I have a 2010 F250 super duty and I cannot figure out what is wrong with my 7 way for trailer lights. I have brake and turn signals but no tail lights. I have checked all fuses and relays and they are fine.
View 4 RepliesI have a 07 f250 and wanted to change them to the 08-14 tail lights. Did Ford change the size or a simple switch...
View 2 RepliesThe rear tail lights on my truck have been out for a while now. I wasn't doing much driving at night so it wasn't much of a bother but the new job is getting me home a little later and having to drive with my hazards on is getting old fast.
My radio wasn't working either and I disconnected it a while back hoping maybe it had something to do with my lights shorting out but no luck. It remains disconnected. Just in the past few days my front running lights have went out as well.
I've tested all fuses multiple times (and replaced a couple of them) and checked and replaced bulbs. My brake lights, headlights, dash lights and hazards all work fine. I have the trailer light hook up on the rear bumper and disconnected it at the wiring harness as well hoping it was the problem but it wasn't.
I have a 2001 f250 v10 lariat ext cab. i was going to get wood the other day down a muddy road. My radio went out and all my running lights. i replaced the fuse radio and now the switch. Still nothing. Could it be a bad ground? i ran a jumper wire on my old switch and they worked then just stopped again. if it is a bad ground where would it be located.
View 3 RepliesThe flashers and blinkers work, the taillights, brake lights and back up lamps do not.
The truck is a 2004 F250 4x4... Checked all fuses. What am I missing?
I left town tonight and dad called to say I had no tail lights. I stopped and checked the book to see where the fuse is and couldn't find anything for the tail lights or parking lamps. I have brake lights, both rear turn signals and the tail lights blink when you lock it with the fob. The trailer socket shows I have trailer tail/marker working. Why don't my tail lights work?
View 14 RepliesI was driving my 97 F250 2wd the other day and it started blowing steam out the tail pipe. In recent months I have replaced the thermostat, heater core, and pressure cap on the reserve tank. I do believe I have blown a head gasket. I did check my oil fill cap and it showed signs of milky residue..
The motor in trouble here is the 4.6L gas. And I have yet to talk with my mechanic I had the thought to replace this one as it has over 330K kilometres on it. I wonder if a newer 4.6 from a similar F150 or F250 would have the same motor mounts. No, I am not looking at brand new as my budget isn't that of a millionaire. I have found a few younger 4.6 motors within my budget.
I Have a 2002 F 250 That I recently changed the fuel pump. and now I'm having a tail light problem. when i start the truck, my tail lights and plate lights comes on (dim). if i turn my head lights on the truck stalls out. if i step on the brake or put the truck in reverse it stalls out. if i put it in drive it runs just fine. i checked my fuses and relays and the problem is still there even when the relay and fuse for the lights are out. when i turn the truck off all the light go out.
can't seem to find any info on this problem anywhere.
I am having a problem with trailer lights and an 03 350. When the truck is in reverse the fuse for travel trailer running lights and tail lights blows immediately. Changing plugs on the truck did not work. Truck has been hooked up to 4 other trailers including another travel trailer with no problems. Our travel trailer has been hooked up to an 08 and a 2011 truck with no problems. Fuse 38 20 amp. 7 post rv plug.
View 3 RepliesI read in a thread about how fog lights need the auto light sensor or something in the kit to be installed and flashed.
My truck is a 2012 f250 XLT that I bought left over from a podunk town IN illinois. It does not have fog lights but it Does have automatic head lamps. So Im very confused on what kit to order to add fog lights to my truck.
I have an 04 F250 with no brake lights. However the third brake light works. I've also noticed that my trailer brake lights don't work either. I do have all my turn signals and running lights. Another issue that could be connected is I have one out of four hazard lights. When I push in the hazards my front passenger blinker works but none of the others. Could this all be due to a relay switch?
View 14 RepliesBought an 04' F250, looked good but definitely not well maintained. Have replaced tranny temp sensor, thermostat, fuel filters, air filter.... Etc. heads have been redone and new studs installed , Egr delete, new oil cooler, flushed cooling system. Now tonight coming home noticed the brake lights aren't working, all 3 are out... fuses are good. I've heard multifunction switch or brake switch.....
View 12 RepliesI have a 2005 Ford F-250. I have checked power to the rear harness and all is good except for the tail/running lights.
Is there a fuse for the tail lights? I have checked the manual and don't see one called out. And the relays under the hood are labeled stop lights/turn signals and those are working fine.
I will see if I can trace the brown wire from the rear harness backwards, but it may be a simple fuse.
I have no 4x4 lights on in cluster when turn the key in the on position and it doesn't engage when I turn my 4x4 selector. And I don't hear anything in the relays .
View 14 RepliesI have a 2005 ford f250 with the factory installed brake controller and towing package,until recently all was well,I tow a fairly large travel trailer and last time I hooked the trailer to the truck I noticed the running lights on the trailer were lit, I checked to make sure that I did not have the parking lights turned on or the headlights. I did find posts about the running lights not working and was surprised to find there is a relay somewhere on the central junction fuse block that was integral to the cfb and not user serviceable. Could my problem be that this relay failed in the closed position or am I not going in the right direction in my quest to find this problem. Also looking for a diagram of where this relay is located on the central junction fuse block? I would also consider doing a work around solution rather than having to replace the entire fuse block.
View 7 RepliesIv been chasing an electrical issue with my park lights staying on. Even with the #8 fuse out and the GEM unplugged the lights stay on.
They are being powered by the #4 fuse circuit that power mirrors, glove box light and under hood light are on. With that fuse pulled the park lights go off.
Now I have to figure out how the 2 circuits are connected.
I've got a 99 F-250 6.8L V10 manual 4WD with no speedometer or odometer. The ABS and MIL lights are on. Code is P0500 - VSS malfunction.
This started when the previous owner hooked up some large LED backup lights to the factory wiring. Something smoked under the dash. He then moved them to a relay-switched +12V feed. He reported that the backup light fuse did not blow.
Ive tested the backup light fuse and the recently replaced VSS. Fuse is good and the VSS tests ok for Ohms and gives AC voltage when the tone ring turns. I pulled the fuse panel, GEM, and PCM. There's no visible damage anywhere there. I'm stumped. Tomorrow, I'll dig for any melted wiring under the dash....
2012 f250, fog lights stopped working and tried fixing yesterday. I'm getting 12.8v at the plug but as soon as you plug the light in it goes to 0. Ran a new ground from frame and the hot from plug and still nothing. High beams off, truck running and switch pulled out. Bulb is fine, hooked it straight to battery and it comes on. I though it was a faulty ground but by running a separate ground and still nothing. I'm at a lose.
View 2 RepliesThought I'd ask a quick question here...
Is the lens on OEM fog lights removeable? Mine is fogged up and discolored, so was wondering if the unit comes apart where I can clean & reseal ?
Or just buy a new set ?
I love my new truck. '15 250 CC SB. It would be nice if when I am backing up not to have the dash lights in my eyes once I turn off the head/parking lights at night. I turn off the head lights so as to make everything darker. Much easier to see what is in my mirrors.
View 2 RepliesI have a 2012 F250 and am having a problem where the interior lights wont come on with the dash switch or when the doors are opened. I have confirmed that it is not a bad fuse, also the lights will come on when the switch on the individual lights is manually pushed, but not automatically like they are supposed to. I dont see it being a door switch issue because the door chime comes on and the stereo goes off when the doors are opened after turning the ignition switch off. I've read that the dealerships will switch out the BCM. I thought maybe the dimmer switch next to the headlight switch but there is no power to it whatsoever, which also I can't dim the instrument panel lights. What did you do to resolve?
View 1 Replies