Ford Super Duty (1999-2016) :: 2004 - Overdrive Not Kicking In
Aug 5, 2013
How many gear shifts I should have on my 6.0 2004 super duty, Ive counted 5 but it seems not to be in overdrive, I'm running a little over 2000 rpms at 65 mph?
View 8 Replies
Advertisement
I have a 2000 F-550 w/7.3. I am having a bit of a problem with the hvac system. When I turn the selector switch to floor heat only or put it on vent or both the a/c clutch kicks on and off. Not when I put it on defrost but as I said only when it is in the other positions. I do know that the clutch will kick in and out when on the defrost position. That is fine. But why would it kick in and out when in the heat only position?
View 2 Replies
This is the first winter for my truck, and the first time I've driven a truck in the winter. I struggled to get out of my street this morning, through 15" of unplowed heavy snow. As the traction control seems to engage, and even sometimes when it doesn't, the truck literally shakes very violently. I even had to lock the rear diff to get out this morning, but that didn't seem to make the shaking any worse. What causes the shaking? Is it just my truck? I've driven Land Rovers with full-time 4x4 for years, never any shaking even when they are spinning like crazy and traction control is operating. One thing I did learn that seemed to be a question of several on this forum...traction control does operate on the front wheels when 4x4 is engaged, in addition to the rears.
View 14 Replies
Bought a 2014 SD 4x4 in December of 2013 and this is the second time the big girl has been to the shop with A/C problems. First time it was the evaporator about three or four months ago. During the last few weeks of the summer I began to smell something strange (like band-aids) when the A/C was on and it lingered until the next re-entry. ALso, began to hear a slight hissing noise when the compressor was kicking in and out. They replaced the evaporator, smell remained as they said it was the refrigerant I was smelling. About two or three weeks ago the smell got slightly "larger", and last weekend she would not cool. This is the fourth time shes been to the shop with other problems such as the My Touch system..............
View 7 Replies
So the first issue is, if the vehicle is cold (regardless of temp outside) it takes forever to start it. It cranks and cranks and cranks and after a couple seconds of cranking I stop, wait a second, then try again. Usually it takes two sometimes three tries to start it. The guy who I bought it off of said it has newer glow plugs (last year I believe) and also I have replaced the batteries. Once its warmed up it does not do this at all.
Secondly and also something that just recently started happening, my water in fuel light keeps kicking in. I drained the water out of the water catcher reservoir under the truck multiple times and the first time water actually came out but every time after that simply diesel fuel comes out. I added a bottle of water remover to the fuel as well and ran it down to a quarter tank. Then filled the truck up completely, added two more bottles of water remover. The light still comes on. I noticed it only comes on when I am going up or down a fill. When I am driving on flat ground it does not kick on.
View 4 Replies
My overdrive recently stopped working on my 2003 F250 and I also noticed that the light on the shifter is not lit indicating that OD is off. When I push the button on the end of the shifter the off light doesn't come on like it used to. I have noticed that sometimes after I shut the engine off and re start it will go into overdrive as normal but the button will not light to off or turn OD off when pushed.
I have been reading about chafed wires in the column where it comes out of the shifter but most guys are saying their off light is blinking and their trucks will not come out of overdrive when the button is pushed. My question is, should I check for the chafed wires in the steering column? The transmission shifts great , just not going into OD all of the time and its killing my fuel mileage turning 2900 rpm at 65 mph.
View 13 Replies
Last year I bought a used '99 F350 w/ ~$135K miles on it. I later noticed that when I pressed on the Overdrive button (automatic transmission) which is on the steering column gear change lever, nothing happened. The overdrive light did not come on and the gear did not change to overdrive.
View 11 Replies
Just recently I started blowing PCM fuses (#19 in the fuse panel) After replacing lots of fuses, I finally figured out what was causing them to blow. I unhooked the overdrive switch, and no fuses blow. I can't see anywhere where the wire is chafed. Maybe it is chafed, and I can't see it or the switch is bad. Can the whole OD switch be replaced? If so, how??
View 13 Replies
Tonight i noticed overdrive flashing. No changes in shifting, truck shifted fine. I shut it off when i got home, started back up, light was not blinking, not sure if its like the check engine light and stays on or not. Where light blinks but shifts fine?
View 10 Replies
Overdrive light started flashing this week on my 2000 F450 7.3 mason dump. It only does it when it shifts into 4th gear once it hits that gear at about 35mph the overdrive light flashes until you restart the truck and it resets. Does the same thing all the time but DOESN'T flash if i'm driving around town on back roads and never get to that gear. Could this be something minor besides the transmission starting to go? It drives and shifts fine even when the light is flashing. I wait to get the error code read?
View 10 Replies
2001 F450/6.8. The trim ring is missing on the shift lever switch and the switch doesn't seem to light up or take the truck out of overdrive when pressed. Truck shifts just fine in all other aspects. Fuses all appear to be good.
View 2 Replies
2006 F250 5.4l 4x4, long box, quad cab
Current issue: No overdrive / slipping into neutral / rough going into reverse
Codes: I don't have exact code but will get (p0755)... but shows shifting solenoid B malfunction ( this is the OD/Reverse one) check engine light on and tow light blinking
So whats been done: shifting solenoid B (OD/Reverse) was replaced (used part) inspected valve body and o rings... all good... worked for a week... then exact same issue. Transmission showed no signs of gear damage, oil looks good
Next: Replaced shifting solenoid B again (new one) and transmission wiring harness. Still no change, same codes. Seems to be having a communication issue between transmission and PCM? However continuity of wires and connectors seems ok.
One more piece of interesting info. Every-time before the truck slips I hear clicking coming from the fuse/relay panel under dash drivers side. No clicking no slipping... however never goes into OD at any time.
View 3 Replies
I recently purchased an 02 F250 v10 4x4 with 150k from a local auto auction. The transmission, for lack of a better term, will "grunt" when going into third and in and out of overdrive. It doesn't seem to slip at all and the fluid looks slightly discolored, but it does not smell burnt. No Torque Converter whine either. A friend of mine who has owned 10+ SDs for his business said I may need to replace the TCM. Not too sure about that, because other than the strange noise, the truck seems to shift normally.
View 5 Replies
I had a fuse blow today that runs the throttle and we could not move it. Replaced it and it blew again. I think this fuse is blowing because the wires on my overdrive are broken. Is there anyway to disconnect the overdrive until I can get replacement parts? As there not enough wire there to put them back together.
View 1 Replies
I'm having an issue on my 2002 F350 7.3. Today I hop in it and drive off I notice my speedometer stopped working. My overdrive light on the shifter started flashing. The trans seems like its not shifting correctly. It will eventually shift into overdrive but not always. Also now when I start off my fuel gauge raises and when I come to a stop it drops all the way to E and causes the ding and fuel light to light up. I figured this was all due to the VSS being bad. So I drove over to Autozone bought another VSS and a cheap tool set and changed it in the parking lot. No dice. I do have a scanner to pull the trans code but its late and I just got home.
View 1 Replies
I have a 2006 F250 with the 6.0 PowerStroke and automatic transmission. I just purchased this truck at an auction about a month ago.
Today I notice the transmission is not shifting into overdrive. No warning lights. If I press the tow/haul button in no change but the tow/haul light does come on. If I press it again (to turn it off) the tow/haul light goes out but still the transmission will not shift into overdrive.
This leaves me at about 2000 RPM at 68 MPH. I just had a Ford dealer perform Transmission service last week. (20,000 miles after the last recorded service.)
I am already not happy with the service I received at the dealer so I am really hesitant to take it back to them if it is something not related to the transmission service they performed.
View 5 Replies
1999 5.4 ... I was just driving down road and truck suddenly wouldnt shift into overdrive/higher gear. pulled to side of road and the motor was revving very high at 2500 rpm. shut truck off and on a few times...kept doing it until finally after a while it went back to normal....
View 1 Replies
The switch for turning overdrive off that's located on the auto trans shifter stopped working. I've taken off the column cover to see if the wires have been severed from the tilt wheel, but nothing wrong there. I also checked the fuses, and all is well. Is it possible that the switch is bad at the end of the shifter, or somewhere farther down the column?
View 14 Replies
I have a '99 F250 SuperDuty Diesel with an Automatic Transmission. There is a button on the end of the gear shift which allows you to turn off overdrive -- in other words the transmission won't shift into overdrive once you press the button.
Here's my problem. I start off driving normally. I've not done nothing to the overdrive button and the truck shifts normally into overdrive. 10-15 minutes down the road, the overdrive light (which indicates the state of the overdrive button) is FLASHING. Pressing the button doesn't stop the flashing. Once this flashing starts, the only thing I notice is a much more abrupt shift from 1 -> 2 gear.
View 14 Replies
I have an '01 F350 super duty dually, 7.3L, auto trans. Over the past weeks my overdrive light on the gearshift would flash intermittently, maybe once every couple weeks. I chalked it up to a prior theft attempt where the steering column was damaged, and had turn signal/hazards issues after that.
Over the past few days my reverse gear has taken longer to engage, and is hard getting into the higher gears at speed. As of yesterday, reverse is out and won't shift out of second. Fluid level is good and clear. Could this be a PCM issue, or some sensor or relay?
View 1 Replies
I have a 2001 F250, 5.4, 4X4. My ignition key stuck in the start position and when I pulled it back to the run position, everything seemed ok. As I started down the road, my speedometer stopped working and my overdrive light was flashing. Also my turn signals had stopped working and my A/C clutch didn't engage. Figured I burnt a fuse. I looked in both the under dash and power distribution box and all seemed well. I checked the fuse for the turn signals/flasher and it was fine. The flashers worked. Thought I might have fried something so I replaced the ignition lock and switch. Also my service engine light came on throwing a code for the vehicle speed sensor.
Looking for solutions on this forum and the internet, I learned that the turn signal switch could have gone bad and the VSS sensor is on the top of the rear dif and an easy fix. Well replaced the sensor but nothing changed. So I went back to the fuse box. Examined every fuse, big and small and I found a 10a with a small space. This was #24 under the dash. From the manual, "#24, 10A, A/C clutch, Blend Door Actuator, Trailer Tow Battery Charge Relay Coil, Four Wheel Anti-Lock Brake System (4WABS), Turn Signal." Replaced it and everything went back to normal. Turn signals work, A/C clutch works, no flashing overdrive light and speedometer works. All from a 10A fuse. If you have any of these symptoms examine all the fuses carefully. There's a 20A fuse for turn/hazard lamps and this other one buried that's only 10A.
View 1 Replies