Ford Super Duty (1999-2016) :: 2008 F250 - Parking Brake Adjustment?
Aug 19, 2017
How do I adjust the parking brake on my 08 F250? It's not holding when my truck is parked on a hill.
View 1 RepliesHow do I adjust the parking brake on my 08 F250? It's not holding when my truck is parked on a hill.
View 1 RepliesThe problem is I haven't seen one for a recent (2011+) SD. I don't see anything that resembles a rear drum. They look like 2 huge regular disc brakes.
I live on a hill. My old man taught me to put the trans in neutral, autos and manuals, put the ebrake on and make sure it holds the vehicle, then put the trans into park or 1st gear. This way the weight of the vehicle doesn't rest on the transmission.
How do I adjust the Ebrake? It's ALMOST holding the truck, just needs a minor tweak. I don't see the dust cover the write ups described at all. The one that reveals the Star Wheel. Are they different on these years then prior SD's?
Are the parking brakes on rear disks adjustable at all? Mine doesn't hold very well anymore, but I'm not quite ready to rebuild the whole thing. If there are adjusters (similar to drums), which way you turn them on which side of the truck?
View 6 RepliesI have a f250 super duty. I blew a brake line the main going to the rear. So the genius that I am I replaced the line an simple enough I decide hell why not replace the master cylinder too, so I did an I bleed the brakes an everything works jst fine but now the the brake light won't turn off I have tried everything not sure what could possibly cause the light to stay on. I will eliminate some suggestions, I bleed the brakes, the brake fluid is full, the level sensor is completely attached, the parking brake is not on, I pulled the parking brake completely out, even completely disconnected the sensor thinking it would turn off bu it didn't.
View 1 RepliesParking brake light stays doesn't come on when the parking brake is engaged. The light DOES come on when starting the vehicle and the gauge cluster cycles through its start up procedure. Couldn't find a fuse that would fix my issue...does one exist?
Truck is an '02 F250 w/ 7.3TD and 6 speed manual.
I'm re-doing the parking brake as part of a rear brake job on my 2009 F250. I need to disconnect the intermediate brake cable at the equalizer, but am having trouble. I've got slack in the cable, but can't push hard enough to get the swaged cable end to move within the connector that's between the equalizer cable and the intermediate cable.
Is there a special tool or some trick to this? If push comes to shove, I can cut the connector (assuming I can get a replacement), but would rather not.
Also, any particular trick to disconnecting the cable to the parking brake lever at the wheel? With that huge spring between the cable bracket and the end of the lever, I haven't been able to move the cable end enough to disconnect it from the lever. Since I don't have the intermediate cable disconnected, could that have something to do with it?
Parking brake lever for the park brake on my 2001 F250 srw. Both are rusted up but im having trouble finding the part.
View 1 RepliesI have a 08 f250, my abs is giving me nothing but problems, always have, have any of you's ever ran new brake line and by passed the abs?
View 2 RepliesI have a 99 f-350 , which i bought recently and either the calibers are froze up in the rear or the cable looks too tight.. Is there any adjustment.... Every place i looked it seems to be none..... on my old 1988. Icould adjust it where the 2 rear cables joined the 1.... Am I missing something or cut the 1 main cable and add a turn buckle....
View 14 RepliesI have a 2008 f-250 6.4 Diesel. Yesterday the Brake Fluid light came on. I thought maybe a sensor, but once I parked and checked I realized my brake fluid was down to the Min line. I started looking for a leak and it was apparent that it was the front drivers wheel area.
I am attaching a picture of the brake. The leak is either coming from the area where the fluid line runs into the gold thing (caliper?) or the bolt at the bottom of the gold thing.
My 2008 ford f250 SD Powerstroke has a bad front passenger side brake rub/ dragging after offroading before off roading just rubbed a little now it drags a lot. what do i need to fix.
View 2 RepliesMy 2016 f250 Lariat 6.2 4x4.. Question.. There's some sort of tapping noise that comes from underneath the under carriage like around exhaust area it seems.It's like a tapping sound the truck makes once its turned off. Does it about 6 times every 2 to 3 minutes.. Cant pin point the noise.
View 8 RepliesMy truck doesn't want to go grab parking!! The shifter has a lot of play, Every time I go to park my truck I have to forcefully hold the shifter up into parking so it can grab. I had times when the shifter its in parking and it will still move, like I've gotten out and pushed it and it moves.
View 1 RepliesThe '99 F250 has the parking brake release under the dash, way down low. While I was in the wrecking yard, I noticed many Excursions and Econolines have them on the left, by the parking brake. Whether one of those might work, if I installed it on my '99?
View 3 RepliesHow to replace the parking brake cable from the pedal down to the connector on the frame? We got a 2000 F350 in the shop with a bad cable, and i never did one. And I don't really want to mess this thing up trying to figure out how to change it.
View 6 RepliesWhen I parked my truck at work this morning, I pushed the parking brake pedal down like always, but it popped back up. I didn't pop all the way back up, it stayed down about 1/4 of the way. Several tries yielded the same results.
Since I'm at work, I didn't have any time to crawl under there are investigate. I'll do so tonight when I get home, or maybe tomorrow. Kinda sounds like the locking "teeth" mechanism may be misaligned?? Since it doesn't come all the way back up, I'm hoping the mechanism isn't totally broken.
When I hook a trailer to my '04 F-250 the parking lights stay on. The lights on the truck are not on. I pulled the fuse for the towing lights and they will go out. Pulled what I believe to be the relay according to the owners manual and they still stay on. I have to unplug the trailer every time I stop for any period of time.
View 3 RepliesMy 2011 F250 has no front or rear running lights working, mirror side marker lights not working and fog lights not working. I have checked all fuses including 30amp trailer light fuse and they are good. The fuses in the passenger kick panel are not getting energized.
I replaced the switch with a friends from same truck and no luck there. The headlights, dash lights and turn signals work fine. Here's the kicker, when I back feed 12V to the yellow/blue wire at front running light it turns them all on, including mirror lights. I've switched out relays in the box under hood and that didn't work.
When I pull the switch on dash to turn on the fog lights the indicator in the switch doesn't work either, they are both listed on the same fuse but as I said, the fuses have continuity across the blades but when I test the socket there is no voltage going to them. I have not connected a trailer to see if those are out yet but will do today.
I'm working on an '05 F350 King Ranch dually, and I'm pretty sure the pb cable is stretched. I recently replaced the shoes in the pb assembly and adjusted the tension while I was in there, but it still barely holds. My next culprit sounds like a stretched cable, and I have a complete set for a new one, but I'm having a hell of a time getting the old one out. The link that holds the front and intermediate cables together won't pry open with any tool I have, and I've broken two drill bits trying to drill out the nub holding the front cable in.
View 5 RepliesWill leaving the parking brake on burn up the axle seals? My parking brake isn't working well at the moment. I need new ones from all the fluid my bad seals leaked on them. So, at the moment they just scrub a bit while its engaged. However, today I found out that my parking brake light for one reason or another is not working and I got in a hurry and didn't release the brake. by the time I got to where I was headed (about 15 miles), I could smell gear fluid burning and my driver side rear was smoking. I'm hoping its the fluid that was already soaked into the shoes. I did find a drop of fluid on the bottom of my brake caliper.
View 5 RepliesThe parking brake audible warning is going off along with the parking brake light. I tried disengaging the brake multiple times and it went off once, however now it will not go off. I found some older pictures of a switch on the arm that swings with your foot when you engage the brake, but I can't find it on my 2004.
Is there a switch down there that needs to be kicked, contacts cleaned or replaced? I checked the fluid level and vacuum hoses and do not see anything obvious.