Ford Super Duty (1999-2016) :: 2008 - Oil Leaking In Front Main?
Dec 30, 2013
Right after i got this truck it developed an oil leak which i thought was the front main. Turns out after a lot if degreaser and watching its not and its actually leaking from a small tube running out of the passenger side of the engine. I think its an oil cooler line but not sure. Its where the cross member is located and i cant get in there very easily or figure out how to load up pics to the site on my phone. What this line may be?
View 7 Replies
Advertisement
Changing out the rear main oil seal on my 1999 F250 Super Duty. I have a 7.3L diesel with 6 spd manual trans. with 98K miles. This past week it has developed a very slow engine oil drip where the engine meets the transfer case. Is it necessary to remove the engine or just the transmission? What does a transmission/transfer case combo weigh? What special tools would I need?
View 1 Replies
What would I need to replace in order to fix this leak ?
View 5 Replies
I have a 2015 F250, cc 4X4 PSD. It has 22,000 miles on it. I notice a small quarter sized drop of oil after it is parked by the right side front wheel. It is coming from behind the dust cover and universal joint where the axle goes into the tube. I dont know how long it has been leaking. My issue is I am about 800 miles from home on a camping trip, have to go back to work Monday, and lcoal dealer here can't take it in till next week. So, if the hubs are not locked and the truck is in 2 wheel drive, the gears shouldn't be turning right? I assume it is ok to drive home. I didn't want to pull the plug and check the fluid because if any runs out and leaves a stain on the cover, I don't want ford trying to deny warranty claiming I messed with it first.
View 5 Replies
I noticed the other day after my truck was parked on a bit of a angle there was diff oil from the passenger side on the ground. reading a bit on here i learned the axle seals are way in the front housing close to the front diff. and yesterday driving a heavy load around my front brake driver side got stuck on a bit and over heated and was smoking, couldn't even touch the rim it was so hot. anyway about this axle seal i got the hub off right now but cant seem to pull out the axle assembly through the knuckle but i see i have to pry and most likely wreck that seal. Looking for a link of piuctures or how to replace the axle seals in the housing.
View 11 Replies
99, F250, 4X4, V10, 72,000 miles. I have had the front axle seals replaced three times in the past 3000 miles, and the right continues to leak. My mechanic screwed up three times?
View 6 Replies
I recently did the water pump and hoses due to seeping around the water pump gasket. While there, I decided to replace the overflow reservoir as well - old and slightly discolored. I'm now on my 3rd overflow reservoir - they are all leaking at the front seam. I don't think I have a blown headgasket or injector issues - no signs of white smoke ever, and there isn't any oil or fuel in the coolant. I've also tried a new cap, but it's starting to leak before I build any noticeable pressure - I can back off on the cap and don't get much pressure released. So - just bad luck on parts from Ford? All were OEM from different Ford dealers.
Pics - hard to see on here but go to Imgur to zoom in. [URL] ...
1999 F350 7.3 CCLB Dually. Stock except for DP Tuner and Gauges.
View 7 Replies
My f250 felt like it had a flat as in it was "swaying" while I was driving today. as I'm pulling into my neighborhood it felt as if i had a flat. There is fluid leaking from what looks like a control arm or possibly a canister that's part of a vacuum system. I'm a carpenter obviously by my terminology used in this post. Its dark so ill take another look in the morning but what I'm talking about..
View 14 Replies
I have an '08 250SD diesel. The upper hose that goes onto the water pump has a leak. Is it usually just the Oring or the hose plastic fitting?
View 2 Replies
The doors on my 2005 crew cab are leaking water. Its happened once before, I fixed it by resetting the main seal around the doors. Now this tropical storm had them leaking again. The rear doors are leaking from the top and getting the head liner wet, and the front left door is leaking a little bit onto the middle pillar Guage and down onto my leg.
Is it time for new door seals? My 01 has never had this problem so im not entirely sure what to do.
View 3 Replies
If I use ATP AT-205 stop leak to stop a slow leak coming from the rear main seal, will it last a long time? And if it stopped working eventually, would adding more stop the leak again?
Also, I'm going to have the transmission out anyway, so how many hours would it probably take to just replace the seal at that point? And someone told me some seals were two halves that fit together as one, and others are just all one piece. Is that true? It would seem to me that a two piece seal like that would start leaking prematurely.
View 3 Replies
How do I get the front axles out of of the knuckle? It seems like the seals are holding them in? Is there any trick to to getting them out,I am trying to do my ball joints
View 1 Replies
i have a 2008 f250 4x4 i need to replace the drive side front lower body bushing and i can not get the pressed on bushing to come out what is the easiest way to get this to come apart i tried using a 4 ft pry bar and i could not get it to pop free.
View 11 Replies
I have a 2008 F250 5.4 4x4 supercab long box (68,000 miles) that has a little bit of movement in the front wheel bearing and hub assemblies. Made it through inspection OK but it will need to be changed soon. Just asking for everyone's thoughts on brands they prefer. I have had great luck with Moog brand products in the past. I put SKF hubs on my wife's 2010 Explorer and they I would say are top quality also. Not interested in a conversion kit or cheap junk. I want a good quality unit. What brand has everyone had good results with? Are Moog or SKF the way to go?
View 8 Replies
I have a 2008 F-450 Lariat 6.4 4x4. I recently started noticing the front driver side wheel (best I can tell) wheel makes a noise as though it's binding uo when turning either direction, and I can feel it as well. 4wd is not activated and the hubs are in auto. When the front end is off the ground, I rotated the wheels and they spun independently unless the hubs were locked. I noticed what appear to be seals on both the driver and passenger side hanging loose (see pics). What this might be? I recently used the 4wd when we visited White Sands National Monument while pulling a 5th wheel RV.
View 9 Replies
2008 F250 Crew Cab 5.4, 79K miles, had new brake pads installed at 40K miles. Recently, I noticed front end shudder and some pedal pulsation while braking. It started kind of sudden. My first thought was a warped rotor.
When I took things apart, I found passenger side front rotor was cracked and the caliper pistons were rusted and falling apart, the old pads were only worn about half way. My thoughts on a bad rotor were confirmed, and then some.
I replaced the broken caliper, both front rotors, installed new pads on all four wheels, and bled the brakes. To my surprise, the brake shuddering did not go away. I'm stumped.
View 10 Replies
I have a 2008 f-250 6.4 Diesel. Yesterday the Brake Fluid light came on. I thought maybe a sensor, but once I parked and checked I realized my brake fluid was down to the Min line. I started looking for a leak and it was apparent that it was the front drivers wheel area.
I am attaching a picture of the brake. The leak is either coming from the area where the fluid line runs into the gold thing (caliper?) or the bolt at the bottom of the gold thing.
View 1 Replies
My 2008 ford f250 SD Powerstroke has a bad front passenger side brake rub/ dragging after offroading before off roading just rubbed a little now it drags a lot. what do i need to fix.
View 2 Replies
I am getting ready to put new axle shaft u-joints in my 2008 F350 (they are shot, they actually rattle on my rough roads). While I am at it I figure I will grease the front wheel brg cartridge, replace the needle brg that is inside the cartridge. I am also afraid I will the axle shaft vacuum seal. I don't want to go to ford an get raped, diesel O-rings doesn't have parts for the newer pickups and I don't want to get junk from the parts houses. Where I can get these parts for a reasonable price? What the best brands are? Are they the same parts as the earlier super duties? I know the lock out is different.
View 2 Replies
I have a 2008 F250 which has been a awesome truck. Very few issues except for one that no one can seem to fix. Its regarding my brakes and a mysterious reason all of them have to a degree locked up and smoked the pads rotors etc. I now have 80k on the truck and have replaced all brakes once and now the front left have locked up for a second time. The scenario goes like this:
So i'm driving along and if the front brake locks up I can begin to smell it. So I pull over and smoke rolls out along with the overheating popping sound from the effected brake. Rear brakes usually are not found until I stop which i get out and then can smell them. Funny thing is the brakes have locked up when not towing. Also, I have never had more than one happen at a time. So as today all brake pads and rotors have been replaced and now the left front has overheated again. From what I can tell the caliper just doesn't fully release. What could be causing this?
View 6 Replies
I am not positive where it could be but I have a good bit of oil on the transmission (i think) i was trying to replace the strarter and noticed it. Where the possible leak could be from? No oil on the ground under the truck.
View 3 Replies
