Ford Super Duty (1999-2016) :: 2005 - Got Warning - Check Air Filter?
Dec 21, 2015
Just had my 2005 F250 a few weeks and the 'check air filter' warning came on
Checked the filter, it looks fine, hasn't come off...it's the cylindrical one.
Dec 21, 2015
Advertisement
Ford Super Duty (1999-2016) :: Check Air Filter Light Comes On Intermittently With Warning Tone
I have a 2006 Powerstroke F350. Recently, the "check air filter" light has been coming on. It comes on intermittently, and every time it comes on it makes a warning tone. Super annoying.
I reset the minder, and even tried unplugging it. No change. I think I must have a short in the sensor wiring, but I can't seem to find a wiring diagram that shows the air filter sensor.
Looking for a wiring diagram that shows how the minder is wired? Or What is the part number for the relevant wiring harness?
Ford Super Duty (1999-2016) :: 2005 F250 - Buzzing Sound Coming From Near Fuel Filter Area In Engine Bay
I have an 2005 F250 4.2tdi XLT. There is a buzzing sound coming from somewhere near the fuel filter area in the engine bay. This started after changing the fuel filter during a service. Its also difficult to start now. It has to swing for 10 secs before the engine fires. What it could be?
View 4 RepliesFord Super Duty (1999-2016) :: Tow / Haul Light On - Check Gauges Warning Came Up - CEL Lit Up
This morning, the tow/haul light came on, tranny temp gauge wouldn't read (stayed below zero), "check gauges" warning came up on the panel, and "check engine" light came on. Truck ran fine/shifted fine, always has.
2007 F-250, V-10, 5-r 110 tranny.
Ford Super Duty (1999-2016) :: Code P0446 And Check Fuel Cap Warning Came On
Got this code a while back (several hundred miles) but have had no runability problems. I know it's the evap canister but my mechanic tells me it could be a myriad of things and he might spend hours on it and still not be able to resolve it. I plan on driving this truck til it's worn out. I've put 125,000 miles on it in 10 years almost all highway. I should be putting much fewer miles on now, only using it when I NEED a truck which should be less and less, mostly for hauling toys.
I hate to drive this thing another 10+ years with the engine fault light on but my mechanic says that if something serious goes wrong it will start to flash. A couple days ago the "check fuel cap" warning came on, but goes off if I hit,the odometer button. I got a new gas cap at Reilly's but it seems like a real POS compared to OEM, very light, and the check fuel cap warning still comes on.
Ford Super Duty (1999-2016) :: 2011 F250 6.2 - Check Gas Cap Warning On Dash?
I am getting this check gas cap warning on the dash. I checked the cap, looks ok... Should I disconnect the battery for a minutes.. and see if it comes back?
View 4 RepliesFord Super Duty (1999-2016) :: Spring On Top Of Oil Filter - Replace Whole Filter Assembly?
So there I was doing a simple oil change and when I took the filter out I noticed the little spring on top, in the center of the big spring (oil filter adapter) cocked to the side with the little plastic piece broken.
does anybody know if I can replace just the oil filter adapter (spring thingy that goes in the middle of the filter when installed) or do I have to replace the whole filter bowl assembly? And if so where would be a good place to get this part?
Ford Super Duty (1999-2016) :: Tranny Filter Change - Stuck Filter ORing
Changing tranny fluid/filter today, all has been going great until I went to take the filter o-ring out that didn't come with the filter. It will not come out! made a hook tool out of an old tooth brush like someone on here did, o-ring wont budge. Tried a hook pick, it wont dudge (actually bent the tip on the pick and started to tear the o-ring). Everything is ready to go back together and get filled, but this stupid o-ring will not come out!
View 3 RepliesFord Super Duty (1999-2016) :: Trans Filter 4R100 - Safety Clip Used To Hold Filter Up?
On my previous 1992 F-350, when I serviced the E40D 2WD trans I replaced the filter during a trans service. I read about some filters falling down inside pan causing shifting issues. There is an aftermarket clip sold that holds the filter in the up position and prevents it from falling into pan.
Is the clip also used on the 2WD 4R100? is it the same issue of potentially falling down in pan as was the case with the E40D? Preparing to service my 2003 F-350 2WD 4R100 and install a new filter and want to be sure I have all parts/supplies ready to go.
Ford Super Duty (1999-2016) :: 2011 F250 6.7 - Check Coolant Additive Warning Light Won't Go Away
I have a annoying check coolant additive warning light that wont go away, is their another way to turn off the light other than the button on the steering wheel? I have searched the forum but have had no luck, my coolant level is at it's proper level.
View 3 RepliesFord Super Duty (1999-2016) :: 2006 F350 - Check Gauges / TBC Fault / Warning Lights
Just got a new-to-me 2006 F350 Super Duty XL with the 5.4L V8 and 5-speed auto. I haven't had a full-size truck in a few years and forgot what I was missing!
When I bought the truck, all gauges were inoperative except for the fuel and oil pressure gauges. The previous owner told me they would work intermittently and at some point just stopped. The usual warning lights - ABS, CEL, and "the wrench" - were all lit, and from Googling and searching this forum, it looked like an easy fix - probably a pinched or frayed shifter wire, or possibly a cluster repair.
I took it home and did a self test on the gauges. The "sweep gauges" made everything swing fine, so I was thinking it might not be a problem in the cluster. I pulled the steering column apart, removed the Tow/Haul overdrive wire from the plastic retainer, re-ran it with some slack, taped the end where it comes out of the shifter (even though I saw no breaks/frays) cleaned the connections, gave it a dollop of dielectric grease in the connector, and put it all back together. VOILA - GAUGES and no warning lights! You can imagine the touchdown dance in the driveway.
Fast forward a few weeks and....back to no gauges and warning lights lit. Figuring the overdrive wire had finally given up, I ordered and installed a replacement shifter figuring it was an easy and cheap fix. No joy - same problem. Tried cleaning and reseating the connection. Nothing. I've searched FTE like mad and it seems like 95% of the problems are with the wire exiting the shifter fraying and/or blowing a fuse, but this is a new shifter. I've also checked fuses #2, #24, #33, #36, #41, and #45 (some referenced #19 but I don't have a fuse there). All were unbroken - just put them back in and reseated firmly. I did a code pull via OBD2 and have a "rear catalytic efficiency degraded" code...not sure if that's related, but figured I just had an exhaust issue.
I may take the dash cover off and try to clean and reset the connections on the gauge cluster, as well as do the same for the PCM. Is it possible that the tow/haul overdrive wire to the PCM (where the shifter connects to) is bad? How to test and/or replace if it comes up bad?
Ford Super Duty (1999-2016) :: 2002 - Gas Engine Won't Start After Replacing Fuel Filter / Pump Relay / Air Filter?
After replacing fuel filter, pump relay, and air filter for good measure my 2002 f250 v10 gas engine still wont start. What to do?
View 13 RepliesFord Super Duty (1999-2016) :: 2005 F250 - Check Gas Cap Message Came On
OK....my gas cap (5.4 gasser) wasn't put on properly at the gas station. A couple of blocks later, the "Check Gas Cap" notice came on. I stopped a few blocks later, and installed the cap properly. The notice STILL came on. After messing with the cap 4 more times, I gave up, but the notice is still on. Do I need to have it "erased" like a code, or is there a problem with the cap? Everything LOOKS fine...
View 2 RepliesFord Super Duty (1999-2016) :: 2005 - Tow Haul Mode - Got Message Check Gauge - CEL On?
My 05 SD started to flash tow haul mode and check gauges message came on while I was towing my car hauler trans temp gauge quit working then check engine light came on too truck runs fine disconnected batteries then re connect them ( trailer now disconnected) problem solved for about 3 mi of driving then it came back w/o trailer I'm thinking rusty trailer ball on hitch caused this maybe not a good ground for trailer tow computer? What kind of scanner etc do I need to possibly clear this problem out? I am the original owner never seen this happen with this or any other trailer I've towed.
View 3 RepliesFord Super Duty (1999-2016) :: 2005 F250 Started Chugging And Check Engine Light Came On
I have a 05 f250 with a 5.4 I'm having issues with I was driving along the truck started chugging along and the check engine light came on so I checked it with my bully dog the codes that came up were p0192 which is fuel pressure sensor circuit low the next one is p0452 is evaporative emission pressure sensor switch low also came up with p0191 tonight haven't dug into that yet.
I change out the pressure sensor switch from a buddies truck didn't make a difference put my sensor in his truck his worked fine I clean the throttle position sensor and The maf also put a new air filter on not throwing a misfire code but seems like it may be. A little background on the truck it's a 5.4 3valve with a bully dog tuner, mufflers been removed added straight pipe mechanically that's all that's done
Ford Super Duty (1999-2016) :: 2005 F250 - Cam Shaft Sensor Replaced - Check Engine Light On?
You know the "mechanic's fiances truck" problem. I recently replaced the cam sensor in my 05' F250 Gas. The check engine light had been on for a while before that and my truck rode great, however I now want to sell it and I can't do that with a check engine light on. It's got about 85k miles on it.
After replacing the sensor, the light went off for about 20 miles, but it is now back on and my truck seems to miss every once in a while on acceleration or cruising. Some days it's worse than others. The check engine light still says cam sensor, but the sensor is brand new.
My fiance is a mechanic, so I don't know all the details about code numbers and such. However, I want to sell this truck pretty soon, and I would like it to run correctly. His dad (another mechanic) seems to think it could be a coil and wants to wait for that light to come on, but I would rather fix the problem and sell the truck!
Ford Super Duty (1999-2016) :: 2005 F250 - Erratic Fuel Gauge Triggering Check Engine Light?
My dads 05 f250 6.0 PSD. He says he'll take off in the morning and the fuel gauge will randomly drop to empty and trigger the low fuel light, but then also the Check Engine Light will come on. My brother did a code scan and no codes come up. Where we should be looking to remedy this one?
View 14 RepliesFord Super Duty (1999-2016) :: 6.0 Powerstroke Will Not Start / Bad Top Filter
My 6.0 powerstroke will not start at all. I changed the rail fuel filter and the oil and oil filter. All oem for caps and filters. But the fuel filter in the engine bay is stuck. I didn't change the filter and I don't think I put diesel on the o ring to lube it. Could this be why it's not starting. I tried using starting fluid aswell no good
View 2 RepliesFord Super Duty (1999-2016) :: 2012 - Have Cabin Air Filter?
Do my 2012 F250 6.7 liter Powerstroke diesel has a cabin air filter? I have looked everywhere I could think of and am unable to find one. Does this mean it doesn't have one?
View 9 RepliesFord Super Duty (1999-2016) :: Fuel And Air Filter Replacement?
How often in miles (mostly highway and city) would you change the following:
1.Baldwin spin on fuel filter added with hutch mod
2. Napa diy 6637 air filter mod with no sleeve over it, just the paper element
3. Stock fuel bowl filter after having added a pre-filter (previously mentioned in #1)
Ford Super Duty (1999-2016) :: Cleaning Exhaust Filter Message
Is this the same thing as the regen? Got it for the first time yesterday at 775 miles. Just curious. On a related note, I've tried to run around town some with 5th and 6th locked out (speeds of around 55-60 on a regular basis, running about 2300-2500 rpms) to try to run this process...am I doing it wrong?
View 10 Replies