Ford Super Duty (1999-2016) :: 2009 - Oil Filter Causes Engine Knocking At Start Up
Apr 3, 2013
I got ready to change oil in our '09 5.4 SD and I ran across a passage in the owners manual that stated that if you use a non-Motorcraft oil filter it may cause engine knocking upon start up.
Our truck knocks for a second or so when it starts. Kinda' reminds me of the piston slap that occurred at start up with the old Ford 300 inline 6 cylinder engines of the past after they got some miles on them. Sounds somewhat similar. This engine has 35,000 actual miles so I wouldn't thing excessive wear would be the culprit.
I'm using a Bosch Premium oil filter now after having heard and read how they are superior in their filtering ability.
Just wondered if any of you guys have run into a similar situation and if the Motorcraft filter in fact makes a difference in reference to start up knock
View 14 Replies
Advertisement
After replacing fuel filter, pump relay, and air filter for good measure my 2002 f250 v10 gas engine still wont start. What to do?
View 13 Replies
Was going to change my transmission fluid and filter today but when I got under the truck to see what tools I needed, I was not sure I could drop the pan enough to get it off.
I have a 2009 V10 4X4 and the exhaust pipe catalytic are running down each side right under where the transmission pan is. It looks like I can get to all the bolts, but because of the catalytic are right under the flange of the pan on each side, the pan will not be able to drop straight down. It looks like it may drop about 3 inches before it hits the catalytic.
Will that be enough to slide the pan forward or maybe tilt it to get it out? Has anyone dropped the pan on their 4X4 with the 5RW100? Just looking to have someone say I can get it out before I try it.
View 14 Replies
My 6.0 powerstroke will not start at all. I changed the rail fuel filter and the oil and oil filter. All oem for caps and filters. But the fuel filter in the engine bay is stuck. I didn't change the filter and I don't think I put diesel on the o ring to lube it. Could this be why it's not starting. I tried using starting fluid aswell no good
View 2 Replies
My 2004 powerstroke recently started making a loud knock during the process of starting. Will make the sound warm or cold, however I mostly hear it when the truck is warm as it cranks a little longer and about two seconds into the crank something starts knocking. After the truck starts it runs perfectly fine.
View 4 Replies
2 nights ago changed the fuel filters for the 3rd time on truck since bought it a year ago. It has 67,000 miles. F350 6.4 L 2008. The truck ran for about 2 minutes and then wouldn't start. For the last two nights have done everything including cycling the key over and over to purge air, replacing the fuel filters thinking the first ones may have been defective, pumped the gas pedal while trying to start it, tried to start it with fuel cut off switch held in, changed o rings etc. The first night I didn't get fuel at the head but after changing the filters a second time, I now have fuel at the head. That is the only progress I have made. The truck has gas and it is fine as we are using it in other trucks. The battery has never been allowed to totally deplete.
View 9 Replies
So there I was doing a simple oil change and when I took the filter out I noticed the little spring on top, in the center of the big spring (oil filter adapter) cocked to the side with the little plastic piece broken.
does anybody know if I can replace just the oil filter adapter (spring thingy that goes in the middle of the filter when installed) or do I have to replace the whole filter bowl assembly? And if so where would be a good place to get this part?
View 5 Replies
Changing tranny fluid/filter today, all has been going great until I went to take the filter o-ring out that didn't come with the filter. It will not come out! made a hook tool out of an old tooth brush like someone on here did, o-ring wont budge. Tried a hook pick, it wont dudge (actually bent the tip on the pick and started to tear the o-ring). Everything is ready to go back together and get filled, but this stupid o-ring will not come out!
View 3 Replies
On my previous 1992 F-350, when I serviced the E40D 2WD trans I replaced the filter during a trans service. I read about some filters falling down inside pan causing shifting issues. There is an aftermarket clip sold that holds the filter in the up position and prevents it from falling into pan.
Is the clip also used on the 2WD 4R100? is it the same issue of potentially falling down in pan as was the case with the E40D? Preparing to service my 2003 F-350 2WD 4R100 and install a new filter and want to be sure I have all parts/supplies ready to go.
View 13 Replies
I'm in having emission problems with my 2010 F250 lariat 6.4 diesel truck my DPF filter keeps getting clogged up engine just shut off on me then I sent it to get cleaned professionally got it installed drive it for 20 miles and my pick up shut off on me and left me stranded and I can't seem to pass inspection...
View 3 Replies
While driving today, 2006 Ford F-250 5.4 L V8 138,000 miles , I experienced a problem. Started with the truck acting as if it was running rough, possibly missing. This was approx. 10 Minutes after starting. Checked the dash, no warning indicators and all gauges were normal. Approx. 4 more miles, the oil pressure alarm signals and I see the oil gauge has dropped to zero. I pull over, turn off and check the oil. Oil is clean and at a normal level. I restart the truck and the oil pressure goes back to normal.
Rev the truck up while sitting there and after a few seconds i hear a knocking noise in the engine and oil pressure drops again. Call the tow truck, driver used to be a mechanic . He asks me to start it again and the same thing happens. If you start it and let it idle oil pressure seems to go up to normal with no engine noise. Finally get to the mechanic and he calls me later saying the oil pump and screen may need to be replaced or the engine may need to be replaced.
View 3 Replies
I have an 2005 F250 4.2tdi XLT. There is a buzzing sound coming from somewhere near the fuel filter area in the engine bay. This started after changing the fuel filter during a service. Its also difficult to start now. It has to swing for 10 secs before the engine fires. What it could be?
View 4 Replies
I had my fuel filters changed at the dealership today on my '15, and then I bought fuel and headed home (70 miles). About half way home I got a "Low Fuel Pressure" message and a little while after that "Reduced Engine Power" along with the check engine light.
I pulled over to see if they did something like leave the drain open, thinking it might be sucking air. Of course it was dark and I could not see anything. However I did hear a buzzing sound and could feel a vibration when I touched the fuel line going into the top of engine filter.
While it is possible I got bad fuel, I suspect they did something wrong installing the filters. Even after cycling the fuel pump multiple times they had a hard time getting it started afterwards; I think they finally disconnected the top fuel line to bleed the air out.
I continued home and made it, but not sure what to do now; its 70 miles back to the dealer.
What is the most likely problem? Improper fuel filter installation or bad fuel?
Should I pull the filters in the morning see if there is something obvious like an out-of-place gasket? If so, top or bottom filter?
Is this a tow truck affair or should I drive 70 miles back to the dealer?
What the heck is the buzzing sound?
View 7 Replies
The factory remote start is not working on my 2009 F 250. The red light is lit when I push the button, the doors lock and you can hear something engage in the engine but it does not crank it. If I keep holding the button the alarm starts to go off. When I walk up to truck the radio is on and I need to hit the remote start button to shut everything down before manually staring.
View 4 Replies
We have a 2009 F350 that the engine is now locked up. Anyhow my question is can a 2001 Triton V10 interchange with what was a 2009 Triton V10 both 6.8L...
View 2 Replies
Do my 2012 F250 6.7 liter Powerstroke diesel has a cabin air filter? I have looked everywhere I could think of and am unable to find one. Does this mean it doesn't have one?
View 9 Replies
How often in miles (mostly highway and city) would you change the following:
1.Baldwin spin on fuel filter added with hutch mod
2. Napa diy 6637 air filter mod with no sleeve over it, just the paper element
3. Stock fuel bowl filter after having added a pre-filter (previously mentioned in #1)
View 1 Replies
I have a 6.8l V10 that ..... seems.... to be knocking. I am used to hearing v8 knocks but not so sure about a v10. The knock seems to double tap sometimes. Could this be a bad valve or lifter instead? Video is linked.
Also oil pressure seems to be fine.
[URL] .....
View 14 Replies
Just had my 2005 F250 a few weeks and the 'check air filter' warning came on
Checked the filter, it looks fine, hasn't come off...it's the cylindrical one.
View 14 Replies
Is this the same thing as the regen? Got it for the first time yesterday at 775 miles. Just curious. On a related note, I've tried to run around town some with 5th and 6th locked out (speeds of around 55-60 on a regular basis, running about 2300-2500 rpms) to try to run this process...am I doing it wrong?
View 10 Replies
Here within the next couple weeks, i am wanting to do some routine maintenance. right now on my list is just an oil change along with the fuel filter.
View 6 Replies
