Ford Super Duty (1999-2016) :: 40/20/40 Center Armrest Broke - Fix?
May 30, 2016
Is there some sort of fix for this?
You know, you get in the truck and lean on the center "arm rest" to get better situated. After a while the constant abuse brakes something and now the armrest is now floppy
FYI, this in an 04 crewcab F350
View 8 Replies
Advertisement
I have the 60/40 seat with fold down "jump seat" that has the 2 cup holders and console. In the down position, it squeaks something fierce on any kind of a bumpy/rough surface. On paved roads it's fine.
View 11 Replies
My drivers side armrest was broken when I bought it. Been searching for repair advise but have not found any. Instead of stopping so you can put your arm on it, it just falls down. I sorta wanted to see what I was getting into before taking it apart.
View 1 Replies
I was having a problem with 4wd and regreased/ cleaned hubs and when I went to test operation both fronts would engage and worked good. After a while.of testing in and out of 4wd I heard a loud clunk and looked under, the front driveshaft blew apart at the weld.the u joints dont seem to be bad so im at a loss as why this snapped. It was not a clean break and the edges looked like it had to started to tear at some part in the past due to rust build upon the inside.of the shaft and torn edge. Im lookin at 2 feet of snow expected here Tuesday, so im trying to find some answers as well as a.new shaft.
View 14 Replies
My outside, driver side front door handle is busted. I was about to order a new one from Rock Auto, and came across this-
DORMAN Part # 80645 {#7C3Z3622405APPTM} Front Left; Paint To Match
DORMAN Part # 79306 {Click Info Link for Alternate/OEM Part Numbers} Front Left; Black; Textured Finish; From 3/15/99
What is the difference here? Is something different on the early 99's?
View 3 Replies
damn motor or something broke and of course its fully open. any tricks to disengage from powered sliding system? just need to get by for a bit til i can get to the dealer.
View 3 Replies
I was trying to replace the output sensor in my 5r110 when it broke off in the housing.
View 7 Replies
The terminal (+) on the passenger side battery broke, and I see is a 1 piece cable and terminal all together.
Where to get that cable on how create a new one?
View 3 Replies
Truck would have a miss that went away when warmed up past 180. Ficm voltage was low so I got a new one from diesel tech ron. After I installed it The truck would crank for maybe 5-6 turns then lock up and kick the starter out. The starter broke away from the motor from the kickback. I got a new starter in and set up my scangauge 2. In the few turns of the motor i can do before it kicks out, ficm is at 48.5 koeo and cranking, ipr at 14.4, and the icp shoots up to 1100. The ficm sync wont come on and I m stumped what to do next. Dont want to start throwing new sensors at it. 2004 f250 6.0 ...
View 1 Replies
I have a 2011 f250 sd that I removed the front grill and noticed 3 of the clips that hold the lower part of the grill in (bolts on the top) are broke. I went to the local Ford dealer for the clips and was told I have to buy the whole complete grille for it. The parts breakdown doesn't show the clips sold individually from the grille.
View 2 Replies
I am wanting to take off the center console lid to recover it. The only way I see to remove just the lid from the truck is to hit the rod out that is in the hinge. I was hitting pretty hard with a punch and it wasn't moving. I don't really want to break it so I'm asking if there is a different way or if I just need to use more force?!
View 4 Replies
I've got a 2008 Ford F250 Superduty Crew Cab. My problem is that the center console of the front bench seat is loose. I keep it folded down nearly all the time and any pressure on the front left corner causes the rear right corner to pivot up.
View 3 Replies
I am putting steel wheels all around on my 99 dually. I want to look like police crown Vic's with black wheels Crome center caps. My current caps will not clip to steel wheels.
Is the center caps that will clip over the lugs on a dually?
View 3 Replies
Have a 2008 F350 Lariat Crew cab and I don't have any power coming to the center console power points. I unplugged the cig lighters and check the harness itself but no juice. Fuse 41 and 43 test good am i missing another fuse not listed?
View 5 Replies
06 F250 6.0 CCSB 4x4 163K Truck was in a pass side wreck about three weeks ago. Aside from bumper, head light, etc I had to replace the track bar and then I had the alignment done. Mech said the steering was loose and was either the steering box or column.
PROBLEM: Truck drove and parked fine last night, I went to leave the driveway this morning and I had to turn the wheel full right while backing up. The wheel locked up and wouldn't turn back to the left to straighten out. Hood wouldn't pop either to check anything
I crawled under the truck, the belt was in place and I didn't see any power steering fluid leaking. Thinking it was a PS problem and the hood not opening, I basically floored it and yanked on the wheel and it broke loose. Also, for what ever reason the hood opened after that
Now the steering is heavy and the wheel doesn't center on it's own. It will stay turned when I let go of the wheel. Scared that it would happen I didn't try turning it full lock on the way to work. but it happened again exiting the parking lot, again full right lock and the wheel stuck.
I managed to yank the wheel to the left again and I heard a distinct pop from what I'm sure was the pass side wheel area.
The PS fluid is dark and I'll figure out how to change it. I've read issues from the U-joints, ball joints, Steering box, steering stabilizer, and failing PS pump could all lead to this. Being the truck had a pass side fender bender, and I'm pretty sure the pop sound came from the pass side how do I check all of these items.
View 13 Replies
I need to replace a bulb (I hope) in my center clearance light and need to remove the amber lens cover. Lots of info about installing for those without but I haven't been able to find anything about removing the lens cover so that I can replace a bulb. I'm working with a 2008 F-450.
View 6 Replies
Just purchased my first ever Ford truck a few weeks ago, it's a 2012, and where the drivers right arm rested on the center console, near the cupholder, it's perpetually sticky. At first i thought it was just filthy, but after thoroughly cleaning it, it just stays sticky.
View 12 Replies
I have a 1 week old 2013 Super Duty. Super Cab, Short Bed, 4x4.
Immediately I noticed on the drive home that the truck likes to wander back and forth and needs constant correction. It was really windy on the drive home from the dealership so I just chalked it up to the wind and didnt worry about it. Now a week later , its still doing the same. I have a 2011 F-150 and also a 2006 F-15 that I get to drive regularly and they definitely track straight and have no problem going down the road without constant correction.
ALSO, I noticed that my Super Duty DOES NOT auto center itself after a turn. Is this normal?? I mean after I make a turn, the steering wheel doesnt try to go back to center. I noticed that right away because I went around a turn and loosened up y hand's grip on the wheel expecting the steering wheel to slide through my hand as it went back to center like I am used to with my F-150s....
So in summary, my new truck wonders all over the road, much more than my F-150 and also doesnt auto center itself. Is this normal for these trucks?
View 7 Replies
I have a new 2015 F350 XLT. For the life of me I cannot open the lid on the center arm rest. I have read the manual, and I can't open the lid. This is my 5th Super Duty with the last being a 2010. So you would think this would be a no brainer. I can pull on the handle and its not opening. Pry the damn thing open? Is there a hidden lock? Hidden treasure?
View 14 Replies
A buddy's 2012 f250 message center is not working at all. He replaced the fuse and it's still not working. The gauges work but not the high tech information center. He isn't sure if it's out of warranty because he can't see the miles. I'm not sure that's it's anywhere related but his back up sensors do not work either.
View 3 Replies
So on my way to work this morning taking off from a light on a smooth blacktop my message center lit up with "tire pressure sensor fault". is there any way to tell which sensor it is without a scan tool?
View 11 Replies