My dads 2012 F350, how do you remove the bed caps on the top of the bed? I can see some plastic clips or something but are they a press together or pull apart or something else?
View 13 Replieswhat I need to do to remove a plow kit on my truck? I bought the truck with the kit already on it and I figured I could get some $$ for it, but I gotta get the darn thing off! I'll be posting pics soon. It looks like it'll come off easy by removing a few bolts, but with my luck I'll completely ruin something.
View 11 RepliesI have manual hubs on my truck. Can I pull those vacuum lines and plug the holes?
View 9 RepliesWe have a 2013 F150 Lariat. When you raise the rear seat bottoms the entire floor board opens into a really large nice flat space. By removing the storage tub from my 2015 SD Lariat will that provide the same results as the F150 ?
View 5 RepliesRead about and want to clean my throttle body. Why have to remove it from the truck ? 2009 f-250 5.4 .....
View 5 Replies2003 F 350 gauge indicates water in fuel. Second hand truck, the hex socket in the plug has be rounded out. Removing plug
View 1 RepliesWe got an F250 in June and had an ARE CX series cap installed on the truck yesterday. We didn't realize the installation of the cap would mean we lost the review camera when the tailgate was removed (DUH). We loved the review camera for hooking up our trailer and are wondering if there is any way to reinstall it on the cap. Or, purchase another camera and integrate it into the existing Ford screen......with the guidance lines?
View 2 RepliesSo I have a 2004 F250 5.4 regular cab 4wd long bed that was bought used with a very heavy Western Pro plow. The truck only has 70K miles and it is equipped with the snow plow package and heavy GVWR package. Since I had no use for the plow, I removed it and all mounting hardware as soon as I got it home. The truck wanders and bounces down the road terribly.
It is tiring to drive and requires total attention. Reading posts on here about "wandering" left me thinking my steering box was probably worn out. I replaced this without any change. I figured that I must have other components needing fixed, but had not had time or money to dig deeper yet.
Now, this morning when leaving work, the truck had accumulated nearly an inch of very heavy, wet snow with a small layer of ice on the hood. Driving home was as if I were in another vehicle. Everything was tight and much less "hopping" when hitting small bumps. So, this leads me to my question. Do you think that simply adding some weight back to the front end, i.e.,: bumper, or brush guard, could be my answer? Or, is this simply covering up a more extensive problem?
I have a F350 2000 crew cab srw with 7.3 diesel. I removed the HID that was installed by previous owner. The factory wiring harness was still intact but now I don't have running lights or dash lights. I still have head lights, brake lights and blinkers... I replaced the head light units with factory replacements......
View 3 RepliesPurchased my 2012 6.7 about 3 weeks ago. Driving yesterday the CEL light came on. I took and had the code read and it was determined that EGT sensor # 4 was bad. Also how far can it be driven before it leaves you stranded since the closest dealer is 35 miles away.
View 2 RepliesMy Son drives a 2012 6.7, and just recently it started overheating bu only under acceleration? It runs cool while idling, and once you reach the desired speed, it cools back down, but under acceleration it overheats? We've checked the obvious (coolant etc...), but can't figure out what it would do this only under acceleration?
View 6 RepliesI have a 2012 F-250...per DOT specs, the fog lights go out with hi-beams on. However, in my opinion, the high beams on my truck are among the worst I've seen. Low beams are OK. Is there some easy mod to keep the fogs on with the brights?
View 14 RepliesDo my 2012 F250 6.7 liter Powerstroke diesel has a cabin air filter? I have looked everywhere I could think of and am unable to find one. Does this mean it doesn't have one?
View 9 RepliesI have a 2012 super duty with a 6.2 in it. I bought it last winter and noticed no air getting to the defrost vents. Now in the heat, sometimes when I turn the air on, all I get is super hot air like the heater. Sometimes playing a bit will work but not always.
View 7 RepliesUSB Port and card were working fine now it says usb empty, tryed disconnecting the battery for 10 minutes and a different card, still nothing, and the port wont charge anything either. The truck is a 2012 .....
View 7 RepliesI recently purchased a 2012 f350 power stroke. Love the truck but went out this morning and the air would only come out of the vents. I couldn't get anything out of the defrost or the floor vents? Truck is out of basic warranty so want to see if I can figure this out myself or if it needs to go in the shop.I've looked for a fuse but didn't see anything that ran an actuator door.
View 5 RepliesI read in a thread about how fog lights need the auto light sensor or something in the kit to be installed and flashed.
My truck is a 2012 f250 XLT that I bought left over from a podunk town IN illinois. It does not have fog lights but it Does have automatic head lamps. So Im very confused on what kit to order to add fog lights to my truck.
How to remove the overhead console on a 2012 F-250 ? I would like to tap into the wiring to power my radar detector.
View 7 RepliesHave a 2012 350 cclb 4x4 6.7 lariat, interior lights don't work. Not with any door open, Not with switch. map lights work. We've checked every fuse in cab and under hood. What to check now ?
View 8 RepliesThis morning on my way to work in my 2012 F-250 I turned the heater on, controlling the temp from the temperature control. When the truck got up to temperature the heater fan would not come on accordingly to bring the inside of the truck up to the temperature that I had selected on the controls, so I tried operate the fan manually and it still didn't turn on. Once at work I didn't have really have time to look at anything with it, I did however shut the truck off and start it again and still nothing. Then after I got off work, driving home still nothing until I was about half way home then all of the sudden it started working again. I'd sure hate to have this happen again later this winter when the temperature gets below zero outside.
View 3 RepliesSo I drive a 2012 F250 6.2L and recently I've been hearing this rattling noise, kinda like a bag of washers being tossed about. I thought it was the snap brackets for the fog lights cause I removed my fogs and the brackets were loose enough to jingle so I zip tied them and it seemed like the rattle stopped, however, coming home the other day I hit a pothole and the rattle jingle noise happened again. I've checked most of the front end making sure all is tight which it is
Update: There were some lose snap bolts and brackets I'd missed so I took them off but no luck. I have come to the conclusion however the noise only occurs when the suspension is compressed. I figured this out by having my 300lb friend stand on the bumper and then I hit the coils with a mallet and I could hear the rattling noise and no I was not mistaking the coil vibration for the rattle noise.