Ford Super Duty (1999-2016) :: 2008 - All Door Stopped Working - SJB?
Sep 5, 2016
All my door locks stopped working in my 2008 F250 Crew Fx4. Locks do not work from a driver or pass. door, key fob, or door keyless pad. When you hit any of the switches you can hear a relay type sound in the SJB.
There was some sort of failure because we could smell it. But I am not sure if it was the SJB that failed or a wire between the SJB and the lock motors.
Looking for a wiring diagram of the door lock circuit? And/or know how to troubleshoot to find the bad wire or if it is the SJB that failed.
View 6 Replies
Advertisement
My door locks stopped working new battery in fob, I can hear them trying to work. 2000 f250 crew cab .....
View 3 Replies
My father-in-law has a 2008 f-250 with the 5.4. as he was driving a while back all the gauges of the dash quit. The engine still kept running without any noticeable difference but when he shut the engine off and tried to restart, it wouldn't even crank but the security light was flashing. He tried starting it again a few hours later and it started just like normal and ran fine.
He has had this problem occur several times in the last few months, but the other day it repeated the problem again and would not restart for about 5 days. He has tried charging the batteries, changing relays, checking all fuses and finding none blown, scanned it with his code reader, and checked the steering column for bare or rubbed wires.
View 10 Replies
My heater stopped working.
View 9 Replies
Troubleshooting a problem with friend's 2000 F250. His power windows aren't working and are causing problems with his door locks and interior lights. When he tries to use his drivers side power window, his power door locks quit working. If he puts the switch to raise, the interior lights flash. From what I've read, it sounds like the GEM to me, we've inspected the wiring and it all looks good. I pulled it out today and it looks good inside, no sign of water leaks on it. If it is the gem, how much do they cost and do they require programming?
View 5 Replies
Last week I noticed my fogs stopped working. So I figured there may be a chance that they were burnt out. Hooked them straight to a battery and they work. Next I checked power at the plugs and no power. Checked the fuse and blown. The only fuse I had on me was a 25 amp fuse. Big mistake. Smoke started coming from the fuse box (palm to the forehead). Well it didn't blow the fuse but still nothing. I got power at the headlight switch and started tracing wires. From what I had read there is relay but it is inside the fuse box? Is this correct. I'm trying to pin point where the problem lies. There aren't any burnt up wires behind the fuse box and now I'm at a loss.
View 7 Replies
Ok I've done some searching and reading and really haven't found a answer. My 99 f250 sd 4x4 v10 with a automatic transmission stock hubs with ESOF. I checked the fuses under steering wheel. All good. Showing no error codes. Replaced vacuum lines. I've been driving it for some time only using the lock outs on the hub. Whats different is there is no light on dash stating 2wd, 4wd or low. And when manually locked they don't move in snow. new hubs? I don't really care about switching with ESOF I just need 4WD for plowing!
View 11 Replies
The 4wd on my 2000 f350 has just stopped working? I have used it a few times since getting it a few months ago and then last night I was going to play paintball in the woods and the 4wd would not engage? when i put it in 4wd it would act like the truck is in neutral and then it lurched forward? The front hubs have the option on them to turn, but I never had to turn them before and they do not move when I tried to? What could be causing the 4wd not to function?
View 4 Replies
I have a 2013 F350 Lariat. Recently, the backup camera has stopped working about 1/3rd of the time. When it doesn't work, a yellow triangle icon appears on the screen with " Camera unavailable. See dealer." The dealer has checked it, twice, and is unable to locate the problem.
View 13 Replies
My truck is a 2011 F-250 6.7L. It's at 91,000 miles, and I have the PremiumCare extended warranty.
About 3 weeks ago (1,000 miles ago) I took my truck in for an A/C problem. The A/C quit blowing cold air. They diagnosed the problem as something inside the dashboard was broken and they needed to completely remove the dashboard to fix it. The repair worked, A/C was back, and I was good to go.
Last week my Satellite Radio and Navigation stopped working. I was getting a "NO GPS" message on the navigation screen and an error on the Satellite Radio screen saying something to the extent of there was no connection with the satellite antenna. I wasn't sure if something failed or if the dealership screwed something up during the A/C repair.
I booked an appointment and took my truck into the dealer that's 50 miles away from my house. The dealer took the truck, put me in a rental, and I came home. As soon as I got home I got a phone call from the dealer saying a cable had to be replaced and they were taking care of the parts and labor. When I asked him what caused this cable to fail (was it a defect, or was it damaged during the A/C repair), he said he didn't know. But, I'd need to pay for the rental car for the day and that they would make me another appointment to do the installation. At that point I asked the service adviser to have their manager call me ASAP. Two hours later I still haven't gotten a call.
Am I wrong to think that it's not fair that I pay for this rental car? My thinking is if it's defective it should be replaced and I should be put in a rental in the meantime. I paid additional for the rental car coverage to include any repairs and the first day of the repairs... but If it's the dealer's screw up, they should be bending over backwards trying to correct the issue and at least pay for the rental car for the day...
View 8 Replies
2001 F250 SD 7.3 PSD Was doing a trailer towing road trip too and from Montana. On the way back the cruise control stopped working. Checked fuse #28. Looked fine. Attempted to do a self test on the cruise control. Holding the OFF button did nothing. Never went into diagnostic mode. Button ? A different fuse?
View 14 Replies
2012 f250, fog lights stopped working and tried fixing yesterday. I'm getting 12.8v at the plug but as soon as you plug the light in it goes to 0. Ran a new ground from frame and the hot from plug and still nothing. High beams off, truck running and switch pulled out. Bulb is fine, hooked it straight to battery and it comes on. I though it was a faulty ground but by running a separate ground and still nothing. I'm at a lose.
View 2 Replies
How do you fix the anti theft light on your truck? Mine stopped working. Where to start with them?
View 2 Replies
Vehicle: 2002 f250 xlt 7.3 powerstroke reg. Cab
Issue: door ajar light stays on, power locks on driver and passenger door don't work, radio stays on after truck is off an door is opened.
Events leading up to issue: went to temporarily hook up a wolo dixie horn to see if it worked. Wanted to do it fast so I took + cable, tied one end to the battery terminal and then connected other end to dixie horn relay. I then grounded both negative wires to the truck. One ground on the frame the other I temporarily wrapped around a one of factory ground mounts under the dash. Immediately after doing this the problems stated above started.
How can I fix this. I need to fix this by tomorrow. I have a guy from Craigslist coming to look at the truck. Now the 4x4 issue.
Truck has zf6 manual and the electric 4wd select ****. Just thought I'd list this if it was needed to be known for solutions.
4x4 high light stays on in while 2wd all the time. 4 low will stay on after switching back to 4 high and 2wd but it goes out if I ether stop the truck shut it off then restart it. or back up and slam on the brakes. Also when in 4 high the front driveshaft won't spin. However It will spin when in 4 low.
Another random issue I'd thought I'd just list while I'm writing this.... Cruise control does not work. And when I press the "on" button and the "coast" button at the same time the horn honks.
View 3 Replies
I have a 1999 Super Duty 5.4l Manual transmission 4x4 105,000 miles the cruise control stopped working a month ago, I didn't think much of it because I frankly don't use cruise as this vehicle is usually used to tow and I don't run cruise towing.
Long story short I went to tow my camp trailer and noticed my brake controller was not actuating the trailer brakes when I braked, the controller is showing connected and when I manually actuate the controller its working, so I knew I had a brake light issue, I checked the brakes and sure enough I have no functioning brake lights.
I bought a Motorcraft OEM brake pedal switch and replaced it to no avail,I have also checked the applicable fuses they are fine. I have a master cylinder cruise control switch to change but have my doubts this is the issue since the brake lights and cruise are non functional.
View 3 Replies
I have an F-250 diesel 2004 and about six months ago it started acting really crazy. Basically most all of the dashboard electronics stopped working like the speedometer , odometer, gauges, etc. additionally all of the interior lights, and the radio stopped working. Now it looks a lot like the attached picture when I'm driving the truck. All of the lights are lit up on the dash panel but nothing actually works. I thought at first that a bunch of fuses might be blown but I have replaced nearly every fuse that has anything to do with any of the affected systems. What the issue might be.
View 11 Replies
I have a 2002 f250 4x4 this snow plowing truck and going to be a pain if i cant figure this out before winter sets in. number 34 fuse (10amp) blows when replaced. cruise stopped working and can not get into gear from park after starting but turn ignition switch to 1 click forward and put into nuetral then start and go on about my business? Cruise recall completed in 06, brake lights work horn works.....
View 7 Replies
I have a 1999 f250 7.3 ... l extended cab 4x4 super duty ... ABS light on, over drive light flashing and speedometer has stopped working .. I have replaced abs senor on the rear of transmission and on the rear end.both new and just replaced abs module just the computer not the pump that was used . And abs light, overdrive light are still on and the speedometer is still not working ..
View 14 Replies
I have a 2003 F250, 4x4, 5.4L and today my fuel gauge stopped working. I don't know if it had anything to do with a stall, I was on an exit ramp and the truck cut off, I quickly restarted and no issues after that. Other than the fuel gauge not working at this point.
I looked at the fuse panel diagram and there is no fuse for just the fuel gauge. The only thing I see is #35, instrument cluster. The rest of my instruments are working, so what else would cause the fuel gauge to stop working? It had a little over a half of a tank before the stall, after the stall it went down to less than half. I filled up shortly later and it's just stuck at less than half.
View 1 Replies
A buddy of mine has a 99 F250, and the 4WD stopped working. The 4wd light in the dash does not turn on with the key with the rest of the lights. There is a Low Range light that does turn on. He took it to a shop/dealership and they said the vacuum was good. They also swapped in a different GEM module, which didn't change anything.
I swapped the relays under the hood - no change. I keep reading that there is a two wire plug on the transfer case I can test for voltage or to manually power the motor. Where is it? I see two plugs - the blue one on the left has 4 wires, the black one has more. Or is that not the shift motor I need to be looking for?
View 6 Replies
2002 f350 7.3 diesel automatic. The cruise stopped about a 1/2 year ago and i have done the recall and replaced the steering wheel switch. but it still doesn't work. the horn works and speedometer works.
View 4 Replies
