2004 f250 wipers and fluid not working Done the usual stuff checked the fuses in the cab and the 15amp fuse is good and the 30 amp fuse is good. Is there something under the hood i should look at?
View 3 RepliesMy windshield wipers aren't working. I can hear the relay click and I've checked the fuse. I found this ground wire, what it goes to?
View 1 RepliesI have a 2005 F-250 6.0 Powerstroke.
My washer fluid pump is not working, it was a few weeks ago but now it is broken. The Owner's Manual only has the listing fuse 33 for "cluster, 4x4, wipers". It looks like some of the older models have an actual fuse for the "washer fluid pump". I checked fuse 33 under the dash and it is ok. What fuse controls the washer fluid pump?
The pump does not make noise when activated, so I'm starting at the fuse but I don't know what the hell is going on.
Wipers/washers didn't work on 2003 f250. No blown fuses in system, supply fuses are 106 and 33, removed wipers and found no voltage on dk/grn wire of connector (fuse106). Turns out that the wire bundle had chafed a wire near the inner fender liner to the point that it cut the wire and broke the connection.
View 3 RepliesMy new to me, 2005 F-250 windshield washer nozzles don't work. I have replaced the windshield washer pump, cleaned out the washer fluid container and rubber filter screen, blew air through the lines and the passenger side nozzle barely sprays and the driver side nozzle does nothing at all. I guess I have clogged nozzles. What is the part number or place you bought them? Looked online and everything I can find is so generic.
View 14 Replies1999 f350 gas 4x4 . Truck runs fine. even passed inspection. However just recently my windshield wipers seem to work only sometimes. Right now won't come on at all. I checked the fuse.
View 3 RepliesSometimes when I start my truck (maybe 2-3x per week) my windshield wipers will wipe one time randomly. They're not on and haven't been on for days.
View 5 RepliesI have a 2005 6.0 with 279k running pretty strong. I met a mechanic that has the same year truck with 700K!! He showed me one of his mods and he used a longer line on his windshield wiper fluid and put a Tee Connector on the line and ran it into his intake for the turbo. He said he will use it when cruising along sparingly but it cleans his turbo and such. Is this a water injection hack?
View 6 RepliesMy 01 F-250's wipers would not shut off. As soon as the key was turned on they would come on. No delay but high and low only. Had to pull the fuse to drive it. I replaced the multi function switch as well as the relay with no fix. I did some reading on this problem and it is related to the "park" switch in the wiper motor itself. I took the black plastic cover off the motor which reveals the worm gear driving the plastic gear which acts as the switch.
The contacts for this switch are hard to get to as they are on the backside. I blew compressed air into every little crevice and removed most of the grease. I regreased and put it back together. Sure enough the wipers work just fine now. I am assuming the compressed air trick may be only temporary. Need to reveal the contacts for the park motor switch without destroying the plastic housing?
My A/C has been working fine up til the end of last season and getting worse now. It comes on and blows really cold, then after a bit a electrical connection gets hot and looses contact somewhere. I can turn it off for about 5 miles then turn it back on, May last the rest of the day, may only last 10 min, then turn it back off, wait 10 min, turn on, does great! I thought it might be a dampener door,, but does the same whether in defrost, regular A/C, or max, so I think it has got to be a electrical connection getting hot and loose.
2004. F250 FX4. 198,000 miles,,,, runs great,,, just a little hot driving!!!
1999 F250 5.4l base work truck. My problem is wipers, washer do not function. It all started with my wipers staying on. I removed the fuse to stop them. When i put it back in nothing. I have bench tested all relays, checked fuses, put in a new mfs, put in a new/used gem, checked all wiring i can seem to find, refreshed grounds etc. I am starting to lose my mind with this thing.
I have gone through all of section A and B of these tests [URL] .... except for the NGS scan tool.
Tonight checked the pins at the central junction box relays to see what was going on. This is where things got interesting. i have constant power at pin 5 of the run/park relay. if i jump this to pin 3 the wipers run. Pin 5 of hi/lo and washer show no voltage, however show continuity to ground. pin 5 of run/park also shows continuity to ground.
With the key on I have 12v at pin 1 of the hi/lo, run/park, and washer sockets. when cycled through the switches show i have continuity to ground on pin 2 of all sockets as they should. However, when relays are in place they do not "click" over.
What am I missing here? As much as I'd hate to do it, I may end up just throwing a switch in to "jump" the run park relay for temporary single speed wipers.
2009 F250 lariat. While driving down the highway my wipers came on when stalk was in the off position. They would not shut off. Had to remove the relay to get them to shut off. Also, during middle of a sunny day the headlights would temporarily come on and shut off when it was in the automatic position. They would not come on if I put it in the off position though. Since both the wipers and high beams are part of the multifunction switch is it likely that the switch has gone bad vs. a more major issue with the computers. No other issues identified.
View 1 RepliesI just bought a 2004 f-250 checked everything out except for the headlights ... when I tried them the didn't work except on flash to pass ... I searched around and found some possible solutions and tried them .... first I checked the bulbs and all the fuss they are good then I bought a headlight switch ....that fixed the problem for about two days then they quit working again... so I took it back and got a new one ... when I first put it the new one in it didn't work then it started working a day or so later and I hadn't done anything to make it work... then a couple days later it went out again ... I have swapped the switch out several times and have had no luck I replaced the multi function switch and still no low beams ...
All the fuses are still good I have checked the wiring visually as much as I can see and see nothing... buddy of mine checked the pins on the headlight switch connector they are all good .. Read something last night about a guy whos alternator was going bad and caused his not to work checked mine its putting out around 13.4 at idle .. is there a relay somewhere ... my book doesn't show the function of any of the relays so I don't know ...not a mechanic but a pretty decent parts changer. Trying to fix this myself . Next week have to take the truck to pull the camper ..
I have a 2008 f250 with 6.4. Was sitting my truck with key on and motor off listening to radio on lunch and my wipers came on by themselves. Switch was in off position and we're in slow speed. If I turn switch they wouldn't change speed til high position. Turned key off and back on and they came on still. Pulled 30 amp fuse in battery junction box to shut them off.
View 3 RepliesI have an F-250 diesel 2004 and about six months ago it started acting really crazy. Basically most all of the dashboard electronics stopped working like the speedometer , odometer, gauges, etc. additionally all of the interior lights, and the radio stopped working. Now it looks a lot like the attached picture when I'm driving the truck. All of the lights are lit up on the dash panel but nothing actually works. I thought at first that a bunch of fuses might be blown but I have replaced nearly every fuse that has anything to do with any of the affected systems. What the issue might be.
View 11 Replies2004 F250. Just got about 6 inches of snow. I use this truck to plow my private road. A few other residences on the road rely on my plowing.
I usually use 4WD Low and gear 2 on automatic transmission to plow. Hub manually locked. But today, when I shifted to 2, and pressed on the gas pedal. The truck was not engaging to drive, as if it were in park or neutral. And when I tried to shift to park, there is grinding noise and wouldn't allow me. I had to turn off the engine to be able to shift to park.
When I manually freed the hub and used 2WD High and gear D, I was able to drive the truck without problem.
Later, I tried using 4WD Low and gear D, and was able to drive a little distance before the truck no longer drives, and pressing on the gas is as if the truck was in park or neutral.
Previous to this earlier, I was driving down the private road to see how much snow we got. Without the plow on, I might have gone up to 10 or 15 mph, and still using 4WD Low and gear 2, maybe for 1/2 mile. Could I have damaged something by driving too fast in that setting?
2004 f250, brake lights except 3rd brake light do not work. flashers also do not work. turn signals work on both sides. when you turn on the flashers only the right indicator on the dash lights. checked all fuses for brake lights and am at a loss. On a float trip this weekend with my toy hauler and need brake lights to get home.
View 2 RepliesI have a 2003 F250 Lariat 6.0L Crew Cab. My wipers, radio and power windows don't work. I have painstakingly checked every one of the fuses to see if there was one or more blown. All were OK.
I removed the fuse panel under the dash and have disassembled it to look for obvious clues, burnt wires/heat damage etc. but everything looks fine. Have pushed all of the fuses in to make sure they were seated properly. No joy.
I recently replaced one of the back windows in my truck and had to detach the rear dome light and I remember one of the wires sparking. Where to start diagnosing this problem?
I have a 7.3l 02 f450. The wipers won't work on any low speeds and only on the fastest will they work. And if you switch it from the fastest to any other speeds, the wipers stop right where they are.
View 1 RepliesMy 01 f250 has a leak coming down my line of sight on the windshield. Not sure if it's the seal, or the clearance light above it. Ever run into this before?
View 3 RepliesI have no windshield wipers. Since i bought the truck ive fixed other issues but cannot figure out the issue with the wipers. Tested for power not sure if it's accurate but seems like there is power to the harness to the motor but not 100% positive.... Can it be the switch? Blinkers and rest on same switch still work but no ww. I also dont hear clicking from a solenoid like ive read on some research.. Fuses are all good pulled everyone out since they arent labeled with numbers next to them...im at such a stand still and cant drive the truck was screwed the other day when we got sun showers for nor reason and i was on a major highway.
View 6 Replies