Ford Super Duty (1999-2016) :: 2005 - Tow Haul Mode - Got Message Check Gauge - CEL On?
Mar 27, 2016
My 05 SD started to flash tow haul mode and check gauges message came on while I was towing my car hauler trans temp gauge quit working then check engine light came on too truck runs fine disconnected batteries then re connect them ( trailer now disconnected) problem solved for about 3 mi of driving then it came back w/o trailer I'm thinking rusty trailer ball on hitch caused this maybe not a good ground for trailer tow computer? What kind of scanner etc do I need to possibly clear this problem out? I am the original owner never seen this happen with this or any other trailer I've towed.
View 3 Replies
Advertisement
This maybe a dumb question. But when do you use this feature? How many pounds should I start using the tow mode? I dont haul much. I just haul a 4place trailer with 4wheelers. And in the bed another 4 wheeler or camp gear. All the 4wheelers weigh over 650lbs wet and the trailer not too sure but its steel.
My truck doesnt have a hard time hauling, it shifts fine. Feels like its not even hauling anything. I did use to tow mode once but it seem it just keeps the rpm higher and I felt that the highter rpm was not needed when I was hauling.
View 14 Replies
I have a 2009 F350 and use it almost exclusively for towing. Every time I stop to fill up or eat or whatever I have to push the tow haul button again when I start the truck- no big deal really just annoying at times because I don't always remember to turn it back on. Is there a way to have it turn on with the button and not turn off until I push it again (even after the trucks been turned off)? I suppose while we're on the subject same with the heated seats?
View 12 Replies
OK....my gas cap (5.4 gasser) wasn't put on properly at the gas station. A couple of blocks later, the "Check Gas Cap" notice came on. I stopped a few blocks later, and installed the cap properly. The notice STILL came on. After messing with the cap 4 more times, I gave up, but the notice is still on. Do I need to have it "erased" like a code, or is there a problem with the cap? Everything LOOKS fine...
View 2 Replies
I have just bought a 2004 F-250 SuperDuty 6.0 Diesel with 98k miles from a Ford dealer (no warantee)...
Just after I drove it home I noticed the Tow/Haul mode switch was not working - no dashboard light and no transmission downshifting.
The dealer took the truck back in and kept it for 2 days, it came back working, they claimed to have replaced the gear shift lever. 500 miles later and the Tow Haul has failed again.
View 14 Replies
New 2016 - 6.7 automatic with exhaust brake:
In tow haul mode is the exhaust brake automatically activated or do you still have to turn on by button? Getting mixed answers, and seems to me that it does not activate unless you push the button which is seems to be what the literature is saying.
On steep downhill pulling heavy trailer, in tow haul mode every time you hit the brake it downshifts, and isn't long before it will over rev, unless you kick it out of tow haul mode. is there a way to hold it in a gear in tow haul mode? Or should I shift into manual mode at the top of the hill then use the +/- buttons.
View 5 Replies
One of our trucks, 2004 F350 Powerstroke, my company truck, recently the last snow even we had, my tow haul mode would pop on and off almost evertime I shifted from drive to reverse while plowing. I didn't want it on, it just kept poping on and off. Thought maybe the button was stuck, but it moved like normal. My other thought was there is a loose connection in the shifter or column causing it to go on and off.
View 6 Replies
This morning, the tow/haul light came on, tranny temp gauge wouldn't read (stayed below zero), "check gauges" warning came up on the panel, and "check engine" light came on. Truck ran fine/shifted fine, always has.
2007 F-250, V-10, 5-r 110 tranny.
View 5 Replies
My dads 05 f250 6.0 PSD. He says he'll take off in the morning and the fuel gauge will randomly drop to empty and trigger the low fuel light, but then also the Check Engine Light will come on. My brother did a code scan and no codes come up. Where we should be looking to remedy this one?
View 14 Replies
Looking for a diagram of where the transmission temp sensor is found ..... I have a 2005 f 250 5.4l FX4.... My tow haul light keeps flashing...
View 4 Replies
Just about every trip i take my temp gauge pegs and dinger goes off and check gauges lights up in the message center. It eventually will go back to normal or if i shut key off and restart truck it goes to normal. im guessing it is the temperature sensor for the gauge but not sure?? If it is, where is the gauge sensor located?
View 14 Replies
I have a 2005 f250 super duty turbo diesel 6.0 automatic. The problem I'm having is, when I engage the tow/haul button the transmission doesn't down shift unless I feather the pedal. Also the engine will overheat at times. I've replaced the thermostat, but that's all so far.
View 2 Replies
OK, I got the message, ran the tests, all is well. Now how do I clear the message? It's a 2013 F350 6.7PSD.
View 11 Replies
A few days ago my check coolant additive message start popping up, 14k miles. After doing some reading it sounds like all I need to do is either have my coolant tested or get the test kit and do it myself. My confusion is which test kit to purchase. Since my truck is a 2015 PSD some people are saying that I need to buy a test kit that comes with test vials instead of using the test strips. Which test kit should I buy?
View 14 Replies
I have a 2008 f350 6.4 (105,000 miles) and I am randomly getting the check charging system the batterys have a standing voltage of 13.8 and 13.9-14v (read from the ecu with scanner) both at idle and under a load. I also checked the alternator and its making 13.8-14 all the batteries are tight and there is no corrosion.
View 1 Replies
Every time I put the truck in reverse, I get a "Check Rear Park Aid" message on my display.
I tried wiping all of the sensors clean, and I checked the electrical connections and all seem to be fine.
View 9 Replies
My F250 with V10 has developed an overheating problem. While driving, the temp gauge suddenly shoots to max, and the truck goes into limp mode. Turning off the truck and ignition, waiting a few minutes, and all seems to be well again - sometimes for only a minute, sometimes for several days. No steam leaking, the water in the reservoir seems to be normal temperature, the radiator is not overly hot, and the AC keeps on blowing ice cold. Me thinks it is not really overheating, it just thinks it is. So where to start? Change the temp sensor first, or the thermostat? It seems the hoses are fairly firm, I don't believe they are collapsing from suction.
View 14 Replies
Bought a brand new F250 6.7 it has 7000 miles in it now and the check engine light comes on and the truck goes into limp mode. I have taken it in to the dealership twice they said there is no code they can find and they just reset the check engine light and it does ok for a bit then starts the cycle all over again. It also is only getting about 6.5 mpg....
View 6 Replies
My 2005 Ford F250 6.0 diesel CLIMATE CONTROL DEFAULTS TO DEFROST mode all the time now. For some reason I'll turn on the AC and it is either already in defrost or changes to it no matter what I do. Is the head unit in the dash the problem or is it a vacuum leak or an electrical issue?
View 2 Replies
Recently had extensive work done on my 2005 F250 PSD. 4 injectors replaced, fuel regulator, and STC fitting on HPOP.
Got the truck back, and the fuel gauge, and "distance to E" display are working intermittently.
When the truck went in for repair, it was about 1/8 tank. After repairs, shop put about 30 miles on the truck.
I picked it up, and the gauge read E, and display said 0 kms to E. I filled the truck up, and the gauge still read E, and said 0 kms to E.
I then drove for a while, then powered down, and back up again, and gauge read below E (like when truck not running), and display had 4 dashes...no numbers, for distance to E. I powered down, and then back up, then it read 696 kms to E, and gauge working normally.
This morning, on a cold start, the 4 dashes, and empty reading returned. I shut off truck, and restarted it, and it started working again.
Could the shop have damaged the sending unit, while driving 30 miles, with so little diesel in the tank?
View 5 Replies
2008 F-250XL, 5.4L V8, 5 speed auto, 3.73 rear.
Two/haul fails to engage and does not light up dash indicator light from time to time. After 4 or 5 tries it usually will engage normally. No codes.
View 2 Replies
