Ford Super Duty (1999-2016) :: 2006 F250 - High Beams Will Not Shut Off
Feb 21, 2014
I have a 2006 F-250 Super Duty (6 liter diesel). The high beams stay on unless I pull the fuse (fuse 30). It doesn't matter what position the headlight switch is in. It is like the high beam flash on the multi-function switch is stuck. It feels fine, but high beams stay on regardless of position, even with the truck off. The low beams (if in low beam when the truck is shut off) do go out as do the running lights after 15 or so seconds (normal) it's just the high beams. Also the high beam indicator light is on all the time (until I pull the fuse) and the fog lights will not come on until I pull the fuse. Should I replace the multifunction switch or look elsewhere?
View 10 Replies
Advertisement
I just had some custom headlights built for my truck. I have noticed if I am on low beam with fogs on, switch to high fogs go off, switch back to low, and fogs come on but highs stay engaged until I turn off fogs, the go low beam... I have heard this has happened before with other trucks and that it was called a Bambi something? And that there was a possible fix...
View 1 Replies
I have an 2001 F250 SD with 7.3 Diesel. Headlight switch failed and I replaced it. But now I have no high beams and my dash lights that light the dash up don't work. Gauges, fog light, low beams all work fine. Fuses checked. Multi function switch checked. What to do next?
View 1 Replies
My truck only has low beams. When you move the stalk on the colum backwords it changes nothing, when you move it forwards the low beams go out but the high beams do not come on.
View 14 Replies
I bought this truck used and it is my first F-250. I took it to the shop last week and they found a few things and a cracked radiator was one. They replaced the radiator with a new one. I heard the sound before the new radiator and I still hear it now. The coolant level is not dropping and the engine is not over heating (also no fluid on the ground). Is this a normal cool down sound?
View 6 Replies
Ok truck shut down wouldn't start back. Put fuel filter o. Frame cranks but won't start. Was told has high pressure oil leak in engine?
View 8 Replies
A good while back I seen a thread to do this , but can't locate it now. I have a 2012 F250 and looking to make my night time driving better ....... I want to run both low and high beams at the same time and getting the fog lamps to stay on when going from low to high beam.
View 14 Replies
Okay so I have an e99 f250 7.3 the problem all started went I hit a puddle the other day. My horn started going crazy and wouldn't shut off so I had to pull the fuse and relay. After that I found another problem, all my dash lights,headlights and running lights will not turn off unless I pull the battery terminals, it does not matter which way the headlight switch is it can be on or off and they stay on. I did find it though if I pull the negative terminals and put them back on the lights stay off if I turn the switch on and try to turn the lights back off with the switch they stay stuck on again untill I pull the terminals what could be the problem I've looked at every fuse and can't find the probelm.
View 8 Replies
I'm in having emission problems with my 2010 F250 lariat 6.4 diesel truck my DPF filter keeps getting clogged up engine just shut off on me then I sent it to get cleaned professionally got it installed drive it for 20 miles and my pick up shut off on me and left me stranded and I can't seem to pass inspection...
View 3 Replies
We currently have a 2011 F250. During the day time, when you turn on the headlights all the way (not just on "auto"), the dash lights and clock shut off. Originally, I thought that they were just dimmed to the point where you couldn't see them, but the brightness is already turned all the way up on the dash lights. If I turn the brightness up any higher, the dome lights turn on, but the dash and clock remain off. If you return the headlights back to the "off" or "auto" position, the clock and dash return to their normal brightness.
View 4 Replies
I have a 2002 f250 SD v10 4x4. I had a ground wire break fixed that know noon of my instruments work. Dash lights up but nothing moves. Pulse my parking lights stay on when the truck is shut off or when I turn lights on then off. I have to disconnect the battery to get hem to shut off.
View 3 Replies
While driving up hill at 60mph the truck lost power. Rpm jumped up as to change gears as it hit 55mph. Still losing power until it shut off. I tried to restart and just got a click from the solenoid. No engine codes whatsoever. Battery had 12.1 volts but when turning the key to start in getting 8 volts. Had it towed home. Today I swapped batteries with my other truck and same click noise from solenoid. All lights, radio, ect still work. Where should I start? Alternator, fuses...?? 2008 f250 5.4 ...
View 12 Replies
03 f 250 super duty, my battery light came on and when I accelerate my dash gauges shut down and radio turns off, if I idle or stay under twenty MPH, everything works fine. Battery and alternator test good, lights never dim, any thoughts
View 4 Replies
My 2006 6.0 shut off immediatEly after starting this morning and never started back up. I have a scan Guage 2 hooked up. I'm showing no ficm voltage and no sync even when cranking. I physically checked the ficm voltage with a dvm at the screw to the far right on the ficm, and I have 48 volts. Why do I have 48 volts at the ficm, but 0 volts showing on my scan guage? And no sync when cranking?
View 4 Replies
I've been battling this high temp issue for a bit now. Here's the recap on my truck.
2005 F250 6.0
120k miles
Edge insight CTS2
New factory Oil cooler
motorcraft coolant -system flushed
Stock EGR- No leakage
Deltas 3-5 degree apart no A/C on
A/C works great!
-Issue- When I turn the A/C on city on normal driving no loads or towing. The temps have gone up as high as 230 eot 230 etc. Ambient temps 83-90F ....
View 3 Replies
So I'll be driving down the road and the gauges will randomly start jumping around then the truck will just shut off, this just started a couple days ago, it seems to be gaining in frequency, when i try and restart the engine all my warning lights flash on and nothing happens, try again and it starts back up, now the last time it happened all of the above happened but it was followed by a fast clicking noise from under the steering column, it has to be a electrical issue as i have full tanks and motor is in tip top shape. Also no codes pop up with my code reader.
View 1 Replies
I recently (2 weeks ago) picked up my first Effie, a 2004 RN F250 Supercab XLT 5.4L 4x4 auto (dual Fuel Petrol/ LPG).
One of the things I am exploring is a problem with the tachometer reading high. I read on a thread somewhere on the forum that it was most likely that the earth of the tach plug was not connected. (It was a great thread but I can't seem to relocate it)
I am still chasing a workshop manual to get wiring diagrams, etc. In the mean time, where to locate the said plug/ earth connection?
View 7 Replies
My dad has a 2000 f250 4x4 with the 5.4. he said his blower would only blow on high. I told him it was his blower motor resistor. i thought it was under glove box. he took it apart and said no but there was a little box thing with wires he took off anyway and put back on. I then told him it was under hood below a/c lines. he replaced old one with a new one from auto zone and replaced the pigtail( plug too) fan works on high and a little bit on low very very little when u switch it to medium it stays the same. High works great. So we replaced the fan switch. (Radio was a bitch to remove) and it still does the same thing. I checked all fuses . when I check the plug at the resistor there is power to the center pin it stays on when u switch to low and medium but when u turn high on power goes out( on test meter) is there something I am missing? the blower blows on high even when u remove the plug from the resistor. Is that normal?.
View 4 Replies
So today pulling out of the gas station I turned my steering wheel to the left and I heard a high pitch squeal from the drivers side. It wouldn't do it again unless I was just creeping, nothing going down the road. I did a few searches on here but they all are if the truck is moving say 30 mph or better. I know I need to replace my ball joints. 99 F250, V10, 4X4, extended cab.
View 8 Replies
My windshield washer has recently just sprayed up about a foot.
Will adding some vinegar to the fluid and see if it will unclog?
Or does this just mean that my pump is giving up?
'99 F250 SD V10
View 7 Replies
What color wire controls the high beams?
View 1 Replies
