Ford Super Duty (1999-2016) :: 2005 V10 - Fuel Level Data Error And Then CEL Comes On
Apr 6, 2010
2005 V-10... I've found some info on the "fuel level data error" but thought there must be more on this. In the last month or so I get the error on the message center and the fuel gauge goes to E. Happened a couple times here and there and then the CEL has come on. Have nto been able to get the CEL to go out because it happens too often now.
Have tried a couple bottles of Techron because that is suppose to fix it but no luck after about 150 miles. Can't find any loose wires/connectors. Am ready to give up and drop the tank. Is the sensor separate or part of the pump assy? Also don't see alot on dropping the tank on SDs. Any tips?
View 14 Replies
Advertisement
I have an '06 F350 dually with a 6.0 diesel. I bought this used about 5 years ago and for the most part have loved it. i would always smile on the inside when i heard people bash the 6.0...i thought i got lucky....until today.
140k miles. recent oil change. all is swell...until this morning. Stick in key and turn it. glow plug indicator comes on...all lights come on for a few second....wrench, abs, dtc etc....wrench shuts off...glow plug light comes on...4 or 5 seconds later wrench light comes back on....turn key and NO CRANK.
All fuses are fine...starter cranks if i jump the solenoid...but it won't start. Miles to empty and everything else is just dashes hit the OBD and it says "engine sensor data error"/ "trans temp error" ...
View 1 Replies
We just bought and '05 F350 Turbo Diesel, about two days after getting it the check engine light came on. We had the dealer check it since the mechanic wasn't in and it came up as "Fuel Level Sensor" . My husband can't remember the exact code. We have been told it's no big deal but we want it fixed and the engine light to go off. The dealer is giving us the runaround, or at least I think so.
View 14 Replies
My '03 V10 F250 gas with 135k miles on it went from showing weird fuel levels last week, showing low when I just put $40 in it to now being absolutely below empty, pegged as far south as it can get. I have a CEL light on too but my OBD test shows, "N/A 01-01". So all I can think is that there may be an open/short circuit that the OBD cannot diag.
I replaced my fuel pump about 2 years ago with a replacement AutoZone unit and all had been fine since then. I just do not remember if the fuel level sensor was part of the pump itself or a separate item. If it's a integral part of the pump I should be able to go back to AutoZone and get a warranted replacement.
Is there anything I can test a forehand before either pulling the tank or doing a dump-truck again?
View 4 Replies
I just got my 2005 F250 diesel out of the shop. The errors codes P0299 and P2263 were listed on the computer. The service done, was to clean carbon from turobo charger and service the EGR valve. I talked with the mechanic and he recommended that I use Cetane Booster Additive. What would the Cetane Booster do? How would it prevent the carbon build-up in the turbocharger? What should I do to prevent turbocharger carbon build-up?
View 3 Replies
2005 F350 crew cab with 6.0 currently cranks but no start with a P2291 error code. Using scanguage 2 it shows icp 0, IPR 67.7, FICM 47.5 while cranking. Disconnected ICP and still no start. removed icp and hooked up air and I do not hear/see any signs of air leaking. When I disconnect the air it then whooshes out. About 2 months ago got a #1 cylinder contribution error code and changed out that injector and it has ran fine up until this issue.
Can this be a IPR? I am leading towards the HPOP, but as it costs a pretty penny would really love to make sure I tried every other avenue.
I have 197K on it, and 2 years ago did a EGR cooler delete. In May this year replaced the oil cooler, and then in August changed out the #1 fuel injector.
Oil cooler screen was broken. Cleaned the entire reservoir out. Could this just be a clogged IPR? or seeing the change while cranking an indication that it is working?
View 1 Replies
2005 F-250, Diesel, 105K miles, all stock, fuel and oil filters changed in May, about 4000 miles ago.
three times in the last 4 days the truck has seemingly run out of fuel. Got a full tank about a week ago, at the same place I always go, so I doubt it is bad fuel. It ran thru a 1/4 tank with no problems.
4 days ago, it wouldn't start. It just didn't seem like it was getting fuel. It sat for several hours and then ran fine for about 15 minutes and then slowly died out. It wouldn't restart. It sat for 8 hours, and then started again, ran for about 15 minutes and I cut it off.
The next day, it started fine, I drove it 3 miles, cut it off, and an hour later it started but ran for only 10 -15 seconds and it slowly died out just like I was running out of fuel.
I started it this morning and it fired up right away. I let it idle in the driveway for 30 minutes, and it ran fine. I cut it off, went to start it 30 seconds later and it won't fire again.
The backyard mechanic I use for simple stuff wants to replace fuel filters and see what happens. BTW - twice when it wouldn't start, he hooked up his computer and it had no error codes. You can hear the fuel pump running when you turn the key on and the mechanic said he could feel the pump working when he put his hand on it.
Should I let him do that or is there something else we should be looking at?
View 7 Replies
I bought my 2005 F-350 Diesel 6.0 Brand New. Whenever my low fuel light comes on, I only have a few miles to go before I run out of diesel. Is there a way to adjust this light so it will come on with maybe 20-30 miles to go before running out? Its seems to only have maybe a gallon in the tank when this light comes on...
View 7 Replies
I recently bought this truck. and the original owner said since he owned it after a couple of minutes after starting it will say water in fuel in the info monitor. I press esc or whatever it goes away and doesn't come back until the engine is shut off and turned back on again. What might be the issue?
View 7 Replies
2005 6.0 F250 super duty ... I was getting the water in fuel light as I have in the past. I drained the fuel pump on the frame like always, but it came back. So I changed the filters thinking this would do it but the light comes on every time I drive. What gives?
View 4 Replies
Recently had extensive work done on my 2005 F250 PSD. 4 injectors replaced, fuel regulator, and STC fitting on HPOP.
Got the truck back, and the fuel gauge, and "distance to E" display are working intermittently.
When the truck went in for repair, it was about 1/8 tank. After repairs, shop put about 30 miles on the truck.
I picked it up, and the gauge read E, and display said 0 kms to E. I filled the truck up, and the gauge still read E, and said 0 kms to E.
I then drove for a while, then powered down, and back up again, and gauge read below E (like when truck not running), and display had 4 dashes...no numbers, for distance to E. I powered down, and then back up, then it read 696 kms to E, and gauge working normally.
This morning, on a cold start, the 4 dashes, and empty reading returned. I shut off truck, and restarted it, and it started working again.
Could the shop have damaged the sending unit, while driving 30 miles, with so little diesel in the tank?
View 5 Replies
I recently bought a 2005 Ford F250 Super Duty, diesel 6.0.
As I was driving to work this morning I noticed that the fuel gauge read almost full when it should have only had a half tank. A little while later I heard a beep and saw that the gauge was now on empty with a "Low Fuel" message displayed. Then I noticed the heater was suddenly blowing cold air.
I've only had the truck for a few weeks, but haven't had any other problems. I did replace the CD receiver and all of the instrument cluster lights a couple weeks ago, but everything seemed to be working fine after.
View 1 Replies
I have an 2005 F250 4.2tdi XLT. There is a buzzing sound coming from somewhere near the fuel filter area in the engine bay. This started after changing the fuel filter during a service. Its also difficult to start now. It has to swing for 10 secs before the engine fires. What it could be?
View 4 Replies
My dads 05 f250 6.0 PSD. He says he'll take off in the morning and the fuel gauge will randomly drop to empty and trigger the low fuel light, but then also the Check Engine Light will come on. My brother did a code scan and no codes come up. Where we should be looking to remedy this one?
View 14 Replies
I just got a 2001 F250 with a Rebuilt V8 5.4 with 310,000 miles about two months ago I changed the oil about three weeks ago. I put full synthetic 5-20w and I went to check the level today and it was way low. I see no leaks and I don't see it mixing with the radiator fluid. Is this normal might it just be burning oil ? I do drive the truck at least 100 miles a day.
View 7 Replies
I have a fabtech 4 link 6" lift on a 2008 6.4. The lift kit used to sit level but the front is sitting lower now. How can I fix this?
View 10 Replies
02 LSV8. 174k miles. Today it threw a Fuel Data Computer Error on the computer readout and the fuel gauge parked at E as if the engine was off. I am sure I have over 1/2 tank of gas.
View 14 Replies
I filled my coolant yesterday after driving to the "max" line. Today when I awoke it was right at the "min" line. I didn't see any noticeable liquid below the truck, except under each front fender but I think this was water from the dew evaporating/condensing and running off the truck. What happened to the coolant or did it just cool down and condense. It got pretty cool last night (mid 40s). I have an 02 f250 5.4L ... I feel like there is a leak somewhere, any link to or a procedure they can explain for finding it?
View 10 Replies
I drained the transmission fluid on my 2000 f250. I measured the fluid at about 6 quarts. I refilled with 6 quarts. I drove until the engine was hot and checked the fluid while running in park. Each time I check it I get a different reading on the dipstick. I wipe off the dipstick each time but sometimes I pull it out and it reads low. The next try it shows about 1/2 inch over full on the dipstick. Can't get two consistent readings. Is it harmful if it is a little over or under full?
View 4 Replies
I noticed my 16 ccsb 4WD lariat 6.2 was slightly leaning to one side in a parking lot yesterday. My driveway at home is dirt and far from level so I would never notice at home. So before I pulled out of the parking spot I got my tape measure out. I've got 41.5 inches from ground to top of wheel well on the drivers side rear. On the passenger side rear I've got 42.25 inches from ground to top of wheel well.
So darn it the truck is 3/4 inch leaning to the driver side. Is this normal? I can understand it not being exact to the millimeter however 3/4 inch seems to me like a lot of tolerance. The bed was empty when i measured and Air pressure in both rear tires is 70psi. I did pull a load with about 2,000 pounds tongue weight the other day however that shouldn't make any difference.
View 14 Replies
I'm planning on doing a 2" level. Will I need a drop pitman arm, or can I stick with the stock pitman arm? Will I need anything else? I plan on doing the level when I replace my coil springs and shocks. (I have another thread on that). I'm driving a 2000 F250 V10 2WD CC SB (twin I-beam front axle) if that info is pertinent to this question.
View 2 Replies
