How to turn off the passenger airbag on my 2005 f350? Also any info about using Alex pepers OBD scanner on this vehicle? I have a three way interface but cannot get it to work.
View 6 RepliesMy batteries drained twice and now I prob. need new ones but with the key off I can turn the blower on any speed and the passenger airbag light blinks. I hear the clicking from a relay under the dash when I do this. I have checked for leaks in the windshield and found none . The fuse box and the GEM are completely dry. My ignition switch will pull out with the key in it . I noticed this just the past few weeks . Now yesterday my odometer speedometer quit. It did pull a code for this. Maybe it is connected maybe not . My odl light is flashing but still works. My cruise doesn't but I realize it is connected to speedometer.
2000 F350 supercab diesel....
Ok so I got a good deal on a used F350. When I got it home I found the heater was stuck on defrost. I posted on here a few weeks ago with questions on what could be wrong. From that post I learned that my front passenger side hub is stuck locked in. I pulled the vacuum lines at every connection from the pump on and had good vacuum all of the way to the passenger side hub. I turned the axle shafts and found the drivers side is free the passenger side is locked.
I flipped the dash switch and heard the drivers side hub lock. Then I turned the axles again and found they were in fact both locked in. I flipped the switch back to 2H and the drivers side freed and the passenger side was still stuck locked in. So I pulled the passenger side hub off of the truck and found it was seized up. I put it back together and locked both hubs in manually until payday when I can pick up a new hub.
Yesterday we had a lot of ice! Where I park the pickup the front wheels drop into a low spot. I could not get backed out of my driveway with the front wheels in the hole and the rear wheels on ice, so I flipped the switch to 4x4 and tried again. It still could not pull out, the front wheels didn't seem to engage. Now I am thinking I have more troubles than just the one hub stuck locked in.
So, my questions now are, 1 if the passenger side hub is bad but both are locked in it should still go into 4x4 correct? 2, the 4x4 light on the dash lights up when I flip the switch. If I had a bad switch or fuse would I still get the same result (light on and drivers side hub clicking in)? Does this pickup have to move a few feet before it engages the 4x4 or should it click right in? And finally what is a short explination of how the 4x4 system works. The dash switch engages the solenoid on the firewall to switch vacuum down to the hubs but what else does it do? I assume it has some kind of switch or motor in the transfer case that engages the 4 wheel drive?
I have a 2005 F350 XL Heavy Duty 6.0L truck that has 68,XXX miles. I recently changed the rear brake pads and about a week later the rear passenger side is leaking brake fluid. The fluid is slowly dripping from the bottom caliper bolt but i am not sure if there are seals in this area. the driver side is fine and the fluid is only leaking from the bottom caliper bolt not the top.
View 2 RepliesHow do you remove the air bag on a 2014 F350 super duty. I have search every where. Nothing new on Google.
View 5 RepliesTrying to get it off. I removed four bolts nd still having trouble.
View 1 RepliesI'm having trouble finding the source of a vibration in the front end if my 1999 f350 super duty 4x4. The vibration is felt all the time but worse when under 40mph, while braking, and especially when turning.
I have replaced the rotors and brakes, tie rods and Drag links since the issue started but no change. In the vibration. What should I check next?
When in 4x4 and I go to do a 90 deg turn. The steering wheel pushes back to straight and seems like I have to fight it to turn the wheels. What could be causing this? I was in 4x4 Low on a dirt road at first then stopped, put it in Neutral, and turned it back to 4x4 High and then when turning in a parking lot it started doing this.
View 8 RepliesSo my cruise quit working AND my air bag light came on... NO codes and my other steering buttons and horn work?? everything I read points to the spiral cable since the AB light is on. But the horn works?? I don't see how the pressure switch or the brake and clutch switch would make the ab light come on...
View 2 RepliesI have a 2011 F350, with a 4 inch Rancho Suspension lift. Ever since the lift kit was installed, more commonly when turning to the left than right, the anti lock brakes come on and the traction control light comes on/flashes. without even stepping on brake pedal.
It seems to happen when the wheel is at about 80% of max turning, about 15mph. Both wheel hubs and sensors have been replaced. road tested with Ford tech , he watched the speed sensor input while hooked to the computer and all sensor are reading correctly.
Today I went in a constant circle and can make it do it non stop, and when you try to press the brake pedal while the anti-lock (grinding/chattering) noise is happening, it only gets louder.
'08 F350 6.4l 4wd, I had the truck come in with a exploded transfer case. (See pics). Ive read all about this happening to many others. The truck still drove, hubs not locked, plenty of fluid in the TC, pretty sure it was the double Cardan that did it. Anyways I replaced thwith TC, replaced the front driveshaft, filled the TC with recommended fluid. Test drove and drives great, shifts fine. Only until I turned left.
At slow speeds turning hard or 15-20 taking a turn, it sounds like a ratchet clicking from somewhere on the left side, right around the drivers door, from what I can hear from the cab. Does it in 2wd, 4wd hi/low, hubs locked or not. I changed the vacuum pump, no leaks, changed the IWE solenoid, pulled out both locking mechanisms, tightened crossmember, checked everything from the hours of research I did on the internet. I cannot find the problem. I don't know what else to check. Front axles free spin and lock when they are supposed to. I'm at the end...
My 2010 F350 shudders when turning right. From what I read it could be the auto locking hubs not dis-engaging or sticking in the locked position. Tutorials show it's pretty easy to pull the auto locking Hub out taking out the three screws holding it in place. My questions is what type of grease do I need to apply to the auto locking hub once I have them out and determine that is what the issue is?
View 13 RepliesI have and 05 F350 4X4. I put it into 4 wheel drive high yesterday to make sure every thing was working correctly and it was so I went to 4 wheel low and that worked fine. Problem is it won't come out of 4 wheel low. I didn't try to go back to 2 wheel when I was in 4 high. What to look for? The truck has the electric switch to engage 4 wheel.
View 12 RepliesRecently drove a 3500 mile road trip with no issues after installing a SCT X4 programmer from 5 star. Upon returning home the following week the ABS light came on and has not gone off. Additionally, last week the truck stalled while driving down the road at around 45 mph. Had something similar happen last summer, got the truck stuck and was trying to rock it in the mud and every time I shifted from reverse or forward the rpm's dropped to 500 and the truck could not respond to the gas pedal and the ABS light came on. Once I got out and washed all the mud from under it light went off and it ran fine without any warning lights.
Truck is an 05, V-10, 4x4, off road and tow package, lariat. No other mods besides the programmer.
I have a '99 F350 4 door. After a good rain (I live in the Pacific NW), my front, passenger floorboard/carpet is very wet. The interesting thing is, before the latest rain, I pulled up the carpet and put a towel on the slant between the dashboard and foot area. I expected the leak to be behind the dashboard, then run down to the flat footwell. Surprisingly, the towel was not wet; however, the flat foot area was. Especially closest to the seat. The slanting part of the carpet and towel were not wet. If the leak is not coming from the windshield/firewall/behind the dashboard, where else could it be? Also, the truck was parked during the entire time.
View 2 RepliesMy dad gave his 2005 Ford F-350 truck with the gas 5.4L (?) I drove it home. If i floor it it misfires badly, or if the RPM's get over 3000 it misfires then about 3800 it stops and keeps going. but i can't give it to much gas....
The spark plugs where replaced 2 years ago along with the cat converters. I can hear some very fait manifold gasket leak ...
A few days ago it was raining and it had a bad misfire with blinking CEL. but it never threw a solid CLE. can i still put the codes on it to see what cylinder it is? Are these issue related? Where should i start?
2005 F-350 diesel... When I first got it the radio was shutting off by its self, my 02 did the same thing so I wasn't to worried about it.
But things have advanced , radio shuts off , windows wont work? Goes on and off at will , does not seem to be road bump related as they go off and on when Im not moving.
Will stay off until I restart truck sometimes and other times it only stays off for a few minutes.
On my 05 350, I noticed the other day that my 4wd wasn't working, when I needed it of course. I quick test this morning and I discovered my PS hub is not locking in. I've read a lot of posts about it being the opposite, the auto portion causing a problem. In my case, it won't lock in in auto or manually turning. I can lock it in, spin the wheel and the axle shaft isn't turning. The pressure is the same as the other side, not too loose or too stiff. Can I pull the hub assembly off and rebuild it? I watched a video about that, but not sure on how my issue would allow me to work on it.
View 4 RepliesIs there an input for an iPod/xm radio on the back of the stereo? On the front there is an AUX button but idk where to plug in. If so how do you remove stock radio? 2005 king ranch 350 is the truck.
View 11 Replies2005 F350 4x4... I just installed some Bilstein 5100 on all 4 corners. Stock truck. No lift.
Now every bump I go over the truck squeaks and creaks like crazy. It's embarrassing. Sounds like bushings? Truck was fine before with the stock Ranchos.
I torqued rear to 46ftlbs and front to 76ftlbs. I tightened the top nut until the bushings compressed 1/4" each.
No instructions came with them. Do I need to lube something?
This was a last minute install before a road trip and they ride great but I'm hoping the noise is something I can take care of.
My power door locks just started acting up. The driver's side switch will not do anything. The passenger's side switch will lock both doors, but it will not unlock them. Is this a switch issue or the actuator? I am assuming the issue is on the drivers side only and am leaning towards the drivers side switch. With that said, I read about a lot of issues with actuators on these truck which makes me think it may be the actuator? Would the doors still lock if the actuator was toast? If it would, why doesn't the driver's side switch work? I tried replacing the driver's side actuator but it made no difference. I also swapped the driver's and passenger's switches and it does the same thing. The passenger locks only and the driver does nothing.
View 10 Replies