Ford Super Duty (1999-2016) :: 2013 F250 - Brake Dust On Chrome Wheels
Mar 27, 2014
I have after market chrome wheel and stock brake pads. The brake pad dust is corroding the chrome. Is their a brake pad I can use so it doesn't happen? Ive been told ceramic pads is the way to go.. The wheels are RBPs. Have a new set of RBPs coming in to replace, also what about pad covers? I tow a 29' boat and the rest is highway miles..
View 7 Replies
Advertisement
I have the 20 inch chrome wheels on my 2016 Lariat. After this winter there is some buildup if some sort in the wheels that will not come off when I hand wash the truck. From what I understand, these are some sort of plastic covering and not true chrome. So my question is can use a really abrasive material or steel wool to remove heavy grime. I have a feeling it is from salt in the roads. I don't want to ruin my wheels.
View 3 Replies
I have an 2011 Ecoboost SCAB and the front brake dust is ruining my chrome package wheels. The rears are fine. Ceramic or low dust pads??
View 14 Replies
I have a 2016 F350 4x4 that has brake dust on the front wheels after only 3000 miles. I have tried to find ceramic pads to replace the semi-metalic pads that are causing the issue. There is no listing for replacement pads that I can find. My question is will 2015 pads fit the 2016? What is the actual part numbers to see if they are the same. This is just one of the problems with having an early build vehicle.
View 14 Replies
I have had the truck just under a year. It has 104k on it i only drive it on weekends. Last weekend going to Home Depot about 15 miles got out and could smell brakes burning. Felt the wheels and the right rear was very hot. Got back home no smell but still hot not as hot as earlier. Pulled the wheel off it looks as if the pads and calipers are fairly new paint is still on them caliper is a TRW. The pads were stuck in the carrier even the stainless clip ends look rusted.
Cleaned it all up both sides lubed the pad carrier with pin lube. Pushed the calipers back in some both sides went in easy. The right rotor has definitley been hot. Put it all back together and went for a test drive. Came back no problems checked the temperature with a laser type heat thermometer all wheels were around 140 f. Went out yesterday morning stopped and could smell the brakes again. Drove it back home and the right rear was 300 f. others 150 to 160 f.
Jacked it up put it in neutral and the you can spin the wheels by hand. Started the truck had the wife get in put it in drive wheels turning applied the brakes they stopped let go they turn freely again tried the parking brake it works fine also. So do I buy new calipers and brakes or maybe is the wheel bearing going bad causing the brakes to heat up?ied.
View 5 Replies
Can 2011 F250 factory 18" wheels fit on 2004 F250?
View 3 Replies
I have a 2000 f250 with auto/manual locking hubs and today the 4x4 quit working. The light comes on the dash and the drive shaft and u joints turn but the front wheels don't turn even when its locked in. I assume its the hubs? And when I am going down the highway about 75 the front starts making a hellacious noise but stops if I slow down is this connected?
View 11 Replies
Yesterday I was parked on an incline with my front wheels on gravel and the rear wheels on wet grass/mud. When I tried to go, the rear wheels started spinning. I then switched on the low 4x4, and tried to go. The rear wheels continued to spin, but the front did not turn. I had new wheels installed, that has a cap that covers the manual locking hub, so I couldn't turn it to lock the hub. What should I look for to fix the problem?
2007 F250 4X4 Larriat SRW
View 2 Replies
The problem is I haven't seen one for a recent (2011+) SD. I don't see anything that resembles a rear drum. They look like 2 huge regular disc brakes.
I live on a hill. My old man taught me to put the trans in neutral, autos and manuals, put the ebrake on and make sure it holds the vehicle, then put the trans into park or 1st gear. This way the weight of the vehicle doesn't rest on the transmission.
How do I adjust the Ebrake? It's ALMOST holding the truck, just needs a minor tweak. I don't see the dust cover the write ups described at all. The one that reveals the Star Wheel. Are they different on these years then prior SD's?
View 14 Replies
2013 F250. Wife turned the ignition on to roll up the windows before the storm (good thing), but left the switch on. Both batteries dead. I charged them both (although not completely). Started OK but have a check engine light on. Should I just put the batteries back on charge?
View 5 Replies
Earlier this week I pulled out my right axle shaft and found the outer portion of the Spicer two piece seal attached to the axle, the part number on the seal is 52148. The axle tube is dry, no signs of the seal leaking. I need to remove that seal from the shaft to install a new outer dust seal. Can that seal be removed with a 3 jaw pulled then get reinstalled, or can I get a new 53148 and install that portion with out removing the carrier. I am not set up where I sit right now to pull both axles.
View 2 Replies
My 2013 F-250 Super-Duty periodically won't start or come out of park. I have tried the ignition trick of tuning it to first position but with no luck. Sometimes I can see the light for the indicating light for being in park flashing on and off rapidly and manage to get it into neutral to start. It appears to be completely random. I potentially happens when I drive it for longer periods or do frequent stops around town.
View 3 Replies
Winter is around the corner and I would like to remove the chrome covers off of my 04 factory rims, the rims are rusting underneath the covers which is forcing my center caps to pop off randomly. Also I was going to get new winter tires so while they rims are off the tire i figured I would Paint them black to match better than the chrome. How to get them off easily? Also a good paint that wont chip easy when i paint them.
View 6 Replies
Background: Some inconsiderate fellow manually collapsed my mirror for me and now it will not fully swing open. I can force it, but will not lock in the full open position. I'm sure the locking mechanism is jammed or worse broke, who knows.
I've removed the mirror from the vehicle but am not sure how to get to the inner motors without breaking something.
View 1 Replies
I just bought a used 2013 F-250 4x4 and it came with the snow plow pkg. heavy duty front springs. I love the truck, but won't be plowing with it, and I don't need the rough ride (and don't like the look of the front end higher than the rear)
How hard is it to swap out the front coil springs and replace them with the "regular" ones?
View 7 Replies
I have 1700 miles on my truck and the A/C cycles between cold and warm air. I have taken it to 2 Ford dealers and they agree there is something wrong but their tests are apparently up to Ford specs. They logged complaints with Ford and they were told this was by design with the new trucks and it was normal for the compressor to constantly cycle. New 2013??
View 2 Replies
I've got a 2005 F250, and I found a good deal on a 2013 tailgate in town. Just wanted to make sure a 2013 tailgate will fit a 2005 before I go through with this.
View 11 Replies
I have a new 2013 f 250 gaser the truck I noticed sits crooked it is lower on drivers side by almost 2 inches and not from the fuel tank.
View 1 Replies
I have a 2013 F250 with a 6.2 L. While driving the vehicle the exhaust sounds nice and throaty. When I put the truck in neutral and rev it, it's quiet, you can barely hear it. Is this normal?
View 3 Replies
I just picked up a 05' F450 Super-Duty it had the rear seat removed and the rear wall, under the window is bare metal. I have all kinds of road noise and dust coming in through the two vents on the back wall. How to fix this?
View 6 Replies
What the expected life cycle is for the fold in/out feature of the power mirrors? I garage my truck and need to fold mirrors when backing in and then unfold once out of the garage--looking at 2 in/out cycles per trip from the house. How long until the motor gasps and dies?
View 1 Replies