Ford Super Duty (1999-2016) :: 2004 F250 Running Low On Oil
Sep 15, 2015
I have a 04 f250 with aprox 95k on it 5.4L I knew I was over mileage for a due oil change I haven't been driving it much it crossed my mind, as I am usually very adamant about changing fluids. I went to check my oil and only a smudge of oil on the dip stick. I know this is not good but the truck runs fine, no noises, no knocking, not a chatter from the valve train. Oil pressure was good everything seemed fine did I get lucky? I know it wasn't good I am not going to let that happen again everyone think I dodged the bullet?
View 9 Replies
Advertisement
I have a 2004 f250 6.8L and recently I've notice the trick not running strong. Is hesitating when i step on the gas pedal. For example, I am driving on the feeder road and fixing to get on the freeway ramp, well i have to spent a bit harder on has pedal to gain speed, but it seems its struggling and I can hear muffler making like a flapping noise. Also when I am going between 40-65mph and I spent on it, the tricks kind of jerks and vibrates. Feels like its coming from transmission. I let go and step on it again and it goes away. What to check??
Miles : 96k
Year: 2004
No Check Engine Light
View 6 Replies
To make a long story short, after replacing the timing chains, guides, and tensioners, the right side cylinder head began running very loud. Think of the usual chatter associated with these engines and multiply it. It was constant, from start up to shut down, and it increased with rpm. Thought at first it may be caused by debris in the oil clogging the lifter(s). After changing the oil multiple times along with different additives and driving roughly 600 miles, the noise persisted. Taking a look down the oil filler tube with a flashlight and with the engine running, the head looked dry. Safe to say at this point I was starving the head of oil.
Removed the valve cover. Removed the rearmost camshaft cap. Sure enough, the oil passage was completely blocked. Inspected everything and there was signs of running dry (minor discoloration, dried oil spots... but no real damage and no play anywhere. Put it all back together and the truck runs quieter than the day a bought it.
Here's the camshaft cap:
This is exactly what it looked like after removal. The material blocking the passage is hard and bridle like plastic.
View 4 Replies
The rear tail lights on my truck have been out for a while now. I wasn't doing much driving at night so it wasn't much of a bother but the new job is getting me home a little later and having to drive with my hazards on is getting old fast.
My radio wasn't working either and I disconnected it a while back hoping maybe it had something to do with my lights shorting out but no luck. It remains disconnected. Just in the past few days my front running lights have went out as well.
I've tested all fuses multiple times (and replaced a couple of them) and checked and replaced bulbs. My brake lights, headlights, dash lights and hazards all work fine. I have the trailer light hook up on the rear bumper and disconnected it at the wiring harness as well hoping it was the problem but it wasn't.
View 3 Replies
My 1999 f-250 superduty shows overheating after it runs for awhile but it doesn't actually overheat the gauge just shows it. What it does is drops down to four cylinders. Is my heads blown or could it be something else it has 260,000 on the engine.
View 2 Replies
I have an 2003 F250 7.3 Diesel 4wd. Yesterday I knew I was low on fuel but I don't think I ran out of diesel. My gauge was above the "E". 50 miles left on my overhead readout, but you never know. All of a sudden the truck misfires and is running very rough before it dies on me. I get it towed home.
Thinking that it possible I ran out of fuel and screwed up my fuel pump, I bought a new fuel pump and fuel filter, installed them and I have the same symptoms. I am guessing I lost my prime, who knows. I have 180,000 miles on it and haven't ever had engine problems.
View 11 Replies
I bought it and changed the fuel filter and it was dirty. Then ran a tank of gas with seafoam and then with lucas fuel injector cleaner. Still nothing. It idles like its missing and as long as you are light on the pedal it revs up fine but if you're heavy on the throttle its. Its has no codes that's why I haven't replaced the coil packs and plugs but they have been ordered. I just thought there would be an engine code if any of the coils or plugs were bad. Looked for a vacuum leak but couldn't find any. The donut gasket on the pass side is bad would that cause it to run shifty with no code.
View 2 Replies
I have a 2005 Ford F-250. I have checked power to the rear harness and all is good except for the tail/running lights.
Is there a fuse for the tail lights? I have checked the manual and don't see one called out. And the relays under the hood are labeled stop lights/turn signals and those are working fine.
I will see if I can trace the brown wire from the rear harness backwards, but it may be a simple fuse.
View 3 Replies
I have a 2005 ford f250 with the factory installed brake controller and towing package,until recently all was well,I tow a fairly large travel trailer and last time I hooked the trailer to the truck I noticed the running lights on the trailer were lit, I checked to make sure that I did not have the parking lights turned on or the headlights. I did find posts about the running lights not working and was surprised to find there is a relay somewhere on the central junction fuse block that was integral to the cfb and not user serviceable. Could my problem be that this relay failed in the closed position or am I not going in the right direction in my quest to find this problem. Also looking for a diagram of where this relay is located on the central junction fuse block? I would also consider doing a work around solution rather than having to replace the entire fuse block.
View 7 Replies
Have a 99 F250 V10 was having issues with it going in limp mode took it to the shop they said number 1 cylinder running hot I had the head rebuild all new gaskets less than 10 miles truck shuts off pullover no antifreeze put antifreeze and water in Reservoir start back up look at Reservoir it's empty shut it off pour more water in Reservoir and it go straight down to empty.
View 6 Replies
2008 F250 5.4L 150k. My truck has been driving pretty rough in low gears, rough idle, and today the check engine light came on then getting on the interstate the light started blinking. I ran the code it came back 0307,300,308,300. After doing some research on here, I've come to the conclusion to change out the coils on 7 & 8. Questions are, should I change plugs as well? And how important is it to keep all the boots (of all 8) the same color (brown or black)? And should I expect to change all the rest soon?
View 1 Replies
Do the raptor style boards will work on an F250, 2012?
I hate the stock ones and want something closer to the body and has some rocker panel protection. Alternatives are welcome but not 1k ones.
View 14 Replies
What may be the issue with my truck. Drove earlier in the day and hauled trailer. Ran fine. Got it home and once I unloaded trailer and went to start up truck again it died a minute into backing up. I tried to restart and turns over but dies in 3-5 seconds. Tried again a few hours later and next morning and same thing.
Pulled code and came up P0172- Bank 1 running rich. I had replaced the Mass Air Flow sensor a few months ago. Since it was still under warranty I went and got a new one in case that was the issue, but didn't fix. When I try to start it smells like gas. Sounds like fuel pump is coming on fine. Checked air filter.
Of course is still hooked up to the trailer and in a tight spot in the yard at the moment so anything basic/inexpensive I can try myself first would be great.
View 1 Replies
Just bought a 2002 F-250 Crew Cab. It has the factory style running boards with the lights at each end. None of them where working so I changed the bulbs and still nothing. I decided to follow the wiring to make sure everything was good and found that neither one of the boards are plugged into anything. They both have about a 2' loomed harness with a plug on the end of each board and it is zipped tied to the frame. But there is no wiring nearby to plug it into, I have checked everywhere. I can run extra wiring no problem if I can find out where they are supposed to plug at.
View 14 Replies
I have an 02 f250 V10 with a rough idle (90K Miles). It's not horrible but it's obviously not running perfect. Everything seems ok when I am up and driving, especially at freeway speeds. I recently noticed that if the truck is in park and I run the RPM's to 1500 or 2K and quickly let off the gas it will die. It never throws any codes. So far I have replaced the IAC Valve, fuel filter, O2 Sensors, PCV valve, cleaned the MAF sensor and replaced the air filter. Plugs and boots were replaced 5K miles ago. Fuel trim levels on both banks are running around -3.1 to positive 3.5 based on what the computer is telling me. Also according to the computer the vacuum sits steady around 25 at idle (+ or - .2). I don't have a manual vacuum gauge, just relying on the computer. I've also gone around to every plug and disconnected both the injector wire and the COP wire and they all seem to equally affect the idle as well as the fuel trim levels.
View 11 Replies
I have an 02 f250 5.4. I just did the intake manifold. I also changed the spark plugs and the valve cover gasket. Following this I drained the oil and filled it with fresh oil.
It started right up but it felt like the engine was really vibrating and running rough. The check engine light than came on. I don't have one of those tools to diagnose it.
What could be wrong?
View 11 Replies
My truck all of the sudden started overheating when running idle or at low speeds. No towing or anything with 89 degrees outside it can hit max water temp in matter of 2 minutes once at running temperature and standing on red light. I checked the coolant level - looks good and changed the thermostat just in case, but the problem is still happening. The fan is running/kicking in as well when it gets hot.
I'm waiting for OBD2 plug to read the stats from the computer, but what else would you suggest I can check for issues ? Oil temp gets to about 222 and transmission to about 194, but it doesn't keep on increasing. One another thing I noticed is that when I have AC running it will actually pop a overheating message on the display (I don't continue to drive it at that point) and when it gets hot it seems as if it didn't have much power.
I don't know if this is connected, but about two months ago it started blowing black smoke when starting from red light or stop sign or when accelerating with gear reduction. It is a 6.7 diesel one and only has 60k miles on it, so I'm hoping its nothing major.
View 2 Replies
My truck has been doing this for a while now but it has progressively gotten worse from about three months ago when I went through some deep water. I don't believe it had to much to do with the water, I just think that the water is what didn't deal the situation and lead to the problem becoming more prevalent. But continuing, yesterday it got down into the high 20's and my engine started acting up (rumbling coughing, surging while at/leaving complete stops) and then it finally through a code for once and I head over to the neighborhood AutoZone expecting to get a lean code (because when the engine is acting up really badly I can unplug the fourth cylinder fuel injector without the engine acting any differently) but instead I received the p1152 (bank two lack of switching (rich)) code....
At this point I believe it is a faulty fuel pressure regulator, but without a good diagnostic obd2 reader or a fuel pressure gauge I'm not sure what to do. I'm currently in college, money is low, and I'm trying to take an accurate shot at the part that needs to be replaced so that I don't have to buy more than one part. Of course AutoZone says o2 sensor but I changed both about five months ago.. I've been chasing this diagnosis around for way too long now. (It's on a 2002 ford f250 5.4l super duty)
View 2 Replies
Looking for some info on wiring up some Day Lights Running Lights on a 2016 F250 with diesel engine? Thinking of adding LED lights to front of vehicle for day time use.
View 13 Replies
So, I have a 2007 f250 with the 6.0. When she's cold she starts fine but runs rough like she has a miss. When she warms up the miss goes away and it runs pretty good. But if I shut it off it won't start for about an hour or so.
ICP sensor has been replaced.
FICM is putting out 50v
View 11 Replies
My 99 f250 ran hot while towing my travel trailer when the fan clutch gave up. ever since iv been noticing coolant loss and pressure in the day tank.ive changed the water pump,radiator. day tank and cap plus the thermostat.
View 9 Replies