Ford Super Duty (1999-2016) :: 2005 F250 - While Towing ABS Light Comes On?
Dec 22, 2014
I am wondering IF THERE ARE ANY CONNECTIONS WITH TOWING AND THE ABS LIGHT coming on? I just did 360 mile round trip on I84 and I 81 in western NY and eastern PA with decent hill climbs (some with 6% or so grades) - think coal country. I was pulling 8,000 or so pounds (trailer with a jeep on it).
On the way out, the ABS light came on. I pulled into a rest stop and shut her down for a bit. I had been driving on this terrain for the better part of 2 hours. I restarted and the ABS light turned off for the balance of the trip. It was cold (in the 20's) outside. On the return trip 2 days later, the same thing happened after 90 minutes. I stopped again and restarted the trip which turned off the light. This time, the light came back on 10 or so minutes later.
This is the only occasion when my ABS light has come on.
2005 F250 Crew Cab SuperDuty 6.0L
View 4 Replies
Advertisement
We have a 99 F250 193,000 miles with a 5.4 and a 5 speed manual with 3:73 gears and we tow a camper that weighs empty 6700 lbs. I knew something was off when we were bringing it home, there was no real umph in the motor. It wouldn't get past 55 in 5th gear on the express way, and just felt as though it was gonna blow up. Its a new to us truck and on paper it should tow this easily. We have a couple of trips under our belt now, and nothing has really changed. With gear and goodies I dont think we're even talking 7500 lbs. I like the truck, and don't really want to get rid of it. With in reason what should I expect to be able to tow and what can I do to better the situation.
View 14 Replies
My 2014 f250 4x4 crew cab with 6.2l gasser only gets about 7.5-8 mpg at 65 mph while pulling my 27' bumper pull travel trailer. I know that thing is basically a wall trapping the air but is there anything I can do to gain a couple mpg more? I can average about 15 mpg at 65 mph without the trailer on the highway.
View 14 Replies
I know there are tons of threads on this and ive spent hours reading through them. but there are a few differences to mine.
2005 F350 6.0l regular cab long box. 4" lift on Duratec 33". Wheels balanced, driveshafts balanced, all u-joints checked and 1 was replaced (made no noticeable difference), all new brakes and rotors recently(due to wear)
When im not towing, vibration is noticeable between 60-65, but its only slight and i can live with it. Its felt in the seat and not the wheel.
There is also a very low grinding/pulsing feeling that happens as i am slowing down from highway speeds starting at around 10 mph until I completely stop. Its not the brakes and feels driveline to me. Can only be felt at these very low speeds while decelerating/coasting. Feel it in the seat and not the wheel. Not the end of the world but i have a feeling its related to my high speed issues. It is not felt on acceleration and I don't feel it when I am moving around parking lots/etc. ONLY when decelerating from highway speeds.
When I am towing the vibration randomly gets really bad right around 65mph the whole truck shakes and its very uncomfortable. It doesn't matter if I am on the gas or not, hill or no hill. If i slow down to 60 it goes away. It is very rhythmic with road speed (3 pulses with a slight pause)
Been doing a lot more towing lately and its bugging me. I keep falling back on tires, but not quite ready to bite the bullet on new tires as the ones on it still have tons of life left.
View 6 Replies
When I hook a trailer to my '04 F-250 the parking lights stay on. The lights on the truck are not on. I pulled the fuse for the towing lights and they will go out. Pulled what I believe to be the relay according to the owners manual and they still stay on. I have to unplug the trailer every time I stop for any period of time.
View 3 Replies
I have had the ABS light on for about a year now. I looked thru the forums and found that the typical reason if a faulty rear VSS (vehicle speed sensor). I found a replacement part online and got it ordered and replaced the original part. Simple 5 minute fix, but it didn't fix it!
Now when I get in and start the truck the ABS light is off, but after I drive off about 20 yards the light comes back on and stays on.
The other day someone stepped out in front of me at a cross walk and I hit the brakes pretty hard and although the truck stopped in time, the rear wheels locked up, so I'm thinking the issue is at the rear.
View 5 Replies
My 99 f250 ran hot while towing my travel trailer when the fan clutch gave up. ever since iv been noticing coolant loss and pressure in the day tank.ive changed the water pump,radiator. day tank and cap plus the thermostat.
View 9 Replies
I have a 2006 f250 superduty crew cab longbed with the v10 gas motor. it has 201000 miles on it and towed great up until last month. I was towing a 5000lb trailer down the interstate at around 68mph,suddenly it was like the drive train disengaged and the motor had nothing left, check engine light on but no overheat condition or lack of oil pressure. we put a new fuel filter and pump on and maf, took trailer out again and same problem, pulled to the side and turned off, immediately restarted and ran fine. It has a cat not cleaning code in it now!
View 14 Replies
2016 F250 6.7L 4x4
I getting some tranny noise when towing on incline from a complete stop. When I slowly press the gas pedal I hear grinding noise. If i press the gas more my truck starts to move and the noise goes away. It doesnt happen all the time. This started right after my 1000 miles recommended break in before towing per ford manual.
My truck now has 2800 miles and the grinding noise occurs intermediately regular driving. Mostly on steep incline or decline. I haven't taken it to the dealer yet because I cant recreate the issue all the time.
View 6 Replies
Dome light (and bed light) won't shut off. Been browsing the forums for similar problems but most of the time it is the door switch issue. I have my doubts about this since the 'Door Ajar' message in the instrument cluster is not brought up, unless a door is actually open. Similarly, when locking the truck and doing a door check, I get only one beep, means all doors are shut. 2005 Ford F-250 Lariat....
View 3 Replies
2005 F250 4x4, manual locking hubs, ABS light stays on. Plugged it up, front sensors had a bad signal. Replaced both front sensors, still had light. Pulled out the sensors, cleaned the sensor rings the best we could with a little screwdriver. Installed the sensors, cleared the codes. Drove the truck a few miles, light came back on. Plugged it up, same codes. Removed the sensors and there was grease back on the sensor rings. Cleaned it up again, ran through the motions, drove it, light comes back on. Is there supposed to be grease on the sensor ring? It keeps coming back in every time it is driven. My next guess would be the hub bearings are going bad?
View 4 Replies
What will make a loud blower sound cycle on and off constantly when towing if i turn the ac off it stops....
View 7 Replies
I recently bought this truck. and the original owner said since he owned it after a couple of minutes after starting it will say water in fuel in the info monitor. I press esc or whatever it goes away and doesn't come back until the engine is shut off and turned back on again. What might be the issue?
View 7 Replies
Looking for a diagram of where the transmission temp sensor is found ..... I have a 2005 f 250 5.4l FX4.... My tow haul light keeps flashing...
View 4 Replies
2005 6.0 F250 super duty ... I was getting the water in fuel light as I have in the past. I drained the fuel pump on the frame like always, but it came back. So I changed the filters thinking this would do it but the light comes on every time I drive. What gives?
View 4 Replies
I recently bought a 2008 F250 with the 6.4 diesel indirectly from a dealership. The truck itself has 220,000ish kilometers, but the engine (as well as the turbos) are Ford reman that had about 12,000km when I bought it and I have only put about 6500km on it. It is already leaking oil but that is for another thread.
The reverse sensors, steering wheel controls and part of the stock 6cd radio have never worked. The towing system has errors as well. The fuel level sensor often has problems reading the new level after I put in fuel, but that is always fixed by disconnecting the batteries and forcing a hard reset.
I figured the steering wheel/cruise control problem was due to either a broken clock spring and/or the brake pressure switch. I replaced both those as well as the airbag because the horn relay failed closed when I put it back in the wheel. It did not fix the problem. The steering wheel buttons still intermittently illuminate, but the radio controls and cruise control buttons do not function regardless. The truck isn't giving any codes either.
The towing system will activate lights and brakes on a trailer as well as set the gain, but it will not detect that it is actually hooked to a trailer. I cleaned the pins, but I haven't looked any further into it. No codes for this as well.
The reverse sensors/system does not work. It will lock itself in "off". I am guessing this is because one or more of the sensors have failed, but I am skeptical that it would be just that given the trucks other problems.
The radio does work, but the auxiliary input/mode will not work. I ran the diagnostics on the radio and on 'Test 1' I got "SELF FAIL B1342 ECU" and "B2477 CONFIG". I tried to clear the codes, but I can't. I think this means the radio is kill.
View 6 Replies
My 2005 ford f250 fx4 won't activate when I turn the key the light illuminates then turns off but when I start the truck and select it it doesn't go into gear
View 2 Replies
I've been having issues with the charging system on my 2005. The battery was 7 years old, so I replaced it. Now, the battery light comes on dimly (and flickers) when at low RPM. I am thinking alternator. I replaced one on my 2002 F150, but haven't done a 250. How hard are they to get to and replace? This is on a 5.4 gasser.....
View 3 Replies
I have a 05 f250 with a 5.4 I'm having issues with I was driving along the truck started chugging along and the check engine light came on so I checked it with my bully dog the codes that came up were p0192 which is fuel pressure sensor circuit low the next one is p0452 is evaporative emission pressure sensor switch low also came up with p0191 tonight haven't dug into that yet.
I change out the pressure sensor switch from a buddies truck didn't make a difference put my sensor in his truck his worked fine I clean the throttle position sensor and The maf also put a new air filter on not throwing a misfire code but seems like it may be. A little background on the truck it's a 5.4 3valve with a bully dog tuner, mufflers been removed added straight pipe mechanically that's all that's done
View 4 Replies
Pulled into parking lot this morning, 05 F250 CC 4x4 V10, truck starts dinging at me, Park brake light comes on. Ease off of gas and idle around to parking place, no sign of brake drag. Release Park brake, no difference, set the brake and release, no difference, guess the microswitch went bad. Not raining, never hit a bump, MAY have had my foot on the brake, but that shouldn't effect the P Brake.
After setting for the 12 hour shift, all is good and well. Did not come back on.
Where this switch is? Is it under the cover by the foot set or under the truck along the cable? Would like to know where to look next time this comes up. Did have 2 new tires installed on the front a week ago, new tierod and aligned at the same time.
Just wondering and curious, my last F150 had all kinds of electrical germlins in the windshield wiper arm.
View 8 Replies
You know the "mechanic's fiances truck" problem. I recently replaced the cam sensor in my 05' F250 Gas. The check engine light had been on for a while before that and my truck rode great, however I now want to sell it and I can't do that with a check engine light on. It's got about 85k miles on it.
After replacing the sensor, the light went off for about 20 miles, but it is now back on and my truck seems to miss every once in a while on acceleration or cruising. Some days it's worse than others. The check engine light still says cam sensor, but the sensor is brand new.
My fiance is a mechanic, so I don't know all the details about code numbers and such. However, I want to sell this truck pretty soon, and I would like it to run correctly. His dad (another mechanic) seems to think it could be a coil and wants to wait for that light to come on, but I would rather fix the problem and sell the truck!
View 1 Replies
