I recently bought this truck. and the original owner said since he owned it after a couple of minutes after starting it will say water in fuel in the info monitor. I press esc or whatever it goes away and doesn't come back until the engine is shut off and turned back on again. What might be the issue?
View 7 Replies2005 6.0 F250 super duty ... I was getting the water in fuel light as I have in the past. I drained the fuel pump on the frame like always, but it came back. So I changed the filters thinking this would do it but the light comes on every time I drive. What gives?
View 4 RepliesMy dads 05 f250 6.0 PSD. He says he'll take off in the morning and the fuel gauge will randomly drop to empty and trigger the low fuel light, but then also the Check Engine Light will come on. My brother did a code scan and no codes come up. Where we should be looking to remedy this one?
View 14 Replies2005 F-250, Diesel, 105K miles, all stock, fuel and oil filters changed in May, about 4000 miles ago.
three times in the last 4 days the truck has seemingly run out of fuel. Got a full tank about a week ago, at the same place I always go, so I doubt it is bad fuel. It ran thru a 1/4 tank with no problems.
4 days ago, it wouldn't start. It just didn't seem like it was getting fuel. It sat for several hours and then ran fine for about 15 minutes and then slowly died out. It wouldn't restart. It sat for 8 hours, and then started again, ran for about 15 minutes and I cut it off.
The next day, it started fine, I drove it 3 miles, cut it off, and an hour later it started but ran for only 10 -15 seconds and it slowly died out just like I was running out of fuel.
I started it this morning and it fired up right away. I let it idle in the driveway for 30 minutes, and it ran fine. I cut it off, went to start it 30 seconds later and it won't fire again.
The backyard mechanic I use for simple stuff wants to replace fuel filters and see what happens. BTW - twice when it wouldn't start, he hooked up his computer and it had no error codes. You can hear the fuel pump running when you turn the key on and the mechanic said he could feel the pump working when he put his hand on it.
Should I let him do that or is there something else we should be looking at?
My water in fuel light came on today so after I get to work I drain the filter like I do monthly and notice the sensor wire had come unplugged. I assume I did not get it plugged in good after my last filter change a couple weeks ago. I replugged the wire and drained the fuel, which was clean but now the light stays on. Is there a reset for the light? It has never come on before in 80k miles. 2011 F250 6.7 Powerstroke.
View 1 RepliesRecently had extensive work done on my 2005 F250 PSD. 4 injectors replaced, fuel regulator, and STC fitting on HPOP.
Got the truck back, and the fuel gauge, and "distance to E" display are working intermittently.
When the truck went in for repair, it was about 1/8 tank. After repairs, shop put about 30 miles on the truck.
I picked it up, and the gauge read E, and display said 0 kms to E. I filled the truck up, and the gauge still read E, and said 0 kms to E.
I then drove for a while, then powered down, and back up again, and gauge read below E (like when truck not running), and display had 4 dashes...no numbers, for distance to E. I powered down, and then back up, then it read 696 kms to E, and gauge working normally.
This morning, on a cold start, the 4 dashes, and empty reading returned. I shut off truck, and restarted it, and it started working again.
Could the shop have damaged the sending unit, while driving 30 miles, with so little diesel in the tank?
I recently bought a 2005 Ford F250 Super Duty, diesel 6.0.
As I was driving to work this morning I noticed that the fuel gauge read almost full when it should have only had a half tank. A little while later I heard a beep and saw that the gauge was now on empty with a "Low Fuel" message displayed. Then I noticed the heater was suddenly blowing cold air.
I've only had the truck for a few weeks, but haven't had any other problems. I did replace the CD receiver and all of the instrument cluster lights a couple weeks ago, but everything seemed to be working fine after.
I have had the ABS light on for about a year now. I looked thru the forums and found that the typical reason if a faulty rear VSS (vehicle speed sensor). I found a replacement part online and got it ordered and replaced the original part. Simple 5 minute fix, but it didn't fix it!
Now when I get in and start the truck the ABS light is off, but after I drive off about 20 yards the light comes back on and stays on.
The other day someone stepped out in front of me at a cross walk and I hit the brakes pretty hard and although the truck stopped in time, the rear wheels locked up, so I'm thinking the issue is at the rear.
I have an 2005 F250 4.2tdi XLT. There is a buzzing sound coming from somewhere near the fuel filter area in the engine bay. This started after changing the fuel filter during a service. Its also difficult to start now. It has to swing for 10 secs before the engine fires. What it could be?
View 4 RepliesDome light (and bed light) won't shut off. Been browsing the forums for similar problems but most of the time it is the door switch issue. I have my doubts about this since the 'Door Ajar' message in the instrument cluster is not brought up, unless a door is actually open. Similarly, when locking the truck and doing a door check, I get only one beep, means all doors are shut. 2005 Ford F-250 Lariat....
View 3 RepliesI am wondering IF THERE ARE ANY CONNECTIONS WITH TOWING AND THE ABS LIGHT coming on? I just did 360 mile round trip on I84 and I 81 in western NY and eastern PA with decent hill climbs (some with 6% or so grades) - think coal country. I was pulling 8,000 or so pounds (trailer with a jeep on it).
On the way out, the ABS light came on. I pulled into a rest stop and shut her down for a bit. I had been driving on this terrain for the better part of 2 hours. I restarted and the ABS light turned off for the balance of the trip. It was cold (in the 20's) outside. On the return trip 2 days later, the same thing happened after 90 minutes. I stopped again and restarted the trip which turned off the light. This time, the light came back on 10 or so minutes later.
This is the only occasion when my ABS light has come on.
2005 F250 Crew Cab SuperDuty 6.0L
2005 F250 4x4, manual locking hubs, ABS light stays on. Plugged it up, front sensors had a bad signal. Replaced both front sensors, still had light. Pulled out the sensors, cleaned the sensor rings the best we could with a little screwdriver. Installed the sensors, cleared the codes. Drove the truck a few miles, light came back on. Plugged it up, same codes. Removed the sensors and there was grease back on the sensor rings. Cleaned it up again, ran through the motions, drove it, light comes back on. Is there supposed to be grease on the sensor ring? It keeps coming back in every time it is driven. My next guess would be the hub bearings are going bad?
View 4 RepliesSo the first issue is, if the vehicle is cold (regardless of temp outside) it takes forever to start it. It cranks and cranks and cranks and after a couple seconds of cranking I stop, wait a second, then try again. Usually it takes two sometimes three tries to start it. The guy who I bought it off of said it has newer glow plugs (last year I believe) and also I have replaced the batteries. Once its warmed up it does not do this at all.
Secondly and also something that just recently started happening, my water in fuel light keeps kicking in. I drained the water out of the water catcher reservoir under the truck multiple times and the first time water actually came out but every time after that simply diesel fuel comes out. I added a bottle of water remover to the fuel as well and ran it down to a quarter tank. Then filled the truck up completely, added two more bottles of water remover. The light still comes on. I noticed it only comes on when I am going up or down a fill. When I am driving on flat ground it does not kick on.
I bought my 2005 F-350 Diesel 6.0 Brand New. Whenever my low fuel light comes on, I only have a few miles to go before I run out of diesel. Is there a way to adjust this light so it will come on with maybe 20-30 miles to go before running out? Its seems to only have maybe a gallon in the tank when this light comes on...
View 7 RepliesLooking for a diagram of where the transmission temp sensor is found ..... I have a 2005 f 250 5.4l FX4.... My tow haul light keeps flashing...
View 4 RepliesMy 2005 ford f250 fx4 won't activate when I turn the key the light illuminates then turns off but when I start the truck and select it it doesn't go into gear
View 2 RepliesI've been having issues with the charging system on my 2005. The battery was 7 years old, so I replaced it. Now, the battery light comes on dimly (and flickers) when at low RPM. I am thinking alternator. I replaced one on my 2002 F150, but haven't done a 250. How hard are they to get to and replace? This is on a 5.4 gasser.....
View 3 RepliesI have a 05 f250 with a 5.4 I'm having issues with I was driving along the truck started chugging along and the check engine light came on so I checked it with my bully dog the codes that came up were p0192 which is fuel pressure sensor circuit low the next one is p0452 is evaporative emission pressure sensor switch low also came up with p0191 tonight haven't dug into that yet.
I change out the pressure sensor switch from a buddies truck didn't make a difference put my sensor in his truck his worked fine I clean the throttle position sensor and The maf also put a new air filter on not throwing a misfire code but seems like it may be. A little background on the truck it's a 5.4 3valve with a bully dog tuner, mufflers been removed added straight pipe mechanically that's all that's done
Pulled into parking lot this morning, 05 F250 CC 4x4 V10, truck starts dinging at me, Park brake light comes on. Ease off of gas and idle around to parking place, no sign of brake drag. Release Park brake, no difference, set the brake and release, no difference, guess the microswitch went bad. Not raining, never hit a bump, MAY have had my foot on the brake, but that shouldn't effect the P Brake.
After setting for the 12 hour shift, all is good and well. Did not come back on.
Where this switch is? Is it under the cover by the foot set or under the truck along the cable? Would like to know where to look next time this comes up. Did have 2 new tires installed on the front a week ago, new tierod and aligned at the same time.
Just wondering and curious, my last F150 had all kinds of electrical germlins in the windshield wiper arm.
You know the "mechanic's fiances truck" problem. I recently replaced the cam sensor in my 05' F250 Gas. The check engine light had been on for a while before that and my truck rode great, however I now want to sell it and I can't do that with a check engine light on. It's got about 85k miles on it.
After replacing the sensor, the light went off for about 20 miles, but it is now back on and my truck seems to miss every once in a while on acceleration or cruising. Some days it's worse than others. The check engine light still says cam sensor, but the sensor is brand new.
My fiance is a mechanic, so I don't know all the details about code numbers and such. However, I want to sell this truck pretty soon, and I would like it to run correctly. His dad (another mechanic) seems to think it could be a coil and wants to wait for that light to come on, but I would rather fix the problem and sell the truck!
I have a 2008 f-550 diesel. Had water in fuel. Flushed the entire system. Replaced the fuel filters and injectors but still will not start.
View 2 Replies