Ford Super Duty (1999-2016) :: 2005 F250 - Front Blinker Does Not Work When Fully Engaged
Jul 30, 2014
I have been having an issue with my blinker for the past few months. When the blinker is fully engaged, the right front blinker doesn't work. If I just push up on the blinker so it doesn't fully click into place, the right front blinker works fine, so it is not a burnt out bulb. I have also checked my blinker light in my mirrors and they work fine. Left blinker works fine. I am stumped on to what this can be and I need to get it inspected. 2005 F-250...
View 3 Replies
Advertisement
My 2005 F250 just had the cab off in December for head studs and gaskets. Its a Crew Cab short bed FX4 so it has ESOF. When I engage 4x4 the blower will switch from blowing air out of the vents to blowing air out of the windshield defrost. Is a vacuum line plugged in wrong somewhere, or is one cracked? Trying to figure this out, its rather annoying
View 2 Replies
2005 F250 6.0L ... My truck is running really rough when the engine isn't all the way quite warmed up. once the truck is fully warmed up to normal running temp it runs good. I am getting four engine codes. P0672, P0673, P0674, P0676 These codes say 2,3,4, and 6 glow plugs have a open circuit. Can this be the cause of my problem?
View 7 Replies
I have a 2005 Ford F-250 Diesel 6.0 my ac works fine but after working a while the air quits coming out of the vents. It happens every time I go on a long trip with the ac or heater. Is like if a duct damper closes because I can hear the motor blower going. The entire ac system is new but it was doing this with the old system....
View 5 Replies
want to raise the front of my 99 f250 super duty. I only found rough country for my options. I am looking for a 2-3" lift. Will the 3" lift spindles work fine? What else am i going to need? Shocks?
[URL].....
View 1 Replies
Okay this is what I got; I recently purchased high mileage 2004 F250 Super Duty short box super cab 5.4 liter. Came with manual 4x4 handle on the floor so no 4 wheel on the fly and this eliminates the vacuum for the auto hubs so this will not be part of the problem. When engaging the hubs and ONLY when engaged the driver side hub grinds. The 4 wheel drive works but it sounds like its ready to grind itself into oblivion. I did pull the hub and the grinding was gone, I happen to have a spare hub that is good and the grinding returned.
I have jacked it up and made sure I have no play in the wheel itself and the axle knuckle on the axle shaft. Some say remove the front drive shaft? Or turn the wheels all the way in one direction engage the hubs and check for binding? I will do this in the morning, but what does that confirm if it not the hub. Could it be the passenger side echoing across? On my 99 Super duty I kept hearing moaning coming from up front like the breaks were shot and if you stuck your head out the window it was the back echoing to make it sound like the front.
View 3 Replies
My f250 felt like it had a flat as in it was "swaying" while I was driving today. as I'm pulling into my neighborhood it felt as if i had a flat. There is fluid leaking from what looks like a control arm or possibly a canister that's part of a vacuum system. I'm a carpenter obviously by my terminology used in this post. Its dark so ill take another look in the morning but what I'm talking about..
View 14 Replies
Truck is a 1999 F-250 with manual climate control with A/C.
Heater core issue:
Heat is not very warm after engine is fully up to temp. Would like to back flush the heater core without damaging or making it leak. How should I do this safely?
Secondly, if I do make it leak, how hard is it to change out?
View 4 Replies
I broke 2 snap ring plier on this thing, what is the make and model of snap ring pliers used to remove the snap ring off axle in hub ? I have some others but too beefy won't move in there. They need to be long but strong. I've heard Snap On Item: SRPC9000A works but I don't know of any Snap On guys around here and I need to get this thing done.
View 10 Replies
I have a 2004 F250 Torqshift trans, 155,000 miles. It has had a slight hesitation when trans is engaged for about 4 years, not a problem the dealer has no fix they said.
Now today for the first time I had a tow haul light come on while driving on the freeway. It would not go into overdrive and the light keep blinking. Later in the day, I let it cool down and it drove fine to the store about 2 miles. When I got in to drive home it had tow haul light go blinking and check engine light came on this time.
I hooked up my code reader and it's giving codes: P0720, P0751 and P0766.
Should I take it to the Ford dealer, a Transmission shop or have a friend who worked at Ford Dealer do the Work? I see that some people have changed out the TFT sensor and corrected the problem. While the pan is down should I just have all the shift solenoid sensors changed?
View 11 Replies
This must have been asked before but I couldn't find any thread about it. Have a 2006 F350 that makes a rattling sound when engaged in front wheel drive. Sounds a bit like a loose ball from a ball bearing (or a small stone) rolling around. What might be causing this?
View 3 Replies
I have an issue in the passenger door lock on my 2000 F250. My key rarely works on the passenger door. If it does work it takes a lot of wiggling and trying.
I have power locks that work normally and the key works great on the driver's door. How it works but I've heard there is an anti-theft feature where if you hit the lock button twice on the fob the door locks no longer work with the key until they are unlocked with the fob again. I figured my lock issue was related to that.
How to work on this system? What might cause this?
View 5 Replies
I just got my truck recently, when I purchased it the power mirrors do not work. Already checked the 5A fuse and it is good. Tried putting in a new switch from O'Reilly's and still did not work. Are these switches supposed to light up like the window and lock switch? Thinking it might be a break in the wiring or motors are seized but I've read that is not as common.
View 1 Replies
Just bought a 2003 5.4 6 speed 4x4 F250 .. The cruise control does not work at all. The only fuse I can find in the owners manual is a 2 amp one .. it is in good shape .. Where do I look now to solve the problem??
View 8 Replies
My reverse sensors have stopped working. As soon as you put in reverse, the on off button will light up and be telling you that it is off. What is going on and how do I correct this?
View 3 Replies
Do the raptor style boards will work on an F250, 2012?
I hate the stock ones and want something closer to the body and has some rocker panel protection. Alternatives are welcome but not 1k ones.
View 14 Replies
I have a 2001 f-250 that has dome lights that work on occasion. Mostly don't work. The inside dash dimmer won't turn them on. And they will sometimes work with the rear doors opening. Not the front(4 doors). The cargo light comes on all the time. So I don't know where to start chasing.
View 9 Replies
I have and 07 F250 and the #2 speed for the blower motor don't work (hasn't since I bought it) I read that the most common cause of this is the resistor under the hood on the firewall so I replaced that and still no 2nd speed??? Where I look next? Motor itself maybe?
View 11 Replies
I recently purchased a 2003 F-250. The door locks don't work properly, the passenger side will lock the entire truck all 4 door locks actually lock. The unlock on the passenger side does not work and neither does the entire switch in the driver side. I attempted to switch the actual switches from the driver to passenger side thinking that it could be a switch that is broken.
After doing that still only the passenger side would lock and the rest of lock unlock buttons did nothing. I have checked all the fuses in my truck and actually took the door panels off today thinking I might find an obvious problem. I know the actuators are a common problem but because all the locks lock in the vehicle I was thinking it might be something else.
View 1 Replies
2013 f-250 crew cab short box, 6.2 gas with 48k miles. Right rear turn signal does not work...SOMETIMES. I took the brake light assembly off...bulb is good, turned on signal and the bulb will flash so I put it back together then drove a couple miles and then signal quits working again. I can't find any loose/corroded/bad wires at the bulb socket and I can't get the bulb to quit working when I have taillight assembly apart, (trying to replicate failure). There are never any blown fuses either.
View 5 Replies
My 2011 f250 is stuck in park and the brake lights do not work. I have changed the brake switch but still wont shift out of park.
View 4 Replies
