Pump works fine. Replaced pvh. Won't go into 4wd hi or lo no matter what I try. Even with them in lock. How do I know if hubs need replaced or just hub locks?
View 2 RepliesI have a 2001 F250 4x4 and the ESOF switch not engaging hubs, currently I have no 4x4 lights coming on in the cluster when i turn the switch. I am not experiencing any of the vaccum symptoms that most people are suggesting. I When I turn the switch i also do not hear any relays clicking. Relays have been tested, and i waited for the 45 second transfer delay that the manual mentions. ESOF switch has power, and is working properly (I know because I bought a new one in attempt to fix the problem) Basically I have no responses from any of my 4x4 indicators or parts.
View 14 RepliesI have a 2000 f250 CCSB 4x4 with the ESOF auto hubs. The auto hubs won't engage automatically. They work fine manually. The transfer case is engaging and correct lights are coming on. There is a little bit of vacuum coming from the vacuum switch but it doesn't seem like much to me. All the dash HVAC controls work fine though. I Lubed and cleaned inside the hubs according to Guzzles directions.
While torn down, I blew through the vacuum port on the outside of the hub and there was little to no restriction. I don't think there is enough vacuum to pull the hubs, but is that possible if all the dash controls work fine? What pressure should it take to engage them? My next step is to pick up a vacuum pump and see if I can engage them with it.
Yesterday I was parked on an incline with my front wheels on gravel and the rear wheels on wet grass/mud. When I tried to go, the rear wheels started spinning. I then switched on the low 4x4, and tried to go. The rear wheels continued to spin, but the front did not turn. I had new wheels installed, that has a cap that covers the manual locking hub, so I couldn't turn it to lock the hub. What should I look for to fix the problem?
2007 F250 4X4 Larriat SRW
Seems recently my 2008 f250 diesel wants to go into 4wd all by itself. It's the electric switch on dash with the auto/lock front hubs. I'm thinking either the dash switch or the accuator motor. Where to start though... Also I can turn the switch to 4 wheel high and it doesn't go in.
View 1 RepliesSo my dad just bought a 2008 f250 xl with a single cd head unit and mp3 hookup. When you press the aux button on the head unit, it displays ' no aux audio". We have tried unplugging the radio and plugging it back in for a few minutes, but that has not worked .. Any way to get the aux input to work?
View 6 RepliesI just got a 2008 Ford F250 PSD 6.4L and there is an oil leak that seems to be coming from somewhere in-between the front oil pan and the oil pan closer to the back. Where this is leaking from and how to fix it.
View 3 RepliesI have a 2008 f-250 4x4 extended cab, I picked up a set of black rock steel wheels 17x9. I now have 265 70 17s on my truck. will these wheels work and with what size tires.
View 4 RepliesLast few months my 08 F250 has been slow going up hills. The fluid checks out ok and it shifts fine.
It just seems to take forever to get up hills. Has 124K....
Also has a huge hissing noise thats RPM dependent on the passenger side. Will make the sound in neutral just revving.
I been having a issue with my truck lately. It's a 2008 with only 88,000 miles. When doing 55mph it feels like the transmission is slipping. Sometimes it will do it over and over. If I speed up to about 60mph it goes away.its has gotten worse in the last month or so. Hoping it's nothing major.
View 6 Replies6.4 diesel 2008 F250.... I have been having lots of trouble with low power and sputtering of this diesel truck . It almost seems like a fuel filter but I changed them out 2 times now and the same thing keeps happening . It has been a very cold winter here and if there was any water - it would freeze.
If I am going down the highway and it starts to sputter. I put transmission into neutral and shut motor off with key. Start it up and it's good for less than a minute or two and it's back to sputtering.
I have a 2008 F250 that the tailgate has always been real easy to open and close until the other day I could not get it to latch so i slammed it and it did latch and it worked a few days but now it won't latch at all. I can open and close the latch with the tailgate down but nothing I do will make it latch in place. I've tried spraying with PB blaster it didn't work. Not sure if its out of adjustment or what.
View 2 RepliesMy Ford 250 is currently stuck in park, it starts but I can't move the shifter. It sounds like it is a fuse issue from what I have read, but I bought the truck at an auction and I don't have a book. Do the brake or parking brake fuse? And where is it located? I know there is a panel under the hood and under the dash, which fuse to look for. It's a 2008 extended cab gas model.
View 13 RepliesHow to disassemble the dashboard on my 2008 F250 FX4? I removed the few screws I could find. But most of the panels seems to be stuck behind the central panel (where the radio and A/C controls are). For the life of me I can't figure how to take it apart.
View 10 RepliesI am trying to replace the ball joint on my 2008 f-250. Does the hub assembly come off of the knuckle or do you remove the whole knuckle and hub assembly together? If you have to remove the hub assembly what is the best way?
View 14 RepliesI believe my brakes have a problem.
Lately, I can stomp on my brakes @ 50 mph and they won't trigger the abs or come close to skidding the tires. The peddle goes to the floor if I push hard enough and the truck doesn't seem to stop fast like it used to.
I'm wondering if there is an issue I should be focusing on, like swelling brake lines or some issue you may know of. I'll try bleeding the brakes this coming weekend, but i think its going to be a bad brake line or something.
My 2008 F250 Super Duty is riding very, very rough. I put in new heavy duty Bilstien shocks 2 or 3 years ago, and I would think they would last longer than this.
Are they any other causes I can look at to see what is causing this truck to ride rough?
I have a 2008 Ford F250 with 6.4. Having alot of problems with the 4X4. Went to put the truck in 4 wheel drive one day and noticed the light on the dash never came on to engage 4X4. Of course we had a big snow storm coming and I didn't have 4 wheel drive. I drove the truck across town and decided to just try 4x4 again and it worked that time. I got the light on the dash and could hear the transfer case shift motor engage. Came out a little later and tried it and it wasn't working again. Took truck to shop where they replaced transfer case shift motor with a remaned motor from oriellys.
4x4 worked for a few weeks then just started doing the same thing again. We thought maybe that motor had problems also so had it replaced too. Truck is still doing the same stuff. Sometimes it works sometimes it doesn't. Figured out that if its not working and I leave it in 4x4 and unhook power to shift motor then plug it back in it will engage 4x4. I've seen some post on here but sounds like everyone i've seen their motor just stops and doesn't work at all.
I have 08 f250 6.4 was driving down the road truck just died. Will turn over but not crank. I've checked oil level, water level, fuses, fuel cut off switch. Still no start.
View 3 RepliesBasically I have a 2008 f250 (6.4l if that makes any difference) That wont engage into 4x4. When you go to turn the switch to engage the 4x4 all you get is a click click click click click. Is that a problem with the 4x4 shifting solenoid on the transfer case? Anything else to look for? The truck has 95k miles on it....
View 2 RepliesMy abs light is constantly on, is it a sensor?
2008 F250, 5.4 l, 4wd .....