Ford Super Duty (1999-2016) :: 2008 F350 Braking Ability Starting To Drop Off
Jul 7, 2017
I tow 10-15K; 6-10x per month with this truck. I can feel the braking ability starting to drop off so I want to get them done pretty quick. I am more or less happy with OEM performance but if there is a better value, and with my SO starting to haul the horse trailer around.. I wouldn't mind upgrading.
What is worth the money? I'm fresh out of school trying to figure out what the best value is.
Calipers?
Rotors?
Pads?
Brake Lines?
What would provide me with a noticeable improvement without breaking the bank?
Last question, could worn rotors cause vibration/shaking in the steering (primarily when turning ramps) at 50-60mph? Tires are brand new, problem showed up before they were replaced.
View 7 Replies
Advertisement
My 2008 250 suddenly lost ability to adjust temp control of heat and A/C. I can adjust the fan speed and the defrost/dash vents/foot heater position controls, but no matter how far I turn the cold/hot dial left or right, the temp is the same. Even in the Max and Norm A/C setting, it's the same temp, which is stuck in the hot range.
View 10 Replies
I've noticed that my 06 f350 will pump the ABS when pulling in muddy spots, mostly in 4x4? It will even start to cook the pads after a bit of spinning. I'm not doing any serious off-road stuff, just trying to pull random farm equipment/trailers. Do these trucks have some sort of traction control that I don't know about or dose my ABS think I have my foot on the brake all the time?
View 9 Replies
I'm having trouble finding the source of a vibration in the front end if my 1999 f350 super duty 4x4. The vibration is felt all the time but worse when under 40mph, while braking, and especially when turning.
I have replaced the rotors and brakes, tie rods and Drag links since the issue started but no change. In the vibration. What should I check next?
View 4 Replies
I have a 99 F250 5.4l 4x4 Super Duty that just all of a sudden stopped going over 30mph. I was traveling down the highway at 70mph and all of a sudden the truck acted as if it were in neutral and started revving up. i let off the gas and the problem stopped. i went to pass someone and it occurred again. I slowed down to 65mph and a couple minutes later it did it again. I wasn't too far from home so i drove it there. By the time i got around the corner I had the truck in second gear to prevent me from going over 25mph. i allowed the truck to rest and then checked the transmission fluid and everything looked good. There was a slight squeak that had just started and appeared to be coming from the drive shaft. I am mechanically inclined but new to working on vehicles..
View 7 Replies
It's a 2001 F-350 Crew cab short bed. Got it from the second owner which had a large file from the original owner on documentation and maintenance records. Truck has 280k, tranny about 80k. Question I have is, I kinda thought it would "feel" more powerful then it does. Temp got to about 35f last night after work and it cranked for about 15-20 sec before it started (yes I let the "Wait to start" light go out).
Then pulling out of work it would hardly get out of its own way. Does this sound normal? When it is warmed up it goes ok, but still I figured when the turbo winds up it would feel a bit "peppier". I get its a diesel and not a hot rod but I was expecting a bit more pep.
MODS on the truck that I can tell: AFE cold intake, 5"? exhaust turbo back, about 4" lift. Stock PCM. In cab controlled rear air bags, nice deck with back up camera.
View 6 Replies
I have a F350 with a V10 Triton motor. It has 186,000 miles on it. I have difficulty in starting it after it has sat for a few days. Typically I have to turn the switch off and on multiple times but it will eventually start. Once it has started it runs and starts fine if it has not sat for any long period of time.
I connected a pressure gauge to the schrader valve. Initially when the key was turned on there was no pressure. While the engine was turning over it was about 30 psi. When the engine started it remained at 30 psi. Ran the engine at 4,000 rpm and the pressure remained about 28 psi. Shut the engine off and turned the key back on the pressure showed 20 psi and remained there.
I'm thinking maybe the problem is with the fuel pressure regulator but can seem to find it. I've spent multiple hours searching online for the location of the Pressure Regulator but no luck.
View 6 Replies
I own a 1999 F350 with a 7.3 diesel engine, every time I drive it, it will start once then it won't start again for hours. At first I thought the starter was getting hot because of the exhaust is too close to it but I tested the wires going to the starter and i am not getting power to the starter when this happens. When it started doing this, it would only act up if it was above 80 degrees outside. Now it makes no difference. I have replaced the Valve cover gaskets, glow plug solenoid, and starter solenoid.
View 3 Replies
First off I want to say I love my 11 f350 6.3 srw she's a awesome truck. I pull a small 7x14 trailer for my biz..
(3600-400) is the usually weight, I always use my tow feature. One day last week I start out hit my button in go, but I notice the engine braking/down shifting wasn't working. The trans still shifts smooth n normal the light is on the dash but no tow engage.
I check the transmission wire plug to make sure it'd getting a good connection, it does. I take the rubber boot off next to the shifter look at those wires they look ok not pinch or nothing, so I'm stumped.
View 6 Replies
I have an 03 F350 4x4 dually. Was pulling hard left at low speed when braking (front). Replaced pads, calipers, rotors, hoses and tires. Still the same problem. You can feel the abs activate right before it almost locks up the left front brake (basically will pull the steering wheel out of my hand). BTW the abs light does not come on.
View 2 Replies
2002 F350 5.4 . I did some plowing today, truck ran Great, but noticed the Auto Shifter starting to get some play in it, 185 k on it. I recall reading about how to tighten it back up.
View 3 Replies
My 2011 f-350 6.2l cold starts hard, it cranks through 2 cycles sometimes before it fires, then it might stall. Sometimes it stalls if I put it into drive or reverse before its warmed up. It has also misfired on one or several cylinders during startup. It has also misfired while driving. It has never stalled when driving. I have replaced the canister purge valve, I have done a full tune up with all factory plugs. All with no change to how it starts. My next step is a Pcv valve, I have one coming from ford today.
View 5 Replies
2005 F350 crew cab with 6.0 currently cranks but no start with a P2291 error code. Using scanguage 2 it shows icp 0, IPR 67.7, FICM 47.5 while cranking. Disconnected ICP and still no start. removed icp and hooked up air and I do not hear/see any signs of air leaking. When I disconnect the air it then whooshes out. About 2 months ago got a #1 cylinder contribution error code and changed out that injector and it has ran fine up until this issue.
Can this be a IPR? I am leading towards the HPOP, but as it costs a pretty penny would really love to make sure I tried every other avenue.
I have 197K on it, and 2 years ago did a EGR cooler delete. In May this year replaced the oil cooler, and then in August changed out the #1 fuel injector.
Oil cooler screen was broken. Cleaned the entire reservoir out. Could this just be a clogged IPR? or seeing the change while cranking an indication that it is working?
View 1 Replies
I have an 08 F-250 CC SB 4x4 Diesel truck that has since new clunked when starting out from a stop and/or coming to a stop. I have 16k on it now and am getting really tired of dealing with it... The clunk starting is when I let off the brake and just apply the throttle. It feels like something slips and then clunk.
The clunk when stopping is the same as starting, except when coming to a stop.This is unloaded or when loaded w/ cargo and/or trailers. I know I can go to the dealer, but I don't want to un-spartan my truck for this...
View 14 Replies
Long story short, I need to replace the box on my 2008 F350. Do the boxes from '14-'15 models line up? I know the fuel door is different, but is the rest the same?
View 4 Replies
I have an 08 f350, and my cab over lights are out...I've checked net for issues and they all point in different directions... Running and towing lights are fine, just cab over lights are out...is there a fuse somewhere I cant find? could one burned bulb be out and it effects all?
View 3 Replies
I have a 2006 f-350 6.0 and i went to fill up my truck with diesel. After that the truck did not start. Currently has the code p2285 - injector control pressure sensor circuit low. I tried disconnecting sensor, still no start.
I have the torque pro app and another 6.0 that I use for comparison. Check power at ficm 48 volt, flp 11.5v, FVP 11.5v. Hpop while cranking shows 1400 psi. removed oil filter and see low pressure oil ok, fills up reservoir. ipr at crank about 65%. fuel filter full of fuel.
Replaced the dummy plug on passenger side because originally hpop was very low psi 12. after replacement it went up to 1400 on cranking. What should I be looking at next, should I be removing ipr? should i be looking at crank sensor or cam sensor? Just installed 2 new batteries also because my dad kept cranking the truck until it died.
Checked to make sure fuel cut off relay not triggered, Ok. The truck has been having long cranks before it died. Also right now the injector cycling is 10 seconds long while on my other 6.0 it is about 4.
View 14 Replies
2008 F250 Crew Cab 5.4, 79K miles, had new brake pads installed at 40K miles. Recently, I noticed front end shudder and some pedal pulsation while braking. It started kind of sudden. My first thought was a warped rotor.
When I took things apart, I found passenger side front rotor was cracked and the caliper pistons were rusted and falling apart, the old pads were only worn about half way. My thoughts on a bad rotor were confirmed, and then some.
I replaced the broken caliper, both front rotors, installed new pads on all four wheels, and bled the brakes. To my surprise, the brake shuddering did not go away. I'm stumped.
View 10 Replies
I have a 08 F350 CC with the factory fog lights. One of them has burnt out. Do I replace just the bulb or the entire unit? Is there a part number?
View 1 Replies
On my 2008 SD F350 my number 1&2 settings on the fan don't work. Only 3&4. What's the problem? How do i fix it?
View 8 Replies
I have an 08 f350 lariat with the 6.8 with 66000 miles. A month ago took it to the dealer with a plugged catilityc converter. All covered under warranty. Got the truck back, starts great when cold including 18 degrees the other morning. I drive 7 miles to work, shut it off and restart, it acts as if the starter is struggling to turn the engine over. Once it cools off, starts fine again. I took it back to dealer, they replaced the starter. No change. Took it back again, they replace battery. Cranks a little faster, but you can tell it's still struggling. It always starts, I'm just wondering how it will be when it's 80 out and in pulling my 9000lb camper....
View 14 Replies
