Have a Howling coming from my single gas tank, truck was sputtering now and then. Yesterday it died and would not start. Towed it home and then it started. Think its the fuel pump, Is it tough to change.... 2005 F250 Super Duty109K Miles...
View 14 Replies2004 F250, I am getting this howling noise when applying the brakes. It sounds like it is from the left front and is more prevalent when applying the brakes down an incline (off ramp, etc) I pulled the wheels off and the pads were probably 50-60% worn. I bought some new pads and installed them and I still get the same noise. I didn't buy the cheap pads, nor the most expensive either. Either way, I can't figure it out. Would I need new rotors? I would think I would have some vibration if the rotors were warped. My other thought was the caliper, but when I replaced the pads it compressed fine and I lubed the slide rails. Not sure what to do at this point. The truck has 94,000 miles on it, FX4, Lariat, Crew Cab, and it has the 5.4L in it.
View 2 RepliesI recently bought a 2005 Ford F250 Super Duty, diesel 6.0.
As I was driving to work this morning I noticed that the fuel gauge read almost full when it should have only had a half tank. A little while later I heard a beep and saw that the gauge was now on empty with a "Low Fuel" message displayed. Then I noticed the heater was suddenly blowing cold air.
I've only had the truck for a few weeks, but haven't had any other problems. I did replace the CD receiver and all of the instrument cluster lights a couple weeks ago, but everything seemed to be working fine after.
I have a 2005 Ford F-250 Diesel 6.0 my ac works fine but after working a while the air quits coming out of the vents. It happens every time I go on a long trip with the ac or heater. Is like if a duct damper closes because I can hear the motor blower going. The entire ac system is new but it was doing this with the old system....
View 5 RepliesI have a 2010 6.4L turbo diesel. Without a trailer on a mtn incline I have no issues. She will fly up the hill and she is quiet when I'm not pulling the 10,000 Lb trailer. When pulling the trailer, I have a loud howling noise and reduced performance. I had it at the Dealership and I had them check the engine/turbo and they found no problems? I asked if they tested under load and they said yes?? Someone suggested that the "Waste gate valve" was defective.
View 4 RepliesMy truck had devolped a whine/howl over the past coulple hundred miles. I thought it was a wheel bearing failing me. So yesterday I pulled it into the shop and jacked up the front end. Everthing checked out fine so I jacked up the rear end, started it up, put it in gear and to my surprise the noise was from the rear end.
I pulled the rear end apart and found the front pinion bearing had a defect in the race and the rollers were starting to pit out causing the noise and harshness when turning it. The truck has 130k, seal wasnt leaking and fluid looked/smelled normal. I think it was a legitimate defect not from abuse or lack of maintenance.
I have an 2005 F250 4.2tdi XLT. There is a buzzing sound coming from somewhere near the fuel filter area in the engine bay. This started after changing the fuel filter during a service. Its also difficult to start now. It has to swing for 10 secs before the engine fires. What it could be?
View 4 RepliesI have a 2003 F250 4wd with a 5.4 and 6 spd and 175,000 miles. Yesterday I came out to start it and noticed it had a ticking noise coming from underneath. According to the stock gauge it had normal oil pressure and the oil looked nice and clean and was full. I checked it while running and was able to verify that it is coming from the bottom oil pan/bell housing area. Before anybody says exhaust leak, I just put on JBA headers a few months ago and verified it wasn't an exhaust leak. I was assuming it was a rod bearing so I figured I would let it get to operating temp and see what happens. Once it started getting warm it started getting quiet and finally it just stopped once it hit full operating temp. Took it for a drive and found that it does it when in gear no matter what but stops when I put it in neutral and let out on the clutch. it makes the noise in neutral with clutch pushed in, but stops as soon as you let it out.
View 5 RepliesI have a 2002 F-250 7.3. I was driving home from work on Tuesday (highway), I heard an intermittent noise coming from the front end, sounded like a rubbing/grinding noise. Yesterday on my way to wok, same thing, on and off. Yesterday on my way home the noise was constant, didn't go away. The noise comes at about 45mph and stays until I'm back under about 45mph, so mainly just on the highway. I put the truck in neutral and let off the pedal and the noise is still there which tells me it isn't engine related.
Yesterday after work I jacked up the front end, spun the tires, no noise. No play in the tires top/bottom or side/side. Took the tires off and what I did notice is the right axle u-joint is shot. I am hearing the noise in 2wd so I don't know if its the u-joint that's making the noise. Could it be a bad wheel hub bearing? Is it the u-joint? Maybe needle bearing??
I'm close to pulling the trigger on a Crew cab F-250 Powerstroke, 156" wheelbase. Need to know about fuel tank capacity? Ford's website and manual are somewhat cryptic. I believe it's 26 gallons.
View 3 RepliesSwitch out a 5.4 in a F-250 4X4 4 my neighbor now I have a noise like fan blades hitting coming from the torque converter it goes and comes and hits good in reverse...
View 9 RepliesSo after this weekend's hurricane my 2011 f-250 started to making a noise when I accelerate. I don't know if water got in some where. But there's no MIL light coming on.
View 11 RepliesI have a 2004 f250 with a 5.4l and it won't start. I went to leave the store and went to start it and the truck started when I turned the ignition on not when I engaged the starter so I drove home anyway but there was what sounded like a spraying noise coming from underneath the truck all the way home the truck did die once on the way home but started right back up without me doing anything. Got home shut the truck off now it won't crank or anything all my lights and everything come on like normal just won't crank. What the problem is?
View 7 RepliesMy 99 F250 has just recently started making a "rattling" noise. The noise sounds like its coming from the front left wheel area. The noise is constant while driving down the road, its NOT created by bumps or anything, its a constant noise while moving.
View 3 RepliesI've been looking at adding an additional diesel tank to my F-250, since the stock tank only holds some 38 gallons. However, I do not want to lose the space on the bed and have been looking at tanks that are mounted under the bed.
Most tanks I see are welded steel, completely overkill and accordingly priced. I'm wondering if a second stock tank pulled from a junkyard might fit in well, but haven't lowered mine yet to check the complete dimensions.
2002 F-250 7.3 4x4 ...
I have a rattling noise coming from the front suspension (both sides) when going over small bumps. Most people point to ball joints, but I find my case odd because I just replaced
Upper/Lower ball joints
Track bar
Tie rod ends
Shocks
Front U joints
Drag link
I did not touch the leaf springs or the sway bar, except to grease the links, which otherwise looked good.
New to me 2003 F250 Super Cab 6.8 V10. Great condition inside and out. 68,000 miles. Began smelling fuel (gas) a few days after driving it 250 miles from purchase location. Traced leak down to the top of the gas tank. Staining was visible around the rear vent. Applied about 5 psi to the tank and sprayed soap around until I saw bubbles coming from a hairline crack at the rear vent connection. Its where the fitting for the hose comes out of the tank.
My first choice would be to hot weld the crack. I'm not very comfortable with the idea of a heat source near a gas tank. I'm not sure, but the heat from the plastic welder might be hot enough to ignite fumes? Second option is to try some industrial 2 part epoxy (PIG) and seal it with that. Is there pressure inside the tank, and if so how much? Can try this fix with epoxy or JB Weld?
I have this howling sound in the back that is like heavy tread tires. But thats not what it is. Had to have some work done at a shop (no choice) and they noted on the receipt a "horrible noise".
This is any speed, accelerating and decelerating and coasting in neutral. I checked the fluid in the diff, it is filled to the hole, has good color, smells ok, and no metal on plug. The carrier bearing appears bulged out in one area but the shaft is tight. There is no unusual vibration. The shop did say that I need rotors in the rear.
2005 F-250 King Ranch Diesel ... My truck when I got it the 4x4 wouldn't engage. I replace the front inner seals, and the lock outs. Still wouldn't work. Took the shift motor off and freed it up and it worked fin till today. Changed the shift motor and still nothing. This truck has been nothing but problems since I have had it and now this ... Truck is going on the market soon and would sell better if the 4x4 worked ...
View 13 RepliesF-250 2005 XLT 5.4L 4X4. Had ford for a few years now (Escape as a personal vehicle and econoline as business vehicle). Now I'm having a little problem with 4x4. It wont engage. Worked fine last week and now nothing! I did check all the fuses and when i switch to either 4Lo or 4Hi I can hear a clicking sound behind the switch but feel like it's getting blocked or something. Tries a few time then stop...
View 14 RepliesI have had the ABS light on for about a year now. I looked thru the forums and found that the typical reason if a faulty rear VSS (vehicle speed sensor). I found a replacement part online and got it ordered and replaced the original part. Simple 5 minute fix, but it didn't fix it!
Now when I get in and start the truck the ABS light is off, but after I drive off about 20 yards the light comes back on and stays on.
The other day someone stepped out in front of me at a cross walk and I hit the brakes pretty hard and although the truck stopped in time, the rear wheels locked up, so I'm thinking the issue is at the rear.