Ford Super Duty (1999-2016) :: 2008 F350 - Rotational Noise Almost Sounds Like Creaking
May 30, 2016
In forward drive or reverse, I hear a rotational noise that almost sounds like the bed creaking when you're getting it on. As I go faster the noise goes faster until drowned out by road and engine noise. The noise is unaffected by applying the brakes. I jacked the truck up and spun tires as fast as I could by hand and got no noise but when I lowered it back to ground and had the truck roll the noise was back. Noise is not affected by turning wheel.
View 13 Replies
Advertisement
A bit annoying. 2008 F-350. When the truck is cold there is a creaking feeling I can feel through my foot. It usually lingers while the truck is warm but eventually goes away. It's in the actual pedal. This may be a stupid question but is there anything that can be lubed under there ?
View 10 Replies
I own a 2012 F350 dually King Ranch with 6,600 miles on it as of today. I noticed that on slight inclines, I can see and feel the hill start assist feature activating and working as before. I was not towing anything today. Starting today though, I hear this loud creaking noise both in forward and reverse directions with quite a bit of shutter from front of the truck lasting one to two seconds as I transition from the brake to accelerator. I checked the front hubs to make sure that they are not in locked position. I tried activating 4WD auto mode, then deactivate it to 2WD mode as I watched the diagram/figure on the dashboard. Nothing would make the loud creaking noise and shutter go away. Is there anything else I can try, or should I take it back to my Ford dealer again (now for another different reason. I had problem with injector #8 failure with CEL come on earlier this week which appears to be fixed for now)???
View 13 Replies
Its a rotational squeak, that sounds like its under the cab or possibly left front tire. The truck only has around 25k miles on it. I recently had a 2" leveling kit installed, 35" tires, and rear airbags installed (within 5k miles). I checked the universals and they seem to ok and there is no noticeable clunk. I am hoping its something small.
View 7 Replies
I recently switched back over to the 5.4 from a diesel. It's a 08 F350. I have about 38,000 on it now. I have no complaints so far, a little less power than the diesel, but I don't tow much anyways. The only thing I can't figure out is a strange noise at around 2500-3000 rpms shortly before a shift sometimes. The best way I can think to describe it is that it sounds like a turbo fart in a diesel. Almost like someone is putting their finger over an air hose on and off a couple times. It doesn't do it all the time, and doesn't shake the truck, or effect the shift at all from what I can tell.
I've put it through a lot of different shifts just to see if it might be transmission related. It downshifts and upshifts perfectly without any noise or slipping, and the fluid looks just as clean as brand new. No smell or anything either. It doesn't feel like torque converter shudder to me either as i can't actually feel anything in the truck, just the small noise. To me it almost sounds like it's coming from under the hood. I'm not overly worried about it right now, because it isn't effecting the way the truck drives or shifts at all, I'm just curious what it could be.
View 1 Replies
I have a new to me 05 F350 dually with 6.0. When I open the door with the key the alarm goes off and the truck won't start. How do I shut this off so I can get in the truck with the key. I can't just leave the door unlocked all the time. It has the key less entry, but I have not set new numbers yet, and if I give the keys to a valet, I don't want to give them the door code too.
View 14 Replies
Every time I apply brakes I hear a weird humming noise, as well as no stopping power. Checked fluids and pads and everything is where it should be. I heard abs can cause this but not sure on that. I know my master cylinder has a very small leak but it hasn't lost any fluids of that sort. I'm lost. I don't know where else to look.
View 2 Replies
'08 F350 6.4l 4wd, I had the truck come in with a exploded transfer case. (See pics). Ive read all about this happening to many others. The truck still drove, hubs not locked, plenty of fluid in the TC, pretty sure it was the double Cardan that did it. Anyways I replaced thwith TC, replaced the front driveshaft, filled the TC with recommended fluid. Test drove and drives great, shifts fine. Only until I turned left.
At slow speeds turning hard or 15-20 taking a turn, it sounds like a ratchet clicking from somewhere on the left side, right around the drivers door, from what I can hear from the cab. Does it in 2wd, 4wd hi/low, hubs locked or not. I changed the vacuum pump, no leaks, changed the IWE solenoid, pulled out both locking mechanisms, tightened crossmember, checked everything from the hours of research I did on the internet. I cannot find the problem. I don't know what else to check. Front axles free spin and lock when they are supposed to. I'm at the end...
View 6 Replies
Truck is an 03 F350 with the 6.0. It sometimes sounds like the shift motor on the transfer case is trying to engage. It has the vacuum system which is blocked off. Warn aftermarket hubs. Switch on the dash with 2wd, 4wd and 4 low.
It's kind of an off and on thing. Try to engage for a few or more seconds then nothing for awhile then repeat. It sounds like it's at the transfer case. It could very well be coming from firewall/engine bay area as well. Is there anything between the dash switch and the motor?
View 2 Replies
I have with my truck is when i pull into a parking lot or even my driveway on a angle the truck sounds the like the bed is loose and the body is creaking.
View 14 Replies
I have a 2001 F250 Super Duty 4x4 with the 5.4L I bought it cheap and runs well. While going through doing the stuff that needs attention I noticed the 4x4 isn't workijg. It has whatbappears to be some cheap maybe plastic locking hubs and the manual pull stick onj the floor for engaging the 4x4.I can pull it into 4H and 4L, the dash lights confirming come on but the front wheels will not lock in.
One of the cheapo hubs looks like someone clamped vice grips on it to try and turn the and doesnt seem to totally lock in. The drivers side hub sounds like it is lock in but makes a terrible lound clicking noise.
They may be the stock hubs, have no markings to designate the direction to lock and unlock and do appear to be somt sort of plastic hub.... Are the hubs my problem since I can manually pull it into 4x4 and I can see the 4x4 shaft spin but the tires are not engaging?
View 2 Replies
Long story short, I need to replace the box on my 2008 F350. Do the boxes from '14-'15 models line up? I know the fuel door is different, but is the rest the same?
View 4 Replies
I have an 08 f350, and my cab over lights are out...I've checked net for issues and they all point in different directions... Running and towing lights are fine, just cab over lights are out...is there a fuse somewhere I cant find? could one burned bulb be out and it effects all?
View 3 Replies
I have a 2003 f250 superduty v-10 -- 4x4 -- when turning with 4wheel drive disengaged I have consistent thumping sound coming from front end -- more so when turning to left but still prevalent on right turns -- I put new hubs in due to the grinding noise when driving slow to mid speeds -- like axles not totally disengaging and grinding on teeth. but this is a secondary noise -- replaced left front axle with dorman unit -- tried to replace u joints on oe axle but rusted so badly couldn't get c clips to separate from ujoints --
this one is kicking my butt and making me look like a novice -- don't think it is ball joints or anything suspension related but I could be wrong -- sounds like thump thump thump as turning in slightly tight circle or going around corner in the parking lot.
View 1 Replies
I have a 08 F350 CC with the factory fog lights. One of them has burnt out. Do I replace just the bulb or the entire unit? Is there a part number?
View 1 Replies
On my 2008 SD F350 my number 1&2 settings on the fan don't work. Only 3&4. What's the problem? How do i fix it?
View 8 Replies
I have an 08 f350 lariat with the 6.8 with 66000 miles. A month ago took it to the dealer with a plugged catilityc converter. All covered under warranty. Got the truck back, starts great when cold including 18 degrees the other morning. I drive 7 miles to work, shut it off and restart, it acts as if the starter is struggling to turn the engine over. Once it cools off, starts fine again. I took it back to dealer, they replaced the starter. No change. Took it back again, they replace battery. Cranks a little faster, but you can tell it's still struggling. It always starts, I'm just wondering how it will be when it's 80 out and in pulling my 9000lb camper....
View 14 Replies
Will a bumper off a 2008 F350 fit on my 2006 F350?
View 7 Replies
Have an 08 f350 xl and was looking to put oem foglights into the bumper where mine has the block out 's, guess what I am asking is if the wiring is already there as it was on a different vehicle I owned ,basically it was a plug and play ,have only had the truck for a week and with the hours I'm working I really haven't had a chance to crawl under and look for the wiring.
View 3 Replies
Truck is 08 f350 lariat with minor issues. Both seat heaters don't get hot. Click is heard under driver seat. Both dash lights come on. No heat. Steering wheel fan control won't turn fan up. Turns it down fine.
PO put aftermarket HID with ballasts and bulbs and factory light housings. Factory housings scatter light and they are waaayyy bright. Can't drive anywhere with out blinding someone. What aftermarket projectors will work with HID set up I already have?
View 4 Replies
2008 F350 6.4 diesel. I have the listed truck in the heading, my #9 fuse which is for the interior lighting, lighted running boards and it is a 15a fuse, keeps blowing as soon as I touch the fuse to the fuse box to replace it. I have look at all the map lights and interior lights and can not find any thing out of the ordinary, all of these light were working fine, also my cruise control and the back up sensors stopped working and they are not on the same fuse and the other components that are on the circuit with the crule and back sensors still work, I know that this is a lot of different things but hate chasing electrical ghosts...
View 3 Replies
