Ford Super Duty (1999-2016) :: 2004 F250 - Slight Hesitation When Trans Is Engaged And Tow Haul Light Blinks
Jul 22, 2013
I have a 2004 F250 Torqshift trans, 155,000 miles. It has had a slight hesitation when trans is engaged for about 4 years, not a problem the dealer has no fix they said.
Now today for the first time I had a tow haul light come on while driving on the freeway. It would not go into overdrive and the light keep blinking. Later in the day, I let it cool down and it drove fine to the store about 2 miles. When I got in to drive home it had tow haul light go blinking and check engine light came on this time.
I hooked up my code reader and it's giving codes: P0720, P0751 and P0766.
Should I take it to the Ford dealer, a Transmission shop or have a friend who worked at Ford Dealer do the Work? I see that some people have changed out the TFT sensor and corrected the problem. While the pan is down should I just have all the shift solenoid sensors changed?
View 11 Replies
Advertisement
I've got a 2006 f250 with 160,000 miles, trans was rebuilt by previous owner about 10,000 miles ago. The tow/haul light started blinking yesterday, only blinks for first couple of minutes of driving and then stops. Service engine light popped on today as well. Won't have access to a code reader until tomorrow, but looking for some preliminary info...
View 3 Replies
Well I went about 20mi to pickup a door for my inlaws. Get about a mile from home and my tow haul light is flashing. Truck starts shifting strange then I smell it trans fluid. If course I get stopped by a red light shut it down. Started and had to rev to get it to move now four houses away from home coast into the drive shut it off and trans fluid is covering the entire bottom of my truck. Even the rear tires inside are covered. I had the wife crank it and I blew a trans line near the ext. trans oil filter. What are the chances that I did not toast my trans? No prior shifting or slipping problems before this mishap.
View 14 Replies
I have a 2006 6.0. It's hard to put into to drive and for you to get it moving you have to just about floor it. The tow haul light is flashing but my bullydog won't pull the codes. It stops moving after like 30 to 40 ft after you got it moving and acts like it's in natural. If you turn it off and back on it sometimes will move another 30 to 40 ft sometimes. It also sometimes if you put it in reverse won't let you give it gas. Like you can push the pedal but the rpms won't climb for this reason I'm thinking something to with a solenoid or fuse or something along those lines and also because if you restart it will move again. I don't know much about transmission. I'm taking it to a shop tomorrow for them to try and read the codes. If they say the transmission is toast i already located another one 2 hours away to swap in which I'll do myself to avoid the high cost of the shop which also I'll look to yall for guidance. I drained some of the transmission fluid and didn't see any metal flakes. Should I pull the pan as well and look if nothing is coming out in the trans fluid ?
View 4 Replies
I have a 2007f550 auto trans with a flashing tow/haul light and a code of po791 coming up. Flashing light will clear in k/o position and remain off until placing selector in drive,after two feet or so of travel,an audible clunk and the trans acts like it is in third gear. Reverse is no change and highway will not shift into o.d. The iss "A" is listed as the culprit but ford doesn't list a iss a.
View 2 Replies
Looking for a diagram of where the transmission temp sensor is found ..... I have a 2005 f 250 5.4l FX4.... My tow haul light keeps flashing...
View 4 Replies
So coming home yesterday from our camping trip the tow/haul light started to flash. this was about 40 miles into the trip. So we pulled over, the tranny fluid looked low, so I added a little more. The light stopped flashing, but maybe another 20 miles it started again, we pulled over and it stopped. We got to a rest stop and after about 20 minutes, I called Good Sams Roadside, there tech said to take it out of tow/haul mode and so we left the rest stop and it was good for just about 40 miles.
We hit another rest stop, at this point we were about 80 miles from home. I did not feel any difference in the truck shifting or if it was acting different. The light flashed again, sometimes going off, then coming back on. We hit two more rest stops, letting the truck rest. We left the last rest stop, we were already halfway up a big hill on the Mass Pike and after 5 miles the light came on, but then after a few miles it stop and from that point to my house ( which was just over 50 miles) it never came back on.
The truck is a 2006 F250 gas that just hit 100,000 miles. New motor put in over the winter and a few years back had the cam phasers and some work done on it. Could this be some sensors, etc that is starting to go and needs to be replaced?
View 7 Replies
Experiencing a melt down with one of my trucks. One of our trucks is an 06 F250 SD with 80k on a 5.4L and the other day the tow/haul light started to flash. I took it to a buddy's repair shop (who is an experienced Ford tech and tranny guy) any way, it shifted fine until about the last 1/2 mile before I got to his shop, then it started shifting in and out of different gears. He found solenoid "A" pressure solenoid failure and one other solenoid failure, he replaced all 7 solenoids and also found the pigtail from the transmission to the wire harness bad as well and replaced that. I pick it up and get about a mile down the road and the light starts to flash again so I took it back, he ran his scanner and now found something with the coast clutch and through all his testing it told him the coast clutch needs replaced. He removed the trans. and tore it all down and found nothing wrong with anything, in fact he said everything looked in great shape and thinks the pcm failed.
View 12 Replies
I purchased a 2000 F250 7.3 4x4 (auto transmission) about 8 months ago. I've noticed recently that when I accelerate there is a slight hesitation like there is slack in the drive line. This does not happen when the truck is moving and I accelerate. There is not audible clunk and the hesitation is not in the motor.
I checked the u-joints and they all feel tight. There is a little slack in transfer case that allows me to turn the drive line slightly back and forth. Is this normal? Should I be planning on a transmission or transfer case rebuild soon?
Update: I was researching the leaf spring isolator pads (mine are warn out or missing) and it sounds like these can cause something similar to what I am experiencing. I am planning on pulling a 28' travel trailer from Colorado to Wisconsin next month and would like to avoid any issues if possible...... Obviously, I know ....
View 4 Replies
I was driving down the freeway the other day and when I hit a rough patch of road, nothing major, the truck sputtered and the 4x4 Low light blinked a few times on the console. I was driving in 2wd at the time. I kept driving and every bump I hit the truck sputtered as though trying to shift and the light blinked. On smooth road it didn't happen.
Today I drove to work at 6:30AM (40 miles), no issue. At noon I drove home and the issue started again. Every bump I hit the light came on and the truck seemed to want to try and shift into 4x4 low.
I got home, parked the truck for a few hours, then went out again, no issue. But about 20 minutes later it started again. I pulled over shifted to 4x4 high, drove it, was fine, went into 4x4 low seemed fine, went back to 2wd drove it some more issue came back. I've read tons of online threads regarding 4x4 lights etc, none like this and none on F250 Super Duty (2008).
View 14 Replies
Okay this is what I got; I recently purchased high mileage 2004 F250 Super Duty short box super cab 5.4 liter. Came with manual 4x4 handle on the floor so no 4 wheel on the fly and this eliminates the vacuum for the auto hubs so this will not be part of the problem. When engaging the hubs and ONLY when engaged the driver side hub grinds. The 4 wheel drive works but it sounds like its ready to grind itself into oblivion. I did pull the hub and the grinding was gone, I happen to have a spare hub that is good and the grinding returned.
I have jacked it up and made sure I have no play in the wheel itself and the axle knuckle on the axle shaft. Some say remove the front drive shaft? Or turn the wheels all the way in one direction engage the hubs and check for binding? I will do this in the morning, but what does that confirm if it not the hub. Could it be the passenger side echoing across? On my 99 Super duty I kept hearing moaning coming from up front like the breaks were shot and if you stuck your head out the window it was the back echoing to make it sound like the front.
View 3 Replies
So I was driving my 2004 6.0 auto on the freeway today when the tow haul light randomly started flashing, nothing felt wrong until I stopped, then when I went to pull away it wouldn't shift down from 5th according to my livewire ts says under the commanded gear gauge. It shifts into 6 and overdrive fine. I turned the truck off, the light went off but as soon as I put it in drive it jumped around from 1-2-5 and back down until it locked in 5 again and the light started flashing again. What this could be?
View 1 Replies
I recently purchased a 04 f250 with the 6.0l powerstroke. I drove it for about 3 weeks now, Ive put my trailer behind it with small loads and just today tried to use the tow/haul button. When you go to pull out the tranny never shifts from first gear?? Its pulls and runs fine until you push the buttan and no shifting........
View 6 Replies
Just got the transmission rebuilt in my truck and other then shifting hard sometimes it has been doing great, Hooked it up to the goose neck this evening and everything was fine then went to back it up and pull it forward and after a short distance the od light was flashing and when i ran a check on it it was p0720? The transmission has less then 1000 miles on it?!?!? 1999 Ford F-250 7.3 Automatic....
View 5 Replies
My 2005 F250 just had the cab off in December for head studs and gaskets. Its a Crew Cab short bed FX4 so it has ESOF. When I engage 4x4 the blower will switch from blowing air out of the vents to blowing air out of the windshield defrost. Is a vacuum line plugged in wrong somewhere, or is one cracked? Trying to figure this out, its rather annoying
View 2 Replies
I just noticed that on the highway sometimes (3 times) the tow/haul light is lit. I press the button and it will not turn off and when I get off of the highway I can tell the trans is shifting through the tow/haul strategy. Once I shut the engine off and restart it the light goes off and it drives normal. When it is driving normal I can turn the tow/haul off and on with no problems but noticed the light coming on it's own recently.
View 10 Replies
I'm looking at a 2004 F250 XLT super cab 4x4 with a 5.4L with only 50k on the clock. It looks to be in great shape and drives good with only a few issues. Cruise doesn't work, it pulls to the left a little, and it has a slight roar coming from the left front wheel. Other than that it seems to be a nice truck. Its blue and grey two tone. Anything else I need to look at before pulling the handle on this one?
View 11 Replies
I have a 2005 f250 super duty turbo diesel 6.0 automatic. The problem I'm having is, when I engage the tow/haul button the transmission doesn't down shift unless I feather the pedal. Also the engine will overheat at times. I've replaced the thermostat, but that's all so far.
View 2 Replies
My daughter has this truck and I was driving it the other day I noticed it misfiring when the trans shifts down under a slight pull and/or going up hills. It looses power and speed when this happens but if you back off, it smooths out when it shifts into overdrive. I haven't had it to a mechanic to check any codes yet.
View 3 Replies
I have been having an issue with my blinker for the past few months. When the blinker is fully engaged, the right front blinker doesn't work. If I just push up on the blinker so it doesn't fully click into place, the right front blinker works fine, so it is not a burnt out bulb. I have also checked my blinker light in my mirrors and they work fine. Left blinker works fine. I am stumped on to what this can be and I need to get it inspected. 2005 F-250...
View 3 Replies
This morning, the tow/haul light came on, tranny temp gauge wouldn't read (stayed below zero), "check gauges" warning came up on the panel, and "check engine" light came on. Truck ran fine/shifted fine, always has.
2007 F-250, V-10, 5-r 110 tranny.
View 5 Replies
