Ford Super Duty (1999-2016) :: Chatter / Binding If Rock Steering Wheel Back And Forth - Fluid Very Cloudy / Gritty?
Sep 27, 2016
I replaced the steering gear box in my 06 F250 CCLB 6.8 over the weekend with a reman Cardone. The old gear box had what I can best describe as a chatter/binding if you rocked the wheel back and forth, that's gone now. I sucked out as much fluid as I could, then filled the reservoir several times while the fluid ran out, what came out was very cloudy and gritty, guessing the old box was chewing itself up.
Can't seem to find a straight answer - what fluid SHOULD this have in it?
Sounds like I should have used Mercon, looks like I grabbed Type F instead. Could that cause the steering effort to be extremely light? I mean like ridiculously light, tip of your pinkie barely touching and turning the wheel light?
View 5 Replies
Advertisement
I have a loose, binding, metal on metal sound on my steering wheel shaft. I have removed the steering wheel, replaced the clockspring, because when I removed wheel clockspring was in pieces and I thought that might be the issue. Guess not, because I'm still having problem. Other than having to remove or replace the whole steering column...
View 2 Replies
I have a 2005 F250 with the 6.0L. I went to pass a person, I got the truck up to 80 - 85 mph and made the pass. Everything was fine for a second or two, then the truck started to rock back and forth violently. It shook so hard, it removed cups from the cup holders. I never felt I lost control of the truck, but I have never experienced anything like it before. I slowed the truck down to about 60 mph and the problem stop. What in the world could have caused this?
View 14 Replies
I have a 2000 Ford F-250 that I have just replaced the tie rod ends on both wheels. The hole where the tie rod attaches to the right steering knuckle getting wallowed out? When I turn the wheel I can see the tie rod end rocking back and forth.
Now if I keep tightening it down it would pull it down past the cotter pin hole exposing way more threads than any to the other tie rod ends. I've searched everywhere and can't find anything that refers to this problem.
View 6 Replies
So now, what I'm noticing is a bit of a clunk in the steering. It's minor, very minor... but like any problem they usually start that way. The sound is very faint, you can't hear it under the truck, only slightly in the cab but you can feel it in the steering wheel, not so much when driving but when sitting still in a parking spot it's pretty obvious if you rotate the wheel back and forth. You can also feel it in the floor. Sometimes I'll notice this if I hit a bump while I'm driving.
Here's what I know, if you grab the tie rod, either end, you get a slight bit of rotation. Not just one end moving, but the whole thing has a small amount of forward back rotation (I'm not sure if this is normal) I had my girlfriend turn the steering wheel while I checked different components and there didn't seem to be any left right play on the tie rods. The boots look good on the tie rods ends, pic included, looks of similar quality of drivers side.
Then the kicker, here's where I noticed the gobs of grease on the top end drag link, pic also included. This was the last link I looked at, and I guess least expected.
So I guess I'm thinking this drag link is bad, but this is my first stop on the advice train. I wiped off the boot that was covered in grease on the drag link and it looked like its in fine enough condition but I also seriously doubt the shop that added the leveling kit just decided to slob grease all over the outside of this drag link boot. I have my truck oil undercoated before every winter but, that was some bit ago, and this looked more like grease to me.
Truck background: 2012 F250 6.7, I'm at 42,000 miles, 34in tires for most of that, and more recently added a 2 inch leveling kit (40,000 miles) and replaced the suspension all around and added a dual stabilizer. I had some noise coming from the drivers side wheel-well a while back and found that one of the end links on the sway bars was simply loose. Tightened up and all good to go. At 30,000 I got some death wobble. Replaced tires, the stock stabilizer had also gone bad, and had an alignment. Everything good since, but I'm thinking some of these problems now might be remnant of the bad tires.
View 3 Replies
I have a 1999 f350 7.3. I'm having a problem where the steering wheel shakes back and forth and the whole truck wobbles. It happens at all speeds, but shakes faster at faster speeds, slower at slower speeds. At first the wheel was just jerking randomly but then I made a right turn, heard a pop, and then it was shaking like crazy. I jacked up the truck and checked the ball joints, checked for and play in the tie rods, and turned the wheel left and right. Everything seems ok so I can't figure out what is causing to wheel to go back and forth.
View 2 Replies
I bought a 2004 F250 Crew Cab LB 4x4 with the 5.4 Motor and when I turn left it has some Tight Spots and I can't figure out why, I checked the Drive axles to make sure the locking hubs were unlocked and they spun freely, I Also have a lot of play in the steering wheel, Could this all be Related to the Steering Box? What else should I check for ?
View 3 Replies
I have a 2008 F-450 Lariat 6.4 4x4. I recently started noticing the front driver side wheel (best I can tell) wheel makes a noise as though it's binding uo when turning either direction, and I can feel it as well. 4wd is not activated and the hubs are in auto. When the front end is off the ground, I rotated the wheels and they spun independently unless the hubs were locked. I noticed what appear to be seals on both the driver and passenger side hanging loose (see pics). What this might be? I recently used the 4wd when we visited White Sands National Monument while pulling a 5th wheel RV.
View 9 Replies
I have a 2010 Santa Fe V6 2WD. When I rock my steering wheel back and forth, I hear a knocking sound when engine is off. Sounds like maybe the steering gear box has play in it.
View 5 Replies
I've done all the fluid but the power steering and the coolant. I'd like to change out the power steering fluid in my 08' F350. What fluid do I need ?
View 2 Replies
I have a 2008 f-250 6.4 Diesel. Yesterday the Brake Fluid light came on. I thought maybe a sensor, but once I parked and checked I realized my brake fluid was down to the Min line. I started looking for a leak and it was apparent that it was the front drivers wheel area.
I am attaching a picture of the brake. The leak is either coming from the area where the fluid line runs into the gold thing (caliper?) or the bolt at the bottom of the gold thing.
View 1 Replies
I blew a power steering cooler line yesterday and lost a bit of fluid. Removed and replaced the line, consequently losing most of the fluid in the system (during line replacement). Re-filled the system and now i have great power steering when driving but none at idle. If I bring my RPMs up about 150-200. I get it back in full force. Could my PS pump be on the way out or might this just be air in the system?
View 3 Replies
I have power steering fluid leaking out of the bottom of the Brake master cylinder out of a round hole. Every time I pushed brakes it leaks a good amount of power steering fluid out. Why it would do this and is there a screw missing out of the hole or what?
View 6 Replies
I have been having some brake chatter for awhile now. I have changed pads, changed rotors, rebuilt both front calipers, flushed all my brake fluid, and made sure my slide pins were good and free. I have noticed some weird wear on the new front rotors and was wondering if it was normal or not. On a different note, I am having to replace my parking brake pads. When I had the axle out I looked in and saw a bunch of gunk.
View 12 Replies
I have owned an 03 Excursion that I have had since last November that has started to feel like the steering is badly broken for a few hundred feet some times and then goes back to normal. It will do it some times after taking a corner and then suddenly there is a 1/4 turn play in the front and its wondering in the lane as I correct it back and forth and then it stops and goes back to normal. I've checked it and it all seems good and tight. The truck is stock height and has stock size wheels....
View 14 Replies
the mechanism that locks the steering wheel is stuck. not the ignition key cylinder (already removed that). how do I release that mechanism to free the steering wheel.
View 3 Replies
OK so my 2001 F250 was leaking power steering fluid from the lower portion of the gearbox (where the pitman arm attaches).
I found a thread on this forum where it showed how you could change the seals out WITHOUT taking the gearbox out.
So I got the pitman arm off with a heavy duty puller. Then I scraped out the 1st rubber seal hoping to reveal a snap ring behind it. Well, the seal is 99% scraped off, but there is not evidence of a snap ring. It does seem like there is some metallic ring holding another rubber seal in behind it. But again, I can't find the little open spots that you put your snap ring pliers in to get snap rings out.
How do I get this metallic thingy out???? I already broke a small drill bit trying to drill it out. It just doesn't seem like the best way to go about it.
View 1 Replies
Seems that after a sharp right turn, for instance turning right at a stop sign I'll get a loud pop that I can feel in the floor pan under my feet.
After the pop the steering wheel and whole front of the truck will shift left and right like someone is grabbing the wheel, sometimes violently. If I drive slowly it will cure itself and sometimes not do it again for several days. I've check ball joints and hubs and they are in great shape. I pulled the hubs and greased the needle bearings about 6 months ago. I checked all steering components and the linkage that attached to the steering arm had some play so I replaced it. Then I found that some idiot took the steel sleeve out of the bushing in one end of the steering stabilizer. I bought a new stabilizer and cured a pop I'd had since I got the truck, but the other issues were not solved.
Alignment has been checked too.
View 14 Replies
My truck has developed a wobble in the steering wheel. I don't mean when you are driving down the road, but the steering wheel wobbles around. It wobbles in any position that the Till shaft is set to. How to repair.
View 10 Replies
just bought this f250 seems to walk on the road alot, had it looked at has new balljoints, he says everything seems tight except there is lots of play at the gearbox, is it recommended to have it rebuilt or buy a reman, was told that even the reman seems to be the same way
View 14 Replies
The steering wheel is locked on my 99 F-350. I messed around with the stupid thing for quite a while this evening and it won't budge! I need it to haul hay tomorrow....
View 13 Replies
