Ford Super Duty (1999-2016) :: 2011 F250 - Check Engine Light On Dash?
Dec 18, 2014
1-11-11 built F250 with the 6.2. 45K miles. Took it to my local HD truck shop to have the code read. The reader said "Evap pressure sensor switch malfunction", "vac above pressure limit wouldn't bleed". He cleared it and it has now come back.
1. Where is said switch located? Is this something I can do as I'm a seasoned wrench but I'm not dropping the tank in my driveway in the winter.
2. Is it in the tank or outside the tank?
3. Has there been any TSBs or recalls on this before I attempt to repair?
View 6 Replies
Advertisement
I am getting this check gas cap warning on the dash. I checked the cap, looks ok... Should I disconnect the battery for a minutes.. and see if it comes back?
View 4 Replies
2 weeks ago I had the check engine light come up on my 2011 F-250 6.2 XLT. Did a diagnostic check and Codes P2098 and P2272 came up. Did some research and found out the second O2 sensor on passenger side had gone bad. I replaced it with a Motorcraft O2 sensor and cleared the code. It has not came back since. But still not getting the fuel mileage I got before. What else could be wrong?
View 5 Replies
We currently have a 2011 F250. During the day time, when you turn on the headlights all the way (not just on "auto"), the dash lights and clock shut off. Originally, I thought that they were just dimmed to the point where you couldn't see them, but the brightness is already turned all the way up on the dash lights. If I turn the brightness up any higher, the dome lights turn on, but the dash and clock remain off. If you return the headlights back to the "off" or "auto" position, the clock and dash return to their normal brightness.
View 4 Replies
I have a annoying check coolant additive warning light that wont go away, is their another way to turn off the light other than the button on the steering wheel? I have searched the forum but have had no luck, my coolant level is at it's proper level.
View 3 Replies
Just replaced the alternator in my 1993 Ford F250. How do I reset my check engine light? It keeps coming on after I drive for roughly 5 to 10 minutes.
View 7 Replies
So yesterday I decided to wash my truck and after taking care of that I took it for a short drive and the tranny started acting funny. Check engine light comes on and the code is P0500 . It calls for a VSS but I cant locate it. Also the fact that it did after washing the truck is making me think its a wiring issue... F250 SD 5.4 4x4 ....
View 5 Replies
My 2014 F-250 is having a repeat problem with an intermittent cell engine light. About 10000 miles ago it happened, and they changed out the egr cooler. Saying it was gummed up with soot. Problem just started up again. Light will stay on for about 3 or 4 restarts then sir off on its own. It's this a known issue with the 6.7? Is there a way to prevent it?
View 7 Replies
Just this morning I tried to remote start my '13 F250 6.7 and all i got was the doors lock and a two honks. The two honks are usually when there is a door left open when you click the lock button two times but all of my doors were locked. After I started the truck with the key and took it out to go run a errand I noticed the check engine light turned on. Could this be connected or just a coincidence?
View 4 Replies
2002 F250 SD 4X4 5.4L. 4.5 inch pro comp lift tire size 305/75/R16. K&N cold air set up. 208,000kms
I know the truck does horrible on gas but lately is been getting worse, maybe I am getting 350km to a tank. Mixed highway city driving. Sounds like I might have a vacuum leak somewhere but I have no engine light. I've had the truck since last year and put about 10,000km. on it done regular oil changes .. brake maintenance no motor work so far.
View 2 Replies
I have the infamous P0461 check engine light coming up. I filled it with Techron and even purchased Techron additive with a full tank and it's not going away. I've also replaced gas cap with OEM brand new yesterday and light keeps coming on after 2-10 miles.
Truck is stock. Bone stock. The fuel gauge is reading accurately and not fluctuating or jumping or behaving erratically. I checked all fuses and all fuses are good (under dash and on floor in cabin).
2010 f250 lariat 5.4 V8 4x4 super cab 189,XXX miles.
View 2 Replies
I have a 05 f250 with a 5.4 I'm having issues with I was driving along the truck started chugging along and the check engine light came on so I checked it with my bully dog the codes that came up were p0192 which is fuel pressure sensor circuit low the next one is p0452 is evaporative emission pressure sensor switch low also came up with p0191 tonight haven't dug into that yet.
I change out the pressure sensor switch from a buddies truck didn't make a difference put my sensor in his truck his worked fine I clean the throttle position sensor and The maf also put a new air filter on not throwing a misfire code but seems like it may be. A little background on the truck it's a 5.4 3valve with a bully dog tuner, mufflers been removed added straight pipe mechanically that's all that's done
View 4 Replies
I own a 2011 F350 dually with the 6.7 in it. It has 136000 on it and zero mods. I was driving over the weekend and the traction control light, brake light, and the ABS lights all came on and the information center displayed Check Brake System. We were towing our 5th wheel when this happened. The brakes on the pickup and trailer both work and we have no problems stopping. About every 15 minutes or so this message pops up and it chimes again. My insight is reading a U0418 code. We are stopped now and the code and alert message is still popping up without the trailer. All fluid levels are where they should be.
We are also getting a check engine light and my Insight is reading the codes P2020 and P20E8.
I can reset the codes dealing with the reductant leakage and low pressure, but not the codes dealing with the brake system.
I have had my pickup in to 2 different ford dealers for these issues and they cannot find anything wrong. I did notice that this time when the Check Brake system warning appeared that the pick up started lunging a bit, we lost power to the stereo and the windshield wipers came on. Our fuel mileage has remained the same and the pickup still tows like a beast.
View 1 Replies
Bought a brand new F250 6.7 it has 7000 miles in it now and the check engine light comes on and the truck goes into limp mode. I have taken it in to the dealership twice they said there is no code they can find and they just reset the check engine light and it does ok for a bit then starts the cycle all over again. It also is only getting about 6.5 mpg....
View 6 Replies
You know the "mechanic's fiances truck" problem. I recently replaced the cam sensor in my 05' F250 Gas. The check engine light had been on for a while before that and my truck rode great, however I now want to sell it and I can't do that with a check engine light on. It's got about 85k miles on it.
After replacing the sensor, the light went off for about 20 miles, but it is now back on and my truck seems to miss every once in a while on acceleration or cruising. Some days it's worse than others. The check engine light still says cam sensor, but the sensor is brand new.
My fiance is a mechanic, so I don't know all the details about code numbers and such. However, I want to sell this truck pretty soon, and I would like it to run correctly. His dad (another mechanic) seems to think it could be a coil and wants to wait for that light to come on, but I would rather fix the problem and sell the truck!
View 1 Replies
Just bought this pickup is a 2011 F250 xl with the 6.2l. The service 4x4 flashes on the dash. The 4x4 shift motor fuse blows instantly when replaced even with the vehicle off. I then went and disconnected the plug ins from the shift motor and tried a new fuse and it blew again. Not sure where to go from here.
View 2 Replies
My dads 05 f250 6.0 PSD. He says he'll take off in the morning and the fuel gauge will randomly drop to empty and trigger the low fuel light, but then also the Check Engine Light will come on. My brother did a code scan and no codes come up. Where we should be looking to remedy this one?
View 14 Replies
My 4wd went out in my 2011 Superduty, the light comes on, i can feel an engagement but then I get check 4wd light on the dash. I stopped to look in the fuse box for a blown fuse but there is no panel cover there.... Im trying to locate this fuse so I can stop to the store real quick on my way home.
View 8 Replies
2001 Ford F-250 7.3 Lariat, Crew cab, 8 ft bed. Have had the truck since about 2007 and 4x4 has never worked. It has the typical ford "self rotting" vacuum lines (which have all been replaced along with the hubs themselves). Took it to a mechanic a few years back and he n-word rigged it (for a lack of a better word) and bypassed a lot of vacuum stuff and it still didn't work. The weird part is this-- the 4x4 light is permanently on on the dash, even if the switch is in the 2wd position. Flip the switch and nothing happens. No sounds, nothing. No mechanic can fix it and I have yet to find a forum with someone having the same problem. (Worth manual transfer case swapping it?)
View 10 Replies
The light on dash for 4X4 stays on no mater where the switch is placed I have it in 2 wd and it stays on. Where I need to start looking.
View 4 Replies
Just picked up my F250 a few days ago and it's been great up until yesterday when I hopped in to start her up and nothing. It's a brand new battery and all lights worked, but the dash was dead. I attempted in vain for an hour or so to diagnose as to why this was happening and just happened to open the door with the key in the ignition and hit the door lock button....all of a sudden the truck starts beeping and the message on the dash said "to disable alarm start vehicle". I turned the key, the dash lighted up and away I went. What I may have done to cause this or has it happened to you? I'm thinking it's something with the key fob but not sure.
View 6 Replies
