Ford Super Duty (1999-2016) :: 2006 F250 - Power Rear Window Broken?
Aug 20, 2009
I have a 2006 F250 Super, CrewCab 4 dr, 6.0 w/60K. Last month I tried the rear power window and .......nothing.
It tried to open 1/2 inch and then stopped, had to try to power it closed and it moved 1/4 inch and I pushed it the rest. Removed the rear cover behind the seats and I can see the motor and wires attempting to move but it does not move and I am afraid to burn the motor out or push too hard and break a cable or worse.
The track looks really dirty, I use that window maybe once every 2 months.
1. Can I replace the motor myself?
2. Can I put something in the track to clean/lubricate?
3. Should I try to open the window under power and some additional manual pushing?
View 14 Replies
Advertisement
I am trying to change out my solid back glass for a power slider that's oem... My question that ford could not answer is, is the wiring all in place minus the switch for the install.. I have a 2012 F250 XLT. I am not even sure where the switch to move the window would go either...
View 2 Replies
The rear power sliding window on my 05 6.0 F250 has started to open and close very slowly. I recently had my windows tinted. I checked track and can not see any obstruction. Having problems with their power sliders? Wondering if coincidence or if there is problem with window motor.
View 2 Replies
I will be pulling apart the back of my crew cab to replace the broken old speakers and run some new wires, thought while I'm in there I should look at the power sliding rear window. The switch has power and the fuse is good, however when pressed, the window won't move. I can move it by hand though.
View 4 Replies
On my way home today I heard wind coming in around my drivers side power window. Its not seating itself straight in the weather stripping. The window is tilted toward the front of the truck. Do I need a new regulator? Or maybe re- epoxy glass to bracket? The window still operates, its just crooked. Also I haven't had those door panels off before..
View 1 Replies
here's the problem. The driver side front power window will only go down and not up. I checked the motor and the master switch with a multimeter and both work just fine. the motor is receiving power and the master switch is sending power. However when i plug the motor back in and re-install it, the window will not go up. Is there some sort of relay that might have gone bad that is not letting the motor raise the window up???
View 5 Replies
I did a search and flipped thru the owners manual without any luck. But my 99 Super Duty is equipped with a rear power sliding window but I can't find the dang switch anywhere. Where is it supposed to be located...
View 10 Replies
My 2006 F350 has a nasty air leak/whistle coming from the rear power sliding window, unfortunately I found the one of the vertical seals laying in the cab. Looking for some insight on if there is a replacement seal kit, where I can find one and how difficult is it to install?
View 2 Replies
Ok, so I have been noticing that the rear power window has been slow to close. So today I open it and now it wont close. When I press the button on the dash, I see the cable snap tight and hear the motor turn on so its not a fuse or motor. What I need to replace/fix. I have tried to blow the track out, tried wd40 tried having somebody hold the button while I try to assist it in closing, but none of that worked. It is now half way and wont go any further.
View 12 Replies
I bought my 06 F250 with the V10 just 2 months ago. I have just a hair over 100k miles on it. A few weeks ago I started hearing this low pitched whine coming from the rear end - and my mechanic found metal shavings in the oil for the rear differential. It starts around 15 mph when I accelerate and it kinda sounds like a real low pitched turbo winding down as I come to a stop.
View 7 Replies
I have a 2006 F250 and the other morning I came out and found the rear view mirror laying on the cab floor. No biggie, I'll just glue it back on. Then I noticed the small black decal looking thing on the inside of the windshield. My question is, does this have to come off in order to re-install the mirror with standard Permatex mirror adhesive, or do I just put adhesive on top of it? Also, is there a different, specific adhesive used here that won't crack the windshield 2 weeks from now, like I read. Took a closer look and realized they used a thin adhesive patch to attach the mirror. I'll get one from the dealer.
View 3 Replies
Looking for a breakdown for installing a new clutch pack in the rear differential of my 06 F250 Diesel sterling 10.5. I found a kit on rockauto.com but it has 4 weird looking shim things I don't recognize, I rebuilt my diff in my 03 crown vic 8.8 but there's some extra pieces in this kit I don't recall.
View 6 Replies
1999 F-250 ... How does one replace the emergency brake cable? The cable in the '99 F-250 I recently bought broke.
The cable was sticking when I got the truck. I like to use the emergency brake every time I park. The previous owner(s) didn't use the emergency brake and the cable had frozen up.
I tried using it every time I parked. I could tell it was frozen, but I was hoping it would loosen up. It held a little bit when I used it; but soon it just broke.
View 3 Replies
I've got a 2006 F250 5.4l Super Cab. When I bought the truck the rear interior door trim panels were missing. I tried to order them straight from ford but it turns out they no longer carry them, and I can't seem to find them anywhere online. I've also looked at the salvage yards in my area- nothing. Where I would be able to find these elusive creatures?
View 3 Replies
Got off the freeway today, driving along about 40 or so thought I smelled something hot like something burning. Stopped in a parking lot and smoke was rolling out from drivers side rear wheel. Look under and oil is dripping from inside of the wheel. Figure the caliper was hung up and got so hot it took the seal out. I can't get to it right now and the shop says I can't get in until next week, need my truck now. How long could I get by the way it is IF I take it real easy.
View 9 Replies
What is the best way to bleed air from the power steering lines? I just replaced the power steering pump on a 06 6.0 f250 and now I need to bleed the lines and refill the power steering. I'm just curious as to what is the best and easiest way to do this.
View 14 Replies
I have a 2004 F350 with a broken drive shaft.
Got the original shaft off and it has the following part number (2C34-4K145-DNA)
but I've since learned that the part number has changed but the only info I could get was 2???. 4R602DQA.
Trying to find the part number so I can find it under 750.00 from the dealer
View 7 Replies
2006 F250 and my passenger light was out. I thought it was a bad bulb and I wanted to upgrade anyway so I bought some Slyvania Ultra headlights. Pulled out the old bulb and it didn't appear to be broken, but I installed the new upgraded lights anyway. Still not coming on. I tried the hi beams and still nothing. Got an electrical probe to test the wires and still no juice. Where the wires run to so I can try to find the break in the line? I'm assuming there is not a seperate fuse for the passenger side...On a side note when I went hunting a few weeks ago I had some kind of animal make a nest under the hood, its possible a mouse/rat/squirrel ate my headlight wire, but the nest was in the top center of the engine by the turbo and oil filter.
View 6 Replies
I have a 2006 F250 XLT 6.0 diesel. I bought last month to haul my fifth wheel. Looking for the wiring diagram for the "under hood lamp". I have no power at the connector of the under hood lamp. I have checked all the fuses in both locations (battery box and central junction box) and did not find a blown fuse. The under hood lamp is not listed on the the central junction box fuse and relay posting in the owner manual. Is it controlled by something else?
View 2 Replies
1999 f250 passenger window went down but will not go up. Neither switch will make it go up. I was wonder if both switch could have went bad? Any way to test a switch?
View 4 Replies
I have a 2006 Ford F-250 5.4l the symptoms are when it's warm it has half power and it will stall at idle. What I have done with the truck is.
New cam phasers
new chain
new tensioners
new vct solenoids
new oil pump
new plugs
new ignition coils
new stock cam shafts
new rockers
new lash adjusters
new exhaust manifolds both sides
new muffler
oil change with the right oil
ran it with sea foam in the crankcase before oil change
new fuel pump module
new evap vent control
new abs speed sensor
I cleaned throttle body with brake cleaner ... Scanned it after a 15 min ride of having to use 2 feet to drive it. The engine codes that came up are p0022 iacv short to ground and p1000 readiness test not complete. I also got p1804 4 wheel drive high indicator circuit failure p1808 4 wheel drive low indicator circuit failure .... Not sure what else to try.
View 7 Replies
