you turn the headlight switch to the headlight on position, you can pull it out exhibiting a positive click as if it is an additional switch for maybe optional fog lights. If the headlight switch is in the off or running lights only position, this will not pull out. I reviewed the elect. diagram but it does not show and addition circuit for the pull switch functionality?
View 4 Replies
Started my truck the other day no problems,minute into the start truck shuts right off like someone turned key. Checked fuses , #30 fuse under the column was blown, replaced it and tried to start truck. No luck fuse keeps popping. After changing again i was able to get truck started for a second and POP goes the fuse?
1999 F550 superduty 7.3....
View 4 Replies
1999 ford superduty keep blowing the 30 amp fuse under the dash, want let it start, why this is happening and the cause of it.
View 1 Replies
I have 2002 F250SD, The horn just starts blowing by itself. Bump the horn switch and it stops for a couple of weeks. I've looked at the wires to the fuse box and no wires shorting out the horn wire. I read some very old posts but nothing conclusive was ever decided on, just a lot of guessing. The horn switch has always been sensitive.
Somebody said the air bag is warming up in the sun and expanding causing the horn to blow. Somebody said the horn relay, but in 55 years of working on trucks, I have never had a horn relay act like that. I'm told the horn relay is built in the back of the fuse box and it all has to be replaced. Some say the clock switch. I don't know what that is or where it is. I guess inside the steering wheel. Is it hard to replace?
Where do I go from here....
View 14 Replies
Sitting in the house, heard a horn blowing and ran outside to find my F350's horn was blowing. When I pushed on the horn button on the steering wheel it quit. Couple of hours later, it started blowing again. Pushed the horn button to make it stop and removed the fuse so it would not start blowing again. Did a forum search, but didn't have any luck. Short in steering wheel?
View 14 Replies
Why I"am blowing #19 fuse it is a 10 amp fuse. It is in the passenger compartment fuse panel. It controls the auxiliary powertrain control module (diesel only),Instrument Cluster, GEM Module, Overdrive Cancel Switch, Idel Validation (Diesel only), Overhead Console and Diesel PCM via Clutch. I would like to know where to start looking to solve this problom.
View 12 Replies
My husband and I have 3 Excursions, V10, 6.0, 7.3 and I have a 6.0 250 crewcab. 3 of the 4 now blow air or heat from just the defroster unless your going at a slow speed.
View 2 Replies