Ford Super Duty (1999-2016) :: 2011 F350 - Front End Noise / Kind Of Shudder?
Oct 31, 2016
Truck is 2011, F350, 4x4 CC Long box with a 6.2, 124,000 km on it. Was driving home last night towing my jet boat when I heard a sudden noise from the front end, kind of shudder, first reaction was a flat so headed to the curd. No flat, nothing running hot, no play in wheels, all looked good underneath the front end. Pulled out and drove away, got about 15 km and it happened again, looked all around nothing obvious so pulled out and drove home (25 km) no issue.
This morning wanted to investigate further. Drove truck down the block and heard a definite rotating type sound. Not a grinding more like a scrape sound. After a minute it went away. Went into a parking lot and drove in tight circles but no strange noise. Found that the auto locking hubs were not working but hub would lock in manual. No strange noises with hubs locked in either.
Jacked up truck rotate front wheels, no sound and no play or wiggle on either side. Pulled the hubs and the passenger side had water in it. Hub was not rusty but it didn't look as good as the other side. Not sure how water got there as I have never driven in water, although I am not original owner but have had it two years and put 25,000 km on it. Could the water have gone in deeper and caused a bearing to fail?
View 2 Replies
Advertisement
When on my 2-post lift my front brake lines on my '11 4x4 are pulled TIGHT, like stupid tight. It's also dumb that the soft line points UP 'cause it gets tugged down to a brutally tight 180.
I've got the front lift pads under the control arms, too, but near the very rear of the control arms so the axle isn't even dropped out all the way I don't think.
There's a bracket down near the bottom of the coil springs that could just be sectioned/lengthened, which I think would alleviate my issue. I'll be working on this soon.
What manufacturer builds a vehicle that yanks on the brake lines under full suspension droop? Shouldn't this be on an engineer's final checklist before the vehicle is released? Oh wait, they gave that task to Team TTB and Engineering Group TFI Or maybe they gave it to the same Audi team that designed the Allroad with airbags that can be damaged if you don't "lock" them out before lifting the vehicle......
View 14 Replies
I just bought a 11 f350 powerstroke. CC lariat 4x4 with 70k miles. Whenever i turn off the truck abt 30-45 seconds later a humming starts and continues for abt 1 minute. Sounds like a pump or a release of air? Is this a normal function or should i have it checked out. I've searched around but found very mixed answers.
View 4 Replies
My truck seems to shudder between 40 and 60 mph when it's in OD. If I turn off OD it seems to go away with the increased rpm's. Although I can't be sure if it genuinely disappears or if I just don't notice since I'm at 2100 rpms instead of 1500. Trans fluid is clean. Is this a common problem in these trucks? Just filled up from flat E the same day air temps about 4 deg. Truck was fully warmed up. Does this sound ignition related, tranny or fuel related?
View 14 Replies
2011 F-350 XL, I can hear a squeal coming from the front brakes when rolling forward slowly, believe the pads are dragging on the rotors. If I touch the brake pedal the squeal stops as it does when I turn the wheel. Took the calipers off and greased the slide pins and put it all back together, still got the squeal. What don't I know???
View 9 Replies
Well, I tried this Death Wobble Kit on my Ford F350 Super Duty from a company called WC Motorsports. Had it installed at a Ford Dealership. DO NOT BUY this kit. Missing parts right out of the box. Also makes a horrible clanking noise after install. Piece of junk. Possible fix to one problem only to have multiple other problems:
1. Clanking Noise
2. Truck pulls to the left
3. Have to cut the factory subframe. (Never a good idea)
4. Changes the degree (not recommended by Ford)
View 10 Replies
I've got a 2011 F-350, when i'm on the driving over 60 mph i hear this humming or buzzing noise coming from around the dash. It kind of comes and goes depending on the wind direction or if I'm passing a semi. Thinking it may be coming from around the windshield seal.
View 4 Replies
My 2015 F-350 Super Duty has a noticeable vibration between 5 and 15 mph when accelerating with my 5th wheel. The 5th wheel is heavy--around 14000 pounds. The pin weight is heavy--around 3000 pounds. The Owner's Manual says on page 191 "When driving with a trailer or payload, a slight vibration or shudder may be present due to the increased payload weight..." (This was brought to my attention by my dealer.)
Seeing the thousands of F-250 and F-350 Fords pulling 5th wheels out there on the road, I wonder how many have this "slight vibration or shudder" and what they have done about it.
View 11 Replies
I have this bucking a jerking when pulling my Sundowner LQ horse trailer, primarily in the 40-50 mph range. I can let off throttle and it stops but resumes unless I feather the throttle.... 2008 f 350, 4WD, 6.4, 48k miles....
View 1 Replies
I have read the older posts here on the super duty ford 4x4 system. At 60,000 miles I noticed what sounds like a gear or bearing noise, or even a whining noise like you would hear from mud grip tires, coming from the front end area, while driving back from Kentucky to Georgia. I have quiet running street tires on this pickup.
I have a 2004 F350 crew cab XL, automatic, 4x4, limited slip axles, 430 gearing and a V10. This truck has always been extremely quiet on the highway. This noise I described above has increased and the truck now has 70,000 miles. I have the factory 4x4 dash switch in my truck cab for the 4x4 engagement. I always thought the dash switch engaged and disengaged the transfer case, and locked or unlocked the automatic hubs.
The service guy at the dealer now tells me that the dash switch only locks and unlocks the front hubs, and the front drive shaft and front differential are engaged full time. So, after checking my tires for defects, and for any play or bearing noise in my wheel bearings, I am looking at pulling the drive shaft out keep the front differential from turning, to determine if I have a bad bearing in the front axle assembly.
Now I read some of the posts here, and they say that with the dash switch in "2 wheel drive", the transfer case should be disengaged and the front drive shaft and front axle should not be turning at all. What is turning up front with the 4x4 disengaged on the dash switch ? I'm afraid to drive my truck out of town now and I need to isolate this issue and get it repaired. This has been a great truck and it's very reliable.
View 10 Replies
I replaced both front bearings, calipers, brake pads, now I have a grinding noise on the left side front stops sometimes when you step on the brakes? 1999 F350 ...
View 6 Replies
I have a 2001 f350 4x4 with7.3 diesel...I have recently noticed a low grind like noise coming from the right front. I have troubled shot the issue and I am 100% sure it is the wheel hub assembly. Did I mention I am running 37x13.50 tires..and now you say no it is the hubs...and they are the original hubs. My question is every thing I look for shows ABS is on my truck... I look at the hub and don't see it.. so with the Dana 60 front does it have ABS or not? Also, should I go motorcraft, Timken or moog wheel hubs?
View 1 Replies
My '11 F250 stock w/airbags has a mild shudder when I let off the gas approaching a stop light. If I air the bags up to about 20 lbs it appears to go away, or at least is undetectable. I don't notice this if travelling at a higher rate of speed on a highway but only when slowing down from a lower speed (<40 mph). What this could be?
View 3 Replies
I got a 2001 f350 got a noise in my left front wheel i know its not the wheel bearings, it only makes the noice when the locking hub is unlocked i did jack the the truck up and spun the wheel got a faint grinding noises form what seems like the locking hub so my question is bad locking hub or needle bearing holding the axle shaft??
View 3 Replies
I've had the 450 a little over two years. Its used 95% of the time for hauling trailers, including the toy hauler. Has not given me a single problem since day one and now has around 21,000 on the odometer.
Lately I've noticed a "grinding" sound coming from the front end somewhere. It is most apparent when I'm turning at slow speeds; especially left. To describe it would be similar to worn out brake pads or maybe a wheel bearing going bad. It does it whether I'm on the brakes or not.
View 14 Replies
2008 F250 Crew Cab 5.4, 79K miles, had new brake pads installed at 40K miles. Recently, I noticed front end shudder and some pedal pulsation while braking. It started kind of sudden. My first thought was a warped rotor.
When I took things apart, I found passenger side front rotor was cracked and the caliper pistons were rusted and falling apart, the old pads were only worn about half way. My thoughts on a bad rotor were confirmed, and then some.
I replaced the broken caliper, both front rotors, installed new pads on all four wheels, and bled the brakes. To my surprise, the brake shuddering did not go away. I'm stumped.
View 10 Replies
Came out to start my truck today a hit the key and got nothing. After I settled down from being upset about my truck already giving me trouble (bought it in Nov and had 25k miles on it, 35k now) and that I should have stayed with a Chevrolet, I was able to start it by crawling under and jumping the started with a screwdriver. The truck started up no problem and got me home where I did some troubleshooting. Looks like I dont get solenoid power at the starter (just main power), the relays and fuses checked out, anhe d it looks like the key is still programmed.
I had been getting what seamed like a delayed start every now and again that was going on for a while, but thought it was just me. The next items I thought that may be the culprit are the neutral safety switch or the ignition switch. The gear selector seams to work fine and it wont start in either P or N, the backup camera turns on and nothing seams to be incorrectly working on that account. Also, the truck is a 2011 F350 Crew Cab 4wd Lariat with the 6.2 gas motor.
View 10 Replies
I bought a 2011 F350 that was in a collision. I have done collision repair before but I have not had to deal with air bags... Both driver wheel and passenger bags deployed. I see some for sale on EBAY for around 300 used....do I just by them and install them? Is there a reset or something else I have to do? I see some sell them with the controller as well...do I need that?
View 14 Replies
I have an 11 F350 6.7. It has just under 200K miles on it. Yesterday I changed the oil. Very uneventful. Today however, I was driving home, about 100 miles, and my truck's temp spiked. Not like a little spike, but jumped to the 3/4 mark(if there was one) then slowly kept rising to to the overheat mark. I pulled off onto the hard shoulder waited an hour or so to let it cool down, then finished the drive home. All the way home my temp gauge seemed like it was on some sort of drug. It would jump a needle width when I would have to accelerate, then slowly cool to normal after I got up to cruising speed.
When I got home I checked the oil level and it was spot on in the "normal" range. I haven't used a different type/brand/weight of oil in the last 100k miles. Did something just give out on my truck? I had the coolant flushed and replaced at the dealer within the last 10k miles. Up until this point this truck has been exceedingly reliable. I pull a 13k 5th wheel once a month and drive about 40k-ish miles a year.
View 9 Replies
I have a 2011 F350 with the towing package. I got it used as it and it was a northern truck. My towing mirrors won't extend in or out. They fold and unfold just fine. When I press the button to telescope them I can hear the motor running so I know the fuse is good. I took the glass off the mirrors and scraped some salt out of the joints. I sprayed some lube on the joints as well but still no luck. I also tried forcing them but not too much to avoid breaking them.
View 1 Replies
I have a 2011 F350 with camper package (didn't want it). When I drive on a bumpy road (without 5th wheel), the truck suspension does not absorb the shock. The ruts just throws the truck side to side. Really hard, so I can't go on a dirt, rough road. On one bump it poped off my rear tire cap.
My problem may be with the camper package trying to keep the truck from going back and forth.
There is a 7/16 inch steal rod going from the truck bed, around the differential, and back up to the other side of the truck. Is that the rear stablizer rod?? Can I disconnect it? What would be
View 13 Replies
