Ford Super Duty (1999-2016) :: 2005 F250 - Timing Chain Rattle?
Aug 25, 2013
I have an 05 5.4 f250 that had a stuck injector. I changed plugs before I realized it was injector. After that the truck had a terrible rattling noise. I ended up changing timing tensioners and guides (guide was broken). Started it up and have the same noise, like timing chain is loose.
What I think happened is gas got into oil when injector was stuck. I had key on to pull codes. Then it lost oil pressure?
Could this cause can phases to go bad? Also can I just install lockouts or do I need to replace phasers as well?
Not sure if there's anything else I should check
View 2 Replies
Advertisement
I have 05 F250 SD with 150k on it. The engine has the typical cam phaser knock, timing chain slap on start up and occasionally have a noisy lifter. As long as I use fresh 20-40 oil the engine symptoms are less and the engine runs strong. The motor also doesn't leak or burn oil and the plugs were change out about 20k ago.
The truck is still good and is prefect for my needs so to me it's seems worth fixing the needed repairs. What I would like to figure out how far should I take the motor... just have the chains, guides and phasers replaced or buy a rebuilt motor and swap it? I'm thinking just doing the phases and etc would be 1/2 the cost but may not last as long as rebuilt motor. But realistically I might only put 5-7k miles are year on it anyways.
View 14 Replies
Today I either broke timing chain or it fell off on the passenger side bank of my 08 F250 V10. Put a hole in valve cover. What to expect for repairs. Is this engine Zero tolerance.. unsure if I should expect bent valves or not and just how far I may have to go with this.. best way to test. I have a bore scope camera and mechanical abilities.
View 14 Replies
I have a 2005 Ford Explorer with a 4.0 SOHC while the engine is running the left side timing chain rattles. I replaced the timing chain and guides and tensioner, the engine has good oil pressure but the noise is still there.
View 2 Replies
My factory-ordered 2016 F250 CC SB 6.2L 4X4 3.73 is about 6 weeks old. Driver and passenger side door rattle noise (in upper back corner) at highway speeds (65-75 mph) has gotten progressively worse over those 6 weeks. See attached video.
Trying to determine if this is caused by:
Door seals: the temperature here in Iowa has dropped from a few weeks in the 90's to the now in the mid-60's.
Could the temperature change have caused the seals to change shape/structure and result in the rattle/noise?
The exterior seal between the front and back doors (attached to front of the back door): mine seems a little loose on top, but nothing that would cause this kind of noise.
View 14 Replies
I have a "rattle/knock" that I think is coming from the doors on my 2000 F250 SD extended cab. The rattle is only there when the truck is going over bumps....especially closly spaced bumps. My buddy has the exact truck and it does not rattle.
View 14 Replies
Have a 15 250 diesel and my drivers side door has a rattle in it. Seems to be coming from around the area were the mirror buttons are. Removed that little panel and applied some silicone around the edges and seemed to work for a bit then back to noise. Seems to go away when cab heats up good or warm outside.
View 5 Replies
2005 F-250 King Ranch Diesel ... My truck when I got it the 4x4 wouldn't engage. I replace the front inner seals, and the lock outs. Still wouldn't work. Took the shift motor off and freed it up and it worked fin till today. Changed the shift motor and still nothing. This truck has been nothing but problems since I have had it and now this ... Truck is going on the market soon and would sell better if the 4x4 worked ...
View 13 Replies
F-250 2005 XLT 5.4L 4X4. Had ford for a few years now (Escape as a personal vehicle and econoline as business vehicle). Now I'm having a little problem with 4x4. It wont engage. Worked fine last week and now nothing! I did check all the fuses and when i switch to either 4Lo or 4Hi I can hear a clicking sound behind the switch but feel like it's getting blocked or something. Tries a few time then stop...
View 14 Replies
I have had the ABS light on for about a year now. I looked thru the forums and found that the typical reason if a faulty rear VSS (vehicle speed sensor). I found a replacement part online and got it ordered and replaced the original part. Simple 5 minute fix, but it didn't fix it!
Now when I get in and start the truck the ABS light is off, but after I drive off about 20 yards the light comes back on and stays on.
The other day someone stepped out in front of me at a cross walk and I hit the brakes pretty hard and although the truck stopped in time, the rear wheels locked up, so I'm thinking the issue is at the rear.
View 5 Replies
I came home from a week's vacation and towed my 16' toyhauler to and from the Sequoia Nat'l Park ... no issues during the entire trip. Guestimating about 5 hours after being home, everything was unpacked and the truck/trailer locked but still hitched ... suddenly the alarm went off ... all by itself! Using the ignition key, I was able to start/stop the 6.0l diesel motor, but the alarm kept going.
I pressed the lock/unlock buttons but still the alarm was going off! I repeated this a few times and concluded that only recourse was to disconnect the batteries. That stopped the alarm. While doing the disconnecting, I detected a faint electrical hot, maybe a burn kind of smell but no smoke of any kind.
I'm worrisome about reconnecting the batteries to see if the truck is back to normal ... I will probably just have it towed to a mechanic ... in any event it's going to go somewhere to be looked at this coming Monday.
View 1 Replies
I recently purchased this truck and have towed a couple of times with it. It has 98,000 miles and I do not know if the automatic transmission fluid has been changed. Should I have it flushed or drop the pan and change it? I have a lift so doing the change is no problem, although it might be worth it to pay a transmission shop to do it.
Also, I hear what appears to be like a heat shield rattle or something that sounds kinda like an exhaust leak during loaded acceleration. What to look for to locate the noise? One last question, the air bag light is on sometimes then off sometimes. Any known air bag light issues? I love the truck, hate the gas mileage!
View 11 Replies
I have an 05 F-250 with the 5.4 liter motor, 4" lift, 35" tires 4x4. I have not had any problems with the truck and have 110,000 miles on it. the only thing I even did to it was replace an alternator. Recently it seems to have lost power.
I use the truck mainly for hauling my smaller horse trailer which is roughly 7500 fully loaded but most times i haul it at about 5500lbs.
I also have a 2003 7.3 which we pull at 20,000lbs no problem
View 11 Replies
Dome light (and bed light) won't shut off. Been browsing the forums for similar problems but most of the time it is the door switch issue. I have my doubts about this since the 'Door Ajar' message in the instrument cluster is not brought up, unless a door is actually open. Similarly, when locking the truck and doing a door check, I get only one beep, means all doors are shut. 2005 Ford F-250 Lariat....
View 3 Replies
OK....my gas cap (5.4 gasser) wasn't put on properly at the gas station. A couple of blocks later, the "Check Gas Cap" notice came on. I stopped a few blocks later, and installed the cap properly. The notice STILL came on. After messing with the cap 4 more times, I gave up, but the notice is still on. Do I need to have it "erased" like a code, or is there a problem with the cap? Everything LOOKS fine...
View 2 Replies
05 5.4 F250 4x4. Keep getting those codes. Can't find any vacuum leaks. swapped rear O2 sensors. Fuel filter twice in last 11k miles last time was 1k ago. Will the 430 code cause the lean codes from a bad cat? I've been getting the 430 code for at least 4 mo's.
View 6 Replies
So, when trying to start my vehicle it doesn't even turn over. Just clicks continuously. Both of my batteries are putting out 12 Volts. I tried the old arcing my solenoid with a screw driver while key is in on position and I got a couple of turns, but it wouldn't completely turnover. My solenoid has power going to it. Checked all fuses that could coincide with this issue. Not sure where to go from here. I have an 05 Ford F-250 XLT.
View 7 Replies
2005 F-250, Diesel, 105K miles, all stock, fuel and oil filters changed in May, about 4000 miles ago.
three times in the last 4 days the truck has seemingly run out of fuel. Got a full tank about a week ago, at the same place I always go, so I doubt it is bad fuel. It ran thru a 1/4 tank with no problems.
4 days ago, it wouldn't start. It just didn't seem like it was getting fuel. It sat for several hours and then ran fine for about 15 minutes and then slowly died out. It wouldn't restart. It sat for 8 hours, and then started again, ran for about 15 minutes and I cut it off.
The next day, it started fine, I drove it 3 miles, cut it off, and an hour later it started but ran for only 10 -15 seconds and it slowly died out just like I was running out of fuel.
I started it this morning and it fired up right away. I let it idle in the driveway for 30 minutes, and it ran fine. I cut it off, went to start it 30 seconds later and it won't fire again.
The backyard mechanic I use for simple stuff wants to replace fuel filters and see what happens. BTW - twice when it wouldn't start, he hooked up his computer and it had no error codes. You can hear the fuel pump running when you turn the key on and the mechanic said he could feel the pump working when he put his hand on it.
Should I let him do that or is there something else we should be looking at?
View 7 Replies
Ok says injector pressure sensor low first guess was the upgrade to the blue spring. Did that code clear for a day then comes back on looking at the hfcm but kinda unsure? Came on after we got the real cold snap and i had to buy a block heater I don't see one on here i also added diesel 911 to the tank this is a 05 f250 w 6.0l....
View 2 Replies
I have a 2005 F250 it has the stock head unit in it and i want to upgrade to an oem unit that has nav. Will the nav units from 2006 and newer fit and plug and play in my 05 ?
View 7 Replies
My 2005 F250 started stuttering, lurching, having wild swings in rpms, nearly dying at stop signs, no pickup when stepping on the gas, then taking off like a bat outta hell. After reading many, many posts here and on other sites, I have concluded that the most likely culprit is the ICP sensor, so I picked one up today (along with a EBP sensor - another story). It appears from the many posts that I have read that Ford/Navistar have frequently changed the location of these sensors. My question is: Where are the ICP and EBP sensors located on the 2005s (actual manufacture date is 07/2004)?
View 6 Replies
