Ford Super Duty (1999-2016) :: 2006 F250 - Smoke Rolling Out From Driver Side Rear Wheel
Jul 22, 2015
Got off the freeway today, driving along about 40 or so thought I smelled something hot like something burning. Stopped in a parking lot and smoke was rolling out from drivers side rear wheel. Look under and oil is dripping from inside of the wheel. Figure the caliper was hung up and got so hot it took the seal out. I can't get to it right now and the shop says I can't get in until next week, need my truck now. How long could I get by the way it is IF I take it real easy.
View 9 Replies
Advertisement
Big trail of clear liquid on garage floor this morning. Truck is dripping on drivers side to rear of drivers side wheel well. Not brake fluid. Trans or antifreeze would have a color to it and a smell. None of that. Was quite humid last night and I did have truck out for about an hour run time. Trying to figure what the heck this is. Don't want to waste my or dealer service time if it's just AC moisture.
2016 f350 crew cab miles under 8k
Where the ac condensate drain is passenger or drivers side?
View 4 Replies
Here's the deal. I have a 2001 F250 4x4 and I am getting a noise in the front drivers side wheel. The noise is not a grind or clunk, but its like a u-joint is rubbing inside an empty cylinder kind of. Anyways, it seems like it does it only with small bumps. I took off my oem hubs and re-installed them and the noise went away for about a week. Now I replaced them with manual locking hubs and the noise is back. One other thing I notice is if i put the switch to 4x4 the noise goes away. I checked all major components for the steering and suspension and nothing was loose. The front end is tight. Is there anything inside the axle that would cause this? I dont know what to check for anymore. Where else to check?
View 4 Replies
99 F-250 Ext cab 4x4 7.3 285,000 miles.
I got home today opened my door and got snaked in the face with the smell of brakes. I got out of the truck then I heard the drivers side rear brakes popping as they are cooling down. I reached down to touched the wheel and it's crazy hot. Opened the garage and went to retrieve the infared thermometer. The rotor/caliper was 350 degrees, hub was 150 degrees, axle tube was 90 degrees.
I took the wheel off and inspected stuff. The rotors do have some heat spots, the caliper visibly looks okay but not 100%. The pads look like even wear. I am guessing that the caliper either is hanging up or I have a wheel bearing going? The passenger side was like 80 degrees on everything. There is a slight shimmy while driving which to me feels to me like the beginning of warped rotors. I don't hear anything to me that screams wheel bearing noise wise.Brakes or bearings?
View 7 Replies
The driver's side mirror on my '06 250 (tow, heated, power, signal) got cracked... and of course whoever did it didn't stick around!!! Two questions...
Is it possible to replace just the glass? Or am I looking at replacing the entire unit?
Would you have a part number, or a link to a good online catalog?
View 1 Replies
I've got a 2008 f-250 extra cab. A small bump will cause the rear driver side door to pop open. What I have to do to fix it, I don't want the grandkids falling out.
View 2 Replies
I have a leak at the driver side exhaust manifold. Its a little tough getting at it to tell if its a lose bolt, crack or bad gasket. What would be the best way to get at this area? Should i remove the tire and wheel well or is their a better way. If i can get at it i may replace the manifold all together.
View 2 Replies
Whats the best way to get at the driver side exhaust manifold? I have a leak and its tough to get at. Should I remove the tire and inner wheel well?
View 1 Replies
On my way home today I heard wind coming in around my drivers side power window. Its not seating itself straight in the weather stripping. The window is tilted toward the front of the truck. Do I need a new regulator? Or maybe re- epoxy glass to bracket? The window still operates, its just crooked. Also I haven't had those door panels off before..
View 1 Replies
So I'm away from home on vacation also away from my tools. Any ways my front drivers side line busted almost causing me to crash earlier today in my 2006 F250 6.0 diesel 4x4. So basically my question is: what tools are needed to do this job? I've already picked up the part now tomorrow morning I will be changing the part...
View 2 Replies
I have a 2004 F250 Lariat Crew Cab FX4 6-3/4' bed.
What is the procedure to remove the Driver's side Rear Sway Bar Link upper bolt? - the link attaches to the frame. The nut is on the inside of the frame with about 1/3" to 2/3" clearance between the frame and the fuel tank. Of course, the frame's "C" shape faces towards the inside.
View 1 Replies
My 2006 F-250 (6.0 Diesel) started blowing black smoke under acceleration yesterday. It has 181k miles on it now. No loss of power, no rough idle, no smoke unless there's a load on the engine like accelerating, but then it doesn't matter if it's 1500 or 3000RPM, just the higher the RPM the more smoke it blows from the exhaust, dark black.
The truck has ARP headstuds, no programmer. Replaced both batteries and the A/C system about 2 weeks ago. About 3000 miles ago it got new glow plugs & harnesses, new alternator, all fluids changed, new aftermarket EGR cooler, new EGR valve, new turbo & actuator, new EBP sensor, new HPOP incl pipes and IPR.
Trucks starts up just fine, runs normal, just yesterday going down the Freeway about 65mph I noticed it started smoking black going up a hill, then smoke went away going downhill... Now every time I accelerate it's smoking black. Taking off from a stop sign it made a little puff of white smoke then went back to black smoke, but that only happened once.
Where I should start looking? No codes so far. But I have an AutoXRay EZ-Scan 6000, what sensors do I need to look at?
View 7 Replies
On the F250 trucks, if I changed the mounting frame under the seat, will the passenger side seat fit on the drivers side? Basically, can I turn a passenger seat into a drivers seat?
View 4 Replies
During the winter, the truck would always start very hard. When it was trying to start it would pump out some white smoke. Now during the summer the truck will still start hard. At one point during the winter we were getting glow plug codes, now these have gone away that its warm. We did replace the glow plug control module, but that did not solve the hard start during the winter. We figured that there was a bad glow plug which is sorting out the rest. So we then figured the hard start issue would go away with the warmer weather but it has not.
View 3 Replies
I just recently purchased my 06 Ford F-250 it's got the 6.0 in it once I made a 6hr trip I've noticed once you warm it up and ride a little bit kill it let set for 30min or better and crank it up it blows white smoke for a min or two than on the way to work this morning my heater.
View 2 Replies
I have a 2005 ford f250 super duty 5.4L the problem am having is the other day I took the truck out the yard an parked it across the street. 2 hours later I went back to move it it would not start the engine just kept rolling over I did this for about an hour it still refused to start. 2 days later I tried it again it started without any problems. I put a code reader on it it said P0453 fuel tank pressure sensor. If that is going bad would that cause that problem or would it be another cause.
View 2 Replies
My 2001 f250 on occasion will roll a very uncomfortable distance when I put it in park. Not all the time, but enough to concern me. It will roll a good 12-18" before the park rod or what have you engages. Doesn't seem to be affected by grade. Matter if fact it has always done it on just slight grades. Nothing like a boat ramp. It rolls enough that if someone had been front or back it would have bumped them.
View 1 Replies
Having issues with rear wheel wells rusting, mine is a 2004 f-250. I wax at least 10 times a yr. Can't believe I have rust there...
View 13 Replies
I have a v10 ticking on drivers side when I first take off in it. It doesn't do it idling and stops after you drive about a mile. I just had ford tune it up before this started so I took it back to have them check the plugs and they said it was a rod! Didn't sound right too me but I did check manifold bolts and they all was in place. Also if it was a rod would the noise go away???
View 6 Replies
So today pulling out of the gas station I turned my steering wheel to the left and I heard a high pitch squeal from the drivers side. It wouldn't do it again unless I was just creeping, nothing going down the road. I did a few searches on here but they all are if the truck is moving say 30 mph or better. I know I need to replace my ball joints. 99 F250, V10, 4X4, extended cab.
View 8 Replies
Have a 15 250 diesel and my drivers side door has a rattle in it. Seems to be coming from around the area were the mirror buttons are. Removed that little panel and applied some silicone around the edges and seemed to work for a bit then back to noise. Seems to go away when cab heats up good or warm outside.
View 5 Replies
