Ford Super Duty (1999-2016) :: 2006 F350 - Rubbing Noise When Make Extreme Right Turn
Jan 7, 2015
I only hear it at low speeds, but I guess that's to be expected. I've heard a similar noise before with other cars/trucks, but I can't recall what causes it. Just looking on tips for where to start looking with the front end parts or wheel/caliper assembly.
Also, but not sure it's related, had a lot of front end wobble when I applied the brakes coming down steep hills last week while pulling a big, but empty, gooseneck trailer. I assumed warped rotors, but later, after I had picked up my load, it quit doing it, albeit I had started babying the brakes. Still, there was one instance of very hard braking and it didn't do it at all, but that was on straight pavement.
It's almost as if having that empty trailer and/or going down a steep hill caused it, and not anything on the truck. But the rubbing sound started before that wobbling. Whatcha think?
View 2 Replies
Advertisement
Have a problem When i make a slight turn to the left sounds like the tire is rubbing the inner fender. Don't do it all the time. The tire is not rubbing.
View 4 Replies
Have a 2001 F350 7.3 4X4 with single wheels in rear. Started hearing brakes noise and decided to change both front and rear pads. Front had almost half the pads left. Rear on drivers side had about half the pads left. The passenger side metal to metal on the inboard pad and about half the pad on the outboard side. The slides on the caliper were a little sluggish but moved freely. Don't think there is enough to have them turned so will have to replace the rotors. Why this would happen. Could the caliper get stuck? It was easy enough to compress with a C clamp.
View 3 Replies
I am looking at a 1997 F350 XLT 4x4 and it has a 5.8L engine. I have an 84 F250 with a 5.0L and it just doesn't have enough power when pulling a trailer. I am wondering if the 5.8L is enough for an F350 of if I should look for a 7.5L?
View 14 Replies
I just can't seem to make sense of, 2006 f350 6.0 once it's been running for a min or so it will die when brake is pressed, also dies when you turn the wheel. Can't find any rub through or bad wiring.if you up rpm slightly it will not die with brake or steering. Tried removing belt thinking it possibly was a pulp and it doesn't die with the brake or steering but will die when going from drive to park. Thinking possible cps....
View 13 Replies
I have a 2006 F350, it keeps blowing fuses for the brake/turn signals. The puzzling​ part is it only does this when the truck is running.
View 2 Replies
My sons 2006 F350 brake lights and rear turn signals quit working. When the headlights are on, all the lights operate but the rear turn signals and brake lights do not nor do the emergency flashers. The front signals work but flash very rapidly. Although I'm not an auto electrician, I'm fairly mechanically inclined but the fact that the front signals work, the rear don't and all lights work as lights, just not as turn signals or brake lights.
View 4 Replies
Have an f350 4x4 diesel that when I drive slow and especially turn to the right it makes a grinding noise. It seems to either go away or just gets muffled by road noise when cruising. The ball joints were bad so I replaced them and I figured with this especially when I turn right it had to be a wheel bearing so I replaced both of them and still same thing. Don't want to throw money at it hoping to fix the issue. Also front duff is full of oil.
View 5 Replies
1999 F350 4x4 dually. Replacing brakes front and back. Rotors, Pads, and hoses. On the left front put rotor back on and torqued down hub nuts on rotor. Then caliper mounting bracket wouldn't fit back between mounting bracket and rotor. Loosened the hub nuts on rotor, and fit mounting bracket in place. Then torqued down the hub nuts again, and rotor rubs on mounting bracket and rotor/hub won't turn.
View 2 Replies
My 2006 F350 is giving me grey hairs. I'm trying to figure out what's going on with it. I have been getting an occasional (more often than not) grinding noise from what seems to be the front of my truck. It will do it from a stop, under light, moderate, or heavy acceleration. Doesn't matter. If I let off the throttle momentarily it will stop until it shifts and will grind again through all shift points it seems.
Logic says it's got to be the wheel bearings or locking hubs. I recently did both on both sides to no relief. Because this is an 06 it had a different hub set up then the previous years which I've read a lot of info about (needle bearings). It doesn't make a lick of difference if hubs are locked or on auto. If in 4x4 (ESOF) or 2wd.
As mentioned I replaced both wheel bearings with FORD parts and both locking hubs From FORD as well. (Small fortune). Axle u joints seemed tight. Greased me up but no play.
View 6 Replies
I have a 2009 f250 4x4 . When i make a turn and sometimes while driving the steering locks up. Sometimes i have to jerk it back. Sometimes it feels like i have no power steering . And some times its seems the gear box is stripped. I had it to a mechanic look at it and all the steering and suspension parts are good. The u joints are also good. There has to be a HUGE problem with this issue, due to know one having a steering box, even the dealer. I have a truck that I can't drive...
View 6 Replies
Having a problem with my truck and I'm stuck. About 9 months ago my 4wd stopped working. Turn the switch and no light or noise. I took a look at fuses and everything was good there. I let it go but now I need 4wd. Today I checked every fuse and all of them were good. I moved to the relays checked them and they were good but for the heck of it replaced them. Checked for power at the pins. The one that needed power had power. Next I went to the switch had 12 volts there. Pulled switch and test with a multimeter and ohms were good. Went. Down to the motor and tested for power there not power to the motor. Is there anything else I'm missing Esof not working. 2002 f350 7.3 auto....
View 2 Replies
I drive a 2014 F350 Platinum SRW. No matter how fast i go, there is always a rubbing noise & i can hear it right outside my front window. Its annoying & loud. The mechanics told me it was my dust seal on my front axle but they changed it & its making the same noise even worse than before.
View 1 Replies
I bought a nice 03 F250 V10 with apx 170k on Friday... After I got home (it was about a 4hr drive) I went to back up into the driveway and heard a loud (deep) rub noise.. Sounds like metal on metal... After a few feet or at a faster pace it goes away. I've tried seeing if it changed or went away depending on how the wheels were turned but it did not make a difference. At first I thought it was coming from the hub but now I'm thinking it could be driveshaft related..
View 6 Replies
I just got a 2000 F350 cc drw 7.3l.
I did search but have had no luck. My turn signals do not work, unless my foot is on the brake pedal my green arrow indicator wont even turn on. When they do my bulbs work but don't cycle so I know all the bulbs are good as I had my wife check all four corners when I got them to come on for a split second. I have tried replacing the MFS and the turn signal relay under the radio in the dash.... When I do turn on my blinkers I can hear the relay click once but that is it, no more.
I tried checking the wiring in the column and tilting the column to its extremes while trying to engage the turn signals. Also, if I unplug the brake light switch then I do not get an arrow on the IC to light up so I am guessing the power flows through that switch. I don't have a chilton manual yet and the owners manual was not in the truck. I did check fuse 23 ?
View 2 Replies
My dually has started to make a rubbing or grinding noise just about every time I make a turn, left or right. What this could be, truck has 8500 miles on it.
SD Dually
View 9 Replies
I got an 03 f250 with a 10 inch lift on 40x14.50 tires on 20x10 fuel hostage wheels. They rub my springs pretty bad when trying to make even the slightest kind of tight turn and the sound they make when they rub is even worse than them actually rubbing. My question is should i stay with this tire and wheel setup and try to get some 6061 billet aluminum 2 inch spacers? (I'm not sure about going that route though because of what i heard about spacers) or go down to some 38s with a 20x14 wheel that hopefully would push the tire away from the hub like spacers would do. I'm leaning more towards going to 38s because of the rubbing and also because I feel they might look better on the 10 inch lift rather than the 40s but dont know whats the best thing to do.
View 12 Replies
I recently had a close encounter with some large rocks on a bad road and broke the power steering cooler. I lost some fluid and pressure as I had no brakes and it steered like a log truck. Replaced the damaged part and added fluid. I was informed by ford technician that air in the lines would make noise but would eventually work itself out. Well the brakes work and steering is getting better but it is noisy with steering and brakes. How long should it take to get the air out? PS the fluid looks foamy now. I should also mention it was making a slight humming noise before the incident with the rock.
View 9 Replies
2000 crew cab powerstroke 4x4... It's a XLT, six inch lift, weld wheels, BFG all terrain (50%). 277,000. One owner. Clean Carfax. All service done by purchase dealer. Mostly stock other than that. Dealer just replaced AC compressor and charged system. Interior is good, except for driver's edge seat. Good cleaning and ok.
The (my?) Truck.Downside. Power door locks make noise but don't work, remote mirror switch intermittent, stereo broken. During my test drive (alone) it drove straight, stopped straight and hard. 4x4 engaged and worked well. No noise in system. Good acceleration. No rattles or noises. Doesn't drip anything on the ground. Cruise and all accessories work.
I'm supposed to go in Monday. My girl is afraid of the mileage. But it seems well maintained for 17 years old. Is 10k an acceptable price? They wanted 11,900. Anything I should be looking for?
View 7 Replies
I have a 2004 F350. I go out to start my vehicle and it may or may not turn over. Other time it starts fine
View 1 Replies
I have a 09 F350 Lariat SuperCrew SRW 4x4, Last night the ignition key would not turn at all. Tried wiggling the steering wheel, (noticed it wasn't locked), wiggled the shift lever (auto trans). After about an hour of "beatn and jiggling, it just started working!?? What caused this, neither does my dealers service dept. It's working fine now.
View 11 Replies
