Ford Super Duty (1999-2016) :: 2011 - Temp Sensor Location?
Aug 3, 2015
I need a replacement driver side door, towing mirror for a 2011 Ford F250 SuperDuty with turn signal, heated, electrically adjustable manual-extend and manual fold options. The truck VIN number is 1FT7X2B67BEC96261. The truck also has an Outside-Air-Temperature indication which is what I'm not sure about. It is my understanding that the Outside-Air-Temperature sensor may be in the side mirror. Looking for any info on the temperature sensor located on this truck? I found an aftermarket mirror while I can not afford Ford. However, the aftermarket mirror ad says it does not have Outside-Air-Temperature and I would like to keep that working.
View 1 Replies
Advertisement
I have noticed my trans temp gauge needle is dead center of the gauge even on a cold start. I thought my sensor was under the pan so I pulled it and did not see any sensor at all. Is there a external sensor?
View 5 Replies
My engine light came on a friend of mine did a scan and came up with o2s12 showing low voltage.we need to know which side and location of sensor..the truck is a 2005 ford f250 super duty 5.4l.
View 2 Replies
Where are the door sensors located?
The ones that turn the light and off when you open and close the doors.
It use to be switches on the old trucks and cars.
But on my 2006 F-250 I can find anything that seems to do that function, nor is anything mentioned in the repair manuel.
View 8 Replies
Where this sensor is? I am trying to mount a front bar and need to know if I can drill thru the tube behind the bumper ( this is the one that is right behind the plastic trim piece.)
View 2 Replies
Truck is 2012 F250XL single cab 6.2. Where is the pitch sensor on this truck? There are times the hill start assist will keep the brakes applied on level ground, and occasionally I will crest a hill onto a level stretch and the truck doesn't want to upshift. So I am thinking the pitch (incline) sensor needs recalibrated. Where it is?
View 7 Replies
My truck has a bit of an interesting trait. Unless it's just about freezing, my transmission is just about always at operating temperature. If it's 50*F outside and I start the truck, the Trans temp is smack dab in the middle. If it's 30*F outside it starts just a little above cold then is "warmed up" when I drive it down my short street block, which ain't right.
All the rest of the time, it's always reading middle of the bar temperature. My old 5.4L never did this. My 7.3L does. Best I can tell is it's a fault in the temperature sensor for the transmission. I don't have a scan gauge yet to get the readings but will be getting one. Just need to know where the sensor is at so I can have a starting point.
View 3 Replies
Looking for a wiring diagram for the coolant temp sensor? 1999 F250 SD V10....
View 4 Replies
I got an f-350 drw it is sluggish on take off feels like a miss. Higher speeds when you step on it. It seems o.k I have been told it could be a crank shaft positioning sensor any in put on this. I have changed the fuel filters, cleaned the e.g.r. valve and yes it was pretty clogged,air filter seems to be good. And 1 last thing for now where would c.s.p.s. be located...
View 4 Replies
I have the 2012 XL F-250 6.2 v8 , I have an ambient (outside air) temperature sensor that needs replacing, I ordered it and was told it is located in the passenger side mirror from the parts guy, there is a tap in the bottom of the mirror to access it, looking for a replacement type video link of how to do this, as I am not finding one via youtube, pulling the tab off on the bottom of the mirror I am not really seeing the part I have as a replacement in the mirror.. This is the XL version/work truck so ALL manual mirrors....
View 1 Replies
Well I have a 2011F250 powerstroke. I recently put a 5" down pipe back exhaust on it. I ordered a 5" to 7" tip and it came in today. Problem is that it's 18" long so the only way it would work is if it exits at the corner of the truck
View 7 Replies
I have an isspro sensor that I need to install on my 4r100. I have it all installed except for the actual sending unit. My question is where is the best place to put it?
I've watched multiple YouTube videos and it seems a lot of people use the test port on the driver side above the linkage. I found out the hard way that it is a very poor choice of location. A lot of people say that the best way is to drop the pan drill a hole and weld in the bung? I was wondering would it be possible to put it on the "out" line on the transmission oil headed to the cooler? 01 f-350 7.3
View 4 Replies
Where is the SYNC module in an '11 F250?
View 3 Replies
Where I can locate rear fender flares that will match 2011 and up f450 flares? Which flares would cover the f450 front fender flares holes?
View 3 Replies
I have an '06 F350 dually with a 6.0 diesel. I bought this used about 5 years ago and for the most part have loved it. i would always smile on the inside when i heard people bash the 6.0...i thought i got lucky....until today.
140k miles. recent oil change. all is swell...until this morning. Stick in key and turn it. glow plug indicator comes on...all lights come on for a few second....wrench, abs, dtc etc....wrench shuts off...glow plug light comes on...4 or 5 seconds later wrench light comes back on....turn key and NO CRANK.
All fuses are fine...starter cranks if i jump the solenoid...but it won't start. Miles to empty and everything else is just dashes hit the OBD and it says "engine sensor data error"/ "trans temp error" ...
View 1 Replies
Ok I ended up buying a 2011 F250 XLT. it has the reverse aid sensors. it worked great till i washed it after plowing. what should I look for or diagnose? also mt my dash says my tires need air. I filled them and reset but it comes back.
View 7 Replies
My CC display shows all icons on the right regardless of settings (see pic). The temperature setting and outside temp will not come on.
The second issue is that my front blower starts to lose velocity and sounds strange on long road trips.
View 1 Replies
So I just replace my Cat. Converter with all new sensors in them. I just replaced my spark plugs. (I'm knocking out these check engine light problems) and I think I'm getting close to the root as to why these other parts went bad. Why my o2 sensor would be stuck on "lean" ....
View 5 Replies
My Bank 2 Sensor 2 oxygen sensor is faulty and I need to replace it. The guys at the parts store were pretty certain it is downstream driver's side, but I just want to make sure before I PB Blasted and removed it. 2008 F250 SD v10 ....
View 1 Replies
Besides the window tag and the door tag, where are other VINs located? The VIN tag in the window looks suspect and there is no door tag. (I covered the first 11 digits of the VIN.) Also, I found a tag on the front pass side of the bed that I've never seen before (mounted between the bed and the cab). What this is?
View 12 Replies
As luck would have it I'm leaving out in the morn for 600 miles , Noticed a nail in my L/F tire yesterday went too Goodyear they pilled the tire patched it inside.. Then this morn went to fuel up my ABS light stayed on .. Did this last yr. went off after a few days but since the tire was pulled maybe its a bad connection ??? ..Jut want to be sure and scan codes
I want to scan it now to check and reset any codes But looked under the Drivers side dash can not find the OBD connection port looked on Passenger side nothing there either.. Looked under hood around fuse box did not see anything that kind of looked like a port with a cap I'd assume they cap them if under the hood .. Its a 05 S/D 6.0 locate this OBD11 port
View 2 Replies
