Ford Super Duty (1999-2016) :: 2006 F250 Engine Just Cranks But Does Not Fire
Oct 7, 2013
I have a 2006 f-250 powerstroke with 97000 on it egr delete exhaust and a h and s xrt pro on it. The pickup will always start when the engine and oil is cool, but once i run it for a while it and the oil gets warm it wont start back up again. I then have to leave it sit for a while and it will start. The engine just cranks but does not fire. I have replaced the dummy plugs on both sides and all the injector o rings on the passenger side. Some mechanic friends of min have had same problemed 6.0 liters and replaced these and it has fixed the problems I do not think it my high pressure pump.
View 2 Replies
Advertisement
Need to diagnose my truck issues. On my 2002 F250 V10, when I try to start it, the engine just cranks and cranks and cranks with no fire or even hint if starting. I am not sure if it has no spark or isn't getting any fuel. I just replaced all ten spark plugs and coils less than 500 miles ago. I want to perform the fix myself, but I need to get the problem diagnose the issue first.
View 8 Replies
1999 7.3 diesel 150K miles.
Over the winter, it sits in my driveway. I keep it plugged in and start it once a week. Lately when I start it, it cranks over and over several times but will not fire up. I stop cranking, wait a couple of seconds and try again and it will then fire right up. After warming up it everything was fine.
Now that it has warmed up outside, it still requires the cranking, stop and trying again but now even when the engine is hot, I have to do this. What is going on?
View 1 Replies
I don't drive the truck much anymore but over time my MPG has gone to total crap...about 10mpg around town...and that's baby-ing it.
Now it suddenly takes many cranks to finally start on a first start. (cold or warm days)....
View 8 Replies
I recently caught up on some maintenance with my truck, changed the turbo pedestal seals, replaced both batteries, brakes, e-brake cable etc and installed new 10k hid headlights. its a single cab 250 with a 7.3 and zf6 4x4 with 133k. a couple days ago I turned on the headlights and the truck died, restarted no problem and would die the next 5 times I tried to turn them on, then it worked fine. yesterday I got in my truck to leave for work and got no wait to start light, no glow plug chatter, no fuel pump running. turns over just fine but no fire.
I got a ride to work and tried it when I got home, fired right up. I pulled the pCM, checked it out, no weird smells and my TS chip wasn't corroded or anything like that, worked fine. drove to 711 to get a 6 pack and it did the headlight thing again. I removed the HIDs because this all started after I installed them and reinstalled my silvanias and it didn't die when I turned them on. this morning went to leave for work, same no start condition. I disconnected both batteries for 30 seconds to reset anything and same problem. I was about ready to light it on fire this morning.
View 1 Replies
My battery light on the dash came on so I tested the battery and it's OK. The last time the truck was started it was 10 degrees and ran for about 3 minutes and shut off because I knew the alternator had to come out. Next I pulled the alternator and had it tested and found to be bad. It was rebuilt and put back in along with a new belt. The motor cranks over well but will not fire. I checked the fuel pump shut off switch and it had not popped up so it seemed fine. The fuses look ok. I ran the battery down a bit so I put the charger on it to bring it up to full charge. When I pulled the alternator I touched it's battery wire to metal for a split second. Sounds like I need to do a pressure test on the fuel system or listen to see if the pump is starting. The truck has 130,000 miles on it.
View 14 Replies
i just bought a 99 F250 4WD with the 5.4 in it i put a brand new starter in it. When i turn the key to try to start it, it just cranks the motor once and stops. The starter isn't grinding or clicking, the motor clicks once and move the belt and pulley a little but that's it. What would cause this?
View 13 Replies
Ok I rebuilt the engine in my f250 5.4 3v. Timing set cam phasers and oil control valves are new. The problem I'm having that just started after 5k miles on a new engine is all of a sudden i will start getting misfires 1st time it happened said #6 i changed coil same problem came back this time said multiple misfires now I'm just getting #4. When the misfires happen if i hold throttle where it is it will misfire as long as i hold it there if I let off gas then apply right back misfires stop for several miles then will happen again. I have changed fuel pump and fuel pump driver module same problem exist.
View 3 Replies
My diesel truck is stuck at work. It cranks but it's not starting up. When I turn the key, the glow plug light takes a lot longer than usual to turn off. When I try to start the truck, it cranks fine and I get a lot of white smoke coming out the exhaust pipe. I've had this truck less than a year and I know very little about Diesel engines. I at least need to get it running long enough to get home. The parking lot at work is really busy pretty much 24/7 and towing it out of there would get pretty dicey.
View 5 Replies
My 2002 F-250 v-10 sat for over a month with me in the hospital for spinal reconstructive surgery. Battery was dead but has been charged and tested as good. The truck cranks strong but will not turnover. I am unable to do other diagnosis, what might be the problem.
View 2 Replies
I replaced the head gaskets on a 2006 F250 6.0 Diesel, put it all back together and started it up. It ran great for a lil bit, then it started cutting out. It did this for about an hour then I killed it and it took a little bit to restart it, spinning over and over to get it to run, this took place several times. The engine died and now it will not start. I keep getting codes P2284 and P2290. What could be causing this problem??
View 9 Replies
My dad has a 2006 F-250 5.4 3v that spun a rod bearing at 107,383 miles. He's never been thrilled with the performance of it (told him he should have gotten the 6.0 when he bought the truck new, but why listen to a 15 yr old ). We've been throwing around a couple different ideas for engine swaps since the 5.4 is dead. We scored a 5.4 2V Lightning engine, but after trying to figure out transmission controllers or if we'd be able to tune the stock PCM for the 2v, we've put the project on hold.
Recently, I've been trying to convince him to do a diesel swap over the L-motor. I have a friend selling a cheap 99 7.3 with trans, PCM, harness, intercooler, piping and other misc stuff. Would that harness generally be plug and play with the body of the 06? Would it be more worthwhile to try to find a 6.0 from 05-07 and swap everything over?
I've also been considering a Cummins swap, although I haven't gone much past looking at complete engines on eBay and Craigslist. Would this be the better route, and just get a standalone controller for the 5R110?
So I'm looking for other's opinions. Should we go 7.3, 6.0 or Cummins? Should we stick with gas over diesel? Try to make the Lightning motor work? Or just go back with a stock 5.4 3V? I should say, he won't sell the truck for whatever reason, so he's not worried about resale or anything. We're in Michigan, so we don't have to worry about emissions. And we're fairly mechanically inclined, so I'm not too worried about doing the swaps, however my knowledge on diesels is limited.
View 4 Replies
I have an 06 f250 6.0 when I'm driving and let off the throttle and coast I hear a rattling sound like a spray paint can being shaked sounds like its coming from engine compartment.
View 6 Replies
So I was going to get the truck washed, but 2 blocks down the road smoke out of the engine bay.
Pulled over popped the hood and the alternator is on fire. Extinguished it self out but the burnt electrical smell.....sheesh..
Anyways, could I potentially drive the truck to the dealer, or will it catch on fire again????
View 11 Replies
I have a 2002 F250 7.3L and it wont start. Its been sitting for the past few days in the cold because the batteries were shot but was plugged in the whole time. I replaced the batteries today and even poured diesel 911 5 hours before trying to start it in case the fuel was gelled. It cranks fine but just wont turn over.
View 2 Replies
I have a 2000 f250, 5.4l triton v8 that cranks like crazy, but won't start. When I spray a little starter fluid in it it will run until the spray wears off. Brand new battery and full gas tank. it does have check engine light on dash, probably from the o2 sensor as the exhaust has almost completely rusted out. Also on a side note the cruise control will not engage.
View 6 Replies
While driving today, 2006 Ford F-250 5.4 L V8 138,000 miles , I experienced a problem. Started with the truck acting as if it was running rough, possibly missing. This was approx. 10 Minutes after starting. Checked the dash, no warning indicators and all gauges were normal. Approx. 4 more miles, the oil pressure alarm signals and I see the oil gauge has dropped to zero. I pull over, turn off and check the oil. Oil is clean and at a normal level. I restart the truck and the oil pressure goes back to normal.
Rev the truck up while sitting there and after a few seconds i hear a knocking noise in the engine and oil pressure drops again. Call the tow truck, driver used to be a mechanic . He asks me to start it again and the same thing happens. If you start it and let it idle oil pressure seems to go up to normal with no engine noise. Finally get to the mechanic and he calls me later saying the oil pump and screen may need to be replaced or the engine may need to be replaced.
View 3 Replies
I recently bought a 2001 f-350 xl 4 door with the 8 foot box it has the 5.4L triton v8. I was heading to a job up in northern Alberta about 10 hours away from where I live. On the drive I lost control of the truck on some black ice I was doing about 50 miles I went into the ditch but nothing crazy drove right out after. Now my truck won't do over 30 mph the engine starts to sputter and back fire I loose all my power, what's going on. At idle she revs fine but as soon as I put her into drive it's like she wants to die what can it be?
View 6 Replies
Looking for a tutorial on how to add the fog lamps to an 06 f250 superduty? I have an xlt with the fog lamp switch just need to install the after market fog lamps they are leds.
View 4 Replies
Last week I flipped the fan switch on and noticed that only hot air was coming from the vents, even with the control set to AC. The vent control switch seems to work fine directing the air but only hot air. The temperature control does not work. The exception is when I put it on max AC I get cold air. I can't be the only one.
View 4 Replies
2006 F250 5.4 - While driving ac changes from vent to defrost on it own..let off gas and it will change back to vent. I replaced vacuum can under hood.. no luck.....
View 1 Replies
