Just picked up new 2014 F350 lariat today and I can't figure out how to change the keypad code. I enter the factory code and hit add, but when I enter a new 5 digit code it wont let me hit enter.
View 2 RepliesI have a 2014 f 350 super cab xlt. Ford design engineers should be ashamed. But really who has installed the older (2009 ish) ford seat in there trucks for a little more comfort? How much fabrication was needed? Hate to say it but if I cant put the older truck seats in I'm going to buy GMC. These seats really suck.
View 3 RepliesDo the wiring for keypad keyless entry is in the harness and the programing in gem module on a 2003 F350 crew cab?? It would seems that is the same harness/parts as the excursion. I have not removed door panel yet, just trying to save some time.
This truck is one of my finest 4x4 rides yet, this would make much better!!! when i picked up my truck, included in the owners info was a factory keypad keyless entry code card, dealer told me that all trucks with keyless have that card regardless if it has keypad or keyless remote entry???
I just bought an '08 F350 Super Duty CC. When I bought it, the previous owner gave a me card with the code on it. So I tried to reprogram the keyless keypad to a new code that I can remember, no luck at all. Followed all the steps on how to reprogram it like a hundred times and still won't reprogram. So I've noticed that none of the lights light up except 7*8, none of the other buttons won't light up.
Could the keyless keypad be going south? Maybe the contacts in the keyless keypad are gummed up or a relay? Need to get this feature to work cause I sure would use it a lot. Also how do I remove the interior door trim to get to the keyless keypad? The door panel has electric locks, electric window, power mirrors, telescoping rear view mirrors, memory seating buttons and speaker pillar.
I recently purchased a 2010 F250 Super Duty and would like to set a keypad code. I have looked every where I can think of except behind the radio.
View 5 RepliesI have an 11 F350 6.7. It has just under 200K miles on it. Yesterday I changed the oil. Very uneventful. Today however, I was driving home, about 100 miles, and my truck's temp spiked. Not like a little spike, but jumped to the 3/4 mark(if there was one) then slowly kept rising to to the overheat mark. I pulled off onto the hard shoulder waited an hour or so to let it cool down, then finished the drive home. All the way home my temp gauge seemed like it was on some sort of drug. It would jump a needle width when I would have to accelerate, then slowly cool to normal after I got up to cruising speed.
When I got home I checked the oil level and it was spot on in the "normal" range. I haven't used a different type/brand/weight of oil in the last 100k miles. Did something just give out on my truck? I had the coolant flushed and replaced at the dealer within the last 10k miles. Up until this point this truck has been exceedingly reliable. I pull a 13k 5th wheel once a month and drive about 40k-ish miles a year.
I just bought a 2014 6.7 and the dealer claims every 10k. What is your alls opinion for optimum performance and engine life?
View 12 Replies2 nights ago changed the fuel filters for the 3rd time on truck since bought it a year ago. It has 67,000 miles. F350 6.4 L 2008. The truck ran for about 2 minutes and then wouldn't start. For the last two nights have done everything including cycling the key over and over to purge air, replacing the fuel filters thinking the first ones may have been defective, pumped the gas pedal while trying to start it, tried to start it with fuel cut off switch held in, changed o rings etc. The first night I didn't get fuel at the head but after changing the filters a second time, I now have fuel at the head. That is the only progress I have made. The truck has gas and it is fine as we are using it in other trucks. The battery has never been allowed to totally deplete.
View 9 RepliesTrying to stay up on my maintenance on my '11 f-350 diesel. It just turned 59k. I can only find Ford's recommended service interval for changing the fluid in the transfer case listed in the "Special Operating Conditions" section of my Scheduled Maintenance Guide for towing, delivery, off-road and dusty conditions at 60,000 miles. I tow some, but maybe 20% of the time, I end up driving a lot of stop and go though.
So I found this nice how to online "Guzzle's Transfer Case Fluid Change" - it's for a 02 heavy duty, is it about the same on the newer diesel trucks?
2001 f350 7.3 Changed front injector drivers side inspected all 4 glow plugs on this side turned motor over my hand 5 time reinstalled plugs put back together hooked both plugs back up started truck and no of the cylinder on drivers side are firing checked them with temp gun!! what did i not do or do wrong.
View 4 Replies2001 F350. I need to take the face plate off of my in dash cup holder and put it on the new one that I bought. Ford charges a premium price on the Dark Parchment or Dark Buckskin that I have. So the dealership I bought the new one from told me its possible to change out the face plate.
View 1 RepliesI bought a 2008 F250 crew cab, long box diesel and other than a couple of minor issues I love it. Tows my race trailer like it isn't even there.
If I use the remote to unlock the doors then everything works as it should, no alarm.
If I unlock the doors using the key pad the alarm sounds?
I have read thru many of the threads I can find but most are reprogramming the keypad. I am suspecting that a door open switch may be the culprit but wouldn't that affect the remote as well?
How do you remove the air bag on a 2014 F350 super duty. I have search every where. Nothing new on Google.
View 5 RepliesOn one of the trucks in work, the salt has corroded the truck side plug for the reverse camera in the tailgate. Because of this, the camera no longer works.
Is this part of the whole rear wiring harness, or it the tailgate plug a separate pigtail that can be replaced? If it is a separate part, what is the part number so I can order it?
Do a 2014 f350 front bumper will fit on a 2001 f350? Wanting to know if the bolt holes and body lines will match up? I put a 2014 rear bumper on and it bolted right up.
View 8 RepliesI just bought a 2014 F350 from copart and its about to arrive in florida on a transporter. There is no key and no power (flood damaged) and wheels are turned sideways. I am having the transported meet me at a ford dealer so I can get the key made to remove steering column lock. Once I have this, any way to manually select neutral to take it out of park and roll it off the truck.
View 2 RepliesI have a 2014 F350 (specs in my signature) and I want to change the 4" rear blocks out for F250 2" blocks to lower the rear of the truck.
Looks like a fairly straight forward replacement but I have a few questions.
Will the shocks need to be replaced? I do eventuality want to replace them as the stock ones are not that great but I only have 2500 miles on them.
When I do order new shocks for my truck after the changing the blocks do I order shocks for a F250?
I would like to go OEM parts for this but I am having trouble finding the blocks and u-bolts that I need. What are the part numbers for these?
Anything else I should know about to do this swap?
I have a 2014 350 crew diesel short box. I am told, I have a 28 gallon tank but can't get over 22 gallons in it even though my gauge show e and my read out says I have 10 miles left until empty? Dealer says the left over 6 gallons is a reserve...
View 14 RepliesI had a 05 f350 5.4 3v come into my shop with a CEL. Did the usual it had a p0307. So I did the usual again changed plug and coil plug cam out no prob they were done 15k ago. Test drove a few times and it was fine. Few days later customer brought back with same code p0307. thought maybe I got a bad plug or coil so I moved them to #6, misfire stays on #7. When I drive it local its fine when I go to pull on to highway and really put my foot in it CEL flashes (misfire) and it pings like crazy and loses all power. Scan it back at shop and still only p0307!!
View 10 Replies2010 F350 in my shop today. so, before dismantling the entire top of the motor for this inbred oil cooler job, is there anything else responsible for the P012 engine oil temp issue? it throws the wrench icon and cuts power and i pulled the P012F code.
View 9 RepliesI have a 2012 F350 XLT that came out of Canada. So of course the speedometer is in KM. (Large numbers are km and smaller numbers are mph). I am trying to find out if I can simply change out my cluster with a mph cluster???
View 4 Replies