Ford Super Duty (1999-2016) :: 2009 F350 - Location Of ABS Control
Sep 22, 2016
2009 Ford F350 Diesel ....
I am trying to find my ABS controller because I have an intermittent ABS light on the dash and the code says something about signal loss on more than one wheel. So I assume I have bad wiring or a loose plug somewhere.
I found this (pic attached) on the left hand side under (or a little behind) drivers seat mounted under truck on the frame rail. I think it is the control module but when I tested wiring I found no continuity to any of the ABS wheel sensors.
Is this the control module?
View 13 Replies
Advertisement
On my 2009 F350 the cruise control won't stay on. The slightest bump and it turns off and I have to push the resume button. It's not the brake pedal/stop light as it will do it with me holding the pedal up. I'm guessing there is a vibration/crash sensor to turn off the cruise control in case of a wreck.
View 6 Replies
My 2009 F350 cruise control has never worked since I bought it used and I'm trying to get it fixed without a trip to the dealer but to no avail unfortunately. I have replaced the cruise control switch on the master cylinder and I checked every fuse connected to the brake system and the brake switch works as far as I can tell. I also tried the diagnostic check where you turn the truck on while holding the off button on the cruise control but the cruise light never flashes. I also thought maybe it was the clock spring or the connection in the steering column being loose but the clock spring makes no noise and the horn and airbag all checkout so I'm at a loss.
View 2 Replies
02 f350 5.4L Where is the body control module located?
View 1 Replies
The 5amp fuse 15, (Stop lite switch, GEM, PCM, 4WABS, Brake shift Interlock, Cluster 7 PCM-Keep Alive memory), is drawing 2.7 amps with key off.
The battery has gone dead two times overnight. The truck will start and run. I don't know where to proceed from this point to isolate the problem.
View 7 Replies
I am putting work lights and LED warning lights on the back rack of the 2014 F350 diesel in work. Where are the wires for the upfitter switches, and are they prewired into the fuse box, or do i have to hook them up?
View 7 Replies
I have a 2002 F-250 Super Duty 4X4 triton V-10. Where the security control module is located? my keyless remote system does not work even after programming a new remote. The Ford dealership charged me an hour labor to diagnose the problem and they said it's the security control module which I just ordered.
View 14 Replies
Where the ICP is located on a 2006 f350? I have a no start condition after the truck warms up, everything else is fine. Started fluid works to crank, I suspect the ICP and /or Orings.
View 4 Replies
Just picked up a 99 F-350 V-10 today. Decently clean, works well. It'll be an occasional tow vehicle for hauling my car to car shows.
Anyhow, on the way home, I couldn't get the cruise control to work. I've read about the brake pressure switch problem before joining today. I can hit the on button and set it, and the cruise indicator lights up in the dash and will stay on, but will not hold the speed.
From what I've read, I can't seem to determine if the brake pressure switch will allow the light to come on or not. Should I be looking elsewhere for the problem?
Next fix - overhead console. That one seems simple.
View 4 Replies
So, all of a sudden, my cruise control won't turn on.
View 2 Replies
I did this years ago in my 04 Mini Cooper, although there were no vacuum lines, just about a 30 wire wiring harness. simple enough, extended each wire 1 by 1 so it reached where i needed it to be for the new location.
How hard would this be to move it? i haven't even taken the control panel out of the dash yet, i will do that tomorrow and see what's back there, it's been a while since i removed one so i don't recall what the wires were like, if there were vacuum lines, etc.
Until tomorrow when i can look for myself, if there is enough slack in the entire harness/vacuum lines/etc to move it slightly up/down/left/right, but in the same general area? I don't really want to move it, but here's the reasoning. my Joying android double din head unit doesn't fit. it fits in the opening in the dash behind the bezel:
And I've trimmed the little "lips/tabs" on the bezel radio opening completely off, there's nothing else to trim, and the plastic trim around the face of the radio prevents it from sliding in flush with the bezel, so the face of the screen is parallel with the face of the a/c controls, like the stock radio is.
kind of hard to tell but if you look close where the sanding marks are, it's completely flat with the main part of the bezel. normal double din installs in 99-04's i believe you only have to trim either the top/bottom, or the side tabs depending on the unit/stereo installation kit/trim pieces, but usually double dins will fit after trimming these tabs. this android unit is slightly larger due to the plastic trim around the screen (not removable, it's part of the actual screen) so that's why i'm having a hard time.
The only thing i can think of is to completely remove that plastic "bar" that's right in between the radio and the a/c controls, the one that's sort of rounded on the front. if i remove that, the radio will fit, but then it will cut into the a/c controls. now i'm not sure if i can maybe trim more bezel off directly under the a/c (there's not much of the bezel left directly under it to even trim) and move the a/c down just enough to allow the radio to fit right above it....or do something more in depth, and relocate it completely, either somewhere else on the dash, maybe in my future full length custom console i plan to build to house a subwoofer or two, as well as cup holders etc....or, which i think would be my favorite but the most work, and probably not even worth it because i THINK there's vacuum lines on the controls, is to move it to the overhead console like the same exact control is mounted in my excursion (which controls the rear air). i think i even have a spare excursion console that i could use so it houses the controls like stock and looks 100% factory rather than fiber glassing etc...i'd really like that option, it'd give me more space in the bezel to mount my clarion 1/2 DIN equalizer near the radio (which i probably can't if i leave the a/c in the dash) and it would keep me from possibly putting the a/c in the console, that's a last resort for me i think.
This is sorta neat how they moved it, i'd assume there may be enough play in the harness to move it here without having the cut/extend anything? that's what this thread is for essentially, so i can find that out .. I also don't know if i want to even put the a/c there because I'm not 100% sure yet, but i may bring my console (at an angle/curve) all the way up to that point on the dash where my console build will meet the dash. Not sure if I'm going to stop it below that point and retain the stock pull out cup holders and little cubby, or just remove that completely and bring the console to the bottom of the actual bezel. Looking for any pics of the back of the a/c controls (again, 2004 f350, non digital controls, same as in that last picture above). As well as info on how to go about extending things if it's doable without being over the top work to complete it.
View 3 Replies
I just picked up a 2000 F350 V10 from a buddy of mine. While driving, I will turn my cruise control on but no light comes on. But it does come on when I hit the set/accel or coast button. But the cruise doesn't activate. I tried the self test and the Cruise light lights up after I hit all 4 buttons.
View 2 Replies
2004 F-350 6.0 4X4 Manual transmission. When I drive on the freeway I can turn on the cruise system w/ the On switch. When I then use the Set button the green dash light comes on but immediately goes off when I release the button. Hold the button, the green light flashes until the button is released.
If I push in the clutch peddle while coasting down a hill and attempt to turn on the CC the light does not come on. Similarly with the brake peddle depressed. Periodically the ABS light comes on and I can tell by the brake peddle feel there is an issue with the ABS.
Additionally, the speedo is not accurate. I have an aftermarket GPS. When driving with traffic in a 65 I am reading about 55. My GPS confirms the speed of 65. The speedo flutters with about a 5 MPH span.
Yes, I have tried the Cruise Control Self diagnosis. It does not work on my truck. Key on w/Off button depressed and nothing.
I have checked for codes w/ Auto Enginuity. C1229 & C1184 both come up.
I have replaced the Vehicle Speed Sensor at the top/front of the rear differential.
I have replaced the Cruise Control Cut out Switch on the master brake cylinder.
Both parts are from Ford parts department.
So... What now?
View 2 Replies
2009 F250 Super Duty 4X4 auto lock hubs not working. Indicator lights on dash come on but will only go into 4 wheel drive when hubs are locked manually. Vacuum is present at lower of the two vacuum lines when engine is running. I attach the lower line to the module, rotate switch to 4X4 high or low and module doesn't allow vacuum to reach upper nipple. Which fuse operates this module?
View 3 Replies
Exactly where that part is, pictures would be useful. Pretty much just had my whole dash apart with no luck. Switched to leds, and can't stand hyper flash like I thought I could. Trying to pull it to make sure I order the right part to correct it.
View 11 Replies
2002 f350 7.3 diesel automatic. The cruise stopped about a 1/2 year ago and i have done the recall and replaced the steering wheel switch. but it still doesn't work. the horn works and speedometer works.
View 4 Replies
I have a 2002 f350 my horn went off in the middle of the night got up and unplugged the horn what is my problem. also, the cruise control won't work when it all happened
View 3 Replies
A quick trip from Tulsa to Dallas and back over the weekend...1st time the 2011 F350 diesel dually has been on the highway in a few months. Going down Friday night the speed control worked fine but on the trip home Saturday, the speed control will turn on....yellow light on dash is on. Press SET, the speed control light turns green, but it will not maintain the speed... just like it is not on at all. Did not take time to stop and shut off the engine to try to reboot, and I may go out now and it will work just fine... But, hat might be going on?
View 1 Replies
My 2000 F-350 SD 4X4 V-10 has no cruise control, and the A/C controls are not powered. Is it possible that both these power option circuits are run through a fuse link, and better yet, through the same fuse link? A/C has been troublesome in the past, but the cruise quit one day without warning. All fuses are good. Tried jumping the A/C pressure switch to recharge it, but no power is present.
View 4 Replies
My blower works half of the time...from what I have researched it is more than likely the resistor. The thing is I can't find it..all the videos and pictures looks like they are the **** control control. Where this is located for the dual climate control?
View 3 Replies
I have a 09 F350 Lariat SuperCrew SRW 4x4, Last night the ignition key would not turn at all. Tried wiggling the steering wheel, (noticed it wasn't locked), wiggled the shift lever (auto trans). After about an hour of "beatn and jiggling, it just started working!?? What caused this, neither does my dealers service dept. It's working fine now.
View 11 Replies
