Ford Super Duty (1999-2016) :: Door Keypad Use Sounds Alarm?
May 6, 2012
I bought a 2008 F250 crew cab, long box diesel and other than a couple of minor issues I love it. Tows my race trailer like it isn't even there.
If I use the remote to unlock the doors then everything works as it should, no alarm.
If I unlock the doors using the key pad the alarm sounds?
I have read thru many of the threads I can find but most are reprogramming the keypad. I am suspecting that a door open switch may be the culprit but wouldn't that affect the remote as well?
View 5 Replies
Advertisement
I have a new to me 05 F350 dually with 6.0. When I open the door with the key the alarm goes off and the truck won't start. How do I shut this off so I can get in the truck with the key. I can't just leave the door unlocked all the time. It has the key less entry, but I have not set new numbers yet, and if I give the keys to a valet, I don't want to give them the door code too.
View 14 Replies
I recently purchased a 2010 F250 Super Duty and would like to set a keypad code. I have looked every where I can think of except behind the radio.
View 5 Replies
Just picked up new 2014 F350 lariat today and I can't figure out how to change the keypad code. I enter the factory code and hit add, but when I enter a new 5 digit code it wont let me hit enter.
View 2 Replies
Do the wiring for keypad keyless entry is in the harness and the programing in gem module on a 2003 F350 crew cab?? It would seems that is the same harness/parts as the excursion. I have not removed door panel yet, just trying to save some time.
This truck is one of my finest 4x4 rides yet, this would make much better!!! when i picked up my truck, included in the owners info was a factory keypad keyless entry code card, dealer told me that all trucks with keyless have that card regardless if it has keypad or keyless remote entry???
View 5 Replies
I just bought an '08 F350 Super Duty CC. When I bought it, the previous owner gave a me card with the code on it. So I tried to reprogram the keyless keypad to a new code that I can remember, no luck at all. Followed all the steps on how to reprogram it like a hundred times and still won't reprogram. So I've noticed that none of the lights light up except 7*8, none of the other buttons won't light up.
Could the keyless keypad be going south? Maybe the contacts in the keyless keypad are gummed up or a relay? Need to get this feature to work cause I sure would use it a lot. Also how do I remove the interior door trim to get to the keyless keypad? The door panel has electric locks, electric window, power mirrors, telescoping rear view mirrors, memory seating buttons and speaker pillar.
View 9 Replies
Just bought 2005 F350 XLT. Took it home last night and the alarm started going off at 2:30am for no reason. Stumbled looking for keys and it shut off by itself before I could(it sounded like it rearmed as well). At about 5:00am it went off again. We live in a rural area with not much around.
My understanding is that the XLT would be a Ford 'accessory' item. It does not seem to be too sensitive as I jumped on the back bumper to see if it would set it off but it did not.
The only thing I can think of is that last night, I had flicked all four of the Auxilary switched on the dash and forgot to switch them off. I popped the hood and none of those wires appear to be connected to anything.
I can't see why those switches would have anything to do with it but I am grasping at straws here.
View 5 Replies
I have with my truck is when i pull into a parking lot or even my driveway on a angle the truck sounds the like the bed is loose and the body is creaking.
View 14 Replies
I came home from a week's vacation and towed my 16' toyhauler to and from the Sequoia Nat'l Park ... no issues during the entire trip. Guestimating about 5 hours after being home, everything was unpacked and the truck/trailer locked but still hitched ... suddenly the alarm went off ... all by itself! Using the ignition key, I was able to start/stop the 6.0l diesel motor, but the alarm kept going.
I pressed the lock/unlock buttons but still the alarm was going off! I repeated this a few times and concluded that only recourse was to disconnect the batteries. That stopped the alarm. While doing the disconnecting, I detected a faint electrical hot, maybe a burn kind of smell but no smoke of any kind.
I'm worrisome about reconnecting the batteries to see if the truck is back to normal ... I will probably just have it towed to a mechanic ... in any event it's going to go somewhere to be looked at this coming Monday.
View 1 Replies
I have a whistle from my 2000 f250 super duty when driving over 60 mph. windshield is new, seal around windshield is good (looks good to me).
whistle sounds like its on right side when driving, and left side when sitting in pass side. wife narrowed it down to the over head console sunglass pocket is where whistle is loudest.
Could the clearance lights be whistling? How does one tighten them up or add sealant to the bottom of them to seal them to the roof. Do I have to drop the front of the headliner to access them?
View 5 Replies
I have a 05 f250 diesel 6.0 with 173k. Between 35-60 mph it has started a humming sound and when the throttle is released the sound stops. I still have power boost etc. Someone mentioned degas cap, turbo pedestal or turbo pipes cracked.
View 14 Replies
I have a 2001 F250 Super Duty 4x4 with the 5.4L I bought it cheap and runs well. While going through doing the stuff that needs attention I noticed the 4x4 isn't workijg. It has whatbappears to be some cheap maybe plastic locking hubs and the manual pull stick onj the floor for engaging the 4x4.I can pull it into 4H and 4L, the dash lights confirming come on but the front wheels will not lock in.
One of the cheapo hubs looks like someone clamped vice grips on it to try and turn the and doesnt seem to totally lock in. The drivers side hub sounds like it is lock in but makes a terrible lound clicking noise.
They may be the stock hubs, have no markings to designate the direction to lock and unlock and do appear to be somt sort of plastic hub.... Are the hubs my problem since I can manually pull it into 4x4 and I can see the 4x4 shaft spin but the tires are not engaging?
View 2 Replies
Just replaced my recently stolen tailgate. What are the dimensions for the King Ranch emblem location for a 2015?
Also, any way to tie the tailgate into the alarm system (similar to the way the hood is). I'm guessing that you could possibly tap into the wiring under the hood and add a switch/contact at the tailgate... Also, how would this interfere with engine immobilizer, etc?
View 5 Replies
2016 F-250 Lariat Crew Cab.. How do I turn off the back-up alarm when backing up with my boat and trailer?
View 10 Replies
My truck was sitting in front of the house, unlocked and the alarm disarmed. For no apparent reason, the alarm on the truck went off. I tried pressing both arm and disarm button on the FOB and the alarm would not shut off. I opened the door, started the engine and the alarm immediately turned itself off. I need to look in the manual and see if there is any condition that would cause that particular event. Strange to say the least.
View 3 Replies
In forward drive or reverse, I hear a rotational noise that almost sounds like the bed creaking when you're getting it on. As I go faster the noise goes faster until drowned out by road and engine noise. The noise is unaffected by applying the brakes. I jacked the truck up and spun tires as fast as I could by hand and got no noise but when I lowered it back to ground and had the truck roll the noise was back. Noise is not affected by turning wheel.
View 13 Replies
I bought a 99 f250 super duty with v-10. Ran great then I decided to hose off engine compartment. No pressure washer just running water trying to get all the dirt off now the engine sounds like its missing. Could I have a coil pack that got wet or is something else wrong.
View 3 Replies
I have a 2002 F250 7.3l with an aftermarket alarm. I can't read what the third letter is on the decal MV? 2000 Modular Vehicle Security. I added a pic of the alarm decal below. The key fob it had was aftermarket for the alarm and stopped working about a year ago. Today I unlocked the drivers door with the key and the lights started flashing and I can hear a clicking sound. It done this a few times back when the key fob still worked and I just kept hitting lock and unlock until it finally stopped. It won't let me start the truck at all and I have tried unhooking the batteries with no luck.
View 4 Replies
I am looking for a site that i can download a service manual with good wire diagrams. I want to install an alarm with remote start and need to know what wires go to what.
View 2 Replies
I have a 2006 f-250 with 5.4L 3valve engine. I was worried about my variable valve timing system because my engine sounds pretty rough and I hear a lot of valve chatter. I know that low oil pressure can be a big problem on these engines. Here is a pic of my oil pressure gauge. This was taken while the truck was warm while parked.
View 14 Replies
I have a 2003 f250 superduty v-10 -- 4x4 -- when turning with 4wheel drive disengaged I have consistent thumping sound coming from front end -- more so when turning to left but still prevalent on right turns -- I put new hubs in due to the grinding noise when driving slow to mid speeds -- like axles not totally disengaging and grinding on teeth. but this is a secondary noise -- replaced left front axle with dorman unit -- tried to replace u joints on oe axle but rusted so badly couldn't get c clips to separate from ujoints --
this one is kicking my butt and making me look like a novice -- don't think it is ball joints or anything suspension related but I could be wrong -- sounds like thump thump thump as turning in slightly tight circle or going around corner in the parking lot.
View 1 Replies
