Checking out my 2007 gasser this weekend an found that my third brake light does not work....no power to the socket. The cargo lights on either side of it in the same assembly work fine so I believe the ground to be intact. My question is does this light have it's own fuse? if not where should I start looking for the solution to my problem?
View 1 RepliesI'm having issue with my brake lights. Checked for voltage and nothing. Checked the fuses under the dash. Checked the brake pedal switch and have power going out when the pedal is pressed. Is there a relay or something somewhere else? 1999 f250 7.3 superduty....
View 2 Replies1999 F250 CCSB Lariat 5.4, 2 wheel drive. I plan to replace the Driveshaft Center Bearing in the next few days. What size is the Nut that I have to remove to remove the yoke next to it so I can press the bearing off?
View 4 RepliesMy 2011 f250 is stuck in park and the brake lights do not work. I have changed the brake switch but still wont shift out of park.
View 4 RepliesThe flashers and blinkers work, the taillights, brake lights and back up lamps do not.
The truck is a 2004 F250 4x4... Checked all fuses. What am I missing?
I have and 07 F250 and the #2 speed for the blower motor don't work (hasn't since I bought it) I read that the most common cause of this is the resistor under the hood on the firewall so I replaced that and still no 2nd speed??? Where I look next? Motor itself maybe?
View 11 RepliesWas checking fuses for why my 3rd brake light and pedal adjustment switch does not work. Was also looking for a fuse to tie into so that a light in the cab floorboard will stay on when the headlights or marker lights are on... After trying several spots to no avail (finally putting it into the bright headlight fuse). I got the light to work.... But now my ABS light stays on!!! Also 3rd brake still not working...
View 1 RepliesI just got my truck recently, when I purchased it the power mirrors do not work. Already checked the 5A fuse and it is good. Tried putting in a new switch from O'Reilly's and still did not work. Are these switches supposed to light up like the window and lock switch? Thinking it might be a break in the wiring or motors are seized but I've read that is not as common.
View 1 RepliesI replaced all the exterior bulbs in my 2013 F250 6.7L with LED bulbs. My trailer lights work but brake and signals don't work on the trailer.
View 5 RepliesI have a 2003 F250 Lariat 6.0L Crew Cab. My wipers, radio and power windows don't work. I have painstakingly checked every one of the fuses to see if there was one or more blown. All were OK.
I removed the fuse panel under the dash and have disassembled it to look for obvious clues, burnt wires/heat damage etc. but everything looks fine. Have pushed all of the fuses in to make sure they were seated properly. No joy.
I recently replaced one of the back windows in my truck and had to detach the rear dome light and I remember one of the wires sparking. Where to start diagnosing this problem?
The brake light stays on all the time. It started 5+ years ago going out intermittently, then began going out more frequently for longer as the years went by, until now, where it stays on continuously (except for one small miracle where it cam back on during a short drive around town). I don't normally care if it stays on, but for the first time in 7 years I'm going on a long road trip and can not engage cruise control with the light on.
View 9 RepliesThe third brake light (on cab) went out and I can't seem to find which bulb to get to replace it. Are they the same as the 2 Taillight bulbs on the bed?
View 3 Replies2008 f250 abs light, check brakes fault, speedo don't work! I was hauling a car the other day and all of a sudden all these lights and faults came on then my speedo quit working and also the odo don't calculate mileage. I changed the speed sensor at the top of the rear end and still nothing. Cruise control also don't work..
View 14 RepliesMy 2002 F250 Crew/Diesel/4X4/lariat has ever since I bought it, had an electronic problem.. sometimes I start it, the heat coil light stays on, sometimes the radio won't work, the windows won't work.. then about 2 minutes later, they work, my back up alarm always comes on turned off... sometimes my fuel gauge registers weird, ....
View 1 RepliesI have a f250 super duty. I blew a brake line the main going to the rear. So the genius that I am I replaced the line an simple enough I decide hell why not replace the master cylinder too, so I did an I bleed the brakes an everything works jst fine but now the the brake light won't turn off I have tried everything not sure what could possibly cause the light to stay on. I will eliminate some suggestions, I bleed the brakes, the brake fluid is full, the level sensor is completely attached, the parking brake is not on, I pulled the parking brake completely out, even completely disconnected the sensor thinking it would turn off bu it didn't.
View 1 RepliesParking brake light stays doesn't come on when the parking brake is engaged. The light DOES come on when starting the vehicle and the gauge cluster cycles through its start up procedure. Couldn't find a fuse that would fix my issue...does one exist?
Truck is an '02 F250 w/ 7.3TD and 6 speed manual.
I just went from 3.73 to 4.30 gears on my 2007 f250 6.0. It has the standard Sterling 10.5 rear and Dana 60 front. My mechanic friend who did the swap said the ABS light came on during his test drive but the truck drove fine. I was of the understanding that the truck would not need to be recalibrated for proper speedometer and transmission function, but what about the ABS?
View 7 RepliesOn my 07 F250 Outlaw recently I replaced my stock 3rd brake light with a Bully LED brake light.. Noticed last night that it is NOT working.. the red LED's arent working but the white cab lights are.
I plugged the stock one back in and still nothing. After looking in the owner manual at the fuse block I did NOT see a fuse for it... Got to experimenting and my peddle raise lower switch is not working either. I looked at that fuse and it looked good but just to be safe I replaced it with a new one and still nothing...
could these be tied together some how for power?
2007 ford f250 .... 200k on it ....
Just had refurb engine installed with new oil elements as well. On a 9 hr road trip, the wrench light came on but no other warning lights.
No stock gauges showed any raises in levels.
No noticed loss of power at all.
The light would only come on once I drove at about 75 mph for about 10+ miles. It would not turn off when i slowed down, but when I would kill the truck and restart it, the light would be off. Just driving in town or on the highway briefly, nothing comes on. Took it in to oreillys to get scanned and they tell me a few codes pull up but none of them are valid. What would trigger the wrench?
2007 f250 4x4 shift on fly will not work. switch to 4x4 high light will not illuminate and it will not go into 4x4. i have tried in park, in neutral, rolling are stopped. both lights work when you turn ignition key to on.
View 12 RepliesPulled into parking lot this morning, 05 F250 CC 4x4 V10, truck starts dinging at me, Park brake light comes on. Ease off of gas and idle around to parking place, no sign of brake drag. Release Park brake, no difference, set the brake and release, no difference, guess the microswitch went bad. Not raining, never hit a bump, MAY have had my foot on the brake, but that shouldn't effect the P Brake.
After setting for the 12 hour shift, all is good and well. Did not come back on.
Where this switch is? Is it under the cover by the foot set or under the truck along the cable? Would like to know where to look next time this comes up. Did have 2 new tires installed on the front a week ago, new tierod and aligned at the same time.
Just wondering and curious, my last F150 had all kinds of electrical germlins in the windshield wiper arm.