Ford Super Duty (1999-2016) :: 2005 - Rock Back And Forth Violently?
Mar 17, 2013
I have a 2005 F250 with the 6.0L. I went to pass a person, I got the truck up to 80 - 85 mph and made the pass. Everything was fine for a second or two, then the truck started to rock back and forth violently. It shook so hard, it removed cups from the cup holders. I never felt I lost control of the truck, but I have never experienced anything like it before. I slowed the truck down to about 60 mph and the problem stop. What in the world could have caused this?
View 14 Replies
Advertisement
I replaced the steering gear box in my 06 F250 CCLB 6.8 over the weekend with a reman Cardone. The old gear box had what I can best describe as a chatter/binding if you rocked the wheel back and forth, that's gone now. I sucked out as much fluid as I could, then filled the reservoir several times while the fluid ran out, what came out was very cloudy and gritty, guessing the old box was chewing itself up.
Can't seem to find a straight answer - what fluid SHOULD this have in it?
Sounds like I should have used Mercon, looks like I grabbed Type F instead. Could that cause the steering effort to be extremely light? I mean like ridiculously light, tip of your pinkie barely touching and turning the wheel light?
View 5 Replies
I am getting what i think is death wobble at around 45-55 mph in my 2012 but not near as violent as others/videos have described. I do not have a lift but i do have 35x55x12 mud tires. I got an alignment but it is still happening. I have read that it is usually caster but i thought this was only in lifted trucks? I am putting a 3.5 inch lift on it to better clear my tires in a couple of weeks and it comes with a trac bar relocation bracket. Will this fix the issue? I have checked tie rods/ball joints as well and they seem ok. Will the relocation bar fix the issue? I also have dual stabilizers on it. That firm up the steering after i put the tires on but the intermittent wobble is still there. Most of my driving is between 45-55mph so it can become annoying.
View 14 Replies
I've been wanting to install a back up camera on my truck for quite some time now. A month ago I backed into a steel pole in a parking garage and trashed my bumper, making me realize I need a backup camera I ordered a cheap ebay camera and 30 feet of extra power and video cable for the install.
Down the road I'll order something better but for now I'm working with a cheapo 15 dollar camera I know where I'm mounting the camera and where/how I'm running the cables, I'm just not sure how to get my head unit to switch automatically when I engage the truck in reverse. I have a pioneer double din touch screen radio as seen here on crutch field.
[URL]...
View 14 Replies
After a long day at work, I had the pleasure of driving home in traffic. While sitting there enjoying the last of the warm weather, I tapped the brakes to slow down and then the truck shut off. I looked down and naturally the battery light came on. I pulled over, turned everything off, then tried to start the truck. The truck fired right up and all indications were normal. The scan gauge showed no codes and batt voltage was normal at 13.3 volts. Where to start looking? Drive home without any faults for the next 20 minutes.
View 2 Replies
My 02 f250 started shaking violently until when I accelerated and the mechanic said it was the wiring harness in the computer. He said it was caused because of over revving I think it was just because the harness was old. Is it because of over revving? Will it happen again?
View 7 Replies
Just purchased new to me '08 F-350 w/ 150K miles and I'm currently having this issue. It will steer to the left and right sharply, and it will stop if I park the truck for a couple of minutes. Can't drive it on the road at the moment as it's too dangerous. Doing a search revealed the following: steering box or u-joints. Should I try using penetrating oil on the u-joints and see if the problem goes away? What is the easiest way to gain access to the u-joints?
View 11 Replies
2008 f250 standard cab long bed 2wd base model 5.4. This thing has been great for the last few years i i owned it but it developed a shake since i got new tires. My mechanic mounted 4 new Hercules Terra trac at 2's on my 18 inch wheels (275 70 18) and when i got the truck back it was shaking violently at anything over 45. Mechanic says the new tires are heavy and its affecting other things...sounds plausible. So here i am a month later with a New steering stabilizer, all new ball joints, new shocks, new u joints, and 1 new tire (he said 1 of the brand new Hercules had a broken chord). The shake is 80% gone but this truck is still not the same. Anything after 65mph and it has a feint wobbly bouncy shake. I don't think its the dreaded hop that everyone gets on these. I have 2 theories:
1. These cheap tires just suck and will never be right
2. The cheap junk Monroe shocks he put on are way too soft to do anything
so what do i do? Should i get some crazy shocks or will that make this truck even bouncier? Im worried about making it even stiffer than it already is.
View 12 Replies
Truck jerks violently when tring to brake only when towing. Its has done it when towing a large trailer with surge brakes, Does it 1 out of 3 times when stopping with electric brakes (goose neck trailer)...
View 12 Replies
Problem: 55-60+ mph hit a bump front end shakes violently. Slow down to 40 mph it stops. DOES NOT happen every time, and may only happen once a week, but when it does my whole front end feels like it will come loose.
Solutions to date that have not worked:
1. Rotate and balance tires. (tire shop)
2. New shocks. (me)
3. New steering stabilizer. (me)
4. Changed ball joint and bushing in track bar. (Dealership)
5. Check ball bearings and seem to be ok. (me)
6. Check tie rod ends and are ok. (Dealership)
The only other options people have given me:
1. Dual Steering Stabilizer. (Have had truck since Jan and hasn't done it in about 19,000 miles. Why would it need it now? Truck has 109,000 miles on it.)
2. New tires. (If it were the tires wouldn't it do it all the time? )
View 14 Replies
I have a 2000 f350 v10 ext cab 8 ft bed 4wd,i replaced all 10 plugs all 10 coils at 40 mph the truck violently shakes an vibrates read on a few things that could be crack cylinder or bad pistons,i did a test on it an says low compression in 2 cylinders 1&2 what can I do an what is the best option for me as I just got the truck not even a month ago...
View 3 Replies
I was towing a 16' Carmate Box trailer (empty), in tow/Haul mode, through the mountains on the PA turnpike. On an uphill section, 70 mph, suddenly blue smoke was pouring out of the back of the truck. I immediately slowed to about 50mph and pulled over at the next opportunity, about a mile. The bottom of the trans pan was coated with fluid, mostly on left side and the exhaust crossover pipe was smoking. Gauges were all normal. Ambient temp was 90F.
I drove another 40 miles, mostly about 60 mph. No problems. When I started climbing in elevation, and hit 70mph again, the smoke started again. I pulled over again and crawled under to fine the crossover pipe in flames. I grabbed a rag and beat out the flames. Fluid was red. Gauges were normal again. Once I disconnected the trailer, I can find no leaks. Snugged pan bolts. I cannot duplicated the problem without the load and speed.
Background: 2005 Crewcab, 5.4, 5R110 trans, 3.73. 416,000 miles, I have towed about 50K miles of that. Trans always ran great. Never replaced.
View 9 Replies
I just noticed the clips in the pictures. Brand new F-250 crew cab.
There are two of them along the bottom edge of the back glass.
I can't find any reference to them in the owners manual and couldn't find anything by Googling it.
What these are and what they are for?
View 14 Replies
A while ago both back doors on my 01 crew cab stopped working. The outside handles jiggle loose but the inside ones feel like normal. They both went at about the same time. If it's those little black boxes that mount by the handle on the door, how do I even get to it to change it if it's stuck shut? I can't reach my hand in there either to even try to see what's wrong with it. How to get it open?
View 9 Replies
I was taking my boat out of the lake last night. Shifted T-box into 4Low and removed the boat. I then tied everything up and when to shift back into 2Hi and it wont. I have a 2001 F350 diesel w/ automatic and the auto locking hubs.Hubs are not engaged atm. I have never had this issue before and was wondering if a shift solinoid is stuck or something might be wrong with my Transfer case??
View 14 Replies
I have a early 2003 SD with the 5.4 triton. It has a oil leak on the passenger side, the oil blows back and gets on the exhaust.
I have been under the truck with the engine running looking at where the head meets the block and at where the valve cover meets the head and can not see a leak.
Sitting there running at idle it does not drip a drop off the engine but the entire underside of the truck is coated in oil.
I did notice that the depression around one of the upper valve cover bolts was filled with oil, I cleaned out the oil, let the truck run and it stays dry.
View 8 Replies
I know it uses the ignition key, but after that? 2016 F-250 Crew Cab.
View 1 Replies
I did my ball joints, and the drivers side oem manual locking hub was a bear to wiggle out but eventually came. When I put it back in after I finished, the wire retaining ring clicked into place but wasn't seated as far in as the passenger side (I could still see the wire). Didn't think much of it. Drove off. 30 miles later I heard a pop and saw the hub rolling down the road behind me.
Stopped and picked it up, went home managed to find a pair of locking rings i kept off my Dana 50, and I just cannot get it to go far enough in for the snap ring to fully seat in the groove. I tried tapping the axle further in, I tried tapping on the steel part of the hub with a deadblow, but it feels like it's in as far as it will go. Not sure what to do, driving without a locking hub right now.
View 8 Replies
I have a 2014 F-250 6.7 crew cab. Noticed today when I put the truck in reverse there's a continuous steady beep where as before the beep was intermittent, as I got closer to the object it would become faster until it would eventually become a steady beep. Which I'm sure was working correctly. Tried cleaning the Camera lens but it didn't work, it continued the steady beep now I'm worried.
View 14 Replies
I have a 2000 f-350 that overheated 2 months ago I replaced the radiator...it seemed fine for a month then started blowing cold air then would start to overheat and back and forth so I replaced the thermosat.......but when i checked the old one with a cooking theromometer it was fine. not long after that the heater core started leaking so i replaced that..and now its back and forth overheating and blowing cold air....then fine for 1/2 hour..then back and forth again.. Truck has 250,000 miles on it
View 12 Replies
I have a 02 F250 V10. When I am pulling a trailer and began to travel over 50 MPH the truck feels like its moving left to right almost like its sliding on ice. Its worse the more weight I am pulling. When I am not pulling anything there is no issues. The trailers I am pulling are gooseneck trailers. What would cause this.
View 11 Replies
