I purchased a new F250 with the Auxiliary Switches. I would like to use them for some LED lights, both front and rear. Where is the point that I can tap into to them? I found the fuses for them, but can not find the point where I can attach the wires.
View 7 RepliesOdd thing happened this evening, I took the truck for a short drive, rolled down the drivers power window, and then needed to turn on the map light, but realized it didn't work, same with the radio. The clock on the radio works, and now none of the window switches do anything.. I tested every fuse under the dash, even swapped around all of the relays that have the same part number, to no avail.. Is there something simple I'm missing that is a common problem with these trucks? I'd hate to have to leave my window down for awhile till I figure it out on my own..
View 14 RepliesI would like to install some lights under the bed rails to light up the inside of my bed at night.
There are many kits available, any specific set or brand you all recommend?
I bought a 2003 F550 Super Duty 4WD, cab and chassis truck. It has a 7.3 TD. Real nice truck. I bought it to turn it into a wrecker. I removed the factory fuel tank (was behind the real axle inside the frame rails.) I installed a 50 gallon aluminum tank behind the cab on the frame rails. The rear tank has to be removed for the wheel lift.
Any way I have everything installed and now the truck dies out after a few minutes. It starts up fine then dies out like its starving for fuel. The tank I installed has a sump pickup (tank came off a freightliner, so its not some home made thing I just welded up in the garage)
I was thinking about installing an auxiliary lift pump as the auxiliary tank is a bit higher than the factory tank, but I want to solve the issue not throw parts at it. I thought at first injectors but it runs perfect after I prime it so my guess is its not the injectors.
I just bought a 2014 F-250 with out upfitter switches, how hard it would be to add them now? and if the wiring is there?
View 7 RepliesI want to install a set of upfitter switches but my truck didn't come with them...so I bought the switches and the relay/wire harness as well...I cannot find any good information on where to mount the relay and where an extra plug on that harness goes too. I have found the wires that attach and go through the firewall but I am not sure where the rest of this mess goes...my truck did not come with the wire harness already installed...
View 4 RepliesWhere the blunt ends are for the Aux Switches. The manual says they are behind the passenger kick panel but I'll be danged if I can find them there. Are there none on the driver side?
View 9 RepliesI just got a 15 f250 with the console and nav system but it didn't come with the upfitter switches.
I picked these up and got a copy of the .pdf for the installation, but I'm finding it hard to follow for where the relay and box should install. I ran the wire up to the upfitter switch location and can even find a nice spot to connect the grounding wire.
I can't for the life of me figure out where the box installs and where the wiring harness taps into the main harness. Need a photo of where your box is installed and where it taps into the main harness?
How hard is it to install the upfitter switches and the fog lights? Is it all plug and play?
View 4 RepliesMy 2005 F250 just had the cab off in December for head studs and gaskets. Its a Crew Cab short bed FX4 so it has ESOF. When I engage 4x4 the blower will switch from blowing air out of the vents to blowing air out of the windshield defrost. Is a vacuum line plugged in wrong somewhere, or is one cracked? Trying to figure this out, its rather annoying
View 2 RepliesI have a 2010 F250 and wanted to power a dash camera using the upfitter switches. I purchased a 12volt wire, but am unsure on where to wire it so that it will only power up when the ignition is on..
View 7 RepliesI would like to do the high idle mod with my 2006 F-350 using the upfitter switches. I've seen a couple of threads about this but they are not real clear to me and don't mention the 2006.
View 14 RepliesMy 1999 F 250 5.4 liter. I know I have a vacuum leak because whenever I accelerate the air conditioning coming from the vents switches to the defroster. So my question is how do I go about finding the leak? My hubs in the front are manual so I know I don't have lines going up there. I do have some mechanical capabilities I've changed water pumps alternators brakes etc. But never anything with vacuum lines or a/c.
View 14 Replies2006 f350 DRW King Ranch diesel with 94,000 miles on it. When I shift in to 4x4 the AC switches to defrost and then takes 2 min to return to the vents. I imagine this is a vacuum leak issue. Where to start hunting? I pulled the dash for another install and all lines were connected. I will say the vacuum pump stays on longer than normal when the ignition is first activated.
View 1 RepliesThe problems that I am having at the moment are that the abs light is on from the speedometer, odometer, also the blinking overdrive light that comes on at around 25 mph. After some research I had purchased a ford factory sensor for the rear dif. I then replaced the old sensor with the factory one. Started the truck and not a single thing had changed, both the meters were not working as well as the od light was still flashing.
View 4 Repliesthis morning my 02 decided to turn the ABS light on, and start bouncing the speedometer. plus, the OD light is flashing when stopped with foot on the brakes, but the trans is shifting fine.
nothing changed on the truck except almost 3 inches of rain fell last night.
will AE tell me if the VSS is going bad?
This is 6.0 VT365 in an F650...truck runs just fine however the SES light stays on. I have noticed that with the truck running the SES light does not come on until the Wait to Start light goes out
I have read the codes using Snap on Scanner and have code 252 which is apparently configuration module (volts below norm or shorted)...but I am told 252 is an un document code...which is not very useful.
I have been working through the various connectors and checking the harness, but not yet finding the issue, as to the the SES light only coming on after the WTS goes out with the engine already running.
I recentlyHad to replace the right front wheel bearing and after the install the speedometer and turn signals don't work, the ABS light is on and the overdrive light on the shifter is flashing. I've replaced the VSS on the rear diff, pulled and cleaned Speed sensors on front hub?
View 2 RepliesI have a 2010 f250 XL v10 6 speed 4wd. I was looking into adding factory fog lights to it. I have the factory plug by the headlight. I've read that some XL trucks just need the fog lights, wiring harness for the lights and the headlight switch with the fog light option.
So today my buddy (has an 09 f250 xlt with factory fog lights) and I decided to try his headlight switch in my truck to see if it would send power to the plug by the headlight. Plugged it in, turned the fog lights on and had no power. Actually the little fog light light on the switch didn't light up that I noticed either. So we compared wiring harnesses going to the headlight switch. Both trucks have 9 wires. #21 fuse in the kick panel is intact and good.
What else my truck would need in order to use the factory fog light parts? I know I could run new wiring and use an aftermarket switch but I'd rather it be factory.
My Dome lights don't work when you open the door. I can manually turn them on though. Also door ajar light is on. Are these issues caused by the door latch switch? Also have no fog lights I replaced the switch and bulbs. I have a 2003 F250.....
View 2 RepliesWas checking fuses for why my 3rd brake light and pedal adjustment switch does not work. Was also looking for a fuse to tie into so that a light in the cab floorboard will stay on when the headlights or marker lights are on... After trying several spots to no avail (finally putting it into the bright headlight fuse). I got the light to work.... But now my ABS light stays on!!! Also 3rd brake still not working...
View 1 Replies