Ford Super Duty (1999-2016) :: 5r110 Trans - Occasional No Shift From Park
May 8, 2013
Iv got a 2003 6.0 stroke with 212k miles on it. Runs like a top. Done a slew of work from injectors to hpop, 2 alternators, intake, exhaust. NO tuner! Stock. Anyway recently I started the old girl up, warmed up a bit and shifted into reverse and truck did nothing. Went to drive and same thing. Held brake and revved it up and it dropped in gear. Shifts fine after that. No issues other than the occasional NO shift from park problem. Iv dropped pan and replaced all filters recently.
View 2 Replies
Advertisement
I have a 2005 Ford 6.0L Diesel with the 5R110 transmission.
About a month ago, i started seeing some strange shifting issues with the transmission. While driving normally, it would suddenly hard shift (slam itself into gear), the entire truck would shake it shifted so hard. It would also cause the Tow/Haul indicator to start blinking. (my understanding is that the Tow/Haul light indicates an error code).
I drained/flushed the transmission, installed the larger pan/with the improved filter. I put Mercon LV back into the transmission (what type of fluid was in there before).
The problem still persists, and got a bit worse. The truck is almost un driveable at this point. Still getting Tow/Haul flashing messages. Can the error code be read by an standard ODB2 reader ?
View 9 Replies
The truck belongs to a very good customer of mine and is a 05 f350sd 6.0 td with 5r110 torqshift tranny. The vehicle presents with these symptoms and codes....
-there is a delay from p to r and its intermittent, sometimes it will be in a weak reverse where it wont creep unless you give it some gas, sometimes it will hit reverse hard after this. sometimes it bangs reverse
-there is a delay into drive intermittently with the same symptoms as reverse where sometimes it bangs and sometimes it will take a little throttle to get it moving
-once the trans is hot (operating temperature) it has trouble downshifting. my solus tells me sometimes it tries to start off in 3 or 5 then sometimes it will bang back down into first and almost chirp tire with little throttle input
-tow haul light will flash after several miles and then it only has 1-2-3-4 no 5-6. then the starting off symptoms get worse
-throws codes for
p0766 shift sol d performance/stuck
p2701 friction element b apply time range/performance
p2703 friction element d apply time range/performance
p0700 trans control system fault.
So far the ideas i have are as follows
replace solenoid D
direct clutch replacement and seals for corresponding drum
torque converter replacement and pump replacement
harness rub through between pcm and transmission
The truck has had similar issues a year ago. Upon testing line pressure i found it was out of spec and replaced the epc. (electronic pressure control solenoid) and this cleared most of it up . I have had the pan down many times and the fluid has not been burnt and there is little debris in the pan. nothing i would consider beyond normal wear. Tomorrow I will be dropping the pan again to inspect the magnet and fluid as well as the condition of the harness. i will post my findings at that time. I am hoping between now and then some of you will be able to point out a few possibilities to get me on the right track.
View 14 Replies
Started flaring between 3rd and 4th I changed the pressure solenoid and the direct clutch and no change. Flushed the tranny and changed filters and no change the oil is not burnt. When it flares it goes into a safe mode on the dash and will shift perfect through 4th gear no issues. I guess I've always know if it's bad it's bad but I don't understand why it works in a safe mode but slips in regular. Also if it is a bad tranny will a 3c2p-7000 work as a swap in my truck. 2008 6.4 4x4 ....
View 5 Replies
So when I try to kick into 'passing gear' in this '01 f250 5.4l, i get no tranny shift. Whether I'm in tow/haul mode or not.
View 10 Replies
99 v10 auto 4x4. Won't go into park completely. Have to start in neutral. was fine yesterday, now it doesn't work. if it wasn't snowing like crazy id just crawl around and find out. do our trucks have a linkage? or shift cable? I imagine I am just out of adjustment somewhere. any advice what to look for or where to start when the snow finally stops??
View 3 Replies
The kid at body shop called, he has the cab ready to swap onto the 04 gas job except for the shifter cable at the trans. I have never done one either, and do not know how to take it off. I thought it was like the old trans where it was in a plastic grommet, but the cable almost looks like it is grafted to the trans. How to get the cable off the trans shift arm?
View 2 Replies
I have a 02 F350 V10 4x4. Tonight I went out to go to a friends house and the truck started fine but when I push in the brake it will not release the lock on the shifter. You can hear a click noise when you push in the brake pedal.
View 14 Replies
I did a bad thing last night, I put a jumper in the 20 amp cigar/data link connector and all kinds of things went out, will not shift out of park, no directional, power windows, power mirrors, no brake lights ,no hazards, no wipers, no interior lights and I don't know what ever else is not working.
View 3 Replies
2003 7.3 powerstroke won't shift out of park when running. When my plugs are warming I have to shift into neutral then start truck. Works just fine after that unless I go in to park again. Brake lights work just fine. So I am guessing brake light switch is fine. What's next to check?
View 5 Replies
I have a 2006 F250 with the 6.0 PowerStroke and automatic transmission. I just purchased this truck at an auction about a month ago.
Today I notice the transmission is not shifting into overdrive. No warning lights. If I press the tow/haul button in no change but the tow/haul light does come on. If I press it again (to turn it off) the tow/haul light goes out but still the transmission will not shift into overdrive.
This leaves me at about 2000 RPM at 68 MPH. I just had a Ford dealer perform Transmission service last week. (20,000 miles after the last recorded service.)
I am already not happy with the service I received at the dealer so I am really hesitant to take it back to them if it is something not related to the transmission service they performed.
View 5 Replies
I have a 99 f250 with some procomp (325s) that are 12.5 wide with a 6in lift my superchip tuner can change the trannys shift points but I am pretty sure a new gear ratio is needed. I dont do a whole lot of off roading with it its mainly my driving around and highway rig whats a good gear ratio that would work for me
View 9 Replies
I took my truck in for a clunking noise in the driveline as I come to a stop and sometimes when shift into park. It is now the 7th and I'm told parts have been ordered and the truck will be worked on when parts come in. I asked to speak to general manager and still no call back. I called customer relations and nothing they can do.
Honestly I think the have me on the back burner since I'm warranty work opposed to marked up repairs. Am I being unreasonable on my expectations of repair time? I called around and a ring and pinion job is quoted at 3 days at the most. Other repairs have been approved as well and parts are in for those, but they have not actually repaired them either.
View 14 Replies
I have a 08 6.4l F250SD. At 127k miles, it has been a great truck. All service has been performed by dealer. When I shift from Park into drive there is a 3-5 second delay, and when it drops into drive the truck rocks. Once driving there are no shift issues. Into reverse there are no issues.
View 14 Replies
I have a 2008 for 250 6.4 powerstroke. Issue I am having is occasionally when I shift from drive to reserve it will slam when I shift to reverse. It is an intermittent issue. What causes this and what to do?
View 1 Replies
My 2011 f250 is stuck in park and the brake lights do not work. I have changed the brake switch but still wont shift out of park.
View 4 Replies
On my '99's 5.4l with 55k, I've got a slight misfire occasionally with lower rpms and higher torque - basically going up a grade that's not quite steep enough for the truck to downshift, but clears up right away the instant it downshifts and gets some rpm. It generally seems like weak spark, or perhaps an injector spray pattern such that it doesn't always get fired off.
To give some history, the truck had more or less sat in a farm garage for ~5 years driven maybe once a quarter before I picked it up ~2 years ago. When I first picked it up, it misfired all over the place. I didn't think much of it, considered it gummy fuel, and dumped a couple cans of SeaFoam in the tank, replaced all 8 plugs (pretty sure with motocraft plugs though I don't explicitly remember), checked my air filter, etc and the misfires cleared right up and it purred nice and smooth like a happy little motor. That was at ~45k, or 10,000 miles ago.
Now it's starting to hiccup again and I'm not entirely sure why. The plugs should be nowhere near burned up yet and there are no lights on the dash. It's never come close to overheating and the only oil leak I know of is that famous small drip on the inside-rear of the passenger side bank drips on the exhaust header just enough to stink every so often when I come to a stop. I don't believe I'm burning any oil and certainly not near enough oil to foul a plug. Including that drip, I go about 3,000 miles before needing to add a quart. I've dumped 2 bottles of Berryman's in the fuel tank and it seems to work, but it's definitely not gone, so I'm thinking it's probably not oil related and more fuel/spark.
I'd had it in the back of my head to replace the fuel filter as well, but I hadn't gotten around it yet as it seems to be getting fuel at high rpm's just fine. I went ahead and bought the filter the other day and plan to install it shortly. It doesn't really make sense that that's what it would be, but I figure I'm due and it's worth a shot. If they were old plugs, I'd just replace them out, but they seem to new to be causing any issues.
View 2 Replies
I have a 2016 F250 extended cab with 8 foot bed with snow plow and camper package currently less than 2500 miles on it. Every once in a while when I make a turn (typically a left hand turn) I will here a brief noise that sounds like a rubbing or "squawk" noise. The noise doesn't seem to be related to the turn so much as to the roll of the truck when it unloads / loads the suspension. I'm guessing it might be related to sway bar bushings or something similar, but I just don't know.
I have tried to find a stretch of road near the dealer where I can make the noise happen so I can take a tech for a ride so I can let them hear exactly what I hear, but as hard as I try I cannot reproduce the noise consistently.
I have visually checked underneath and I do not see anything wrong and I suspect it's not serious, but I'd like to know the cause and obviously correct the problem.
View 14 Replies
2004, 6.0, 96,000. I noticed a occasional clunking under the passenger foot area. The exhaust pipe is loose at the turbo connection on top the engine. It is swinging L & R & hitting the spring hanger & transmission cross member. Is there a rolled pin, dimple or other alignment device at the flange at the turbo???
View 4 Replies
My '05 (134k, rwd, V10) has had an occasional issue with stalling when going into neutral. The normal idle speed in park or neutral is 700. In drive or reverse it dips down to 350 or so and then evens out at 500. The stalling is not all the time, perhaps 2 out of 10 shifts. It is slightly worse with the A/C running. Every time it stalls, it records a P0506 error which I then clear out with my ScanGauge II.
I have done some research and have replaced the air filter (super dirty), fuel filter (not sure on how old) and cleaned the MAF tonight. For the MAF, I pulled it from the air tube and gave it a bunch of squirts of MAF cleaner. I did this 3 times letting it dry in between cleanings. I have run a bottle of SeaFoam through it, as well. The idle seems to be very smooth and it pulls my 7k travel trailer without issue. That did get a little better with the new air filter and fuel filter.
I went for a ride tonight and the problem persists. I'm taking it in to have the A/C recharged next week and will have the shop diagnose it. I came across this post which details my issue exactly. The steps are to reprogram the PCM and TCM, and possibly replace the throttle body. Is the reprogram something an independent shop can/should do?
P0506 idle lower than expected on 05 ford f350 v10
View 3 Replies
With my windows up I occasionally get a slight whiff or smell of gasoline with the engine running. Doesn't matter if A/C is on or off. I crawled all under the truck and can't see any fuel dripping. (2005 5.4)
View 4 Replies
