Ford Super Duty (1999-2016) :: 2006 F350 - Warning Lights With Tone On Startup
Nov 5, 2014
2006 350 6.0, on startup the high and low 4x4 and brake lights come on the dash with a constant tone for a minute or two then stop.
View 2 Replies2006 350 6.0, on startup the high and low 4x4 and brake lights come on the dash with a constant tone for a minute or two then stop.
View 2 RepliesJust got a new-to-me 2006 F350 Super Duty XL with the 5.4L V8 and 5-speed auto. I haven't had a full-size truck in a few years and forgot what I was missing!
When I bought the truck, all gauges were inoperative except for the fuel and oil pressure gauges. The previous owner told me they would work intermittently and at some point just stopped. The usual warning lights - ABS, CEL, and "the wrench" - were all lit, and from Googling and searching this forum, it looked like an easy fix - probably a pinched or frayed shifter wire, or possibly a cluster repair.
I took it home and did a self test on the gauges. The "sweep gauges" made everything swing fine, so I was thinking it might not be a problem in the cluster. I pulled the steering column apart, removed the Tow/Haul overdrive wire from the plastic retainer, re-ran it with some slack, taped the end where it comes out of the shifter (even though I saw no breaks/frays) cleaned the connections, gave it a dollop of dielectric grease in the connector, and put it all back together. VOILA - GAUGES and no warning lights! You can imagine the touchdown dance in the driveway.
Fast forward a few weeks and....back to no gauges and warning lights lit. Figuring the overdrive wire had finally given up, I ordered and installed a replacement shifter figuring it was an easy and cheap fix. No joy - same problem. Tried cleaning and reseating the connection. Nothing. I've searched FTE like mad and it seems like 95% of the problems are with the wire exiting the shifter fraying and/or blowing a fuse, but this is a new shifter. I've also checked fuses #2, #24, #33, #36, #41, and #45 (some referenced #19 but I don't have a fuse there). All were unbroken - just put them back in and reseated firmly. I did a code pull via OBD2 and have a "rear catalytic efficiency degraded" code...not sure if that's related, but figured I just had an exhaust issue.
I may take the dash cover off and try to clean and reset the connections on the gauge cluster, as well as do the same for the PCM. Is it possible that the tow/haul overdrive wire to the PCM (where the shifter connects to) is bad? How to test and/or replace if it comes up bad?
I have a 2006 Powerstroke F350. Recently, the "check air filter" light has been coming on. It comes on intermittently, and every time it comes on it makes a warning tone. Super annoying.
I reset the minder, and even tried unplugging it. No change. I think I must have a short in the sensor wiring, but I can't seem to find a wiring diagram that shows the air filter sensor.
Looking for a wiring diagram that shows how the minder is wired? Or What is the part number for the relevant wiring harness?
I have a 2006 F350 CCLB FX4. Is there a way to allow the running/parking lights to come on when I open the door like my dad's 2012? I don't have any roof/clearance lights yet, I'm a little on the fence about drilling holes in my roof but it seems the truck should have them, especially being an F350.
View 14 RepliesMy sons 2006 F350 brake lights and rear turn signals quit working. When the headlights are on, all the lights operate but the rear turn signals and brake lights do not nor do the emergency flashers. The front signals work but flash very rapidly. Although I'm not an auto electrician, I'm fairly mechanically inclined but the fact that the front signals work, the rear don't and all lights work as lights, just not as turn signals or brake lights.
View 4 RepliesStarted my truck this morning. 2000 F350, V10, 153000 on the clock. Immediately sounded like a shotgun went off under the hood, now it sounds like it's running a cutoff exhaust. Had a tiny manifold tick prior to this, but can it backfire hard enough to crack/destroy the manifold?
View 5 RepliesWe have an F350 at work with a 7.3, I believe it is a 2000. The truck is secondhand to us, although we have had it for a number of years at this point. It has a banks powerpak and transcommand system installed by the previous owner (I got the paperwork from my boss but I haven't sorted through it yet to tell you anymore than that), as well as a pac break exhaust break and a transflow auxillary fuel system.
These were also installed by the previous owner. We do not use the exhaust break due to it getting stuck on/closed (probably an easy fix...it used to work properly we just haven't had a chance to look at it) and the fuel tank was removed when we put a different box on the truck, and was not reinstalled. I can't say whether or not it was removed properly, or whether shortcuts were taken.
The issue:
About a year ago, the truck stalled without warning. No coughing or hiccuping, just suddenly the motor stopped. It restarted instantly, and off we went. This happened again occasionally, but not frequently. Over the last month or so this started happening much more regularly, and we also experienced sudden losses in power for several seconds where the engine seems to return to idle, but does not stall.
We haven't been able to determine any pattern to these issues to try and narrow down the cause.
I have a 1997 f-350 crew cab 4x4 w/ off road package and 7.5 fuel muncher power package. My engine stalls going down the road w/ no warning. Sometimes it will start back up immediately, and other times not until i cycle the ignition 6 times or so.it seems to be getting worse as time goes by. Since it started i replaced tps, cap, rotor, plugs and wires. I also replaced fuel tank and pump and filter about 1.5 years ago. Some other issues to clear up, but concerned w/ current problem.
View 2 RepliesI have an 08 f350, and my cab over lights are out...I've checked net for issues and they all point in different directions... Running and towing lights are fine, just cab over lights are out...is there a fuse somewhere I cant find? could one burned bulb be out and it effects all?
View 3 RepliesOn my way into work this morning, all the warning lights came on, along with the check engine wrench. My display was showing that I was overheating and the gauges stopped working. While this was happening, there was no noticeable change in the way the truck was performing.
After about a minute or two, the warning lights shut off and the gauges worked again as normal. The gauges did not show that the truck was overheating at that time. Another few minutes went by and the same thing happened again. Then the gauges came on and the warning lights shut off for the second time, it did not happen again for my 10 minute ride to work. On my way home this evening, this did not happen again.
The truck seems to be charging and the battery seems to holding a large as well. The truck is a 2015 F350 XLT 6.2 with about 9700 miles on it.
Truck wont start with key. It has a brand new battery, brand new starter & brand new solenoid. When I turn the key to the on position the lights come on but it wont start. The truck will start when I jump the solenoid. Im wondering if its the ignition key cylinder or the ignition switch, or maybe something else like a relay or faulty wire. Where I should start or what the problem could possible be?
View 6 RepliesHave an 08 f350 xl and was looking to put oem foglights into the bumper where mine has the block out 's, guess what I am asking is if the wiring is already there as it was on a different vehicle I owned ,basically it was a plug and play ,have only had the truck for a week and with the hours I'm working I really haven't had a chance to crawl under and look for the wiring.
View 3 RepliesI have a 2000 7.3L PSD and the light switch pulls out like the newer Fords do to activate their fog lights, I am just trying to find out if who has hooked up fog lights to this switch on a 2000? If so, how?
View 4 RepliesMy daughter came home a bit ago and told me the backup lights on my '02 F350 were on. Pretty odd because the keys were in my pocket at the time.
When I opened the door to the truck, I noticed a faint electrical smell and noticed the fan for the environmental controls was running as well.
I'm guessing the light issue is probably a sensor or something at the transmission but why would the blower be running as well?
Early last week I finally decided to try and figure out why my cruise control hadn't been working and discovered fuse F2.34 was blown. Replaced it and went through the test procedure described here: [URL] ....
No issues and the cruise is working again. I had to take it on a road trip for work the following day and didn't have any issues for almost 1,000 miles.
I drove it last night and didn't have the issue. I drove it again this morning to several places and everything was fine.
I've got a tuner with a code reader. Would something like the above problem register a code?
I've not stuck my head under the truck yet (it's cold and dark out.) What sensors I might need to check out? Is there a testing procedure available to ID the faulty component?
The battery is disconnected for the night, but I'd sure like to get this thing sorted before I hit the road for work again this week.
I just picked up a 2001 Ford F350 4x4 7.3 SRW last week. I've been slowly going through the truck replacing everything. One thing I've always liked on trucks is the cab clearance lights, which this one doesn't have (it's a base XLT with no options).
So I looked on Amazon and ended up ordering this....
But then I realized that the harness isn't included, and I can't find it for sale anywhere. I searched the Ford parts site but can't seem to find it.
I'm thinking about returning those lights and getting this set: [URL] .... But I'm not 100% sure that the harness that's included will fit my truck, it only says Ford.
I just bout a F350 V10, 2008. All is great except for the clearance lights. I took advice from this site....checked the bulbs....replaced the fuse....still doesn't work. There is no damage on this truck. Is there something special I need to do to turn these lights on?
View 2 RepliesWe have a 1994 350 ford dually. the brake light and the abs light came on and it has no brakes. replaced the master cylinder ... still no brakes. what next?
View 1 RepliesNo straight answers found yet. It's just the running lights that get stuck on.
I don't have auto lights, and after a period of a minute or 2 the lights pop off. There must be a relay sticking somewhere.
Looking for a diagram that shows where the relay for running lights is located?
I am off to work tomorrow 800 Mile drive and I cant get this thing out of 4X4 Low. Tried driving (inching) back and forth. Got front end up on jacks to try to free up driveline... Is there any way to Manually put in 2WD. I just don't have time to run to town and get parts (new switching motor) if that is what the issue is?
View 7 RepliesI have a 2001 F350 and instrument cluster lights will not work. Fuses are good and the gauges still work just not the lights.
View 5 RepliesI have a 2015 F350 and with the long dark hours of driving, I want to put some auxillary lights on the front of my truck. I have a ranch style bumper on the front and I am thinking about installing a pair of flush mount LED driving lights. I was wondering, how well they work? I am personally thinking about the rigid flushmount hybrid driving/flood lights with the focused beam.
View 6 Replies