The blower motor went out on my 2008 F-350,? I can't for the life of me figure out how to get it out. Do I have to remove the dash? I am positive it is fried, I ran a hot wire straight to the motor and it still wouldn't come on.
View 2 RepliesMy Blower motor is intermittently going on and off. After messing with it for a while it seems to stay on. Motor may be going out. Not real easy to change the blower motor on this 2008. Haynes manual says to take the 2008 and up trucks to the dealer.
2008 F250 4DR 5.4L
My A/C, vent fan (blower motor) keeps going in and out. Does not do it all the time, but when it goes out, it will come back on after a few moments, but will not run full speed. If you try to adjust the speed, it just cuts off again. What is causing this.
View 7 Repliesmy blower keeps blowing even when i turn off the system, it does stop when the motor is off but comes back on once i start the truck...relay is fine.
View 6 Replies2012 F350 Lariat 6.7
The blower motor has quit. All fuses relays etc appeared to be ok. So I tested the connector going into the motor, I saw 13.9 volts so assumed it was a bad motor.
After removing the motor I bench tested it by connecting 12volts to one side of the connector and negative to the other. It spun up.
I re-tested the motor supply connector in the vehicle, it has 13.9 volts on the yellow wire, and 4.44 on the other. I adjusted the fan speed on the climate control, although the fan images on the display increased, there was no change to the voltages on either line.
I used the 13.9v connection on the positive terminal and a ground on the negative, the motor spins.
Is there a method for accessing codes that will display what is causing this failure?
So why do I have 4.44 volts at what should be a ground? Is this a bad resistor or is the climate control euchred.
Have a 2004 F-250 and blower motor speed 3 is not working..replaced resistor pack with Motorcraft part and everything works except position 3 ....
View 6 RepliesLike the title says; I have a 2001 F350 with No blower Motor and Just Defrost, it is actually a friends, he is building a fence, and I am looking into the truck problem. The just defrost is probably a vacuum issue, but I do not have any book for this truck, so I have no vacuum or wiring diagrams. As far as the blower motor, I am thinking switch or motor, fuse has been checked? Is there any other "control" box involved with this year/model? Also any dash tear-out instructions, to make the access easier?
View 1 RepliesCurrently My AC / Heat blower motor operates but, speed 1 and 2 are the same, 3 and 4 are fine. I replaced the blower rheostat that is located on the firewall, but still no difference in fan speed.. A few years ago the blower only operated on Hi and the rheostat was the problem then.
View 3 RepliesI have a 2003 super duty V10 4WD super cab long bed.
loud deep rumble noise when turn on the blower. both heat and a/c. removed the blower and seemed to turn ok. blew out all vents. removed heater radiator cover, checked most flaps to see if working. doesn't seem to be obstruction invent. the flap behind blower clear and functioning ok.
When on second speed, almost sounds like blower motor is out of balance. if run on high for 1 minute, smell electrical burning! Think to replace motor will work? will post another issue with radio and power windows
I have and 07 F250 and the #2 speed for the blower motor don't work (hasn't since I bought it) I read that the most common cause of this is the resistor under the hood on the firewall so I replaced that and still no 2nd speed??? Where I look next? Motor itself maybe?
View 11 Replies2001 f350 blower motor for (A/C - Heater) works sometimes and sometimes does not.
View 5 RepliesMy HVAC blower motor stopped today while the wife was driving the F250. I thought I should swap relays (with the heated mirror relay - same Ford Part Number) to rule it out or identify it as the culprit. However, since these are close to the firewall, I have a hard time getting the grip and leverage to pull the relay out of the Battery Junction Box (BJB). How to make this a bit easier?
View 5 RepliesOnly 2 speeds of the 4 speeds are working on my blower. I was thinking it may be the switch, but someone at the shop told me to replace the blower resistor first. I did that and still only have 2 speeds. Im guessing I need to replace the switch now?
Also, I am having problems with my heat adjustment. I have it set to warm (half way between cold and hot) and out of the blue it will start blowing hot. I turn it down all the way to cold until it blows cold air and turn it back to warm, and it will be fine for a few minutes and start blowing hot again. Vacuum problem? blend door problem? How would I go about trouble shooting this problem?
Ok, I have had this problem a couple of times before, generally when it is wet and cold outside and the result is a very dead battery. The heat/ac blower fan continues to run after the truck has been shut off and the key removed. I believe that it even comes on after the truck has been shut off. What could be causing this?
View 14 Replies15 f350 gas xlt with 8.6 Western proplus straight blade. I noticed that while only applying throttle and fully angling the plow ,the hvac system turns off and then on again and the dashboard lights also turn off with the message system also going blank. I've brought it back to the body builder, twice, that installed it and they don't acknowledge a problem. The only answer I got was it's probably a bad battery. The funny part is you can angle it all day while it idles but as soon as you apply throttle and fully angle it left or right it cause the loss of power to certain accessories. When it does this it also causes a relay to click under the dash panel on the drivers side .
View 8 RepliesI have a 2000 F250 and the blower motor stopped working, the a/c clutch locks in but the blower will not run. I back tracked and I have no power at the motor or the resistors, or the speed switch. There has to be a relay that is turned on by the a/c selector to power the blower circuit. I guess my question is need a schematic of the a/c circuits? Or the location of the relay?
View 7 RepliesMy blower assembly (not at the blower but in the box below it) is filling up with water. Any way to look into besides drilling a hole in the bottom of the box?
View 1 RepliesMy blower doesn't seem to blow very hard. I've been in other fords and the ac and heat blows great. Someone suggested that that I pull the fan motor and clean the blades.
View 4 RepliesMy 2002 Super Duty blower makes a gargling sound when I turn it past the lowest level. Why?
View 2 RepliesMy 2001 f350 a/c blower works better on a/c compared to max a/c . When I turn the selector to max a/c it makes more of a blowing noise but less air blows out of the vents though. When I select plain a/c it makes less noise but blows more air out of the vents. What is wrong and how to go about fixing it is 93 here today and won't get much cooler over the summer months .
View 5 RepliesI have an '03 F250 and the second position of the blower switch doesn't work. The first, third, and fourth are all fine.
I bought a Motorcraft YH-1670 blower switch, but can't figure out where it's located?
I looked behind the glove box, but didn't see it there. I did not remove the screws to the cover behind the glove box because I wanted to first confirm where the switch is located.