I have a 2005 f350 6.0 has 585000. Installed new hpop and lpop and new ipr .pressured oil system with air don't hear any leaks. After truck done started then put truck together no start same problem as before. No oil pressure on dash. All checks goqd except not enough high pressure.
View 2 RepliesI recently came a cross a no start issue with my truck. It is 2005 ford f350 6.0 ... Found out I have a leak in the high pressure system. When I was taking out the bolts out from the manifold I stripped out two bolts. I know ford part # w301383 is the ford bolt. But I was thinking why use that same bolt and had have that issue again later.
View 1 Replies I have a quick question regarding tire pressure. Where we work, we have a 2005 F350.
Stock tire pressure for stock tires 275/70R18 states 65 PSI for the front and 75 PSI for the rear.
The truck currently has 295/65R18 tires all around. They are some sort of Wrangler tire, not sure of exact model, but they are more of a all-terrain tire. The truck sticks to the road though.
What would be the recommended cold tire pressure with these? Can I stick with what the stock tires would be?
2005 F350 Lariat ..... I cant get my AC to work in my truck.
AC will not cycle on, Originally thought the system was low because I jumped the pressure switch and it cycled fine (But did not cool inside the vehicle). Checked the pressure and it was in the 40lb range on the low side. My blower will only blow on high but I assumed it was a defective fan speed control.. Possibly an issue with the climate control?
Over the last two weeks I have had an intermittent no start on my 2005 F350 6.0. on four different occasions. With enough cranking and charging batteries it would start again. I am running a scangauge, during these no-starts ICP was at 200. I pulled the IPR and the screen was damaged so I ordered a new one thinking the IPR would fail intermittently. Replaced the IPR last night with a new one, and truck ran great. Started it three different times with no problems and let it run about twenty minutes.
This morning, another no-start, but IPR is at 1162 psi now during cranking. I am thinking fuel delivery now, but have not yet checked fuel pressure, I need to find an adapter for the M12-1.5 port on the secondary fuel filter.
Details: 2005 F350 6.0 SRW 150,000 miles 4x4
Studded a year ago
New oil cooler a year ago
Upgraded STC fitting a year ago
Coolant system flushed and coolant replaced with ELC months prior to cooler change
Coolant filter installed months prior to cooler change
EGR Delete
Scangauge II
Plenty of Oil
New Motorcraft Fuel Filters
Fuel Filter Bowl fills fast during KOEO
LPO registering on dash gauge during long crank
1162 PSI ICP during crank
37% IPR during crank
FICM voltage 48 - 47.5v during crank and run
Batteries tested good last week
SYC = 1 (last night while running)
Codes: Threw a code this morning during long crank "P2614 - Camshaft position output circuit" - One forum stated that this code will appear during long cranks - don't think this is my problem. This is the only code that it has kicked out during this issue.
Fuel Pressure = UNKNOWN
I picked up my 05 F350 dually 5 speed w/ the 6.0 powerstroke motor in august... It only had 38k on it when I bought it... its got 43K miles on it now...
Ran great in the warm weather but ever since it got cold out its been a struggle. It was running rough on the way home and kept stalling while i was driving it.. (acting like it was starving for fuel).
I went and replaced both fuel filters and started the truck... let it warm up and it stalled while sitting in my drive way and haven't been able to start it since...
I have fuel additive in it but since I don't drive it all the time (maybe 3 times a week for 30 miles) could it be possible that the fuel is gelling?
I was going to check the EGR valve tonight...
2005 f350 crewcab 6.0 sprayed engine down with degreaser and hosed off 4 days ago wont start have dried and blown everything out still nothing....
View 3 RepliesSo I went to start the truck this morning around 8:00 and it was 7 degrees outside, when the truck started the oil light came on and oil gauge was on low? So I turned it off right away. few hours later I tried it again and still nothing I thought maybe the oil was frozen. After I started the truck the oil was higher on the dipstick so I am assuming the oil pump is functional. What could be causing this? Could it be the the gauge is not working? The truck is a 2000 F-350 V-8 5.4 gas. I'm hoping it is something simple I am suppose to work this afternoon
View 14 RepliesI've got a 2000 F350 crew cab with a camper I bought in Chile and I'm going to be driving it from the tip of south america back to the US. It's a 9 month epic family road trip. It'll involve crossing the Andes several times and going over 15,000 ft. There are roads up to 19,500 ft in various places.
My question is am I going to have problems with the altitude? What can i do about it? I've got another truck which is a unimog, it's slow as hell but has a special kind of booster gas you can inject in to the engine to get it started in very cold weather and at high altitude. I chose the F350 for the truck instead of the unimog because a unimog is slow as hell (think 40mph max speed), but it handles extreme conditions well.
1999 F350 Crewcab 4x4 dually V10. Fan switch only works on High. All fuses and relays look Good. Is it a bad speed control switch? What can it be?
View 8 RepliesI have a miss at high rpms.. I pulled this engine, manual trans, and 4x4 axle and put them in my F350 Majestic motorhome. 156,000 miles on the engine. Slightly dusted engine with good compression 375-400 (cranking and corrected for altitude). Has a little bit of a long start.
No smoke on start up unless 10 degrees or colder
No smoke when pulling either.
Glowplugs ...Good
GPR... Good
Checked resistance from IDM to injectors ...Good
History of some ether for starting before I got my hands on it. I have AE with the ford enhancement. But I am new to working on a powerstroke and new to AE.
ICP ...new
CPS...new
Oil ....new
EBP...new
Installed a pressure gauge to the drivers side upper port on my fuel bowl:
60 psi at idle
55 psi at WOT 2500-3000 rpms under a load
HPOP stabilized pressure is 2750 @ 40% duty cycle
Truck still misses (semi-intermittently) at higher rpm with a load.
Rechecked codes KOEO: None present
I visually inspected valve movement while running (idle). Did the buzz test when cold.... All injectors sounded the same when tested individually.
Did a cct when not completely warm:
P0266
p0272
Repeated the test at normal operating temperature:
P0266
Torque values on rocker arms bolts and injector holds are good. Fuel quality isn't an issue since this problem has remained for 5 tanks of fuel. What I should do next?
Just got larger tires on my truck and tire pressure monitor light is on. How would I go about resetting this?
View 14 RepliesI've looked at this 10 ways to Sunday, but the play on words have me questioning if it is the same thing. My truck says Tire Pressure Monitor Fault. I have a 2011 F350, if that makes a difference. I checked all my tires, they are about 80psi each, front and back. What could be the problem? Is it something to take to a Ford Dealer or something I can fix myself?
View 7 RepliesNew too my Ford, but anyway it's -10 Celsius. My trucks been idling for a few hours and probably will all day because of my job. Usually idles about 600rpm normally. So today the oil temp was about 80degrees Celsius. Then the truck idled up too about 1000rpm for a while. If I touch the gas it goes back to normal idle speed but then starts idling up again after 30 sec. What temp does the truck want too keep it at?
View 3 Replies2013 F350 passenger headlight bulb keeps blowing both high and low? Replaced 2 times now?
View 1 RepliesSo I scored a real deal on a set of Michelin on same size 17" OEM wheels that were taken off a brand new 2017 F-250 at about 100 miles. I installed them on my F-350 and had no faults show up. The tires had been marked as to which corner they had come off of so I put them on the same corners of my truck.
After driving about 50 miles I got a "Tire Pressure Monitor Fault" code. I pulled out my owner's manual and followed the relearning procedure exactly but I get the two beeps and the fail retry message from the left front. I have tried three times and get the same result.
Looking for info if the 2017 F-250 sensors are compatible with the 2011 F-350? Have I overlooked something? I habitually manually check my tires anyway, is there a way to disable the TPMS? Is it time for the dreaded trip to the dealer?
I have and 05 F350 4X4. I put it into 4 wheel drive high yesterday to make sure every thing was working correctly and it was so I went to 4 wheel low and that worked fine. Problem is it won't come out of 4 wheel low. I didn't try to go back to 2 wheel when I was in 4 high. What to look for? The truck has the electric switch to engage 4 wheel.
View 12 RepliesRecently drove a 3500 mile road trip with no issues after installing a SCT X4 programmer from 5 star. Upon returning home the following week the ABS light came on and has not gone off. Additionally, last week the truck stalled while driving down the road at around 45 mph. Had something similar happen last summer, got the truck stuck and was trying to rock it in the mud and every time I shifted from reverse or forward the rpm's dropped to 500 and the truck could not respond to the gas pedal and the ABS light came on. Once I got out and washed all the mud from under it light went off and it ran fine without any warning lights.
Truck is an 05, V-10, 4x4, off road and tow package, lariat. No other mods besides the programmer.
My uncles 1999 v10 started to leak from the high-pressure hose on the gearbox. Replaced the hose which lasted for a short time but is now leaking at the same spot. The hose swivels, is this normal, seems like a dumb design for a pressure hose. Also is there a certain trick to doing this hose? He also insists on using PS fluid instead of the ATF it calls for. Could this cause a problem with the seal?
Edit: Also the truck has been lifted on 35s since 16k miles and its now roughly at 170k. He tows with it as it is his work truck. But the truck is well taken care of.
Have a 06 f350 just rebuilt the engine. Started up ran it down the road a couple miles and lost low side oil pressure. Got back to the house and will not start again so put a gauge on and it only has 3 lbs after cranking for 10-15 sec. Pulled the balancer and lpop cover and front cover had some deeper scoring then before. No noticeable stuff in the pan or filter. Changed out the front cover and lpop. Still has only about 5 psi.
View 3 RepliesVery strange things happening with 2009 F350 Gas, first the heater blower only is now working on high, progressively has gotten worse, low settings started not working a while ago, now only high works. Just recently the strangest thing, start the truck OK, turn on radio OK, turn lights on then the radio goes off. Will bring it to dealer in a day or two if I can't figure this one out.
View 3 Replies