Ford Super Duty (1999-2016) :: 2005 F250 XLT Won't Start And Turn Over?
Mar 21, 2017
So, when trying to start my vehicle it doesn't even turn over. Just clicks continuously. Both of my batteries are putting out 12 Volts. I tried the old arcing my solenoid with a screw driver while key is in on position and I got a couple of turns, but it wouldn't completely turnover. My solenoid has power going to it. Checked all fuses that could coincide with this issue. Not sure where to go from here. I have an 05 Ford F-250 XLT.
View 7 Replies
Advertisement
2005 6.0 F250 SD Powerstroke... Truck died on the road and wouldn't start
The symptoms were... I changed the Radiator and had the cooling system flushed... couple of weeks later it stopped while driving... did some research and talked to a few people and the STC valve seemed to be the issue... So new STC, new intake gaskets, cleaned and new EGR gaskets and I just put in a new Turbo (Ford installed it)... had a stripped bolt under the EGR cooler arm and had to remove the Turbo to get to it.... 14 days later......
Changed STC fitting and gaskets in the high pressure oil pump, IPR screen, exhaust manifold gaskets and Cleaned the EGR and changed gaskets and no start. Tried starter fluid and it turned but wouldn't stay on and the batteries died. Would you all say I'm on the right path?
View 6 Replies
I have a 2000 F250 with a V10, that won't start or turn over. I replaced the solenoid on the fender well, auto store check the starter 3 times and said it was good, new battery installed and same issue of not starting.
Here is a video of what it does when attempting to start : F250 starting issue - YouTube....
Where and what to look at?
View 10 Replies
My 2005 ford f250 fx4 won't activate when I turn the key the light illuminates then turns off but when I start the truck and select it it doesn't go into gear
View 2 Replies
I have a 2005 ford f250 super duty 5.4L the problem am having is the other day I took the truck out the yard an parked it across the street. 2 hours later I went back to move it it would not start the engine just kept rolling over I did this for about an hour it still refused to start. 2 days later I tried it again it started without any problems. I put a code reader on it it said P0453 fuel tank pressure sensor. If that is going bad would that cause that problem or would it be another cause.
View 2 Replies
I have a 05 f250 6.0 that currently will not start and no smoke. Replaced batteries and tested ficm. At initial injector buzz voltage drops to 18.8 then jumps back to 48.8 and drops again to 18.8 while cranking. My question is if the voltage is this low does the pcb still just need a resolder or are there components that will need to be replaced?
View 1 Replies
My 2000 F-250 V10 won't start has a new alternator and new starter all it does is Click when I turn the key?
View 14 Replies
I have a 2005 F250 with the 5.4. This truck has been one thing after another, as you can tell from my other posts. The problem this time is, if it cranks hard to start because it's cold(can be anywhere from as high as 32, but usually in the teens) it will start just fine, then several minutes later throw the check engine light. Put the scanner on, like clockwork, 4 codes, always cylinder 1 misfire pending, misfire on first 1,000 revolutions pending, cylinder 1 misfire confirmed, misfire on first 1,000 revolutions confirmed.
Sometimes you can hear a slight lope in the idle when it does this. Clear the codes, runs perfectly fine. It will never do it after it's been started for the day. Some days you would think for sure it would throw it when it's frigid and the winds been blowing on it, it doesn't bother, other days you wouldn't think it would, and it does.Can the computer think that since it didn't start right up, it misfired?
View 9 Replies
I have a 2002 F250 7.3L and it wont start. Its been sitting for the past few days in the cold because the batteries were shot but was plugged in the whole time. I replaced the batteries today and even poured diesel 911 5 hours before trying to start it in case the fuel was gelled. It cranks fine but just wont turn over.
View 2 Replies
Pulled into parking lot this morning, 05 F250 CC 4x4 V10, truck starts dinging at me, Park brake light comes on. Ease off of gas and idle around to parking place, no sign of brake drag. Release Park brake, no difference, set the brake and release, no difference, guess the microswitch went bad. Not raining, never hit a bump, MAY have had my foot on the brake, but that shouldn't effect the P Brake.
After setting for the 12 hour shift, all is good and well. Did not come back on.
Where this switch is? Is it under the cover by the foot set or under the truck along the cable? Would like to know where to look next time this comes up. Did have 2 new tires installed on the front a week ago, new tierod and aligned at the same time.
Just wondering and curious, my last F150 had all kinds of electrical germlins in the windshield wiper arm.
View 8 Replies
I have a 2005 F250 , 4.2 tdi diesel. I just bought the truck recently and still getting to know it.
I noticed recently that when I turn on the key, the vacuum pump starts running and does not go off. It seems to run continuously and will only shut off if I block the white outlet pipe with my finger. Is this normal or is the pump stuffed.
View 6 Replies
I have 05 F250 SD with 150k on it. The engine has the typical cam phaser knock, timing chain slap on start up and occasionally have a noisy lifter. As long as I use fresh 20-40 oil the engine symptoms are less and the engine runs strong. The motor also doesn't leak or burn oil and the plugs were change out about 20k ago.
The truck is still good and is prefect for my needs so to me it's seems worth fixing the needed repairs. What I would like to figure out how far should I take the motor... just have the chains, guides and phasers replaced or buy a rebuilt motor and swap it? I'm thinking just doing the phases and etc would be 1/2 the cost but may not last as long as rebuilt motor. But realistically I might only put 5-7k miles are year on it anyways.
View 14 Replies
I picked up a set of harley davidson look-a-like headlights online for my 05. I go to install them and when I tighten them up it causes the turn signal bulbs to push in towards the fender on both. I put my hand back there and it feels like the bulb socket is being forced against the header panel assembly. Am I missing something?
View 2 Replies
2005 F-250 King Ranch Diesel ... My truck when I got it the 4x4 wouldn't engage. I replace the front inner seals, and the lock outs. Still wouldn't work. Took the shift motor off and freed it up and it worked fin till today. Changed the shift motor and still nothing. This truck has been nothing but problems since I have had it and now this ... Truck is going on the market soon and would sell better if the 4x4 worked ...
View 13 Replies
F-250 2005 XLT 5.4L 4X4. Had ford for a few years now (Escape as a personal vehicle and econoline as business vehicle). Now I'm having a little problem with 4x4. It wont engage. Worked fine last week and now nothing! I did check all the fuses and when i switch to either 4Lo or 4Hi I can hear a clicking sound behind the switch but feel like it's getting blocked or something. Tries a few time then stop...
View 14 Replies
I have had the ABS light on for about a year now. I looked thru the forums and found that the typical reason if a faulty rear VSS (vehicle speed sensor). I found a replacement part online and got it ordered and replaced the original part. Simple 5 minute fix, but it didn't fix it!
Now when I get in and start the truck the ABS light is off, but after I drive off about 20 yards the light comes back on and stays on.
The other day someone stepped out in front of me at a cross walk and I hit the brakes pretty hard and although the truck stopped in time, the rear wheels locked up, so I'm thinking the issue is at the rear.
View 5 Replies
I came home from a week's vacation and towed my 16' toyhauler to and from the Sequoia Nat'l Park ... no issues during the entire trip. Guestimating about 5 hours after being home, everything was unpacked and the truck/trailer locked but still hitched ... suddenly the alarm went off ... all by itself! Using the ignition key, I was able to start/stop the 6.0l diesel motor, but the alarm kept going.
I pressed the lock/unlock buttons but still the alarm was going off! I repeated this a few times and concluded that only recourse was to disconnect the batteries. That stopped the alarm. While doing the disconnecting, I detected a faint electrical hot, maybe a burn kind of smell but no smoke of any kind.
I'm worrisome about reconnecting the batteries to see if the truck is back to normal ... I will probably just have it towed to a mechanic ... in any event it's going to go somewhere to be looked at this coming Monday.
View 1 Replies
2004 S/D 4x4 V10 F-250 72,000 miles. Replaced Battery about 6 months ago. I have tested the Battery today and it's fine. I had replaced starter at same time. The issue I'm having now is that the engine will not start. Behaves as if the Battery has low charge state, Which is not the case. Starter engages and will "crank" for a turn or two and thats it. like low charge on battery. I don't know what to look for next, except pull the starter and test it. Fluids at Level.
View 5 Replies
I have an 05 F-250 with the 5.4 liter motor, 4" lift, 35" tires 4x4. I have not had any problems with the truck and have 110,000 miles on it. the only thing I even did to it was replace an alternator. Recently it seems to have lost power.
I use the truck mainly for hauling my smaller horse trailer which is roughly 7500 fully loaded but most times i haul it at about 5500lbs.
I also have a 2003 7.3 which we pull at 20,000lbs no problem
View 11 Replies
Dome light (and bed light) won't shut off. Been browsing the forums for similar problems but most of the time it is the door switch issue. I have my doubts about this since the 'Door Ajar' message in the instrument cluster is not brought up, unless a door is actually open. Similarly, when locking the truck and doing a door check, I get only one beep, means all doors are shut. 2005 Ford F-250 Lariat....
View 3 Replies
OK....my gas cap (5.4 gasser) wasn't put on properly at the gas station. A couple of blocks later, the "Check Gas Cap" notice came on. I stopped a few blocks later, and installed the cap properly. The notice STILL came on. After messing with the cap 4 more times, I gave up, but the notice is still on. Do I need to have it "erased" like a code, or is there a problem with the cap? Everything LOOKS fine...
View 2 Replies
