I'm looking to buy a 08 f250. It has 70k miles on it. The guy is running a mini max tuner on it. I did notice on a cold start as soon as he hit the acceleration it had alot of black smoke. Is this normal? And is there anything I should b aware of when looking this truck over.
View 2 RepliesTruck: 1999 Ford Truck F 350 4WD Super Duty V8-7.3L DSL Turbo VIN F
Problem: Especially when it is cold outside . . . The truck takes forever to start and while doing so a ton of white/grey smoke comes out of the exhaust.
My starting schema: Turn the key on have the gas pedal pushed to the floor until the "wait to start" light goes out. Then, I turn the key off and back on while still pressing the gas pedal all the way down. When the "wait to start" light goes out again I remove my foot from the pedal and try to start it. I never leave it cranking for more than 5-7 seconds. If, after trying this process several times I will not push the pedal in at all. Also, sometimes I will leave the pedal pushed in while I am cranking it over.
The truck used to start after a couple of tries but lately it won't start at all, even after 20 tries. Sometimes it will spin up for a second as if the engine gets going but then just doesn't continue running. When it is warm out it will usually start after a few tries but doesn't seem normal to me. After I first bought the truck(used) it would start up within half a second after turning the key.This all started after I had to fix an o-ring that was damaged on the top/back of the motor that was dumping all my oil out of the top/back of the motor.
I have a serious issue with my 2004 F250 6.0. Pulling a trailer something under the hood sounded like an explosion and lost power and boost. The truck started blowing black smoke from the tail pipe. I could see no psychical damage to anything under the hood. There was absolutely no power but managed to cripple home. What happen.
View 14 RepliesI have just replaced the EGR cooler, Oil Cooler, professional turbo reconditioning, both dummy plug's and stand-pipe's, blue spring, fuel filters, oil changed, cleaned the EGR valve and intake manifold. I am in the process of doing a coolant flush when my issue occurred. I was on the road for about 10 minutes when I lost power and started blowing black smoke. I have normal power till about 45 mph then nothing. I can baby the truck up to 55-60 and then nothing and the whole time blowing black smoke.
I stomp on the pedal with no power. I hear the whine of the turbo. The truck idles and sounds fine. My SCT showed my oil and coolant temps within 15 degrees. I opened the hood and saw soot all over the top of the engine from the compressor to the EGR valve and all in the valley from valve cover to valve cover; but more so on the driver side to FICM. I obviously didn't connect something properly. I am just about to remove the intake manifold and reinstall, but before I do just wanted some input.
Just bought a 02 f-250 7.3 with 115k miles. A couple days after I bought it I noticed a lot of white smoke on cold starts for about 20-30 sec at 50 degree temperature. So I tested the GPR which ended up being bad a replaced with the one that is double in size(name escapes me atm) and also did the 50 cent mod to keep the through-valve cover harness from losing connection since both sides were lose.
After that the temp warmed back up and it would only blow a "puff" of white smoke. The past two days it has gotten down to 30-32 and the truck has a rough time starting. Cranks fine but it's almost like it's getting choked or flooded then it will blow smoke for 3-4 minutes after it starts. The truck does have a FASS fuel system on it with stock injectors. Should I try to Ohm out the glow plugs again or where should I start trouble shooting?
I have a 06 6.0 Powerstroke 6 Speed every time I get on it or even try to get going I have no power and I have pure black smoke blowing out the exhaust somebody told me to change the fuel filters which I did which they were pretty nasty then after I did that I seem to still have the same problem so then they told me to check the EGR valve put injector cleaner in it to clean the injectors which I have not done a gr or injector cleaner yet just wanted to know, what it could be or what I can do to prevent the black smoke I have no power either...
View 1 RepliesMy 2006 F-250 (6.0 Diesel) started blowing black smoke under acceleration yesterday. It has 181k miles on it now. No loss of power, no rough idle, no smoke unless there's a load on the engine like accelerating, but then it doesn't matter if it's 1500 or 3000RPM, just the higher the RPM the more smoke it blows from the exhaust, dark black.
The truck has ARP headstuds, no programmer. Replaced both batteries and the A/C system about 2 weeks ago. About 3000 miles ago it got new glow plugs & harnesses, new alternator, all fluids changed, new aftermarket EGR cooler, new EGR valve, new turbo & actuator, new EBP sensor, new HPOP incl pipes and IPR.
Trucks starts up just fine, runs normal, just yesterday going down the Freeway about 65mph I noticed it started smoking black going up a hill, then smoke went away going downhill... Now every time I accelerate it's smoking black. Taking off from a stop sign it made a little puff of white smoke then went back to black smoke, but that only happened once.
Where I should start looking? No codes so far. But I have an AutoXRay EZ-Scan 6000, what sensors do I need to look at?
2005 F250
123'xxx miles
EGR delete kit
This is my problem, the truck Idles then revs by itself and throws black smoke.If i leave it on it eventually seems like it floods and shuts off,when i first noticed this it had a loss of power and was having a hard time shifting gears, it would idle fine but when i would try and drive the truck it had no power. I changed the diesel filters and the air filter and the problem persists.
Could this be a bad turbo? Injector?
Here is the video of the problem.. F250 problem. - YouTube..
My mechanic cannot figure it out nor can a Ford mechanic. About every one to two weeks, only in the morning, after I drive about a half mile it starts running rough and stalls at idle. It behaves like it is flooding out. When I can get it started black smoke pours out until it clears. I can hold it above 2000 rpm but, as I lower the revs, it starts stalling again until it stops. I've tried blowing it out on a long stretch but at normal speed it does it again. After repeating this several times it suddenly runs right and won't happen again for a couple weeks, the longest being four weeks. I thought it might be the remote start but that theory was busted. I've searched here and in other sites and replaced the IAC but it still did it. Replacing the O2 sensors did not work. I don't want to keep throwing parts at it.
'03 F250 FX4, 5.4 gas....
I have a 99 350 sd 7.3 low power black smoke sets a p1211 under heavy throttle. Check icp on scanner under heavy throttle falls from 1900s to mid 1700s ipr duty cycle runs about 62% wanting to know if I am looking for a hpop problem or injector issue...
View 1 RepliesI just bought a 2002 v10 crew cab, everything great form the first 3 months, but then my coolant sensor stopped working, changed it, and the same thing! Only works a couple of times, and the truck started to rough idle a little, and now I have black smoke coming out of the exhaust!
View 3 Replies2005 6.0l PSD. Driving flat road pulling 8K trailer. Not pushing it at all. Sudden air hissing sound on (seems like) passenger side of truck. Black smoke pouring from tailpipe. Check intercooler pipe and is ok. Can't see anything that is loose. Only 8 miles to the campground so limp down the road at 30 MPH which is all it will do. Hissing sound is remarkable predictable in that it is repetitive every 5 seconds or so. Lasts for maybe 2 seconds then stops the repeats.
There is no turbo boost either on the dash gauge or the Scan II gauge. Shutting the engine down, there is no turbo wind down. Scan II show no codes. Check everything I can reach and find nothing extraordinary. Tried starting a driving it today and had boost for a minute only then nothing. Blowing white smoke too. Check the oil and it is oil. Check the radiator fluid and it is oil free. Running low on fuel and wonder if I have a water in the fuel problem. However, don't think that should effect the non functioning turbo...
I have an 2006 F350 diesel. Starting my engine when cold produces a lot of smoke. It can take up to 10 times turning the key to finally get it to run. This is not a problem when I have the engine warmer plugged in. After the engine warms up the engine does not smoke anymore. Thinking about finally taking it in and having it worked on but thought I would ask your opinions first. I ran a quart of very expensive injector cleaner in it with no improvement. The engine light will sometimes come on and other times it won't come on. I did take the truck to Oreillys and had the engine analyzer on it and two pages of possibilities (problems) came up. Engine has 110K miles.
View 14 RepliesSo I just purchased a 2011 F350 6.7 this week...I've had absolutely no problems until I drove it to the dealer just to get it detailed...I give the salesman my key and he comes back and says it won't start...we tried numerous time to start it...put jump boxes on both batteries and nothing...had full power to all accessories but when attempting to crank it would black out on the dash screen and give me a "stop vehicle" warning....does this deal with security?....also after hassling to get rental for a hour or so,we tried agian and it fired right up?!?...also it started double honking when locking. ..is that due to the hood being up?
View 3 RepliesJust bought my first Ford. Its a 2015 F250 Platinum. Im at 1400 miles and Im becoming concerned because when I start the truck for the first time in the day, no matter how long I let it sit and warm up I am noticing that on the first couple of miles of driving I hear a high revving sound as I accelerate and it seems to quick shift during those first few miles.
As I continue to drive the high rev sound just fades away and all engine sounds and shifting are as normal as can be and will remain that way until the truck has been sitting for an extended period of time and is cold. I thought it had something to do with tranny temp but this morning I let the tranny warm up to about 115 deg in neutral before taking off but still had the high rev for the first few miles. I have never owned a ford nor have I ever owned a heavy duty truck, hoping this is normal.
I just replaced my up pipes, turbo pedestal O-ring, ICP, IPR, New O-rings in all my injectors and torqued to spec, new glow plugs, glow plug relay, oil loom wiring harness, new O-rings on oil cooler, oil filter, oil, and antifreeze. I have tried and tried on upwards of 50 or time to get it to turn over. A little white smoke came out and it sounded like it wanted to fire up, but only a few times. I have good batteries and a charger on it working along, 3-4 trys in 5-10 second burts or longer if it doesnt lose power every 30 -hr. oil is in HPOP too. 2001 F-350 7.3 auto 2wd 4dr longbed 329,611 ml..
View 8 RepliesI have a 05 f250 6.0 that currently will not start and no smoke. Replaced batteries and tested ficm. At initial injector buzz voltage drops to 18.8 then jumps back to 48.8 and drops again to 18.8 while cranking. My question is if the voltage is this low does the pcb still just need a resolder or are there components that will need to be replaced?
View 1 RepliesThe last couple weeks my excursion had started to have a stumble and smoke white ate the first startup or after I let it sit for a long time. I did get progressively worse. I noticed the hpop line to the driver side head was leaking from the fitting so I rebuilt the boss fitting and now it's not leaking but when I started it up this morning it did the same thing.
If I give it throttle it clears up pretty quickly but if I let it just idle it will put white for probably 5 minutes. I have no codes showing when I looked with the scanner I don't see any other oil leaks and I don't smell a fuel leak.
I normally just troll the existing threads and find what I need, but I am stumped. Just had the HPOP replaced and ran fine for 2 months. Then I started getting a hot no start. So it sat for a couple of days. Then I went to pull it in the shop, it started, I backed up 10 ft and it shut off. I started it back up and it died. I am going to hook it up and figure out my AE software tonight. So question, can an IPR valve get clogged after the fact? Or could it be a bad HPOP?
View 12 RepliesI have a 2011 F250 with the 6.2 gas engine. I have been having a problem that the dealership says there is nothing they can do and have never heard about.
After the truck sits all night I get in and drive it for 10-15 min. It gets warm and I get out turning it off. When I come back about 15-45 min later I start it up and go to leave. As I pull out and start to accelerate in first gear the truck goes to an idle for about 2-3 seconds. I push the gas pedal and get no response. After a couple of seconds it picks up wherever you have the gas pedal. If you have the pedal to the floor it jumps you forward. This is not putting on any lights and the computer is not throwing any codes. According to the dealership the computer is telling them there is nothing wrong.
This has happened 12 times in the past 6 months. It has happened since I bought the truck. I have just started documenting it as of 6 months ago. It is not something I can make it do on command. After it happens once it doesn't seem to do it again for a week or two. I have 31000 miles on the truck. The dealership has had it for 4 days now and can't seem to get it to happen for them.
I'm having a problem with starting the V10 in my 99 E350 cube van. It refuses to start when cold unless I stick my finger in the idle air control valve and force it shut, or use starting fluid, or a combination of both. Once I do get it started, it will die if I touch the throttle, but once warmed up, it runs fine. I have replaced the IAC, the cylinder head temperature sensor, the fuel filter and fuel pump, and cleaned the MAF. My code reader shows no codes, and like I say once warmed up it will run fine and restart no problem.
View 1 Replies