Ford Super Duty (1999-2016) :: 2006 - After Accelerating Hard Rev Out?
Jan 21, 2016
I have an issue with my 6.0 that no one can figure out. It has been happening for about 3 years. After accelerating hard, motor will rev out like it just popped out of gear. It is still in drive and the edge cts says 4th gear usually. I have to let off the pedal and coast a bit and everything "sync's" up again and works fine. It can happen from a hard launch from a light or get on the freeway. I recently put an ATS transmission in because I figured solenoids were beginning to fail. Still does it. I am running innovative tunes with sct tuner. It had a Suncoast billet flex plate and ATS 5 star converter. I run Amsoil fluid, it is clean, red, and at the proper level. Truck has almost 80k miles. Also 37" tires and 4.88 gears. It has not done it while towing our 35' toyhauler, but I am easy on the pedal when I tow. I recently checked the transfer case and changed fluid to Amsoil. The old fluid looked good.
View 7 Replies
Advertisement
Ok so I'm having a problem that seems to have been getting worse. 1999 7.3, auto, 4 door, long bed, 6" lift. When I got the truck a while back I had a slight problem where if I was accelerating hard I would hear a clunk when it shifted into 3rd gear. I'm not hard on the truck that often so it took me a while to realize that the noise was the driveshaft hitting the floorboard right at the joint at the transfer case output.
The carrier bearing was flopping around a bit so I replaced that first. No better... kept driving the truck since it was only a problem while being really hard on it. But it's gotten worse so now when I tow (usually not more than 7-8k lbs) I have a bad vibration on takeoff at low speed. If I try to take off from a stop very hard with any load the driveshaft jumps into the floorboard. So I just replaced the transmission mount and checked the motor mounts, no better. Only thing I can figure at this point is axle wrap...?
View 14 Replies
I've been having sporadic starting issues with my truck since the fall. I had the spark plugs changed but that did not work. The hard starts usually occur when the engine is hot....after filling gas or just running into the grocery store. The engine seems to turn over slowly the first try and won't start. The second or third try the engine turns over normally and the truck usually starts.
I just got back from a 90 minute drive and shut off the truck for 5 minutes and now it won't even turn over. My thought is that it can't be the battery....its been charging for 90 minutes. Headlights are strong, wipers work fast, fan blows hard. That being said I think alternator or battery can be ruled out?
Where do I look next? Starter? Is there a starter solenoid that could be defective?
View 6 Replies
When braking the truck shakes terribly, enough to toss a drink out of the cup holder almost. Sometimes there is a slight feeling in the peddle but not always. The shudder feels like it is timed with each revolution of the wheels.
It developed from a perfectly stopping truck over the course of maybe a month. I don't drive the truck that much either.
Things I have checked:
1, all u-joints, they all look and feel good, no play or slop in them
2, air pressure in all tires, even rotated them, no effect
3, brakes-front and back all looked good but I went ahead and replaced front pads and rotors, cleaned caliper pins, zero effect.
4, shudder exists whether in gear and slowing or in neutral, 2wd and 4wd
What the heck else is there to check? My first thought was, front brakes/warped rotors, but after pulling them apart there was so much life left on the rotors and pads and replacing all that with new did nothing! Could bad back brakes cause this much of a shudder? They look fine as well.
View 5 Replies
I have an 06' f350 6Ltr. Over 300 k. Good shape, i have owned it for about a year. My first diesel. Last week it wouldnt start, had a 1/4 tank. Read about problems with other trucks with a broken pick up on fuel pump. So i filled the tank and it started. Next morning used command start and it ran for 1 minute then shutdown. took about 5 minutes of manually turning it over and it fires up ran all day. Does this almost everyday since and now shuts down while driving after hard acceleration and surges under acceleration when on incline or underload. Changed fuel relay, fuel filters. Researched and asked around but getting mixed opinions. I am mechanically inclined but this is a little beyond my scope of trouble shooting and id rather not start throwing parts at it.
View 1 Replies
My manual hubs on my 2006 f250 have become very hard to rotate so I would like to replace them. I saw that bronco graveyard has Warn hubs for a Dana 60 front axle. Is this what I need? My door sticker with the axle code is illegible, and I want to make sure I get the right hubs.
View 5 Replies
06 250 5.4 40k on it, usually when cold and accelerating engine will misfire and stutter and then continue accelerating. The wrench light will flash sometimes but it wont store a code. This used to be vague in occurrence but has now started to be more a common occurrence even when up to normal operating temps.It seems only to misfire /stutter on hard acceleration or towing/hauling heavy loads. The only answer I got from a mech would be to do a computer reflash, not sure why /how this would fix whats going on.
View 1 Replies
During the winter, the truck would always start very hard. When it was trying to start it would pump out some white smoke. Now during the summer the truck will still start hard. At one point during the winter we were getting glow plug codes, now these have gone away that its warm. We did replace the glow plug control module, but that did not solve the hard start during the winter. We figured that there was a bad glow plug which is sorting out the rest. So we then figured the hard start issue would go away with the warmer weather but it has not.
View 3 Replies
While in Tow/Haul with my 5th wheel when slowing down probably at 5 or 10 mph the last downshift is very hard and the brake pedal gets real soft until full stop. Afterwards the brake pedal is firm. Tow/Haul without the trailer is fine. It's an '06 F250 Supercrew 4x4.
View 6 Replies
So I have a 2016 6.7L love it but it has this vibration at 65 mph that is worse when accelerating up a hill. It feels like an out of balance wheel but I have had them balanced 3 times. road forced 2 times. My dealer replaced the driveline also. I did a test with 400 lbs of concrete bags in the bed and it was vibration free. It almost is like the pinion angle is off.
View 11 Replies
So my '99 F350 4x4 is making a clunking sound and there is a distinct jolt in the truck while this is occurring.
Symptoms: From a stop while accelerating, there is a distinct jolt and clunk. The best way I can describe the feeling is like something isn't tightened down all the way so there is a split second while inertia is generated and the "looseness" catches up to the acceleration.
When stopping, the clunk and jolt is generated when the truck comes to a complete stop. When the truck rebounds backwards a bit because of the suspension pulls it backwards after stopping, you will hear the clunk again.
I replaced the ball joints a week ago an a wheel hub bearing on the right side. I don't recall this before these repairs, but it may have been making this noise. I was more focused on the grinding from the wheel bearing so I may not have noticed the clunk and jolt then.
Where I should start looking for the problem?
View 14 Replies
Truck is a stock 2001 f250 7.3 with 205,000 miles. When accelerating or braking from about 40-60mph it starts to shake a little bit. When braking it shakes a lot more from 60 down to 40. But the faster you speed up the less it shakes when taking off. Looked at everything underneath is tight, and it has stock a stock steering stabilizer. Would a new stabilizer fix this you think?
View 7 Replies
So lately I have noticed that my 99 F-250 has a bit of a "bump" while accelerating. Think of it as accelerating with a trailer and something is loose on the hitch, making a sort of bump or thump. I talked to the guy at the parts store and he said to put it in neutral and wiggle the driveshaft up and down, side to side.
When I did that it moved up and down, but not side to side, but I'm not sure if that's because it's just positioned that way or what. The wobble was coming from the slip yoke back by the rear diff. Is this something I should be concerned about? Also, I have an ext. cab and short box, 1 piece driveshaft.
Here's a video (a very crappy video at that), not sure if it gets enough info through or not but hopefully you kinda get how much play is in there.
View 8 Replies
The truck is a 2012 f250 6.2 flex fuel from alberta canada. This isn't the first tranny form out there that I've heard do this. Tranny seems fine shifts all right just a whine while accelerating.
View 7 Replies
F250 5.4L have had a new fuel pump installed and new spark plugs (one blew out). When accelerating, or at a stop i get a kinda hesitation. It did it when I first bought the truck but put correct size tires on it and it went away. What it may be? I don't have a check engine light or anything and at cruise speed no problem--it's just when a slight load is put on the engine?
View 1 Replies
I have a 1999 F 250. When I accelerate my AC from the vents changes to the defrost. Other than that it works great and is ice cold. Why it's doing this.
View 5 Replies
The other day I was driving to work and I noticed my truck wasn't accelerating right and the transmission wasn't shifting into high gear. Its almost like the truck went into neutral around 2000 rpm. What the issue could be? I really don't want to replace my transmission if I don't have to.
View 3 Replies
My V10 was knocking when accelerating under 2000 rpm; rain and moisture made the problem worse. I discovered that the 2-part wiper cowl under the windshield allowed water to leak into the engine compartment and onto the throttle body, which then dripped onto the left side of the engine. This caused the spark plugs to rust and the 3 back ignition coils (coil on plug) on the driver's side to crack and fail. This caused a horrible misfire/knock that was worst under 2000 rpm especially in high gear and when the environment was wet. I fixed the misfire and cowling leak. Has not returned. I caulked the cowl and changed all my spark plugs and ignition coils.
View 3 Replies
Brand new to diesels with an 02 F250, 7.3 auto, 149k, 4R100. I have been hearing a whine (not the turbo...) for the last few days and after searching the web I'm freaked out about transmission issues. The whine is mostly present in gear while accelerating, I can slightly hear it in park/neutral as well. The sound is a little higher pitched than a power steering pump, pitch rises with acceleration but doesn't FALL as fast as the RPM with shifts, it lags for just a second then drops and starts the climb again with the next gear (i feel like this is indicative of something?). Runs fine and drives like what I would think is normal, only leak i see looks to be from valve covers making its way to everything. Transmission fluid looks great on the dipstick.
View 1 Replies
My 1999 superduty seems to be hard to get the 4x4 lever out of 4 low, truck has a 5.4,auto transmission and manual hubs and manual shift lever...
View 6 Replies
I have a older minimax with the latest updates and have noticed that under full acceleration the tranny seems to rev up faster than the truck is accelerating. This occurs i think in 3rd gear like accelerating onto a on ramp etc. Kinda like its slipping if you know what I mean. I'm running the mild tunes in tow mode. Everything else seems ok.
View 7 Replies
