Ford Super Duty (1999-2016) :: 2014 F250 - Trailer Brake Controller Settings
May 8, 2016
I tow a 5th wheel with my 2014 F-250 that has an factory TBC. I just installed Electric over Hydraulic disc brakes on my 5th wheel and was trying to see if there was a setting I needed to change on the TBC to tell it that is now E/H versus E. In the Information section of the dashboard display it talks about the controller actuating electric drum brakes but the manual talks about it being able to do electric AND E/H. What I need to do here...if anything?
View 6 Replies
Advertisement
Where I can find a good used or a good deal on a new factory trailer brake controller to fit a 2006 F250 Diesel Truck?
View 1 Replies
I am looking at a 2014 f250, if has all of the options I want on a truck except the brake controller. Can a brake controller be added to this vehicle ? is it already wired for and do you just remove the blank plastic and pop in ? one ?
View 3 Replies
I've just bought a new 2016 SD xlt. The only extra I wanted that is missing is the factory trailer brake controller. The dealer told me it had to be programmed. I was expecting plug and play and planned to do it myself till they told me that. Is this true?
View 14 Replies
Have recently been getting a "TBC Fault" message and the Beep, as the message goes on and off(annoying) looked around think its the Controler itself,,If I move the slider, and Jiggle it,,the message Blinks on and off as I move the Slider,,,Looking for the method of removing it from the Cubby Hole,,,Gave it a tug,,,and wiggle did not move must have a Clip or Tab to release it.
View 8 Replies
We bought a 2012 f550 chassis and had a utility bed outfited. As far as I know the truck does not have a tow package (major F-up). They did install a receiver and electric in the rear. The 7 way pin in the rear does have the appropriate wires (including blue). I can not find the harness in the cab under the dash. I have looked near the radio where I have found the harness on our other trucks. I specifically looked for the red white and blue wire under there. Where is this harness? Is the harness still in the cab even without the tow package? This will be for the old school plug in controller, not the ford intergrated contoller.
View 4 Replies
My 08, when I connect my 7-pin trailer up, bouncing down the road that message and tone CONSTANTLY going off....drives me nuts! I have went thru the wire harness 2x now, cleaned all the contacts, etc. Any other thing short of a 12 gauge? When it does pop on, the controller starts flashing...I've reached down a few times and manually hit the brakes and it still hits em so whatever it is, I feel its very minor or whatever....just don't know where to go now! All contacts have been cleaned good as well.
View 8 Replies
First, need a wiring diagram for the outputs on the back of the brake controller module? I want to check and see if there is a problem with the connection to the rheostat. I can activate the trailer brakes with the slider bar but not with the brakes.
Second, where I can get a new OEM controller that will replace my old one if I can't "Cypher it out"?
View 2 Replies
I 2000 f250 throughout a few years.
Anyways, I recently aquired a tekonsha voyager (for free) and went to install it, but have run into a problem with the installation.
I searched to find a wire color guide to figure out what wires are which on the under dash connector, but cannot find the answer I'm searching for.
Currently I have a red, green, blue, brown, and yellow wire on the underdash connector, while the tekonsha only has red, white, blue, and black. (I know what colors do what on the controller, but am completly lost on the under dash plug, and can't trace it back without tearing out the entire dash assembly.
View 3 Replies
I have (2) 2014 f250's both have given the trailer disconnected message randomly from the day they were new. Dealer says everything is with in specification. I just live with it now but something must be wrong with the design. Only does it when no trailer is connected an might be worse when it rains. Might have to hit the ok button every 10 minutes so on bad days.
View 14 Replies
2010 F250 Lariat, cab and a half, PSD. 5600 miles.
Sunday I started the pickup and received "trailer brake module fault" in the message center. I wasn't pulling so wasn't too concerned - hit the reset and continued on.
Sunday night I started the pickup again and received the same message followed by "check brake system". I also lost illuminated gear selection, the traction control active symbol was displayed and the traction control "off" (PB) was illuminated. After several attempts it reset, everything returned to normal and I was able to get home without incident.
Monday morning it wouldn't start. It indicated "trailer brake module fault", "check brake system", traction control active and off, no gear indication, the odometer indicated "-------" and it did not react to the key in the start position.
Tuesday morning I attempted to start and it was the same as the previous attempt. I noticed that the theft prevention appeared active (flashing) so I removed the key, locked the doors, unlocked the doors, tried again - no joy.
I kept trying while holding my mouth in different positions and finally by the grace of God it fired. I delivered it to the dealer.
The dealer called yesterday afternoon and reported that everything is a result of a bad trailer brake module. The new one is to arrive today, they will install and everything will be peachy.
I asked if they could just unplug it and reprogram the truck to believe it never had one - the service writer said it can't be done, different piece parts on trucks with or without trailer brakes.
I really have no choice but to push the "I believe" button and carry on but I am slightly concerned. The fact that the trailer brake module can cause catastrophic failure doesn't seem too cool, I don't have a real warm and fuzzy feeling associated with venturing far from pavement, reliable communication or alternative transportation.
In the meantime I suggest that no one take "trailer brake module failure" lightly.
View 14 Replies
I am having an issue with the under dash plug for the brake controller on my 2001 Ford F250 Super Duty. I plugged in my Curt Brake Controller and figured all was good.
As usual with anything I do it isn't that easy. There is no power to the controller or the plug.
Is there a specific fuse I should check or even look to see if it has been installed because apparently this truck never had one installed even though it has a 7 blade plug installed and is plugged into the wire harness in the rear.
View 5 Replies
Setup my Reese brake controller on my 2011 today. The lights, turnsignals, and brakes work when I push the brake pedal. But when I move the lever on the controller, I get nothing. Also, on the info screen, it still says trailer disconnected. What gives?
View 5 Replies
I have a 2005 Ford F-250. I have checked power to the rear harness and all is good except for the tail/running lights.
Is there a fuse for the tail lights? I have checked the manual and don't see one called out. And the relays under the hood are labeled stop lights/turn signals and those are working fine.
I will see if I can trace the brown wire from the rear harness backwards, but it may be a simple fuse.
View 3 Replies
Any info if the "Aux" terminal on the trailer harness wiring on '01 F250s is for reverse lighting? I'd like to put some on my stock trailer. Also, is the "12v" terminal feed switch operated or hot always?
View 2 Replies
I have a 2005 ford f250 with the factory installed brake controller and towing package,until recently all was well,I tow a fairly large travel trailer and last time I hooked the trailer to the truck I noticed the running lights on the trailer were lit, I checked to make sure that I did not have the parking lights turned on or the headlights. I did find posts about the running lights not working and was surprised to find there is a relay somewhere on the central junction fuse block that was integral to the cfb and not user serviceable. Could my problem be that this relay failed in the closed position or am I not going in the right direction in my quest to find this problem. Also looking for a diagram of where this relay is located on the central junction fuse block? I would also consider doing a work around solution rather than having to replace the entire fuse block.
View 7 Replies
I have a 2014 F 450 and today one of my trailers will not engaged the brakes and it is saying on the display that there is no trailer connected. I cannot engage the brakes manually with switch.
I have running lights, I have brake lights I have hazards lights and turn signals. The brakeaway switch is not engaging the brakes when removed, I hooked up to another trailer of mine and it recognized and acknowledged being hooked to a trailer.
So... I know it is something with the trailer but what wire I should be looking at on the trailer?
View 14 Replies
I have an 08 F450 equipped with Ford integrated trailer brake controller. I tow between 6,000# and 14,000# machinery on a daily basis. I know the gain can be adjusted up to ten. I have noticed while braking "normal" The controller only outputs 1 green bar of power. Manually, the brakes on all my trailers don't grab untill around 3 bars of output. I find myself always sliding the manual lever to relieve the truck. The truck is suffering. I have the gain set to 10 just to get minimal result from the 1 bar output. I know my trailer brakes rock, they can stop the truck and trailer if needed. Can it be adjusted? How many bars are you folks getting with easy braking?
View 6 Replies
So the other day 2/3/2014 my dad and I went out during the snow storm for the people that needed assistance. That day I pulled a 95' RWD dually with a 4 car open trailer and pushed 4 people from one location. Then after I went to assist the tractor trailer driver. My truck is a 2002 F250 super duty 5.4L with 4:10 gears. I got him unstuck then pulled him a 1/2 mile up a hill.
Pulling a stuck semi out of the snow - YouTube .....
View 6 Replies
My husband and I bought a 09 f-250 with 58000 miles. It used to pull our travel trailer with no power issues. Now the rpms go up & the power goes down. It never gets hot nor any lights come on. It's been in the shop twice. The first time nothing was found. The second time we were told it was dirty fuel filters. The truck only has 70k miles...
View 2 Replies
I replaced all the exterior bulbs in my 2013 F250 6.7L with LED bulbs. My trailer lights work but brake and signals don't work on the trailer.
View 5 Replies
