Starts fine most of the time. Then suddenly key will turn but not engage ignition. Power OK to everything but ignition. Have replaced starter & ignition module. Still does the same thing. Leave for a while & truck starts fine. 2006 F250 6 litre diesel ...
View 1 Replies2012 350, crew, 4x4, 6.7, LB. Ignition does not always engage when you turn the key (we've changed the tumbler and the batteries) after sometime the truck will start. the dome lights do not work in auto anymore and every so often the steering will "grab" to the left, when I compensate it will switch to the right. I can drive from 20 - 300 miles sometimes before it does this and then it may or may not come out of it right within 5 - 20 minutes.
View 1 RepliesI have an 06 F 250. Recently my gauges and radio have been randomly turning off then back on when I am driving down the road. How I can fix this????
View 3 RepliesMy truck: 2001 F250 V8 Triton Automatic 4x4
Problem: 4x4 won't engage
Symptoms: No dash lights....nothing happens when I turn the 4x4 switch. When I start the truck I hear what sounds like a motor (transfer case motor maybe?) trying to switch (even though my dash switch is on 2WD)... It tries three times and stops.
What I've done: Checked fuses ...they appear ok to me
I don't have a maintenance manual yet ...
The 4x4 used to work up until about 2 weeks ago. Started having a hard time getting it to go into (and out of) 4x4 and then it just stopped all together.
2005 F-250 King Ranch Diesel ... My truck when I got it the 4x4 wouldn't engage. I replace the front inner seals, and the lock outs. Still wouldn't work. Took the shift motor off and freed it up and it worked fin till today. Changed the shift motor and still nothing. This truck has been nothing but problems since I have had it and now this ... Truck is going on the market soon and would sell better if the 4x4 worked ...
View 13 RepliesF-250 2005 XLT 5.4L 4X4. Had ford for a few years now (Escape as a personal vehicle and econoline as business vehicle). Now I'm having a little problem with 4x4. It wont engage. Worked fine last week and now nothing! I did check all the fuses and when i switch to either 4Lo or 4Hi I can hear a clicking sound behind the switch but feel like it's getting blocked or something. Tries a few time then stop...
View 14 RepliesI have a 04 ford f250 superduty... I tried to use my 4x4 today and the front wheels would not engage using the ESOF. The light comes on in the dash saying its in 4x4. i do not believe i have a vacuum leak because it doesn't switch over to the automatic setting for defrost. what else could it possibly be I'm stumped at this point.
View 14 Replies4x4 will not engage. 4x4 light on dash does not come on. Can not hear motor switching into 4x4. Check fuses under dash all looked good.
Truck is a 2004 F250SD V10 ....
I have a problem on my F250 4x4. The 4x4 doesn't engage from inside. I tested for vacuum on the pipe that leads out of the solenoid. There seems to be no vacuum building on the outlet line. This is the line that go to the wheels. Is my solenoid stuffed. the pump works well and vents do not default to defrost.
View 14 RepliesBasically I have a 2008 f250 (6.4l if that makes any difference) That wont engage into 4x4. When you go to turn the switch to engage the 4x4 all you get is a click click click click click. Is that a problem with the 4x4 shifting solenoid on the transfer case? Anything else to look for? The truck has 95k miles on it....
View 2 RepliesI have a 2006 F250 Superduty 4x4 that the brake lights hazards and turn signals have stopped working in the rear.. The middle cab brake light does not work either.. The running lights do work as well as the turn signal and all lights in the front.. I also checked the trailer plugs and both work for running brake and signal lights.. I have checked all fuses under the hood as well under the dash with a test light and i have nothing blown.. I have replaced the Brake switch as well as the flasher module under the dash and picked up a new multifunction switch (Turn signal/hazard) and that didn't work either.. I'm stumped at this point.. I have not checked the bulbs yet but wouldn't think they would all blow at the same time.. (will do this next)..
View 3 RepliesI am having some issues with my 2003 f250 6.0l 4x4. I cannot get the 4x4 to engage. There are no lights on the dash and no power to the switch other than the light. It doesn't matter if I have the hubs in lock or auto. It just seems like i have no power to the system. I have check all the fuses and they all check fine. I also check the transfer case motor and it seemed fine. I must be missing something. This truck is worthless without 4x4.
View 14 RepliesThe transfer case on my 2001 F250 Powerstroke will not engage when the ESOF is switched to 4hi or 4lo. I checked the fuses and they are good. I removed the electric motor on the side of the transfer case and while it was hanging down with the two plugs attached I did not see any movement when the dash switch was moved to the 4hi position. I used a wrench to manually shift the transfer case and still did not get the transfer case to engage. What next?
View 9 RepliesAbout a month ago I bought a 2004 F-250 160xxx from a reputable Ford dealer here in town. The dealer performed a safety and emissions inspection, and spent about a grand on other repairs, as a condition of my purchase. Today I had it in the shop for an instrument cluster issue (at a different Ford dealer, closer to my house), and was told the vacuum lines were all messed up. Their write up is below:
"Check 4x4 operation. Transfer case shifts to 4x4 and 4x4 low. Front hubs do not engage automatically. Check vacuum at the hubs. No vacuum. Check the vacuum at the solenoid. No vacuum. Perform visual of the engine vacuum lines. There is no vacuum to the reservoir. Vacuum line is routed wrong from the fuel pressure regulator to the vapor management valve. There is other vacuum concerns. All of the vacuum line routing needs to be inspected and corrected."
The service rep told me it is questionable whether the 4x4 ever worked, although during the few weeks I've owned it, I could hear gears or other mechanical parts making noise which seemed to me to be in response to me turning the 4x4 electronic switch. She also said there was a vacuum line dangling loose with a screw in the end of it.
Before I contact the dealer where I bought the truck, I am planning my going-in position. But I wanted to get a sense of a) how serious of a problem this might be? and b) how reasonable it is that the dealer didn't catch this issue before I bought the truck while they were in their fixing other things?
The dealer who sold me the truck made it very clear that the sale was as-is, and I took it to my mechanic prior to purchase, though unfortunately he only had time for a cursory look at the engine. Obviously he didn't look closely enough to find this issue.
I'm not sure if I should ask the dealer who sold it to me to fix it, or ask them to allow me to return it, or sell it back to them, or if I should eat the cost of fixing it. How wrong would it be to try to trade it in for something else?
I have an 01 f250 with a 4r100. Trans has not been slipping at all and yesterday it started a rough shift between 1st and 2nd. (3-4K Rpms) At the same time 4th gear stopped engaging. Shifts out of 3rd but does not go into 4th. I can hit my od button and it will shift back into 3rd and start pulling. Still no slipping just doesn't want to change 1-2 or engage 4th. I have done a full trans fluid change including new filter and tc. Old fluid looked fine with no metal flakes or garbage in it. So all new fluid still same problem. I was thinking of changing my shift solenoid.
View 9 RepliesHow do you get the door chime to go away when the key is still in the ignition?
Also, how do stop the driver seat from moving every time the key is removed?
Where I should start looking to solve this thing. Got in my truck to drive home at the end of the day today and noticed the radio was on. Started it up, seemed normal. Shortly after the thing started incessantly *BONG-BONG-BONG*-ing at me. Drove home, turned it off. Started pulling fuses, find the culprit, silence it.
It's no longer constantly on and it seems to have flattened out and is only doing it now when the key is in the off position, otherwise silent when running or in the normal on position. I know it's not this contact (the one in the tumbler above the release pin) that's making the problem happen, as mine is disconnected. It's definitely something in the ignition tumbler or similar that's making at least a couple of the circuits think the key is in when it shouldn't be.
I don't even have the factory service manual for this thing yet with all the electrical diagrams to figure it out. Truck is a 2001 F250 PSD Lariat CC, for what it's worth.
I have a 2000 f250, 5.4l triton v8 that cranks like crazy, but won't start. When I spray a little starter fluid in it it will run until the spray wears off. Brand new battery and full gas tank. it does have check engine light on dash, probably from the o2 sensor as the exhaust has almost completely rusted out. Also on a side note the cruise control will not engage.
View 6 Replies1999 5.4L F250 ... When I turn my ignition all my lights come on and I have power to dash and etc, battery is strong, but when I turn the key I get nothing even when I do the shifter trick for the slip we get on most fords nothing took ignition lock cylinder out and blasted it with electronic connection cleaner, when key is turn i loose all power to everything and there is no "click" or i gage from anything under the hood or the starter rally confused!
View 13 RepliesUpgrading ignition coils on 5.4's? Looking to upgrade mine and only came across a few and the reviews are mixed. I am primarily looking to smooth out the idle and gain some minimal power and maybe get a flicker of a gain in mpg.
View 3 RepliesI have a 09 F350 Lariat SuperCrew SRW 4x4, Last night the ignition key would not turn at all. Tried wiggling the steering wheel, (noticed it wasn't locked), wiggled the shift lever (auto trans). After about an hour of "beatn and jiggling, it just started working!?? What caused this, neither does my dealers service dept. It's working fine now.
View 11 Replies