Ford Super Duty (1999-2016) :: 2011 F250 - Really Hard To Steer
Feb 25, 2015
I own a 2011 f-250 superduty, and have been having a problem with the steering, it goes from normal to lost of assist. Real hard to steer and dangerous. Then it will go away for a month, then start again. Some one on this site told me to flush the system which I did and it was fine for a month. A friend at a local ford dealer told me they had contamination in the system and I had to replace pump, reservoir, and flush system again....
View 10 Replies
Advertisement
I have a 2011 F250 with the 6.2 34000 miles and my Transmission shifts hard between 2-3 and 4-5 took it to the Ford dealer and they said it is the shift solenoids are bad but it is cause from the Powertrain Control Module and its not covered by the warranty because it is part of the emission system.
View 4 Replies
Got the death wobble, had everything replaced. Wobble was worse, upgraded track bar. Then no wobble but bad bump steer. Put on new OEM track bar.
Ok but still if I hit a hole on the interstate I get death wobble and little mini wobbles on any bump. What is the permanent fix for this other than selling the truck?
2011 6.7L FWD Lariat, upgraded exhaust and Def removed.
View 4 Replies
My '01 f250 7.3 has gotten hard to start. It seems to maybe be due to cooler weather, but not always. I have been told that there is some sort of valve in the fuel tank that could possibly cause this when the fuel gets around a 1/4 tank or so. But, it's doing it at any fuel level. But it doesn't do it all the time. I do notice it more in cooler weather. Anyway, when I try to crank it, I'll let the "wait to start" light go off and then wait a bit more. I'll turn it over and it almost as if the batteries are weak.
I'll stop and give it a few seconds and turn it again and it will normally start. But sometimes I'll do this 5 or 6 times and it will finally fire. But the more I have to try, it's like fuel builds in the cylinders and it smoke like a coal train for a minute or so. Almost like gas motor that has been flooded. But the smoke burns off and it runs like a top. I was thinking the batteries may be weak , but sometimes the starter will spin the motor with no trouble at all. I'm at a loss. Is it possible for fuel to drain from the system causing it to have to reprime itself? Here lately the smoking has me concerned even though it clears up.
View 7 Replies
I have a 1997 f-250 heavy duty with the 7.3 I have been having problems with very aggressive and hard shifting. While it is acting up the overdrive light on the shifter blinks. This problem goes away and it might be good for a month or so, But it always comes back. I have had it to a professional trans tech, He replaced a part on the side of the tranny. I thought it was fixed, But now it is acting up again.
View 4 Replies
I have a 1999 f250 sd with the 7.3. I'm not sure what is going on with my pickup. When I turn to the right i can turn with one finger, but when I turn left i have to put some muscle into it. Power steering fluid is full. I raised the front end and it turns both ways easy. My ball joints feel fine, there is no tire shake when i have it off the ground. My tie rods feel fine also, nice and tight. I was thinking about replacing the steering sector to see if thats the issue but wanted to get a second opinion first.
View 2 Replies
I have a 2011 F-350 6.2L that has extremely hard shifts from 3 to 4 going up and 2 to 1 going down. Sometimes on downshifts it feels like something has ran into the back of the truck. I had the computer updated when the truck had approximately 40,000 miles on it and he assisted a little bit. The truck now has 140,000 miles and it is back to shifting horribly. I put it in the shop at the dealer on 30 December 2013. The dealer says that the problem is that the shift solenoids need to be replaced but that they are not available. The truck is still sitting at the dealer and I am being told that the parts should be available mid February.
View 10 Replies
I have a 2011 f250 6.7 and I have a very bad vibration between 40-50 that seems to peak around 45-47. It also starts again at 80+ . the dealer told me they could not find a problem. Then another told me its normal. The tire shop around here told me the tires were shot so I bought new tires. No luck. It does not affect it if I change gears.
2011 f250 4x4 6.7 SWB. 140,000 miles
View 11 Replies
I have a 2002 ford f250 with the 7.3l diesel. I recently installed a ts performance chip. On my pcm. And after i first tried all the different stages I didn't like how my transmission was shifting hard. So I contacted the manufacturer and he told me they could reprogram the chip for smoother shifting. So I removed the pcm and removed the chip. But when I went to reinstall the pcm I bent one of the pins on the pcm some how.
So I took it back out and straightened the pin with pliers . i reinstalled it back in the truck. Only to find when I reattached the battery cable I have no power to anything ignition ,horn, lights,Cigarette lighter etc. So my question is if the pcm is bad, or not contacting properly due to the pin being messed up. would that have anything to do with the lights and horn and all that? I suspect its the gem bsm or Vsm. Whichever one my truck has. But really not sure because everything worked fine just 20 min b4.
View 1 Replies
When braking the truck shakes terribly, enough to toss a drink out of the cup holder almost. Sometimes there is a slight feeling in the peddle but not always. The shudder feels like it is timed with each revolution of the wheels.
It developed from a perfectly stopping truck over the course of maybe a month. I don't drive the truck that much either.
Things I have checked:
1, all u-joints, they all look and feel good, no play or slop in them
2, air pressure in all tires, even rotated them, no effect
3, brakes-front and back all looked good but I went ahead and replaced front pads and rotors, cleaned caliper pins, zero effect.
4, shudder exists whether in gear and slowing or in neutral, 2wd and 4wd
What the heck else is there to check? My first thought was, front brakes/warped rotors, but after pulling them apart there was so much life left on the rotors and pads and replacing all that with new did nothing! Could bad back brakes cause this much of a shudder? They look fine as well.
View 5 Replies
On my 2008 f250 I can not turn the hubs without a set of pliers...does that mean I need new hubs....
What auto tranny do I have with the 5.4.. is it a six speed...
View 14 Replies
I recently purchased a 00 F250 psd 4x4. Other than doing all of the fixes it needs to make it ride better I have been questioning the trucks "get up and go" and the EXTREMELY sensitive skinny pedal. Truck seems to pull very hard and puts out some black smoke under hard throttle but nothing like the really tuned trucks I have seen. But the skinny is so sensitive its hard to drive under 40mph in 3rd and once it gets up to 55 or so its real sharp getting on and off the throttle. Trans shifts great, TC locks and unlocks, truck runs awesome IMO but just a bit harsh. Is there a way to find out if it was tuned prior to me buying it other than inspecting for a chip, or is this the way they are and I just have to get used to it more...?
View 9 Replies
I put some bfg at's on my '16 f250 6.2 today, 285/70r17 from 245/75r17. Has went to a larger tire and had funny downshifts? I had two hard down shifts on the way home from tire shop that I have never had before. I'm hoping this will go away once the computer relearns. Should I disconnect the battery or anything or just drive it and let it learn? I'm a little disappointed, the tires still look tiny, and checking clearances at liners and radius arms, I could have cleared a lot more tire easily. They sure looked bigger on dads '04. These will do me for a year or so until I can upgrade wheels, tires and suspension.
Before
After
View 9 Replies
I have a 2004 F250 5.4 gasser, 214K on it. It is my daily driver, and it gets around 6mpg. I feel like this is a lot less then it should get. However that's not the only problem. it wasn't always this bad, but now almost every time I start it, it cranks and cranks and cranks but wont start. I turn the key back, forward again, it turns over 2 or 3 times, and starts, but kind of spits and sputters at a low rpm before speeding up the rpms. I feel like these issues are linked, but its pretty annoying that the starting issue happens everyday. Its been doing this for about 3 years now and I feel like one day it will let me down. People start looking at me if I have to try to start it 2 or 3 times.
View 1 Replies
My 2000 F250 4 x 4 just started being almost impossible to steer to right when stopped. To the left it is ok. I was on a trip and when I got where I was going noticed the steering very hard. I checked the fluid level and it was almost empty. I filled the reservoir and let it sit 4 days. I am back on the road now and it is still doing it. Stopped to left is easy to right almost impossible.
My brakes are good. I noticed a couple times when I had to slam on the brakes on the tirp the rear tires chirped. I don't tow anything with it, just a family vehicle with 408000 miles. The power steering pump was replaced a few years ago. Pump, gearbox, etc? I need to get this fixed as I have another trip coming up in a few days.
View 2 Replies
I have been having hard shifting from 1st-2nd when cold. Rpms up to 2000 and let off then goes into 2nd. After that, she shifts fine and shifts well until next morning when she sits overnight. Build tag is August 09, 2001, so no old mechanical diode? Took a sample of fluid and it is dark red (pic attached) and smells like hydraulic fluid...I don't think it smells burned. Does it sound like the calve body 1-2 shift or solenoid pack or needing rebuild?
View 3 Replies
I recently purchased a 2011 F-350 w/6.7 diesel. When I first start it & let it run say 30 seconds and take off it shifts fine from 1 to 2 but when it goes from 2-3 it hangs there a second and then finally shifts into 3rd hard. 3rd to 4th is ok but 4-5 again is a hard shift and from 5 to 6 is OK. It will do this for a while like through the neighborhood and down the road 10 miles then it is fine. Shifts beautifully when warmed up.
My local Ford dealer has a guy that is supposed to be very knowledgeable with Super Duty trucks. I have had it to him twice and he says this is normal. All shift hard until the transmission is up to operating temperature. Says the engine is very powerful and until everything is up to temperature this will happen. If so then it would be normal to let it sit and run for a while before you take off in the morning. I am getting ready to hook the truck up to my 33' camper and go on our first camping season with the trailer/truck combination and if I need to leave it sit and warm up I will.
View 4 Replies
Bought my 2011 F250 6.2L brand new and have had issues with it accelerating since new. I had it in once and they replaced the mass air I believe.
When I merge onto the highway for example and give it some good gas (not really stomping on it) it down shifts and pauses like it trying to figure out what gear it wants to be in, then it picks a gear and the RPM's rev high, but then sometimes it will do the same thing again and then finally take off. If I completely lay into the throttle, it revs high and drops into a gear, then comes back out and drops into another gear, then does it yet again.
Not a fun situation to be in when big rigs are barreling down on you in the right lane! I work 6 days a week and a lot of doubles, so my one day off is usually spent running errands and dropping my truck off all day with the possibility of leaving it for two days just isn't viable, so I hate to bring it in for them to tell me it's fine.
View 14 Replies
Love my '11 f250 SD 4WD CC SB. 6.2 with 3.73 e-locker. I've got 5 Star tunes in it, and the truck is a joy to drive empty, and tows my current 7k camper fine, though on steep inclines I wish I had the 4:30 gears.
Well, we just bought a bigger trailer, dry weight is an addtl 2400+ at 9400, so I'll need to do something.
I don't want a different truck, don't want (another trouble-prone) diesel. I think with 4:30s and the tune, I should be fine towing that trailer (with gear and passengers, probably 11-11.5k loaded). Not doing mountains here, just Michigan hills.
What's the best way to "do" a gear swap? I know if I buy a set of gears and a shop screws Em up, it's gonna whine/hum and still cost 2k to do (truck is 4wd)
I'm up in the boonies and finding a shop to swap the gears will be a problem. Getting Em done right will be even MORE trouble.
Can I just find 4:30 axles ans have them swapped (anything in t-case or sensors need to be touched?). I don't care if I lose the e-locker, I never use it.
View 14 Replies
So two weeks ago I had a battery melt on me and I replaced it. Then last week I had the other battery almost blow up on me (it was a mess and smoking). I didnt use it all weekend. Today it started right up. I drove it like 500 feet and it just died. It is very weird. Both batteries are fully charged. Relay is good. When I put in the key it does nothing. No sound no radio no clicking. However, the gps still works (the online monitoring kind). I can fold in my out revie mirrors. And I can lock and unlock the doors. and the interior overhead lights come on. Nothing else has power at all. And I can't put it in neutral. Right now the truck is blocking my driveway so nothing can get in or our of here. I am wondering if it is some type of antitheft issue...
View 5 Replies
While cleaning the door handles the switch to extend and retract the side view mirrors hung was depressed and evidently got stuck as it was still pressed in. My hope is that this just blew a fuse and not burn up anything. The mirrors still fold and can be adjusted just not extended. Is there a fuse specific for this that may be blown?
View 2 Replies
